Comparison of leaching tests to determine and quantify the release of inorganic contaminants in demolition waste

The changes in waste management policy caused by the massive generation of waste materials (e.g. construction and demolition waste material, municipal waste incineration products) has led to an increase in the reuse and recycling of waste materials. For environmental risk assessment, test procedures are necessary to examine waste materials before they can be reused. In this article, results of column and lysimeter leaching tests having been applied to inorganic compounds in a reference demolition waste material are presented. The results show a good agreement between the leaching behaviour determined with the lysimeter unit and the column units used in the laboratory. In view of less time and system requirements compared to lysimeter systems, laboratory column units can be considered as a practicable instrument to assess the time-dependent release of inorganic compounds under conditions similar to those encountered in a natural environment. The high concentrations of elements in the seepage water at the initial stage of elution are reflected by the laboratory column leaching tests. In particular, authorities or laboratories might benefit and have an easy-to-use, but nevertheless reliable, method to serve as a basis for decision-making.     

A comparison of two techniques for studying sediment desorption kinetics of hydrophobic pollutants

A comparison of two techniques (gaseous purge and vial desorption) for studying the kinetics of desorption of hydrophobic pollutants from natural sediments was conducted using identical, pre-equilibrated pollutant-sediment suspensions. Desorption profiles for the two techniques [for Lindane, Aldrin, 2,2'-dichlorobiphenyl (2,2'-DCB), 4,4'-dichlorobiphenyl (4,4'-DCB), and 2,2',6,6'-tetrachlorobiphenyl (TCB)] were then compared, based on the distribution of pollutant mass between the labile (fast) and non-labile (slow) desorption phases and the release rate constants for each phase of release. The vial desorption technique shows many practical advantages over the gaseous purge technique, including its more realistic mixing conditions, the use of an independent sample for each data point (as opposed to a calculation of a cumulative mass purged at each time point), the fact that the vials constitute a closed system and are therefore less subject to ambient contamination, and the relatively low demands of time and money for the vial technique. No consistent trends in labile rate constants or in pollutant distribution between the labile and non-labile phase were observed between the two techniques. A comparison of kinetic parameters shows much faster non-labile rate constants for the gaseous purge technique, attributed to the violent, continuous agitation employed, which likely disrupted sediment aggregates and oxidized the natural organic matter associated with the sediment. Non-labile rate constants have implications for the long-term fate of compounds adsorbed to repetitively disturbed sediments. This study suggests that the traditionally less popular vial desorption technique may yield more realistic non-labile desorption rate constants.     

Seasonal variations of hydrophobic organic contaminant concentrations in the water-column of the Seine Estuary and their transfer to a planktonic species Eurytemora affinis (Calanoïda, copepoda). Part 1: PCBs and PAHs

Hydrophobic organic contaminants (HOC) (i.e. PAHs and PCBs) were measured in the water column and in Eurytemora affinis samples from the Seine Estuary collected from November 2002 to February 2005. Results showed seasonal variations of both total PCB and PAH levels in the suspended particulate matter (SPM) and in the copepods with maximum levels during winter times. PAH and PCB concentrations in the SPM ranged from 499 to 5819ngg(-1) and from 58 to 463ngg(-1), respectively. Phenanthrene, pyrene and benzo[b+j+k]fluoranthene (B[b+j+k]F) were the predominant PAH compounds in the water column, while CB 101, 118, 153 and 138 were the most abundant PCB congeners. PCBs and PAHs bioaccumulated by E. affinis (EA) varied between 383 and 1785ngg(-1) and 165-3866ngg(-1). CB101, 153, 138 and B[b+j+k] were, respectively, the major compounds of PCB and PAH fingerprints in EA. Thereby, the copepods could reach high accumulation factor (ACF) (91000 for PCBs and 17000 for PAHs). The principal component analyses of contaminant concentrations and environmental parameter datasets distinguished two groups of copepods. The winter time cluster, with high percentage of adult copepods, which bioaccumulated the highest PCB and PAH body-burdens, and the second cluster with juveniles showing the lowest HOC concentrations. Thus, PAH and PCB concentrations in EA exhibited significant correlations with the percentage of adults making up the samples.     

