Emission Control in Coking Operations By Use of Stage Charging

At the Clairton Coke Works of the United States Steel Corporation (the world’s largest coke plant), with coal charges of about 30,000 net tons per day, a system designated as “stage charging” has been developed for charging coal into the coke oven chamber without emissions to the atmosphere. The principles of the system are based on controlled sequential flow of the coal from the charging hoppers, during which the oven chamber is maintained under a very slight negative pressure condition by use of steam aspiration in the offtakes for on-the-main charging. The techniques are basic but require knowledge of the coal characteristics, adequate and properly maintained aspirating systems, including clean offtake piping, control of coal volume in the individual hoppers, and last, and probably most important, adherence by the operating crew to specific charging and leveling practices.     

Performance and Cost Comparisons between Fabric Filters and Alternate Participate Control Techniques

A study was conducted to evaluate performance and cost comparisons of fabric filters and alternate fine particulate control techniques. In relating the removal of fine particulate to costs, due to the lack of fractional efficiency data, it was found necessary to treat a specific application in order to make the study manageable. The case chosen is that of the coal fired industrial boiler since Enviro-Systems has a pilot program in this application area.     

A Policy of Options

As many of you know, I previously served as Deputy Administrator of the Environmental Protection Agency at a time when the problem of air pollution control was reaching a peak of public awareness. The work of the Air Pollution Control Association in investigating facts and accelerating the development of solutions earned my high respect then and my continued admiration now.     

Cooling Towers and the Environment

Measurements of natural draft cooling tower plume behavior, as well as meteorological variables, were obtained from aircraft flights near major power plants of the American Electric Power System. Persistence of the visible plume to great distances depends essentially on ambient humidity. Atmospheric stability at plume elevation was also important. Cooling tower-induced fog at ground-level was never observed in any of the tests, and aerodynamic downwash of the visible plume was absent also. The cooling towers did cause modification of natural clouds and they occasionally shadowed some local areas from the sun. Merging of the stack and cooling tower plumes was a common occurrence.     

Weekday-Weekend Pollutant Studies of the Los Angeles Basin

Pollutant data from the Los Angeles Basin were analyzed for weekday-weekend differences for the smog months of June through September 1972 and 1973. The pollutants investigated were oxidant, NO, NO₂, total hydrocarbons (HC), CO, and particulates. In order to maintain the diurnal variation, the concentration percentiles were calculated for each weekday and weekend hour.     

Cyclic Trends in Los Angeles Fine Participates

Noontime visibilities in downtown Los Angeles, averaged over the smog season of June through November, show two cycles of general deterioration and improvement. The improvement since 1962 is confirmed by available high volume filter data and conditions in 1974/75 are at least as good as at anytime since observations were begun in 1933. The decrease in frequency of “rule 57” days suggests that the improvement of the last decade and perhaps the cyclic variation of the past 40 years has been primarily of meteorological origin.     

A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.     

An Ozone Event in Indianapolis

There are doubts concerning the sources of the pollutant ozone in an urban location. Current control regulations,¹ for example, are based on local sources. Many studies suggest that plumes of pollutants released by upwind areas are the cause. For example, New York City has been associated with high O₃ in New England,² Chicago with O₃ in Milwaukee,³ and St. Louis with O₃ in rural Illinois.⁴ Others^5,6 have suggested the problem must be treated on a synoptic scale. In an effort to understand the problem at Indianapolis better, a series of experiments involving aircraft flights were conducted in the Indianapolis area and their results are herein reported. Specifically, a cross country flight of over 100 mi both to the northeast and southwest of Indianapolis, a vertical spiral to 28,000 ft, low level data associated with takeoff and landing of the aircraft, and ground data at four sites, are available for the afternoon of June 9,1976.     

An Overview of EPA’s Quality Assurance Program

Quality Assurance has been defined in many different ways to express concern for the “quality” of the output of some operation or function. For the purpose of this presentation, quality assurance is defined as the sum of those activities within an environmental monitoring or measurement program which are primarily for the purpose of documenting the precision, accuracy, representativeness, and completeness of the data that are produced. Further, we view quality assurance as a management tool which encompasses both administrative and technical functions which generally fall into three categories: (1) Prevention which includes those activities carried out prior to the proper placement and operation of the measurement system; (2) Evaluation which includes the continuous overview and checks on the performance of the systems and operators; and (3) Correction which includes changes made to improve or stabilize the capability and performance of the system.