Observations of mercury wet deposition in Mexico

We provide a longer-term record of Hg wet deposition at two tropical latitude monitoring sites in Mexico, selected to provide regionally representative data. Weekly wet deposition samples were collected over 2 years, from September 2003 to November 2005. Based on this data set, we discuss the magnitude and seasonal variation of Hg in wet deposition and compare the results to other measurement sites and to several model estimates. With precipitation-weighted mean (PWM) concentrations of 8.2 and 7.9 ng L^?1, respectively, during the sampling period from Sep 30 2003 to Oct 11 2005, and median weekly concentrations of 9.4?±?1 ng L^?1 for both sites, the wet Hg concentrations and deposition at HD01 were much lower than those observed at the US Gulf Coast MDN sites while the wet Hg deposition at OA02 was much lower than most MDN sites, but somewhat similar to US MDN sites along the Pacific Coast. Based on the limited available data, we conclude that the approximately 30 % higher average precipitation at HD01 and roughly equal PWM concentrations lead to the higher deposition at HD01 versus OA02. We believe that these observations may offer scientists and modelers additional understanding of the depositional fluxes in the lower latitudes of North America.     

Hepatic monooxygenase (CYP1A and CYP3A) and UDPGT enzymatic activities as biomarkers for long-term carbofuran exposure in tench (Tinca tinca L)

The effect of a long-term exposure of tenchs to different concentrations (10 and 100 micro g/L) of the pesticide carbofuran has been evaluated. Microsomal hepatic cytochrome P450 subfamily 1A (CYP1A) and 3A (CYP3A) activities, as well as the phase II enzyme uridine diphospho-glucuronosyltransferase (UDPGT) activity were evaluated as adequate biomarkers of fish exposure to environmentally relevant concentrations of the pesticide carbofuran in freshwater ecosystems. A clear time-dependent inhibition of both CYP1A and UDPGT activities was observed in fish exposed to the highest dose of carbofuran with respect to controls, whereas in the case of CYP3A activity, values of exposed animals did not show a clear pattern of alteration during the experiment. The results of the present study demonstrated that hepatic CYP1A and UDPGT activities from tench could be considered as sensitive biomarkers for carbamate pesticides in polluted water, thus allowing future and ecologically relevant biomonitoring studies with this species.     

A preliminary in vitro assessment of GroBiotic-A, brewer's yeast and fructooligosaccharide as prebiotics for the red drum Sciaenops ocellatus

This study examined the effects of brewers yeast, fructooligosaccharide (FOS), and GroBiotic-A, a mixture of partially autolyzed brewers yeast, dairy components and dried fermentation products, on the intestinal microbial community of red drum, Sciaenops ocellatus. Gastrointestinal (GI) tracts were aseptically removed from three sub-adult red drum previously maintained on a commercial diet and placed in an anaerobic chamber. Intestinal contents were removed, diluted and incubated in vitro in one of four liquid media: normal diet alone, diet + 2% (w/w) GroBiotic-A, diet + 2% brewers yeast, and diet + 2% FOS. After 24 and 48 h of incubation at 25 degrees C, supernatants were removed for volatile fatty acid (VFA) analysis and DNA was extracted for denaturing gradient gel electrophoresis (DGGE) analysis. Polymerase chain reaction (PCR) was performed on a highly conserved region of M 16S rDNA and the amplicons were subjected to DGGE. The microbial community (MC) fingerprint was used to distinguish microbial populations. The intestinal contents incubated with GroBiotic-A had significantly (P<0.05) higher acetate and total VFA concentrations at 48 h compared to the other treatments. DGGE analysis demonstrated that the microbial community was significantly altered by Grobiotic-A and brewers yeast.     

