Polychlorinated biphenyls and organochlorine pesticides in EELS (Anguilla anguilla L.) from Welsh rivers

Organochlorine concentrations in the muscle tissues of eels at 41 freshwater sites across Wales were surveyed in 1993. Positive but weak relationships were detected between eel age or length and the concentration of some organochlorines. Isomers of HCH were below detection at most sites. Dieldrin was widespread at 10-100 microg kt(-1) wet weight, despite its ban in sheep dip in 1989. Total DDT residue concentrations averaged 73 microg kg(-1). Total PCB burdens expressed as Arochlor 1260, were > 50 microg kg(-1) at 76% of sites and > 100 microg kg(-1) at 46% of sites. The range of concentrations was comparable with other UK data. Rural sites had relatively low levels of PCBs, highest contamination occurring in the lower reaches of industrialised catchments. The inferences for environmental effects are discussed.     

Trends in surface water chemistry of acidified UK freshwaters, 1988-2002

Analysis of water chemistry data from 15 years of monitoring at 22 acid-sensitive lakes and streams in the UK reveals coherent national chemical trends indicative of recovery from acidification. Excess sulphate and base cations exhibit significant decline, often accompanied by an increase in an alkalinity-based determination of acid neutralising capacity (AB-ANC) and, at fewer sites, a decline in hydrogen and labile aluminium. Acid neutralising capacity determined by "charge-balance" (CB-ANC) exhibits few trends, possibly due to compound errors associated with its determination. Trend slopes in excess sulphate correlate with those for base cations, hydrogen ion and AB-ANC, with between-site variability linked to catchment hydrology, sea-salt inputs and forestry. Nitrate concentrations have not changed significantly but show high sensitivity to varying climate. Trends in AB-ANC are influenced by significant increases in dissolved organic carbon, the cause of which it is vital to establish before trends in the former can definitively be attributed to decreasing acidic deposition.     

Buoyancy-Driven Two-Layer Exchange Flows Across a Slowly Submerging Barrier

Results are presented from a combined analytical and laboratory study of unsteady, two-layer, density-driven, sub-maximal exchange over a slowly-descending estuarine barrier located very close to the junction of the river mouth and the near-shore coastal zone. As in the precursor study (Cuthbertson et al. 2004, Environ. Fluid Mech. 4, 127–155) that the present investigation extends, the rate of descent of the barrier is assumed to be sufficiently slow for the unsteady exchange flow to adjust continuously to the appropriate quasi-steady conditions at every stage of the descent. The results demonstrate that the thickness of each layer at the barrier crest can be predicted satisfactorily by a hydraulic analysis that (i) assumes the existence of a single control point at the barrier crest and (ii) incorporates the hydraulic losses arising from the sudden expansion and contraction of the upper and lower layers, respectively, at the channel exit. Predictions of the normalised elevations of the interface at the barrier and exit for the “inviscid” maximal exchange case are shown to coincide with the maximal exchange predictions of Zhu and Lawrence (2000, J. Hydraul. Eng. ASCE 126(12), 921–928).     

A Modelling Study of Transient,Buoyancy-Driven Exchange Flow over a Descending Barrier

Results are presented from a series of model studies of the transient exchange flow resulting from the steady descent of an impermeable barrier separating initially-quiescent fresh and saline water bodies having density ₀ and ₀+()₀, respectively. A set of parametric laboratory experiments has been carried out (i) to determine the characteristic features of the time-dependent exchange flow over the barrier crest and (ii) to quantify the temporal increase in the thickness and spatial extent of the brackish water reservoir formed behind the barrier by the outflowing, partly-mixed saline water. The results of the laboratory experiments have been compared with the predictions of a theoretical model adapted from the steady, so-called maximal exchange flow case and good qualitative agreement between theory and experiment has been demonstrated. The comparisons indicate that head losses of between 7% and 3% are applicable to the flow over the ridge crest in the early and late stages, respectively, of the barrier descent phase, with these losses being attributed to mixing processes associated with the counterflowing layers of fresh and saline water in the vicinity of the ridge crest. The experimental data show (and the theoretical model predictions confirm) that (i) the dimensionless time of detection t _det(g/H _b)^1/2 of the brackish water pool fed by the dense outflow increases (at a given distance from the barrier) with increasing values of the descent rate parameter g'H _b/(dh _b/dt)² and (ii) the normalised thickness (x,t)/H _b of the pool at a given reference station increases monotonically with increasing values of the modified time (t–t _det)/(H _b/g)^1/2, with the rate of thickening decreasing with increasing values of the descent rate parameter g'H _b(dh _b/dt)². Here, g=(g/₀)()₀ is the modified gravitational acceleration, H _b is the mean depth of the water and dh _b/dt denotes the rate of descent of the barrier height h _b with elapsed time t after the two water bodies are first brought into contact.     

Quality assurance of imposex and intersex measurements in marine snails

Collaboration between the QUASIMEME and BEQUALM projects has proved to be an effective mechanism to further the development of quality assurance procedures for the measurement of the biological effects of tributyltin (imposex and intersex) to meet the requirements of international and national marine monitoring programmes. The data arising from the Laboratory Performance Studies are demonstrating the level of agreement between laboratories, suggesting factors leading to differences between laboratories, and guiding the development of QA procedures.     