Estrogenic activity removal of 17beta-estradiol by ozonation and identification of by-products

This work investigated the degradation of a natural estrogen (17beta-estradiol) and the removal of estrogenic activity by the ozonation process in three different pHs (3, 7 and 11). A recombinant yeast assay (YES assay) was employed to determine estrogenic activity of the ozonized samples and of the by-products formed during the ozonation. Ozonation was very efficient for the removal of 17beta-estradiol in aqueous solutions. High removals (>99%) were achieved with low ozone dosages in the three different pHs. Several by-products were formed during the ozonation of 17beta-estradiol. However, only a few compounds could be identified and confirmed. Different by-products are formed at different pHs, which is probably due to different chemical pathways and different oxidants (O(3) and OH radical). The by-products formed at pH 11 were 10epsilon-17beta-dihydroxy-1, 4-estradieno-3-one (DEO) and 2-hydroxyestradiol, which were not formed in pH 3. Only testosterone could be observed in pH 3, whereas at pH 7 all three by-products were found. At pH 7 and 11 the applied ozone dosages were not enough to remove all the estrogenicity from samples, even though the 17beta-estradiol residual concentration for these two pHs was lower than at pH 3. Higher estrogenicity was detected at pH 11. An explanation to this fact may be that oxidation via OH radical forms more by-products with estrogenic activity. Probably, the formation of 2-hydroxyestradiol at pHs 7 and 11 is contributing to the residual estrogenicity of samples ozonized at these pHs. In this work, complete removal of estrogenic activity was only obtained at pH 3.     

Desorption of arsenic from drinking water distribution system solids

Previous work has shown that arsenic can accumulate in drinking water distribution system (DWDS) solids (Lytle et~al., 2004) when arsenic is present in the water. The release of arsenic back into the water through particulate transport and/or chemical release (e.g. desorption, dissolution) could result in elevated arsenic levels at the consumers' tap. The primary objective of this work was to examine the impact of pH and orthophosphate on the chemical release (i.e. desorption) of arsenic from nine DWDS solids collected from utilities located in the Midwest. Arsenic release comparisons were based on the examination of arsenic and other water quality parameters in leach water after contact with the solids over the course of 168~hours. Results showed that arsenic was released from solids and suggested that arsenic release was a result of desorption rather than dissolution. Arsenic release generally increased with increasing initial arsenic concentration in the solid and increasing pH levels (in the test range of 7 to 9). Finally, orthophosphate (3 and 5 mg PO₄/L) increased arsenic release at all pH values examined. Based on the study results, utilities with measurable levels of arsenic present in their water should be aware that some water quality changes can cause arsenic release in the DWDS potentially resulting in elevated levels at the consumer's tap.     

Oxidation of trichloroethene over metal oxide catalysts: kinetic studies and correlation with adsorption properties

The performance of bulk chromium oxide is compared with that of a Mn commercial catalyst for the deep oxidation of trichloroethene (1000-2500ppmv, 55h(-1) space velocity) in air, in dry and wet (20000ppm of H(2)O) conditions, in terms of activity, selectivity and stability. Chromium oxide was found to be more active (on a catalyst weight basis), however its activity decreases continuously with time on stream. The presence of water increases its stability, the Mn catalyst showing the opposite behaviour. The effect of water on the Cr catalyst can be explained according to the Deacon equilibrium, as the presence of water tends to decrease the Cl(2) concentration, assumed to be responsible of the catalyst deactivation. Regarding to the selectivity, the Mn catalyst yields C(2)Cl(4), CCl(4) and CHCl(3) as organochlorinated by-products, whereas chromium oxide produces only trace amounts of CCl(4). Simple power-law kinetics expressions (first-order for Mn and zero-order for Cr) provide fairly good fits for the evolution of the conversion with the temperature. Furthermore, the kinetic behaviour of chromium oxide can be represented with a Langmuir-Hinshelwood model taking into account the chlorine inhibitory effect.     