Trends in snowpack chemistry and comparison to National Atmospheric Deposition Program results for the Rocky Mountains, US, 1993–2004

Seasonal snowpack chemistry data from the Rocky Mountain region of the US was examined to identify long-term trends in concentration and chemical deposition in snow and in snow-water equivalent. For the period 1993–2004, comparisons of trends were made between 54 Rocky Mountain Snowpack sites and 16 National Atmospheric Deposition Program wetfall sites located nearby in the region. The region was divided into three subregions: Northern, Central, and Southern. A non-parametric correlation method known as the Regional Kendall Test was used. This technique collectively computed the slope, direction, and probability of trend for several sites at once in each of the Northern, Central, and Southern Rockies subregions. Seasonal Kendall tests were used to evaluate trends at individual sites.Significant trends occurred during the period in wetfall and snowpack concentrations and deposition, and in precipitation. For the comparison, trends in concentrations of ammonium, nitrate, and sulfate for the two networks were in fair agreement. In several cases, increases in ammonium and nitrate concentrations, and decreases in sulfate concentrations for both wetfall and snowpack were consistent in the three subregions. However, deposition patterns between wetfall and snowpack more often were opposite, particularly for ammonium and nitrate. Decreases in ammonium and nitrate deposition in wetfall in the central and southern rockies subregions mostly were moderately significant (p<0.11) in constrast to highly significant increases in snowpack (p<0.02). These opposite trends likely are explained by different rates of declining precipitation during the recent drought (1999–2004) and increasing concentration. Furthermore, dry deposition was an important factor in total deposition of nitrogen in the region. Sulfate deposition decreased with moderate to high significance in all three subregions in both wetfall and snowpack. Precipitation trends consistently were downward and significant for wetfall, snowpack, and snow-telemetry data for the central and southern rockies subregions (p<0.03), while no trends were noted for the Northern Rockies subregion.     

Field and laboratory simulations of storm water pulses: behavioural avoidance by marine epifauna

Epifaunal communities associated with macroalgae were exposed to storm water pulses using a custom made irrigation system. Treatments included Millipore freshwater, freshwater spiked with trace metals and seawater controls to allow for the relative importance of freshwater inundation, trace metals and increased flow to be determined. Experimental pulses created conditions similar to those that occur following real storm water events. Brief storm water pulses reduced the abundance of amphipods and gastropods. Freshwater was the causative agent as there were no additional effects of trace metals on the assemblages. Laboratory assays indicated that neither direct nor latent mortality was likely following experimental pulses and that epifauna readily avoid storm water. Indirect effects upon epifauna through salinity-induced changes to algal habitats were not found in field recolonisation experiments. Results demonstrate the importance of examining the effects of pulsed contaminants under realistic exposure conditions and the need to consider ecologically relevant endpoints.     

In field arsenic removal from natural water by zero-valent iron assisted by solar radiation

An in situ arsenic removal method applicable to highly contaminated water is presented. The method is based in the use of steel wool, lemon juice and solar radiation. The method was evaluated using water from the Camarones River, Atacama Desert in northern Chile, in which the arsenic concentration ranges between 1000 and 1300 μg L⁻¹. Response surface method analysis was used to optimize the amount of zero-valent iron (steel wool) and the citrate concentration (lemon juice) to be used. The optimal conditions when using solar radiation to remove arsenic from natural water from the Camarones river are: 1.3 g L⁻¹ of steel wool and one drop (ca. 0.04 mL) of lemon juice. Under these conditions, removal percentages are higher than 99.5% and the final arsenic concentration is below 10 μg L⁻¹. This highly effective arsenic removal method is easy to use and inexpensive to implement.     

