重点产业源增长对北部湾地区气态污染物模拟的影响

根据污染源普查资料制作北部湾地区2007年人为排放源清单,以及中期/远期参比情景(REF15/REF20)和远期调控情景(SCEi20)下的排放源清单.采用WRF-Chem模拟北部湾地区空气质量现状及未来变化.2007年SO2和NO2月平均质量浓度模拟值与监测值比较吻合.广东、广西(海南)地区污染物质量浓度较高(低)....     

Risk assessment on disinfection by-products of drinking water of different water sources and disinfection processes

The occurrences of trihalomethanes (THMs) and haloacetics (HAAs) in the water supply in Beijing and Canada were investigated. The concentrations of THMs and HAAs in Beijing and Canada were below the maximum contaminant levels specified by the USEPA and WHO standards. The multi-pathway risk assessment (assessed through oral ingestion, dermal absorption and inhalation exposure to drinking water) was used to assess the cancer risk and the hazard index of THMs and HAAs from fifteen waterworks in Beijing, China and three treatment plants using different disinfection processes in Canada. Residents in Beijing and residents who were served by three treatment plants using different disinfection processes in Canada had a higher risk of cancer through oral ingestion than through the other two pathways. The cancer risk resulted from disinfection by-products (DBPs) was 8.50E-05(for males), 9.25E-05(for females) in Beijing, China, while it was 1.18E-04, 1.44E-04 in Canada. The risk was higher when water treatment plants used surface water source than when they used ground water source and mixture water source in Beijing. The risk showed different changes in three treatment plants using different disinfection processes in Canada. The lifetime cancer risk for THMs followed the order: Plant 2>Plant 1>Plant 3. And, the lifetime cancer risk for HAAs was: Plant 1>Plant 2>Plant 3.     

团粒喷播在废弃采石场生态恢复方面的应用

废弃采石场严重影响城市周边的生态景观,极易导致生态环境的继续恶化。以文登某一采石场破损山体的绿化工程为例,运用团粒喷播生态修复技术对废弃矿山进行生态性治理,并探讨其生态恢复方法,以期为今后废弃矿山的残损山体植被恢复和生态环境重建提供参考。     

基于我国规范与PIARC标准的公路隧道需风量分析

以某长大高速公路隧道为例,结合我国隧道通风设计规范JTJ026.1-1999与PIARC2007标准(世界道路协会),针对不同行车速度,不同车辆更新情况、不同排放标准组合形式以及是否考虑NOx等情况,对各个不同工况的需风量分别进行计算,并从需风量计算方法、机动车排放量和污染物设计浓度三个方面对隧道需风量差异进行分析。研究结果表明:我国设计规范与PIARC2007存在较大差距,为了适应当前及今后我国交通量及机动车排放特点的发展趋势,我国现行规范应在机动车排放量、污染物设计浓度限值等方面做出必要改进以达到合理确定隧道需风量的目的。     

低温A/O-MBR工艺启动试验研究

研究了A/O-MBR工艺低温(水温在5~12℃)启动效能,结果表明,低温下A/O-MBR工艺启动迅速,活性污泥的培养驯化时间较短。启动过程中根据出水水质情况,逐渐提高负荷,运行34 d,系统对COD的去除率能达到90%以上,系统对氨氮的去除率能达到96%以上,至稳定运行后氨氮的负荷平均可达到0.419kg/(m3.d),反硝化效果系统去除率基本能稳定在60%左右。     

电渗析法再生CO_2电还原电解液的研究

探索了电渗析法再生CO2电还原电解液的可行性。以HCOOK溶液作为CO2电还原反应后的模拟液,采用单室电渗析装置对其进行再生,考察了电流、时间、温度等操作条件对电流效率和再生率的影响,研究结果表明:在常温条件下,操作电流低于极限电流时,采用电渗析法再生CO2电还原电解液具有高的电流效率和再生率。     

四川某中小城镇污水处理厂进水水质统计分析

生活污水水质对处理工艺的选择、设计参数的选取以及稳定运行十分重要。运用SPSS软件,对四川某中小城镇污水处理厂为期一年的进水指标(水量、COD、氨氮、总磷、pH、SS)进行方差和相关性分析。方差分析结果显示进水量、氨氮和SS在月份和季节之间存在显著性差异,而总磷和pH仅在月份之间存在显著差异,COD在季度和月份之间无显著性差异;指标相关性分析表明,进水量和氨氮之间呈负相关,氨氮和总磷、COD和总磷之间呈正相关,且相关性显著。在此分析的基础上对污水处理厂设计、工艺选择及运行管理提出了一些建议。     

Effect of platinum on the photocatalytic degradation of chlorinated organic compound

TiO2 nanoparticles, doped with di erent Pt contents, were prepared by a modified photodeposition method using Degussa P-25 TiO2, H2PtCl6 6H2O and methanol as the solvents. The physicochemical properties of Pt/TiO2 were investigated by the nitrogen adsorption and desorption isotherm measurement technique, X-ray di raction analysis and photoluminescence spectra, respectively. Reaction rates from photocatalytic removal of dichloromethane over Degussa P-25 TiO2 and Pt/TiO2 were evaluated. The average diameter and BET surface area of the TiO2 catalyst particles were 300 nm and 50 m2/g, respectively. The degradation e ciency was 99.0%, 82.7%, 55.2%, and 57.9% with TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. And the degradation e ciency was 99.3%, 79.7%, 76.5%, and 73.4% with a 0.005 wt.% Pt/TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. In addition, we found that the photoluminescence emission peak intensities decreased with increases in the doping amount of Pt, which indicates that the irradiative recombination was weakened. Furthermore, the results showed that the UV/0.005 wt.% Pt/TiO2 process was capable of e ciently decomposing gaseous DCM in air.     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

Removal of phosphate by Fe-coordinated amino-functionalized 3D mesoporous silicates hybrid materials

Phosphate removal from aqueous waste streams is an important approach to control the eutrophication downstream bodies of water. A Fe(III) coordinated amino-functionalized silicate adsorbent for phosphate adsorption was synthesized by a post-grafting and metal cation incorporation process. The surface structure of the adsorbent was characterized by X-ray di raction, N2 adsoropion/desoprotion technique, and Fourier transform infrared spectroscopy. The experimental results showed that the adsorption equilibrium data were well fitted to the Langmuir equation. The maximum adsorption capacity of the modified silicate material was 51.8 mg/g. The kinetic data from the adsorption of phosphate were fitted to pseudo second-order model. The phosphate adsorption was highly pH dependent and the relatively high removal of phosphate fell within the pH range 3.0–6.0. The coexistence of other anions in solutions has an adverse e ect on phosphate adsorption; a decrease in adsorption capacity followed the order of exogenous anions: F?? > SO2?? 4 > NO??3 > Cl??. In addition, the adsorbed phosphate could be desorbed by NaOH solutions. This silicate adsorbent with a large adsorption capacity and relatively high selectivity could be utilized for the removal of phosphate from aqueous waste streams or in aquatic environment.