The influence of temperature on the deactivation of commercial Pd/Rh automotive catalysts

Automotive catalyst deactivation can be promoted by thermal and poisoning mechanisms. Catalyst efficiency is reduced by thermal degradation resulting in the agglomeration of precious metals and the reduction of the washcoat surface area. In this paper, the temperature influence on the commercial Pd/Rh-based automotive catalyst performance was studied. Textural and physicochemical characterisation techniques were employed, such as X-ray fluorescence (XRF), atomic absorption spectrometry (AAS), N₂ physisorption, X-ray diffraction (XRD), temperature programmed reduction (TPR) and scanning electron microscopy coupled with energy-dispersive X-ray analysis (SEM–EDX). The catalysts were evaluated for CO and propane oxidation with a stoichiometric gas mixture similar to engine exhaust gas. The results indicated the transformation of alumina into high temperature phases and the formation of new mixed oxide phases. Evidence of sintered particles and several spots of palladium agglomerates was seen by SEM–EDX analysis. The activity results showed the effects of thermal deactivation on the conversion of the pollutants. In spite of exposure to extreme temperature conditions (72 h at 1200 °C), significant activity was still observed for carbon monoxide and propane oxidation reactions.     

Medical radioisotopes in the environment – following the pathway from patient to river sediment

Motivated by the detection of ¹³¹I in river sediment in routine long-term surveillance samples, a systematic short-term study of the wastewater treatment chain was planned and conducted. Inflow, effluent and primary sludge were collected on a daily basis during two weeks at a regional wastewater treatment plant. Samples were investigated by gamma spectroscopy. Four medically used isotopes could be identified (¹³¹I and ^99mTc regularly, ¹⁵³Sm and ¹²³I sporadically). The concentration levels coincide well with literature data for ¹³¹I, and with our own long-term data for ¹³¹I and ^99mTc for the same plant. Cosmogenic ⁷Be activity in primary sludge correlated well with rainfall intensity. Surface sediment was sampled at low tide at both shores of the river, up- and downstream of the plant. ¹³¹I was identified in all samples, with a sharp maximum (about 100 Bq kg⁻¹ d.m.) at the discharge point of the plant and lower levels elsewhere, decreasing monotonically in downstream direction. ⁷Be and ¹³⁷Cs showed the same behaviour, but no peak at the discharge point. Predictions from simple equilibrium models for the transport and sedimentation of ¹³¹I show good agreement with the experimental data and suggest that the wastewater treatment plant is the main source for this isotope.     

Aryl hydrocarbon receptor-mediated activity of atmospheric particulate matter from an urban and a rural site in Switzerland

Atmospheric particulate matter (PM) is an air-suspended mixture of solid and liquid particles that vary in size, shape, and chemical composition. Long-term exposure to elevated concentrations of fine atmospheric particles is considered to pose a health threat to humans and animals. In this context, it has been hypothesized that toxic chemicals such as polycyclic aromatic hydrocarbons (PAHs) play an important role. Some PAHs are known to be carcinogenic and it has been shown that carcinogenic effects of PAHs are mediated by the aryl hydrocarbon receptor (AhR). In this study, PM1 was collected at a rural and an urban traffic site during an intense winter smog period, in which concentration of PM1 often exceeded 50 μg m^?3. We applied an in vitro reporter gene assay (DR-CALUX) to detect and quantify PM1-associated chemicals that induce AhR-mediated gene expression. This activity was expressed as CALUX equivalents of 2,3,7,8-tetrachlorodibenzodioxin (PM-TCDD-CEQs). In addition, concentrations of PAHs in the PM1 extracts were determined using gas chromatography/high-resolution mass spectrometry. Concentrations of PM-TCDD-CEQs ranged from 10 to 85 pg m^?3 and from 19 to 87 pg m^?3 at the urban and rural site, respectively. By the use of known relative potency factors, the measured concentration of a PAH was converted into a PAH-TCDD-CEQ concentration. ΣPAH-TCDD-CEQ and PM-TCDD-CEQ were highly correlated at both sites (r² = 0.90 and 0.69). The calculated ΣPAH-TCDD-CEQs explain between 2% and 20% of the measured PM-TCDD-CEQs. Benzo[k]fluoranthene was the most important PAH causing approximately 60% of the total ΣPAH-TCDD-CEQ activity. In contrast to NO, CO, PM10, and PM1, the concentration of PM-TCDD-CEQs showed no significant difference between the two sites. No indications were found that road traffic emissions caused elevated concentrations of PM-TCDD-CEQs at the urban traffic site.     

From waste to value-added products: A review of opportunities for fish waste valorization

The fishing industry is responsible for generating large amounts of organic waste rich in compounds of commercial interest. This review aimed to present the state of the art about the possibilities of using solid waste to obtain value-added products. Skins, fins, and scales have been used to obtain gelatin and collagen, a promising compound for use as an additive in yogurts and creams, as well as for the synthesis of biodegradable packaging that, if applicable, can reduce the environmental impact caused by petroleum packaging. Other parts, such as the head and the viscera, contain polyunsaturated fatty acids and other fat-soluble vitamins that have been studied for the production of omega-3 capsules for the pharmaceutical industry, but when the extracted oil does not fit the feeding parameters, it can be applied for the production of biodiesel. Furthermore, fishes are a promising source of astaxanthin, a carotenoid with high antioxidant properties. The use of combined techniques such as chemical and enzymatic methods can increase the extraction yield and favor the obtaining of more purified compounds, in addition to promoting the reduction of chemicals that are aggressive to the environment. In general, conscious production in the fishing industry through the valorization of waste generated for use as inputs for other value chains encompasses aspects of the circular economy, which can positively impact several Sustainable Development Goals.     

