Characteristics and assessment of phthalate esters in urban dusts in Guangzhou city, China

Phthalate esters (PAEs) were examined in indoor and outdoor dust samples from the subtropical city of Guangzhou, China. The ∑(16)PAEs concentrations ranged from 121 to 3,223 μg g(-1) dust, with the median concentration of 840 μg g(-1) dust. Significantly higher concentrations of PAEs in dust samples were found in offices where electrical and electronic devices, carpet pads, and office furniture were widely used. Of the 16 PAEs, diisobutyl phthalate (DiBP), di-n-butyl phthalate (DnBP), and di(2-ethylhexyl) phthalate (DEHP) dominated the PAEs in indoor and outdoor dust samples, and accounted for >96.8% and >93.1% of the ∑(16)PAEs concentrations, respectively. The median daily inhalation exposure of ∑(16)PAEs were 3.53 and 0.247 μg kg(-1) body weight day(-1), and at the 95(th) percentile were 7.62 and 0.530 μg kg(-1) body weight day(-1), up on the measured concentrations and estimated dust ingestion rates, respectively, for toddles and adults. The ubiquitous distribution of PAEs as noted in this study suggests the need for detailed assessment of PAEs concentrations using more sites and to further investigate the factors influencing PAEs exposure in China.     

Composition and source apportionment of PAHs in sediments at river mouths and channel in Kaohsiung Harbor, Taiwan

Fifty-eight sediment samples were collected in 2009 from the bottom of river mouths near Kaohsiung Harbor (Taiwan) and the harbor channel for the analyses of polycyclic aromatic hydrocarbons (PAHs) using gas chromatography-mass spectrometry (GC-MS). Concentrations of total PAHs varied from 39 to 30,521 ng g(-1) (dry weight); samples collected from the mouths of Love River, Canon River, Jen-Gen River, and Salt River showed the highest PAHs concentrations. This indicates that the major sources of sediment PAHs come from those polluted urban rivers and the harbor channel. In samples collected from the Salt River mouth, approximately 43% of the PAHs are identified as PAHs with 2 or 3 rings. However, samples collected from other locations contain predominantly PAHs with 4 rings (32 to 42%) or 5 and 6 rings (36 to 44%). Emissions from traffic-related sources and waste incineration contribute to the majority of PAHs found in most channel and river mouth sediments. However, coal/oil combustion is the main cause of high concentrations of PAHs observed in the Salt River mouth sediments. Principal component analyses with multivariate linear regression (PCA/MLR) have been used to further quantify the source contributions, and the results show that the contributions of coal/oil combustion, traffic-related and waste incineration are 37%, 33% and 30%, respectively.     

Toxicity of propargylic alcohols on green alga--Pseudokirchneriella subcapitata

The present study evaluates the toxicity of 34 propargylic alcohols, including primary, primary homo-, secondary, and tertiary alcohols, based on their effects on phytoplankton. A closed-system algal toxicity test was applied because the closed-system technique presents more realistic concentration-response relationships for the above compounds than the conventional batch tests. The green alga, Pseudokirchneriella subcapitata, was the test organism and final yield and growth rate were chosen as the test endpoints. Among all the propargylic alcohols tested, 1-pentyn-3-ol is the most toxic compound with its EC50 equal to 0.50 mg L(-1), which can be classified as a "R50" compound (very toxic to aquatic organisms, EC50/LC50 < 1 mg L(-1)), following the current practice for classification of chemicals in the European Union (EU). There are several other compounds including 2-decyn-1-ol, 3-decyn-1-ol, 1-hexyn-3-ol, 3-butyn-2-ol, and 3-hexyne-2,5-diol, which deserve more attention for their possible adverse impact on the aquatic environment, because these alcohols can be classified as "R51" compounds (toxic to aquatic organisms, EC50/LC50 between 1 and 10 mg L(-1)). Compared to the base-line toxicity relationship (narcosis QSAR) derived previously, tertiary propargylic alcohols can be identified as nonpolar narcotic chemicals, while secondary alcohols and primary alcohols with low molecular weight generally exhibit obvious excess toxicity in relation to the base-line toxicity. Finally, quantitative structure-activity relationships were established for deriving a preliminary estimation of the toxicity of other propargylic alcohols.     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.     

Comparative assessments of VOC emission rates and associated health risks from wastewater treatment processes

With the growing concern regarding emission of volatile organic compounds (VOCs) from wastewater treatment plants (WWTPs), the relationship between the VOC emission rates and the associated public health risks has been rarely discussed. The objective of this study was to examine and compare the VOC emission rates and cancer and non-cancer risks by inhalation intake, using a municipal WWTP in China as an example, with respect to the effects of treatment technologies, VOC species, and seasonal variation. Given the treatment technology considered, the emission rates of VOCs in this study were estimated by means of mass balance or calculated on the molecular level. From the viewpoints of both emission rates and cancer and non-cancer risks, sedimentation was the treatment technology with the highest health risks to the workers. Slightly lower VOC emission rates and health risks than those for sedimentation were observed in anaerobic treatment. Although the aeration significantly enhanced the VOC emission rates in the aerobic treatment process, the associated health risks were limited due to the low VOC concentrations in the gas phase, which were likely attributed to the strong mixing and dilution with fresh air by aeration. Amongst the VOCs investigated, benzene was the VOC with both a relatively high emission rate and health risk, while trichloroethylene possessed a high emission rate but the lowest health risk. Without strong interfacial aeration and turbulence between the water and atmosphere, the effects of treatment technology and seasonal variation on the health risks might be connected to the VOC emission rates, while the effect of VOC species depended considerably on the respective cancer slope factors and reference concentrations; the employment of aeration provided a different conclusion in which the emission rates were enhanced without a significant increase in the related cancer risks. These findings can provide insight into future health risk management and reduction strategies for workers in WWTPs.     

