塔式起重机安全评判专家系统的研制

塔式起重机作为建筑施工的主要设备,在建筑等行业发挥着极其重要的作用,因而其安全问题受到各国有关部门的高度重视,但塔式起重机的事故率近年来仍未见下降,其安全问题仍然是建筑施工中的忧患之一。为此,笔者在建造了塔式起重机安全的依赖关系图的基础上,采用基于现代设计方法学的专家系统构造技术,使用ＶＩＳＵＡＬＣ＋ ＋ 开发了塔式起重机安全评判专家系统ＴＱＥＳ。该系统经全部测试通过,可对一般的塔式起重机进行安全评判     

Characterization and control of odorous gases at a landfill site: a case study in Hangzhou, China

Municipal solid waste (MSW) landfills are one of the major sources of offensive odors potentially creating annoyance in adjacent communities. At the end of May 2007, an odor pollution incident occurred at the Tianziling landfill site, Hangzhou, China, where the residents lodged complaints about the intense odor from the landfill, which drew a significant attention from the government. In this study, ambient air monitoring was conducted at the Tianziling landfill site. The main odor composition of the gas samples collected on June 1st 2007 and the reduction of various odorous gases from the samples collected on June 1st 2009 due to the applied odor control techniques were determined using gas chromatography-mass spectrometry (GC-MS). In addition, variations of primary odorous gaseous (NH₃ and H₂S) concentrations at different locations in the landfill site from July 2007 to June 2009 were also investigated by using classical spectrophotometric methods. Results showed that a total of 68 volatile compounds were identified among which H₂S (56.58-579.84 μg/m³) and NH₃ (520-4460 μg/m³) were the notable odor components contributing to 4.47-10.92% and 83.91-93.94% of total concentrations, respectively. Similar spatial and temporal shifts of H₂S and NH₃ concentrations were observed and were significantly affected by environmental factors including temperature, air pressure and wind direction. Odor pollution was worse when high temperature, high humidity, low air pressure, and southeast, northeast or east wind appeared. Moreover, the environmental sampling points of the dumping area and the leachate treatment plant were found to be the main odor sources at the Tianziling landfill site. The odor control technologies used in this project had a good mitigating effect on the primary odorous compounds. This study provides long-term valuable information concerning the characteristics and control of odors at landfill sites in a long run.     

Fixation and partitioning of heavy metals in slag after incineration of sewage sludge

Fixation of heavy metals in the slag produced during incineration of sewage sludge will reduce emission of the metals to the atmosphere and make the incineration process more environmentally friendly. The effects of incineration conditions (incineration temperature 500-1100°C, furnace residence time 0-60min, mass fraction of water in the sludge 0-75%) on the fixation rates and species partitioning of Cd, Pb, Cr, Cu, Zn, Mn and Ni in slag were investigated. When the incineration temperature was increased from 500 to 1100°C, the fixation rate of Cd decreased from 87% to 49%, while the fixation rates of Cu and Mn were stable. The maximum fixation rates for Pb and Zn and for Ni and Cr were reached at 900 and 1100°C, respectively. The fixation rates of Cu, Ni, Cd, Cr and Zn decreased as the residence time increased. With a 20min residence time, the fixation rates of Pb and Mn were low. The maximum fixation rates of Ni, Mn, Zn, Cu and Cr were achieved when the mass fraction of water in the sludge was 55%. The fixation rate of Cd decreased as the water mass fraction increased, while the fixation rate of Pb increased. Partitioning analysis of the metals contained in the slag showed that increasing the incineration temperature and residence time promoted complete oxidation of the metals. This reduced the non-residual fractions of the metals, which would lower the bioavailability of the metals. The mass fraction of water in the sludge had little effect on the partitioning of the metals. Correlation analysis indicated that the fixation rates of heavy metals in the sludge and the forms of heavy metals in the incinerator slag could be controlled by optimization of the incineration conditions. These results show how the bioavailability of the metals can be reduced for environmentally friendly disposal of the incinerator slag.     

