Low cost measurements of nitrogen and sulphur dry deposition velocities at a semi-alpine site: gradient measurements and a comparison with deposition model estimates

The conditional time averaged gradient method was used to measure air-surface exchange of nitrogen and sulphur compounds at a semi-alpine site in Southern Norway. Dry deposition velocities were then obtained from the bi-weekly concentration gradient measurements. Annual deposition velocities were found to be 1.4, 11.8 and 4.0 mm s(-1) for NH3, HNO3 and SO2, respectively, if all data were included, and to be 10.8, 11.8 and 13.0 mm s(-1), respectively, if only positive values were included. Measured deposition velocities were compared to two sets of values estimated from a big-leaf dry deposition module applying to two different land types (short grass and forbs, and tundra), driven by measured micrometeorological parameters. The deposition module gives reasonable values for this site throughout the year, but does not reproduce the large variability as shown in the measured data. No apparent seasonal variations were found from either measurements or module estimates due to the very low productivity of the studied area.     

Life cycle responses of the midge Chironomus riparius to polycyclic aromatic compound exposure

During acute exposure, polycyclic aromatic compounds (PACs) act mainly by narcosis, but during chronic exposure the same compounds may exert sublethal life cycle effects. The aim of this study was therefore to evaluate the chronic effects of sediment spiked PACs on the emergence of the midge Chironomus riparius. Three isomer pairs were selected, and 28-day LC50 values and 50% emergence times (EMt50) were determined. Concentration-response relationships were observed for phenanthrene, acridine, phenanthridine and acridone. Anthracene and phenanthridone had no effect on total emergence, but did cause a delay in emergence. Calculated porewater LC50 values correlated well with logKow values, suggesting narcosis as mode of action. In contrast, effect concentrations for delay in emergence (EMt50) deviated from narcosis, suggesting a specific mode of action during chronic exposure. It is concluded that emergence is a powerful endpoint to detect life cycle effects of PACs on a key sediment inhabiting invertebrate.     

Atmospheric pollutants monitoring by analysis of epiphytic lichens

The Canoparmelia texana epiphytic lichenized fungi was used to monitor atmospheric pollution in the S?o Paulo metropolitan region, SP, Brazil. The cluster analysis applied to the element concentration values confirmed the site groups of different levels of pollution due to industrial and vehicular emissions. In the distribution maps of element concentrations, higher concentrations of Ba and Mn were observed in the vicinity of industries and of a petrochemical complex. The highest concentration of Co found in lichens from the S?o Miguel Paulista site is due to the emissions from a metallurgical processing plant that produces this element. For Br and Zn, the highest concentrations could be associated both to vehicular and industrial emissions. Exploratory analyses revealed that the accumulation of toxic elements in C. texana may be of use in evaluating the human risk of cardiopulmonary mortality due to prolonged exposure to ambient levels of air pollution.     

Plant and Soil System Responses to Ozone After 3 Years in a Lysimeter Study with Juvenile Beech (Fagus sylvatica L.)

A lysimeter study was performed to monitor effects of elevated ozone on juvenile trees of Fagus sylvatica L. as well as on the plant–soil system. During a fumigation period over almost three growing seasons, parameters related to plant growth, phenological development and physiology as well as soil functions were studied. The data analyses identified elevated ozone to delay leaf phenology at early and to accelerate it at late developmental stages, to reduce growth, some leaf nutrients (Ca, K) as well as some soluble phenolics (hydroxycinnamic acid derivatives, total flavonol glycosides). No or very weak ozone effects were found in mobile carbon pools of leaves (starch, sucrose), and other phenolic compounds (flavans). Altered gene expression related to stress and carbon cycling corresponded well with findings from leaf phenology and chemical composition analyses indicating earlier senescence and oxidative stress in leaves under elevated ozone. Conversely in the soil system, no effects of ozone were detected on soil enzyme activities, rates of litter degradation and lysimeter water balances. Despite the fact that the three reported years 2003–2005 were climatically very contrasting including a hot and dry as well as an extremely wet summer, and also mild as well as cold winters, the influence of ozone on a number of plant parameters is remarkably consistent, further underlining the phytotoxic potential of elevated tropospheric ozone levels.     

Lysimeter Experiments to Investigate the Fate of Chemicals in Soils – Comparison of Five Different Lysimeter Systems

Several lysimeter scenarios and approaches exist to study the fate of agro-chemicals or contaminants from deposition in soil columns. In many systems just transport and leaching of the parent compound is followed, in some systems the leaching and transport of the metabolites is investigated as well. In more sophisticated lysimeter systems the volatilization and also the mineralization of the applied chemicals can be additionally monitored. Depending on the lysimeter system used and on the fact whether the applied chemicals are ¹⁴C-labeled or not, different results and various interpretations of the results might be achieved. Different lysimeter systems are described in this paper and a real dataset of a specific lysimeter experiment was transferred and evaluated in a virtual approach in the different lysimeter systems in order to show the advantages and disadvantages of the various systems.     