Design approaches for a cycling adsorbent/photocatalyst system for indoor air purification: formaldehyde example

A kinetic model for a cycling adsorbent/photocatalyst combination for formaldehyde removal in indoor air (Chin et al. J. Catalysis 2006, 237, 29-37) was previously developed in our lab, demonstrating agreement with lab-scale batch operation data of other researchers (Shiraishi et al. Chem. Engineer. Sci. 2003, 58, 929-934). Model parameters evaluated included adsorption equilibrium and rate constants for the adsorbent (activated carbon) honeycomb rotor, and catalytic rate constant for pseudo-first-order formaldehyde destruction in the titanium dioxide photoreactor. This paper explores design consequences for this novel system. In particular, the batch parameter values are used to model both adsorbent and photocatalyst behavior for continuous operation in typical residential home challenges. Design variables, including realistic make-up air fraction, adsorbent honeycomb rotation speed, and formaldehyde source emission rate, are considered to evaluate the ability of the system to achieve World Health Organization pollutant guidelines. In all circumstances, the size of the required rotating adsorbent bed and photoreactor for single-stage operation and the resultant formaldehyde concentration in the home are calculated. The ability of how well such a system might be accommodated within the typical dimensions of commercial ventilation ducts is also considered.     

Transport of atmospheric fine particulate matter: part 2--findings from recent field programs on the intraurban variability in fine particulate matter

Air quality field data, collected as part of the fine particulate matter Supersites Program and other field measurements programs, have been used to assess the degree of intraurban variability for various physical and chemical properties of ambient fine particulate matter. Spatial patterns vary from nearly homogeneous to quite heterogeneous, depending on the city, parameter of interest, and the approach or method used to define spatial variability. Secondary formation, which is often regional in nature, drives fine particulate matter mass and the relevant chemical components toward high intraurban spatial homogeneity. Those particulate matter components that are dominated by primary emissions within the urban area, such as black carbon and several trace elements, tend to exhibit greater spatial heterogeneity. A variety of study designs and data analysis approaches have been used to characterize intraurban variability. High temporal correlation does not imply spatial homogeneity. For example, there can be high temporal correlation but with spatial heterogeneity manifested as smooth spatial gradients, often emanating from areas of high emissions such as the urban core or industrial zones.     

Development of a regenerable system employing silica-titania composites for the recovery of mercury from end-box exhaust at a chlor-alkali facility

The release of mercury to the environment is of particular concern because of its volatility, persistence, and tendency to bioaccumulate. The recovery of mercury from end-box exhaust at chlor-alkali facilities is important to prevent release into the environment and reduce emissions as required by NESHAP (National Emission Standards for Hazardous Air Pollutants). A pilot-scale photocatalytic reactor packed with silica-titania composite (STC) pellets was tested at a chloralkali facility over a 3-month period. This pilot reactor treated up to 10 ft3/min (ACFM) of end-box exhaust and achieved 95% removal. The pilot reactor was able to maintain excellent removal efficiency even with large fluctuations in influent mercury concentration (400-1600 microg/ft3). The STC pellets were regenerated ex situ by regeneration with hydrochloric acid and performed similarly to virgin STC pellets when returned to service. On the basis of these promising results, two full-scale reactors with in situ regeneration capabilities were installed and operated. After optimization, these reactors performed similarly to the pilot reactor. A cost analysis was performed comparing the treatment costs (i.e., cost per pound of mercury removed) for sulfur-impregnated activated carbon and the STC system. The STC proved to be both technologically and economically feasible for this installation.     

The impact of the 2004 tsunami on coastal Thai communities: assessing adaptive capacity

The suddenness and scale of the 26 December 2004 tsunami and the challenges posed to affected communities highlighted the benefits of their members having a capacity to confront and adapt to the consequences of such a disaster. Research into adaptive capacity or resilience has been conducted almost exclusively with Western populations. This paper describes an exploratory study of the potential of a measure of collective efficacy developed for Western populations to predict the capacity of members of a collective society, Thai citizens affected by the 2004 tsunami, to confront effectively the recovery demands associated with this disaster. Following a demonstration that this measure could predict adaptive capacity, the role of religious affiliation, ethnicity and place of residence in sustaining collective efficacy is discussed. The implications of the findings for future research on, and intervention to develop, adaptive capacity among Thai citizens in particular and collectivist societies in general are discussed.