酸洗废液制备高纯氧化铁红

以钢板酸洗废液为原料,采用铁粉预处理、除杂、合成、水洗、干燥、煅烧等工序制备高纯氧化铁红.最佳工艺条件为:预处理温度80℃,预处理时间3h,铁粉加入量为理论值的1.5倍;除杂温度65 ℃,聚丙烯酰胺加入量60 mg/L;米用将FeC12溶液和饱和NH4HCO3溶液同时滴加入反应器的方式进行沉淀反应;煅烧温度800℃.在此工艺条件下处理酸洗废液,可制得纯度为99.3％的高纯氧化铁红.     

石油污染土壤修复技术的进展

综述了石油污染土壤修复技术的发展现状及存在的瓶颈,分析了石油污染对油-水-土界面性质、土-水关系和土壤渗透性等水理性质的影响.对石油污染土壤再利用于工程建设进行了探讨,并总结了石油污染土壤主要的力学性质变化,为石油污染土壤修复技术的工程实践和机理研究提供参考.     

Glass–ceramic from mixtures of bottom ash and fly ash

Along with the gradually increasing yield of the residues, appropriate management and treatment of the residues have become an urgent environmental protection problem. This work investigated the preparation of a glass–ceramic from a mixture of bottom ash and fly ash by petrurgic method. The nucleation and crystallization kinetics of the new glass–ceramic can be obtained by melting the mixture of 80% bottom ash and 20% fly ash at 950 °C, which was then cooled in the furnace for 1 h. Major minerals forming in the glass–ceramics mainly are gehlenite (Ca₂Al₂SiO₇) & akermanite (Ca₂MgSiO₇) and wollastonite (CaSiO₃). In addition, regarding chemical/mechanical properties, the chemical resistance showing durability, and the leaching concentration of heavy metals confirmed the possibility of engineering and construction applications of the most superior glass–ceramic product. Finally, petrurgic method of a mixture of bottom ash and fly ash at 950 °C represents a simple, inexpensive, and energy saving method compared with the conventional heat treatment.     

Greenhouse gas emissions from MSW incineration in China: Impacts of waste characteristics and energy recovery

Determination of the amount of greenhouse gas (GHG) emitted during municipal solid waste incineration (MSWI) is complex because both contributions and savings of GHGs exist in the process. To identify the critical factors influencing GHG emissions from MSWI in China, a GHG accounting model was established and applied to six Chinese cities located in different regions. The results showed that MSWI in most of the cities was the source of GHGs, with emissions of 25–207 kg CO₂-eq t^?1 rw. Within all process stages, the emission of fossil CO₂ from the combustion of MSW was the main contributor (111–254 kg CO₂-eq t^?1 rw), while the substitution of electricity reduced the GHG emissions by 150–247 kg CO₂-eq t^?1 rw. By affecting the fossil carbon content and the lower heating value of the waste, the contents of plastic and food waste in the MSW were the critical factors influencing GHG emissions of MSWI. Decreasing food waste content in MSW by half will significantly reduce the GHG emissions from MSWI, and such a reduction will convert MSWI in Urumqi and Tianjin from GHG sources to GHG sinks. Comparison of the GHG emissions in the six Chinese cities with those in European countries revealed that higher energy recovery efficiency in Europe induced much greater reductions in GHG emissions. Recovering the excess heat after generation of electricity would be a good measure to convert MSWI in all the six cities evaluated herein into sinks of GHGs.     

干洗业四氯乙烯职业危害与环境对策

干洗业四氯乙烯溶剂及其处理的安全问题已被认为是干洗业持续发展的评判标准。干洗过程中的溶剂残渣对顾客和生态环境都造成影响。干洗业环境广问题不仅仅是传统的职业卫生问题,而且作为纺织品生命周期的一个有机构成引起环保工作者和绿色消费活动倡导者的关注。     

山铝热电分厂烟气脱硫可行性分析

阐明了烟气脱硫的重要性,对现有烟气脱硫工艺做了简介和比较,结合山西分公司热电分厂的烟尘排放情况及生产工艺、现场实际情况,进行了可行性分析,并提出推荐实施方案。