New Fe-immobilized natural bentonite plate used as photo-Fenton catalyst for organic pollutant degradation

Novel photo-Fenton catalysts were prepared by immobilizing iron species on commercial bentonite plates via two methods: (1) ion exchange reaction (Fe³⁺ vs. Na⁺) by aqueous suspension powder-clay/FeCl₃ followed by plate preparation, and (2) forced hydrolysis of Fe(NO₃)₃ onto a prefabricated clay plate. The last method led to a more photo-active Fe-oxide/bentonite plate. This material allowed, at a non-adjusted initial pH of 5.5 and in the presence of H₂O₂, the total degradation of resorcinol and 55% mineralization in 80 and 100 min of irradiation, respectively. The reached degradation percentages were correlated to the presence of dissolved iron, demonstrating that in these processes, the homogeneous photo-Fenton reactions were mainly responsible for the resorcinol elimination.Likewise, in slurry system, where clay has normally an increased surface area, there was no increase in activity because of a reduced leached iron probably due to the diminished light penetration in the suspension. Despite the lower surface area, in comparison to that of the slurry, the clay plates have the advantage, as heterogeneous photo-catalysts, that separation of the reaction media after treatment is not needed, and thus, a potential use for batch and continuous reaction systems is proposed.     

Arsenic release from pyrite ash waste over an active hydrogeological system and its effects on water quality

Environmental Science and Pollution Research - Arsenic is a potentially toxic element of concern for environmental compartments, and it is a frequent pollutant in many abandoned industrial sites....     

Impact of mining activities on soils in a semi-arid environment: Sierra Almagrera district, SE Spain

Field and laboratory-column studies were undertaken in order to investigate soil contamination derived from past mining activity in the Sierra Almagrera (SA) district in southeast Spain. The tailings, soil and sediment samples that were collected showed high concentrations of Ag, As, Ba, Cu, Pb, Sb and Zn when analyzed. The mean concentrations of these elements in the tailings were 29.8, 285.4, 54000, 57.7, 2687.5, 179.0 and 2269.0 ppm, respectively. In the soil samples these decreased to 14.3, 96.9, 24700, 37.5, 1859.1, 168.5 and 815.7 ppm, respectively. Geochemical analyses demonstrated high levels of As, Pb and Zn which were above the intervention values set forth in the Andalusian Regulations for Contaminated Soils for As (>50 ppm), Pb (>500 ppm) and Zn (>2000 ppm). Column experiments and mineralogical studies suggest that the dissolution of sulfates and other secondary phases, accumulated in soils and waste-sites during the dry season, acts to control the mobility of metals. The elution curves obtained from column experiments showed a mobilization of Ba, Cu, Pb and Zn, while a low mobility was seen for Ag, As and Sb.     

Effects of female mating status on copulation behaviour and sperm expenditure in the freshwater crayfish <Emphasis Type="Italic">Austropotamobius italicus</Emphasis>

Sperm competition models predict that males should adjust their sperm expenditure according to the risk and/or intensity of sperm competition. In this paper, we analysed copulatory behaviour of both sexes and sperm expenditure in relation to female mating status (virgin or mated) in the freshwater crayfish Austropotamobius italicus, a species where males have been reported to feed on and remove sperm laid by other males. The same females were allowed to be inseminated sequentially by two males, and we compared the sexual behaviours of partners between the first (virgin females) and the second mating (mated females). We found that female resistance did not differ between the first and the second mating, nor males refused or took more time to mount a mated female. However, when mating with a mated female, males reached an effective copulation position significantly later. This occurred because second-mating males removed, by eating, all or most spermatophores previously deposited by first males. As removal was often incomplete, this resulted in a larger amount of sperm being deposited on female ventral parts after the second mating, although second males did not allocate more sperm to mated females than first males did. Thus, the peculiar mode of sperm competition, where males remove previously deposited sperm, and the consequent predictable strong last male prevalence in paternity likely led to the observed lack of adjustment of sperm expenditure to female mating status in this species.     

Measuring detoxification and maturity in compost made from "alperujo", the solid by-product of extracting olive oil by the two-phase centrifugation system

Olive-mill wastes and by-products from the edible olive oil industry contain a high non-stabilised organic load, including organic acids, phenolic compounds and fats with antimicrobial and phytotoxic properties, which make them unsuitable for direct agricultural application. The most abundant olive-mill by-product in Spain is "alperujo" (AL), a solid material with a lack of consistency and low porosity due to its high water content and small particle size, which can be suitably composted by adding bulking agents. Six piles were prepared by mixing AL with cotton waste, grape stalk, olive leaf and fresh cow bedding, then successively composted, five of them managed by forced ventilation assisted by mechanical turning and the sixth only turned. After monitoring the process, the relationship between the germination index (GI) and the presence of some potentially phytotoxic compounds, as well as several maturity and stability indices, was assessed. As composting advanced, the GI increased and both the fat and water-soluble phenol contents decreased, indicating a gradual detoxification as the composts matured. The values of the maturity and stability indices were frequently different from the values reported for other composts.     

