Mass balance and characterization of bio-oil from sludge pyrolysis generated in the treatment of effluent from the biodiesel industry

Journal of Material Cycles and Waste Management - The present work produced bio-oil from the pyrolysis of sludge from the biodiesel processing industry in a fixed bed reactor, aiming at industrial...     

Can preferential credit programs speed up the adoption of low-carbon agricultural systems in Mato Grosso,Brazil? Results from bioeconomic microsimulation

The need to balance agricultural production and environmental protection shifted the focus of Brazilian land-use policy toward sustainable agriculture. In 2010, Brazil established preferential credit lines to finance investments into low-carbon integrated agricultural systems of crop, livestock and forestry. This article presents a simulation-based empirical assessment of integrated system adoption in the state of Mato Grosso, where highly mechanized soybean–cotton and soybean–maize double-crop systems currently prevail. We employ bioeconomic modeling to explicitly capture the heterogeneity of farm-level costs and benefits of adoption. By parameterizing and validating our simulations with both empirical and experimental data, we evaluate the effectiveness of the ABC Integration credit through indicators such as land-use change, adoption rates and budgetary costs of credit provision. Alternative scenarios reveal that specific credit conditions might speed up the diffusion of low-carbon agricultural systems in Mato Grosso.

     

Performance and stability of an anaerobic fixed bed reactor subjected to progressive increasing concentrations of influent organic matter and organic shock loads

Data on the performance of a horizontal-flow anaerobic immobilized biomass (HAIB) reactor subjected to step increases of organic loading rates (OLR) and to organic shock loads (OSL) are presented and discussed. The tubular reactor (100 cm long and 5 cm diameter) with a useful volume of 1995 mL was filled with polyurethane foam cubic matrices holding immobilized biomass and fed with synthetic wastewater. The reactor was operated at the controlled temperature of 30+/-1 degrees C and hydraulic retention time of 7 h. After about 15 days, the HAIB reactor attained operating stability. Thereafter, it was subjected to step increases of the applied OLR that ranged from 6.8 to 18.8 kg COD/m(3)d. After steady state had been achieved at each step, OSL corresponding to approximately three times the operating OLR were applied for 7 h. No disturbance was observed due to the step increase in OLR. An increase in effluent chemical oxygen demand (COD) and volatile fatty acids (VFA) concentrations and a decrease in the percentage of methane in the biogas were observed due to OSL applications. However, stability of the monitoring parameters was always restored approximately 17 h after the application of OSL for all conditions tested.     

Evaluation of hexavalent chromium removal in a continuous biological filter with the use of central composite design (CCD)

Hexavalent chromium is frequently found in industrial effluents as a result of the industrial applications of this compound and its anti-corrosive features. However, hexavalent chromium is extremely toxic, and its discharge in water is regulated, with a maximum limit of 0.1 mg/L in accordance with legislation established by CONAMA-Brazil (no. 397, April 3, 2008). To achieve lower discharge values, it is necessary to reduce from Cr(VI) to Cr(III), which is less toxic, and an economic alternative involves biological removal of this compound. Residence time distributions (RTDs) were measured to evaluate the behavior of actual biofilter operation conditions in a biofilter flow. The medium residence time distributions used were 8 and 24 h (recommended by the legislation). To optimize this process, a central composite design was used, considering the initial chromium concentration and pH as the independent variables and the removal of hexavalent chromium as the response. The boundary curves and surface response showed optimal behavior at 3.94 mg/L [Cr(0)] and a pH of 6.2. The removal process of hexavalent chromium is mathematically described by the Michaelis-Menten kinetic model. This model appropriately represents the variation of chromium concentration along the bioreactor.     

An abiotic typology and reference conditions for nutrients and chlorophyll-a in subtropical reservoirs (São Paulo State,Brazil)

Environmental Science and Pollution Research - The establishment of reference conditions and typology are two important steps in water resources management. The reference conditions enable the...     

Use of fluff in a coking coal blend in a pilot scale

Journal of Material Cycles and Waste Management - Fluff is a shredder waste made up mostly of polymeric material generated in semi-integrated steel manufacturing plants, which is usually disposed...     

Work-related deaths in Washington State, 1998-2002

INTRODUCTION: In Washington State, 87 workers are killed each year, on average, while in work status. To understand these incidents and to assist in focusing on and development of potential prevention measures, they must be well characterized. METHODS: Work-related fatalities between the years 1998 and 2002 are described by the demographics of the victims, types of incidents, the victims' occupations, and industries and location in which they worked. RESULTS: Motor vehicle- and machinery-related incidents accounted for nearly 33% and 14% of the incidents, respectively. Agriculture, forestry, fishing, hunting, and mining (n=87), and construction (n=83) had the most fatalities. Fatality rates per 100,000 workers for these industries were 25.7 and 8.7, respectively, compared to the state-wide average of 3.1 fatalities/100,000 workers. DISCUSSION: These data indicate numerous areas for prevention of work-related traumatic injuries and fatalities.     

Adsorption and desorption variability of four herbicides used in paddy rice production

This investigation was performed to determine the effect of physicochemical soil properties on penoxsulam, molinate, bentazon, and MCPA adsorption–desorption processes. Four soils from Melozal (35° 43′ S; 71° 41′ W), Parral (36° 08′ S; 71° 52′ W), San Carlos (36° 24′ S; 71° 57′ W), and Panimavida (35° 44′ S; 71° 24′ W) were utilized. Herbicide adsorption reached equilibrium after 4 h in all soils. The Freundlich L-type isotherm described the adsorption process, which showed a high affinity between herbicides and sorption sites mainly because of hydrophobic and H-bonds interaction. Penoxsulam showed the highest adsorption coefficients (4.23 ± 0.72 to 10.69 ± 1.58 mL g^?1) and were related to soil pH. Molinate showed K_d values between 1.72 ± 0.01 and 2.3 ± 0.01 mL g^?1and were related to soil pH and organic matter, specifically to the amount of humic substances. Bentazon had a high relationship with pH and humic substances and its K_d values were the lowest, ranging from 0.11 ± 0.01 to 0.42 ± 0.01 mL g^?1. MCPA K_d ranged from 0.14 ± 0.02 to 2.72 ± 0.01 mL g^?1, however its adsorption was related to humic acids and clay content. According to these results, the soil factors that could explain the sorption process of the studied herbicides under paddy rice soil conditions, were principally humic substances and soil pH. Considering the sorption variability observed in this study and the potential risk for groundwater contamination, it is necessary to develop weed rice management strategies that limit use of herbicides that exhibit low soil adsorption in areas with predisposing conditions to soil leaching.