The modelling of a hybrid combined cycle with pressurised fluidised bed combustion and CO2 capture

This study investigates the possibility of capturing CO₂ from flue gas under pressurised conditions, which could prove to be beneficial in comparison to working under atmospheric conditions. Simulations of two hybrid combined cycles with pressurised fluidised bed combustion and CO₂ capture are presented. CO₂ is captured from pressurised flue gas by means of chemical absorption after the boiler but before expansion. The results show a CO₂ capture penalty of approximately 8 percentage points (including 90% CO₂ capture rate and compression to 110 bar), which makes the efficiency for the best performing cycle 43.9%. It is 5.2 percentage points higher than the most probable alternative, i.e. using a natural gas fired combined cycle and a pulverised coal fired condensing plant separately with the same fuel split ratio. The largest part of the penalty is associated with the lower mass flow of flue gas after CO₂ capture, which leads to a decrease in work output in the expander and potential for feed water heating. The penalty caused by the regeneration of absorbent is quite low, since the high pressure permits the use of potassium carbonate, which requires less regeneration heat than for example the more commonly proposed monoethanolamine. Although the efficiencies of the cycles look promising it will be important to perform a cost estimate to be able to make a fair comparison with other systems. Such a cost estimate has not been done in this study. A significant drawback of these hybrid cycles in that respect is the complex nature of the systems that will have a negative effect on the economy.     

Leachate recirculation effects on waste degradation: study on columns

The purpose of this study is to determine the impact of leachate recirculation on the degradation of municipal solid wastes (bioreactor concept). The study was carried out using columns containing approximately 50 kg of waste, in order to follow waste degradation over a limited time. Three types of waste were studied: fresh waste of standard composition, fresh waste of fermentable composition and some 8-yr-old waste extracted from a site in France. Measurement of the global parameters, such as chemical oxygen demand (COD), volatile acidity, alkalinity, leachate conductivity, methane potential of the wastes and biogas production monitoring (volume of CO2 and CH4 produced), were carried out. The quantity of oxydizable matter and biogas production was increased by the leachate recirculation, and the duration of the first degradation phases was reduced in all cases. Chloride, ammonium and organic pollution accumulation was observed according to the duration of recirculation. After 400 days of degradation, waste stabilization seemed to be reached for all of the recirculated columns (COD<300 mg/L O2, and methane potential reached).     

Diel cycles of arsenic speciation due to photooxidation in acid mine drainage from the Iberian Pyrite Belt (Sw Spain)

Twenty four hours diel cycles of arsenic speciation in Acid Mine Drainage (AMD) due to photooxidation have been reported for the first time. AMD samples were taken during 48 h (31st March and 1st April, 2005) at 6 h intervals from the effluent of a massive abandoned polymetallic sulphide mine of the Iberian Pyrite Belt (Sw Spain). Samples were preserved in situ using cationic exchange prior to analysis by coupled high performance liquid chromatography, hydride generation and atomic fluorescence spectrometry (HPLC-HG-AFS) for arsenic speciation. The results indicated the presence of inorganic arsenic species with daily means of 262mugl(-1) for As(V) and 107 microg l(-1) for As(III). No marked diel trend was observed for As(V). However, a marked diel trend was observed for As(III) in the two studied days, with maximum concentrations during nighttime (141-143 microg l(-1)) and minimum concentrations at daytime (72-77 microg l(-1)). This difference in concentration during daytime and nighttime is ca. 100%. A similar diel cycle was observed for iron. An explanation for the arsenic diel cycles observed is the light induced photooxidation of As(III) and the elimination of As(V) due to its adsorption onto Fe precipitates during the daytime. Furthermore, the diel changes in arsenic speciation emphasize the importance of designing suitable sampling strategies in AMD systems.     

Chloramphenicol influence on antioxidant enzymes with preliminary approach on microsomal CYP1A immunopositive-protein in Chamelea gallina

Chloramphenicol (CA) is a largely used antibiotic and it is an inhibitor of protein synthesis that also induces ROS production. In this work there were investigated activities and expressions in the Adriatic bivalve Chamelea gallina of some antioxidant and detoxification proteins like superoxide dismutase (Mn-SOD, Cu/Zn-SOD), catalase (CAT) and Cytochrome P450 (CYP1A). Clams exposed to 5mgl(-1) of chloramphenicol were sampled 2, 4 and 8 days after treatment (CA2, CA4 and CA8). SODs, CAT, and CYP1A activity and/or expression were detected in pooled digestive glands by Western blotting and by spectrophotometrical analysis. Enzymes activities increase during the entire antibiotic exposure. With respect to the control Cu/Zn-SOD expression increases, while Mn-SOD expression decreases significantly after 4 days. Two CYP1A immunopositive-proteins (57.7 and 59.8kDa) were detected. The lower band significantly decreases in CA8, the upper one also in CA4 condition. High levels of Mn-SOD, CAT activity and Cu/Zn-SOD expression, indicate intense ROS production while Mn-SOD expression inhibition might be ascribable to mitochondrial alterations due to CA and indirectly to ROS. CYP1A1 action determines H(2)O(2) production that would contribute to a CYP1A1 gene promoter down regulation, a response to oxidative stress with the antioxidant enzymes activation as a final result. This study highlights the close association, in C. gallina, in presence of chloramphenicol, between SOD/CAT and CYP system, and it appear particularly interesting to the lack of similar researches on mollusc species.     