Study of the operational conditions for anaerobic digestion of urban solid wastes

This paper describes an experimental evaluation of anaerobic digestion technology as an option for the management of organic solid waste in developing countries. As raw material, a real and heterogeneous organic waste from urban solid wastes was used. In the first experimental phase, seed selection was achieved through an evaluation of three different anaerobic sludges coming from wastewater treatment plants. The methanization potential of these sludges was assessed in three different batch digesters of 500 mL, at two temperature levels. The results showed that by increasing the temperature to 15 degrees C above room temperature, the methane production increases to three times. So, the best results were obtained in the digester fed with a mixed sludge, working at mesophilic conditions (38-40 degrees C). Then, this selected seed was used at the next experimental phase, testing at different digestion times (DT) of 25, 20 and 18 days in a bigger batch digester of 20 L with a reaction volume of 13 L. The conversion rates were registered at the lowest DT (18 days), reaching 44.9 L/kg(-1) of wet wasteday(-1). Moreover, DT also has a strong influence over COD removal, because there is a direct relationship between solids removal inside the reactor and DT.     

Ecosystem Services Provided by Agroecosystems: A Qualitative and Quantitative Assessment of this Relationship in the Pampa Region,Argentina

The development of an analytical framework relating agricultural conditions and ecosystem services (ES) provision could be very useful for developing land-use systems which sustain natural resources for future use. According to this, a conceptual network was developed, based on literature review and expert knowledge, about the functional relationships between agricultural management and ES provision in the Pampa region (Argentina). We selected eight ES to develop this conceptual network: (1) carbon (C) balance, (2) nitrogen (N) balance, (3) groundwater contamination control, (4) soil water balance, (5) soil structural maintenance, (6) N₂O emission control, (7) regulation of biotic adversities, and (8) biodiversity maintenance. This conceptual network revealed a high degree of interdependence among ES provided by Pampean agroecosystems, finding two trade-offs, and two synergies among them. Then, we analyzed the conceptual network structure, and found that both environmental and management variables influenced ES provision. Finally, we selected four ES to parameterize and quantify along 10 growing seasons (2000/2001–2009/2010) through a probabilistic methodology called Bayesian Networks. Only N balance was negatively impacted by agricultural management; while C balance, groundwater contamination control, and N₂O emission control were not. Outcomes of our work emphasize the idea that qualitative and quantitative methodologies should be implemented together to assess ES provision in Pampean agroecosystems, as well as in other agricultural systems.     

Life cycle energy and CO2 emissions analysis of food packaging: an insight into the methodology from an Italian perspective

Packaging is strictly connected to environmental issues as it is a product characterised by high material consumption rate; it is often transported over long distances and has a short life. Providing environmental analysis is, therefore, urgent to identify energy and resources efficient solutions. The paper, taking advantage of a real case study, presents a life cycle-based comparative analysis among three different food packaging systems. The paper compares the life cycle of tin steel, polypropylene and glass-based packaging of an Italian preserves producer. The analysis leads to the conclusion that, for the baseline scenario, polypropylene packaging represents the greenest solution, whereas glass packaging is the worst choice. The paper presents a scenario analysis varying both the method used for accounting for recycling as well as the recycling rates of the packaging materials. Changes in overall results with parameters analysis changing are calculated and highlighted throughout the paper. The impact of a reuse policy of the glass-based solution is also analysed; a model for disposable glass packaging is proposed and the obtained results are compared with the single use polypropylene and tin steel-based packaging. In order to analyse the impact of different End of Life scenarios on the present case study, collecting as well as recycling rates of some European countries have been used. The results revealed a significant fluctuation both in energy consumption and in CO₂ emission as the nation changes. Summing up, a methodology for packaging environmental impact analysis is applied to a real case study, some crucial aspects of the methodology have been analysed in depth in order to give a contribution in packaging environmental impact analysis.     

Trace elements fingerprint of feathers differs between breeding and non-breeding areas in an Afro-Palearctic migratory bird,the barn swallow (Hirundo rustica)

Environmental Science and Pollution Research - Trace elements are widespread contaminants that can potentially threaten ecosystems and human health. Considering their distribution and toxicity,...     

Analysis of indoor gaseous formic and acetic acid, using radial diffusive samplers

A diffusive sampling method for the determination of gaseous acetic and formic acids, using a radial symmetry diffusive sampler, has been optimised for a 7-day exposure time in this study. Sampling rate determinations were performed on data obtained from a dynamic exposure chamber, simulating the indoor conditions of an empty, closed, room, at room temperature and minimal wind speed. Analysis has been performed by means of ion chromatography. The sampling rates for formic acid concentrations of 128 microg m(-3) and 1248 microg m(-3) were determined to be 91.2 +/- 3.9 ml min(-1) and 111.6 +/- 2.8 ml min(-1), respectively. The acetic acid sampling rate was independent of the concentration in the range 160 microg m(-3)-1564 microg m(-3), and amounted to 97.3 +/- 3.1 ml min(-1). Experimentally determined sampling rates showed deviations of 3% for acetic acid, and 3-21% for formic acid, in relation to theoretically derived values. The blank values were as low as 1.69 +/- 0.07 microg for formic acid and 1.21 +/- 0.14 microg for acetic acid, and detection limits lower than 0.5 microg m(-3) could be achieved, which is an improvement of 98-99% compared to previously validated diffusive sampling methods. This study describes the first step of an extended validation program in which the applicability of these types of samplers for the measurement of organic acids will be validated and optimised for the environmental conditions typical for museum showcases.