Human influence over 150 years of coastal evolution in the Volturno delta system (southern Italy)

This paper focused on the past shoreline change rates along the coastal plain of the Volturno River, in southern Italy, western Mediterranean. A wide database comprising historical maps, aerial photographs, topographic sheets, bathymetric data was used to extract the spatial and temporal information of the coastlines at seven time points. Coastline displacement was calculated for two successive time points and relative surface variation (accretion and erosion) was estimated as well as minimum and maximum accretion/erosion linear values and rates. The surface variation analysis has revealed that the studied coast can be considered homogeneous since the 1970s, whereas it exhibits a variety of shoreline evolutionary trends after that time period. Timing and causes of trends and rates of variation were detected. Based on the estimated shoreline change rates, an appropriate morhodynamic one-line model was applied to predict evolutionary scenarios also in presence of port and defence works. The results obtained strongly emphasize that a successful coastal management requires a constant monitoring of the human-induced changes to account for the variability of rates over time.     

Bioassays for the evaluation of reclaimed opencast coal mining areas

Environmental Science and Pollution Research - This study aimed to use bioassays (single and multispecies) with organisms from different trophic levels to assess soil quality in reclaimed coal...     

Effects of reduced water quality on coral reefs in and out of no‐take marine reserves

Near‐shore marine environments are increasingly subjected to reduced water quality, and their ability to withstand it is critical to their persistence. The potential role marine reserves may play in mitigating the effects of reduced water quality has received little attention. We investigated the spatial and temporal variability in live coral and macro‐algal cover and water quality during moderate and major flooding events of the Fitzroy River within the Keppel Bay region of the Great Barrier Reef Marine Park from 2007 to 2013. We used 7 years of remote sensing data on water quality and data from long‐term monitoring of coral reefs to quantify exposure of coral reefs to flood plumes. We used a distance linear model to partition the contribution of abiotic and biotic factors, including zoning, as drivers of the observed changes in coral and macro‐algae cover. Moderate flood plumes from 2007 to 2009 did not affect coral cover on reefs in the Keppel Islands, suggesting the reef has intrinsic resistance against short‐term exposure to reduced water quality. However, from 2009 to 2013, live coral cover declined by ～50% following several weeks of exposure to turbid, low salinity water from major flood plume events in 2011 and subsequent moderate events in 2012 and 2013. Although the flooding events in 2012 and 2013 were smaller than the flooding events between 2007 to 2009, the ability of the reefs to withstand these moderate floods was lost, as evidenced by a ～20% decline in coral cover between 2011 to 2013. Although zoning (no‐take reserve or fished) was identified a significant driver of coral cover, we recorded consistently lower coral cover on reserve reefs than on fished reefs throughout the study period and significantly lower cover in 2011. Our findings suggest that even reefs with an inherent resistance to reduced water quality are not able to withstand repeated disturbance events. The limitations of reserves in mitigating the effects of reduced water quality on near‐shore coral reefs underscores the importance of integrated management approaches that combine effective land‐based management with networks of no‐take reserves.     

Assessment of potentially harmful elements pollution in the Calore River basin (Southern Italy)

The geographical distribution of concentration values for harmful elements was determined in the Campania region, Italy. The study area consists of the drainage basin of the River Calore, a tributary of the river Volturno, the largest Southern Italian river. The results provide reliable analytical data allowing a quantitative assessment of the trace element pollution threat to the ecosystem and human health. Altogether 562 stream sediment samples were collected at a sampling density of 1 site per 5 km². All samples were air-dried, sieved to <100 mesh fraction and analyzed for 37 elements after an aqua regia extraction by a combination of ICP-AES and ICP-MS. In addition to elemental analysis, gamma-ray spectrometry data were collected (a total of 562 measurements) using a hand-held Scintrex GRS-500 spectrometer. Statistical analyses were performed to show the single-element distribution and the distribution of elemental association factor scores resulting from R-mode factor analyses. Maps showing element distributions were made using GeoDAS and ArcGIS software. Our study showed that, despite evidence from concentrations of many elements for enrichment over natural background values, the spatial distribution of major and trace elements in Calore River basin is determined mostly by geogenic factors. The southwestern area of the basin highlighted an enrichment of many elements potentially harmful for human health and other living organisms (Al, Fe, K, Na, As, Cd, La, Pb, Th, Tl, U); however, these anomalies are due to the presence of pyroclastic and alkaline volcanic lithologies. Even where sedimentary lithologies occur, many harmful elements (Co, Cr, Mn, Ni) showed high concentration levels due to natural origins. Conversely, a strong heavy metal contamination (Pb, Zn, Cu, Sb, Ag, Au, Hg), due to an anthropogenic contribution, is highlighted in many areas characterized by the presence of road junctions, urban settlements and industrial areas. The enrichment factor of these elements is 3–4 times higher than the background values. The southwestern area of the basin is characterized by a moderate/high degree of contamination, just where the two busiest roads of the area run and the highest concentration of industries occurs.