Modular Design of Field Lysimeters for Specific Application Needs

In Europe, the use of direct methods using lysimeters for measuring water and solute flow in soils increased in recent years. Large weighable lysimeters are best suitable for obtaining reliable data about seepage water quantity and quality. Field lysimeters – lysimeters built in directly in agriculturally used areas – of high technical standard allow a precise determination of the influence of different cropping systems on groundwater quality. They combine the advantages of true field conditions and laboratory possibilities of varying parameters, handling and maintenance. Due to the specific needs of each application the instrumentation varies. Based on general remarks on the advantages of precise weighing lysimeters four standardized lysimeter configurations are presented. Beside the specific needs of design and setup of lysimeter stations, there is need to define general requirements to enable comparable results based on standardized basic design and to reduce individual mistakes.     

Three-Dimensional Modelling of Concentration Fluctuations in Complicated Geometry

The strong fluctuating component in the measured concentration time series of a dispersing gaseous pollutant in the atmospheric boundary layer, and the hazard level associated to short-term concentration levels, demonstrate the necessity of calculating the magnitude of turbulent fluctuations of concentration using computational simulation models. Moreover the computation of concentration fluctuations in cases of dispersion in realistic situations, such as built-up areas or street canyons, is of special practical interest for hazard assessment purposes. In this paper, the formulation and evaluation of a model for concentration fluctuations, based on a transport equation, are presented. The model is applicable in cases of complex geometry. It is included in the framework of a computational code, developed for simulating the dispersion of buoyant pollutants over complex geometries. The experimental data used for the model evaluation concerned the dispersion of a passive gas in a street canyon between 4 identical rectangular buildings performed in a wind tunnel. The experimental concentration fluctuations data have been derived from measured high frequency concentrations. The concentration fluctuations model is evaluated by comparing the model's predictions with the observations in the form of scatter plots, quantile-quantile plots, contour plots and statistical indices as the fractional bias, the geometrical mean variance and the factor-of-two percentage. From the above comparisons it is concluded that the overall model performance in the present complex geometry case is satisfactory. The discrepancies between model predictions and observations are attributed to inaccuracies in prescribing the actual wind tunnel boundary conditions to the computational code.     

Identifying the largest individual sample value from a two-way composite sampling design

Composite sampling techniques for identifying the largest individual sample value seem to be cost effective when the composite samples are internally homogeneous. However, since it is not always possible to form homogeneous composite samples, these methods can lead to higher costs than expected. In this paper we propose a two-way composite sampling design as a way to improve on the cost effectiveness of the methods available to identify the largest individual sample value.     

Phylogenetic relationships within the Octocorallia (Cnidaria: Anthozoa) based on nuclear 18S rRNA sequences

We determined the nuclear 18S rRNA sequences for 41 species of octocorals and used these to address the validity of the historical ordinal divisions and the current subordinal divisions within the subclass Octocorallia. We also explored the phylogenetic affinities of the species Dendrobrachia paucispina, which was originally classified in the order Antipatharia (subclass Ceriantipatharia) although polyp structure indicates it belongs in the subclass Octocorallia. Trees constructed using maximum likelihood techniques are incongruent with the current and historical taxonomy of the Octocorallia. There appeared to be three major clades of octocorals. The first clade included most, but not all, pennatulaceans as a monophyletic group. The second clade contained 21 species, representing all major octocoral groups other than pennatulaceans. The third clade contained members from three suborders of the Alcyonacea and one member of the Pennatulacea. These data could not be used to distinguish the branching order of the three major clades. The species D. paucispina had a close affinity with the genera Corallium and Paragorgia (Alcyonacea: Scleraxonia), although its morphology suggests it is more similar to the genus Chrysogorgia (Alcyonacea: Calcaxonia). The morphological character of dimorphism (the presence of both autozooids and siphonozooids within a single colony) corresponded loosely with the topology of the most likely trees, and a single origin of dimorphism could not be rejected. Despite sampling from the majority of families within the Octocorallia, many of the relationships within this group remain ambiguous. Received: 16 June 2000 / Accepted: 14 September 2000     

A Systematic Test of an Enterprise Strategy for Community-Based Biodiversity Conservation

Abstract: A commonly held belief is that if people can benefit financially from enterprises that depend on nearby forests, reefs, and other natural habitats, then they will take action to conserve and sustainably use them. The Biodiversity Conservation Network brought together conservation and development organizations and local communities to systematically test this hypothesis across 39 conservation project sites in Asia and the Pacific. Each project implemented one or more community-based enterprises such as setting up an ecotourism lodge, distilling essential oils from wild plant roots, producing jams and jellies from forest fruits, harvesting timber, or collecting marine samples to test for pharmaceutical compounds. Each project team collected the biological, enterprise, and social data necessary to test the network's hypothesis. We present the results of this test. We found that a community-based enterprise strategy can lead to conservation, but only under limited conditions and never on its own. We summarize the specific conditions under which an enterprise strategy will and will not work in a decision chart that can be used by project managers to determine whether this strategy might make sense at their site. We also found that an enterprise strategy can be subsidized and still create a net gain that pays for conservation. Based on our experiences, we recommend developing "learning portfolios" that combine action and research to test other conservation strategies.