Land desertification monitoring and assessment in Yulin of Northwest China using remote sensing and geographic information systems (GIS)

The objective of this study is to develop techniques for assessing and analysing land desertification in Yulin of Northwest China, as a typical monitoring region through the use of remotely sensed data and geographic information systems (GIS). The methodology included the use of Landsat TM data from 1987, 1996 and 2006, supplemented by aerial photos in 1960, topographic maps, field work and use of other existing data. From this, land cover, the Normalised Difference Vegetation Index (NDVI), farmland, woodland and grassland maps at 1:100,000 were prepared for land desertification monitoring in the area. In the study, all data was entered into a GIS using ILWIS software to perform land desertification monitoring. The results indicate that land desertification in the area has been developing rapidly during the past 40 years. Although land desertification has to some extent been controlled in the area by planting grasses and trees, the issue of land desertification is still serious. The study also demonstrates an example of why the integration of remote sensing with GIS is critical for the monitoring of environmental changes in arid and semi-arid regions, e.g. in land desertification monitoring in the Yulin pilot area. However, land desertification monitoring using remote sensing and GIS still needs to be continued and also refined for the purpose of long-term monitoring and the management of fragile ecosystems in the area.     

Dry deposition study by using dry deposition plate and water surface sampler in Shalu, central Taiwan

This study presents the chemical composition of dry deposition by using dry deposition plate and water surfaces sampler during daytime and nighttime sampling periods at a near highway traffic sampling site. In addition, the characterization for mass and water soluble species of total suspended particulate (TSP), PM2.5 and PM10 were also studied at this sampling site during August 22 to October 31 of 2006 around central Taiwan. The samples collected were analyzed by using Ion Chromatography (DIONEX 100) for the ionic species analysis. Results of the particulate dry deposition fluxes are higher in the water surfaces sampler than that of the dry deposition plate. In other words, the results also indicated that water surface can absorb more ambient dry deposition inorganic pollutants than that of dry deposition plate in this study. The results obtained in this study indicated that the ionic species of Cl(-), NO3(-) and SO4(2-) occupied about average 60-70% downward flux out of total ionic species for either dry deposition plate or water surfaces sampler during August to October of 2006 at this near highway traffic sampling site.     

Seasonal variations in microcystin concentrations in Lake Taihu, China

An enzyme-limited immunosorbent assay (ELISA) was used to monitor spatial and temporal variation of microcystins (MCs) in Lake Taihu. MC concentrations were higher in summer and autumn than in other seasons. Maximal MC concentration was 15.6 mug L(-1). Compared to central Lake Taihu and Wuli Bay, Meiliang Bay had higher MC concentrations due to high biomass of Microcystis.     

Determination of total petroleum hydrocarbons (TPH) in agricultural soils near a petrochemical complex in Guangzhou,China

The total petroleum hydrocarbons (TPH) pollution in regional agricultural soils was investigated. Seventy soil samples collected from surface layers (0–20 cm) and horizons of five selected pedons in the vicinity of a petrochemical complex in Guangzhou, China were analyzed, and the vertical variation and spatial variability of TPH were evaluated. The TPH concentration in top soils around the petrochemical complex ranged from 1,179.3 to 6,354.9 mg kg^− 1, with the average of 2,676.6 mg kg^− 1. Furthermore, significant differences between land-use types showed that the TPH concentration in top soils was strongly influenced by accidental spills. Both the TPH trends in pedons and the identified hot-spot areas also showed that the accidental explosions or burning accidents were mainly responsible for the pollution. The results reported here suggest that the regular monitoring and inspection shall be conducted for safety and to avoid or minimize the accidents, and the effective measures should be taken to remediate the contaminated areas and to assure that the important industrialization of Guangzhou area would not mean human health risks near the petrochemical complex.     

Even sampling designs generation by charges repulsion simulation

Evenly distributed sampling design is generally considered as an efficient sampling design. It is widely used in sampling for the environmental survey. In this paper, we present a novel method for generating N evenly distributed samples within a given irregular polygon via simulating the movements of some ideal homogeneous point charges. Initially, charges are randomly put into the sampling region; then, they are freed and held orderly; and after enough runs, the charges will finally reach a stable state with all of them having a zero resultant force and velocity; and so they distribute evenly within the region. Their layout can thus be considered as an evenly distributed sampling design. The main advantages of this method are: (1) it is easy to understand and implement; (2) it is efficient in both running and generating better designs. Analysis and experimental results indicate that this method is an efficient and robust method for generating even sampling designs for 2D polygonal sampling region.