The influence of radical architecture on cadmium bioaccumulation in the black mangrove, Avicennia germinans L

Two groups of Avicennia germinans plants with differences in the radical architecture were exposed under hydroponic conditions to 95ppm of cadmium (Cd) for a period of 24h. Later, Cd concentration in roots, stems and leaves was determined by graphite furnace atomic absorption spectrophotometry. Our results showed that, for both groups of plants, the roots accumulated higher concentration of Cd as compared to stems and leaves, though, the plants of group B displayed enhanced radical architecture, better growth performance, and lower Cd concentration as compared to plants of group A. In contrast, low values of leaves/roots Cd transportation index, and bioaccumulation factor were found in plants of group B. These results suggest that the higher radical architecture developed in plants of group B might better adjust the uptake of Cd as a result of an integrated network of multiple response processes for instances, production of organic acids, antioxidative replay, cell-wall lignification and/or suberization. Further studies will be focused in understanding the role of the radical system in mangrove plants with the rhizosphere activation and root adsorption to soil Cd under natural conditions.     

Algal-bacterial interactions in metal contaminated floodplain sediments

The aim of the present study was to investigate algal-bacterial interactions in a gradient of metal contaminated natural sediments. By means of multivariate techniques, we related the genetic structure (denaturing gradient gel electrophoresis, DGGE) and the physiological structure (community-level physiological profiling, CLPP) of the bacterial communities to the species composition of the algal communities and to the abiotic environmental variables, including metal contamination. The results revealed that genetic and physiological structure of the bacterial communities correlated with the species composition of the algal community, but hardly to the level of metal pollution. This must be interpreted as an indication for a strong and species-specific linkage of algal and bacterial species in floodplain sediments. Metals were, however, not proven to affect either the algal or the bacterial communities of the Dutch river floodplains.     

Zinc and cadmium accumulation and tolerance in populations of Sedum alfredii

To investigate the variation of Zn and Cd accumulation and tolerance of Sedum alfredii (a newly reported Zn/Cd hyperaccumulator), field surveys and hydroponic experiments were conducted among three populations of this species: two originating from old Pb/Zn mines in Zhejiang (ZJ) and Hunan (HN) Provinces and one from a "clean" site in Guangdong (GD) Province, China. Under field conditions, up to 12,524 and 12,253 mg kg(-1) Zn, and 1400 and 97 mg kg(-1) Cd in shoots of ZJ and HN plants were recorded respectively. Under hydroponic conditions, ZJ and HN plants accumulated significantly higher Zn and Cd in their leaves and stems, and possessed significantly higher Zn and Cd tolerance than GD plants. Among the two contaminated populations, ZJ plants showed higher Cd tolerance and accumulation (in leaves) than HN plants. The present results indicate that significant differences in Zn and Cd accumulation and tolerance exist in populations of S. alfredii.     

Copper, zinc and cadmium in marine cage fish farm sediments: an extensive survey

The diet of cage-farmed Atlantic salmon contains a range of trace metals, some of which have toxic properties, e.g. zinc, copper and cadmium. A survey of metal concentrations (ICP-MS analysis) in surface sediments of ca. 70 stations was carried out in both May and December 2000 around a Scottish fish farm. Additionally, at 13 stations on 2 orthogonal transects centered on the farm, sediments were analysed at 1cm intervals to 8 cm depth. Maximum concentrations in surface sediments were 921, 805 and 3.5 microg g(-1) for Zn, Cu and Cd, respectively, and were found at stations near the fish farm. The calculated losses from the farm (feed input minus fish output) were 87.0%, 4.3% and 14.0% of the background-corrected inventories for Zn, Cu and Cd, respectively, indicating that for Cu and Cd at least, the feed is not the only source.