Movement of petroleum hydrocarbons in sandy coastal soils

In a field trial, oiled beach sand was buried in a coastal dune system in south Wales. A monitoring programme was designed to assess the rate of leaching of inorganic ions and hydrocarbons from the deposit. Active breakdown of the weathered oil occurred within the oiled beach sand, but hydrocarbons from the original material, or arising as a result of degradation, did not follow the same leaching pattern as inorganic ions; they remained within the original deposit. The results suggest that weathered oil coming ashore from spills at sea can be mixed with sand and buried to degrade in coastal soils, without risk of groundwater contamination by hydrocarbons.     

Gravity currents in rotating,wedge-shaped,adverse channels

Results are presented from a series of parametric experimental and analytical studies of the behaviour of dense gravity currents along rotating, up-sloping, wedge-shaped channels. High resolution density profile measurements at fixed cross- and along-channel locations reveal the outflowing bottom gravity currents to adjust to quasi-steady, geostrophically-balanced conditions along the channels, with the outflow layer thickness and cross-channel interface slope shown to scale with the inlet Burger number for all experimental conditions tested. A general analytical solution to the classic rotating hydraulics problem has been developed under the assumption of inviscid, zero-potential-vorticity conditions to model dense water flow through a triangular constriction and thus simulate the vee-channel configurations under consideration. Predictions from this zero-PV model are shown to provide good overall quantitative agreement with experimental measurements obtained both under hydraulically-controlled conditions at the channel exit and for subcritical conditions generated along the channel length. Quantitative discrepancies between measurements and analytical predictions are attributed primarily to assumptions and limitations associated with the zero-PV modelling approach adopted, as well as the to the rapid adjustment in outflow characteristics as the channel exit is approached, as characterised by the along-channel variation in densimetric Froude number for the outflows.     

Minimising transportation in manufacturing supply chains

The movement of raw material, work-parts and bought-out components is an essential aspect of modern-day global manufacturing systems. It is also an expensive, non-value adding and pollution-generating activity with many undesirable consequences. These manifest themselves not only in terms of the immediate cost of transportation between suppliers, manufacturers and customers but also in the consequential effect this movement has on human health and the environment. Accordingly, modern manufacturing supply chains should be designed with great care to minimise the amount of movement required both internally within a manufacturing facility's production system and externally between the supplier, manufacturer and customer. In so doing, a good supply chain design minimises the costs associated with the transportation of goods along with the effect this has on the environment. In complex supply chains, however, minimising overall transportation movement for large sets of components is no easy task. Consequently, the contribution contained in this paper seeks to outline a technique whereby an initial supply chain design solution which does so can be identified. The method is explained in the first instance via a straightforward material movement example. The resulting solution is subsequently modified to indicate its application in the context of temporal supply chain design. By utilising this approach, the article emphasises the importance of obtaining a solution that minimises transportation movement within the supply chain together with the practical effects of doing so on flexibility, cost and environmental pollution. In addition, the work required for further development of this technique is outlined and finally suitable conclusions are drawn.     

Indoor/Outdoor Ozone Concentrations at a Contemporary Art Gallery

Ozone concentrations were measured both inside and outside the Sainsbury Centre for Visual Arts, near a small city in rural eastern England, during a three-week period in summer. The inside concentration was typically 70 ± 10% of the outside concentration during the period of expected maximum outside levels. During the period of observation the maximum outside ozone levels ranged up to 60 ppb, although there have been periods at this location where outside ozone levels have been well in excess of 120 ppb. The relatively high indoor/outdoor ozone ratio is a function of the Centre’s design, its internal geometry, and its ventilation system. Conventional art galleries and museums experience much lower indoor ozone exposure. The measured indoor ozone levels imply deleterious effects on the gallery exhibits and an enhanced ozone exposure may have to be considered in the design of modern galleries and museums.     

Spatial scale of the patchiness of plant poisons: a critical influence on foraging efficiency

Generalist mammalian browsers and folivores feed on a range of chemically different plant species, which may assist them in diluting toxins and diversifying nutrient consumption. The frequency and order in which their diets are mixed are important determinants of intake. As a result, the degree of plant heterogeneity in an environment, and the spatial scale at which this occurs, should directly influence herbivore foraging decisions. We tested whether altering the Spatial scale of plants, and thus plant secondary metabolites (PSMs), affected foraging efficiency of a generalist folivore, the common brushtail possum (Trichosurus vulpecula). First, we demonstrated that possums were able to consume more from a mixed diet of two chemically different species, Eucalyptus globulus and E. tenuiramis, than when either of these species was offered alone. We then tested whether altering the spatial scale between E. globulus and E. tenuiramis, as small- or large-scale plant heterogeneity "patches," affected possum foraging behavior and, ultimately, their foraging efficiency. Possums increased their foraging efficiency when the spatial scale of plant heterogeneity was small rather than large. We argue that the ability to regularly switch diets, when plant spatial distribution is at a small scale, reduces the negative effects of PSM ingestion. We predict that the heterogeneity of plant patches, in relation to PSM distribution, and the scale at which this occurs across a landscape, are critical factors that influence foraging efficiency and, ultimately, fitness of mammalian herbivores. This research provides a fundamental link between plant chemistry, foraging, and habitat heterogeneity.