The use of the removable thin film coating technique as an alternative to traditional decontamination methods to mitigate and abate hazardous particulates

This article summarizes a study that evaluated a new decontamination technique for the mitigation and abatement of hazardous dust and particulates. Traditional decontamination methods are time‐consuming, expensive, can create airborne hazards, and do not always bring the concentration of the contaminant to acceptable levels. The use of the removable thin film coating will increase efficiency, will not generate airborne hazards, will decrease costs, and, with one application, will bring the hazardous dust concentrations to acceptable levels. Qualitative tests demonstrated that the removable thin film coating reduced the amount of visible luminescent dust (a surrogate for hazardous dust) from various surfaces. It also indicated that wherever there were minute scratches, the coating did not remove all of the dust. However, the qualitative tests showed that this decontamination method worked well as a preventative method, protecting clean areas from becoming contaminated when exposed to the luminescent dust. Further investigation was conducted using a scanning electron microscope (SEM) and carbon dust. Overall, the SEM experiment demonstrated that there was a statistically significant (p = 0.00007) removal of carbon dust (less than 10 μm in size) from surfaces with crevasses larger than 3 μm. The SEM also revealed that there were some limitations where there were large clusters of carbon dust; in these instances, the coating would tear and remain on the sample surface. One method to resolve this limitation involved adding Kevlar^TM fibers to the removable thin film coating. It was thought that this would increase the strength of the coating and eliminate the coating from tearing when removing large clusters of a contaminant. Unfortunately, this did not alleviate the issue. The use of an engineered textile, saturated with the coating, appeared to eliminate the problem with the coating not being able to remove the contaminant from the minute surface scratches and improved the removal process of the coating. © 2008 Wiley Periodicals, Inc.     

MULTI INCREMENT® TCE vadose‐zone investigation

MULTI INCREMENT® and discrete sampling strategies were used to estimate the average concentration and the three‐dimensional distribution of TCE in a 3,300‐m³ zone composed of two decision units (e.g., area of concern, population, exposure unit). Authors of this article and a private contractor (Stanley Consultants Inc.), respectively, implemented these two sampling strategies independently. Compared to discrete sampling, the MULTI INCREMENT sampling strategy identified more locations where percent‐level concentrations of TCE have migrated, is more economical, and provided greater data quality. © 2008 Wiley Periodicals, Inc.     

Odor Control for Land Application of Lime Stabilized Biosolids

Over three million dry metric tons of biosolids produced in the United States are land applied as Class B. Lime stabilization is employed for biosolids treatment at approximately 20% of the wastewater treatment plants because it is a simple and inexpensive process. During lime stabilization, the pH of sewage sludge is raised above 12 for pathogen inactivation and odor reduction. Lime dose and mixing have been found to greatly reduce odor generation from lime stabilized biosolids. A better quality biosolids product is less likely to create public opposition to land application programs. In this study, land application tests using Class B biosolids were conducted in order to determine whether better mixing can reduce odor generation during the land application of lime stabilized biosolids. The mixing quality of a treatment plant’s lime stabilized biosolids was improved by relocating the lime addition point, which prolonged the mixing time and produced a better mixed biosolids product. Based on field observations of land application, the poorly mixed biosolids were more odorous and offensive prior to incorporation. However, once incorporated into the soil, there was no appreciable odor difference between the biosolids. Another land application study was conducted to assess the odor of unincorporated Class A biosolids and compare it with incorporated Class A biosolids with the soil.     

Adsorption of basic dye from aqueous solution onto fly ash

The fly ash treated by H₂SO₄ was used as a low-cost adsorbent for the removal of a typical dye, methylene blue, from aqueous solution. An increase in the specific surface area and dye-adsorption capacity was observed after the acid treatment. The adsorption isotherm and kinetics of the treated fly ash were studied. The experimental results were fitted using Langmuir and Freundlich isotherms. It shows that the Freundlich isotherm is better in describing the adsorption process. Two kinetic models, pseudo-first order and pseudo-second order, were employed to analyze the kinetic data. It was found that the pseudo-second-order model is the better choice to describe the adsorption behavior. The thermodynamic study reveals that the enthalpy (ΔH⁰) value is positive (5.63 kJ/mol), suggesting an endothermic nature of the adsorption.