Applicability of high rate transpiration system for treatment of biologically treated distillery effluent

The biologically treated distillery effluent (BTDE) contains intense colour, high total dissolved solids (TDS), chemical oxygen demand (COD) and biochemical oxygen demand (BOD). These properties even after primary, secondary and tertiary treatments contain high concentrations of TDS, COD and BOD. The paper highlights the safe disposal and treatment of BTDE on land through High Rate Transpiration System (HRTS). HRTS is a zero discharge, low cost, high-tech method for improving the quality of BTDE for potential reuse. The experiments conducted at bench and pilot scale showed that HRTS having coconut husk as a bedding material could successfully treat the BTDE with a hydraulic load of 200 m³ ha⁻¹ day⁻¹ having BOD of 100 mg l⁻¹ and 500 m³ ha⁻¹ day⁻¹ having BOD of 500 mg l⁻¹ with average COD load of 0.686 and 2.88 ton ha⁻¹ day⁻¹ during the post and pre monsoon periods respectively. There was no significant increase in the organic carbon of the soil irrigated with BTDE. The concentrations of various pollutants analyzed in the leachate were within the prescribed limit for the drinking water sources. The colour removal was 99 to 100% and BOD and COD were possible to treat with optimum hydraulic loading of BTDE through HRTS planted with Dendrocalamus strictus.     

Polycyclic Aromatic Hydrocarbons: Need for Assessment of Health Risks in India? Study of An Urban-Industrial Location in India

This paper reports the PAHs levels in the atmosphere of an urbanised industrial site of India. A high-resolution capillary gas chromatograph with a mass spectrometric detector (HRCGC-MS) and a high performance liquid chromatograph (HPLC) equipped with a fluorescence detector were used for the identification and quantitation of PAHs. The atmospheric levels of PAHs were higher (4.66 ng/m³ yearly average) than most of the concentrations previously reported in the literature. Indian sites were found more contaminated with potently carcinogenic: four and above ringed PAHs. Based on a good correlation between the levels of lead, vanadium, BaP and BghiP, the vehicular emission appears to be a major source of the PAHs. Further, the higher levels of observed PAHs could be attributed to the vertical distribution of the aerosols, the preference of the PAHs for the particulate phase and the greater availability of the substrate in the atmosphere for their sorption. This paper also discusses the need for development of a PAHs monitoring protocol and related health effect studies in developing countries such as India.     

Drought stress induced changes in lipid peroxidation and antioxidant system in genus Avena

Seven species of genus Avena viz., Avena sativa, Avena strigosa, Avena brevis, Avena vaviloviana, Avena abyssinica, Avena marocana and Avena sterilis were used to study the impact of drought stress on lipid peroxidation and other antioxidant enzymes. Maximum increase in the catalase activity was recorded in A. vaviloviana (129.97%) followed by A. sativa (122.82%) and A. brevis (83.38%) at vegetative stage; however at flowering stage the maximum increase was reported in A. sativa (25.62%) followed by A. sterilis (20.46%) and A. brevis (18.53%). At vegetative stage drought, maximum increase in peroxidase activity was recorded in A. sativa (122.82%) followed by A. brevis (83.38%) and A. sterilis (49.78%). Flowering stage drought, showed maximum increase in A. Sativa (27.09%) followed by A. marocana (23.50%) and A. sterilis (20.46%). A. sativa and A. sterilis showed stress tolerance at both the stages by accumulating higher percentage of peroxidase followed by A. brevis at vegetative and A. marocana at flowering stage. Level of lipid peroxidation in terms of Malondialdehyde (MDA) content was increased in the leaves when plants were subjected to moisture stress. The rate of increase in lipid peroxidation occurs irrespective of stage however; maximum increase was recorded in A. strigosa at both the stages. Avena species which showed high level of MDA content, indicates more lipid peroxidation and more membrane permeability and are comparatively more susceptible for water stress than those which produce less Malondialdehyde (MDA) content at higher magnitude of water stress such species have better capability for moisture stress tolerance.     

Removal of arsenic by Acidothiobacillus ferrooxidans bacteria in bench scale fixed-bed bioreactor system

In the present study arsenic contaminated simulated water and groundwater was treated by the combination of biological oxidation of tri-valent arsenite [As (III)] to penta-valent arsenate [As (V)] in presence of Acidothiobacillus ferrooxidans bacteria and its removal by adsorptive filtration in a bioreactor system. This method includes the immobilisation of A.ferrooxidans on Granulated Activated Carbon (GAC) capable of oxidising ferrous [Fe (II)] to ferric [Fe (III)]. The Fe (III) significantly converts the As (III) to As (V) and ultimately removed greater than 95% by the bed of GAC, limestone, and sand. The significant influence of Fe (II) concentration (0.1–1.5?gL^?1), flowrate (0.06–0.18?Lh^?1), and initial As (III) concentration (100–1000?µgL^?1) on the arsenic removal efficiency was investigated. The simulated water sample containing the different concentration of As (III) and other ions was used in the study. The removal of other co-existing ions present in contaminated water was also investigated in column study. The concentration of arsenic was found to be <10?µgL^?1 which is below Maximum Contaminant Level (MCL) as per WHO in treated water. The results confirmed that the present system including adsorptive-filtration was successfully used for the treatment of contaminated water containing As (III) ions.     

Cellular uptake and mutagenic potential of metal oxide nanoparticles in bacterial cells

Extensive production and consumption of nanomaterials such as ZnO and TiO₂ has increased their release and disposal into the environment. The accumulation of nanoparticles (NPs) in ecosystem is likely to pose threat to non-specific targets such as bacteria. The present study explored the effect of ZnO and TiO₂ NPs in a model bacterium, Salmonella typhimurium. The uptake of ZnO and TiO₂ bare NPs in nano range without agglomeration was observed in S. typhimurium. TEM analysis demonstrated the internalization and uniform distribution of NPs inside the cells. Flow cytometry data also demonstrates that both ZnO and TiO₂ NPs were significantly internalized in the S. typhimurium cells in a concentration dependent manner. A significant increase in uptake was observed in the S. typhimurium treated even with 8 and 80 ng mL⁻¹ of ZnO and TiO₂ NPs with S9 after 60 min, possibly the formation of micelles or protein coat facilitated entry of NPs. These NPs exhibited weak mutagenic potential in S. typhimurium strains TA98, TA1537 and Escherichia coli (WP2uvrA) of Ames test underscoring the possible carcinogenic potential similar to certain mutagenic chemicals. Our study reiterates the need for re-evaluating environmental toxicity of ZnO and TiO₂ NPs presumably considered safe in environment.     

Predicting the distributional range shifts of Rhizocarpon geographicum (L.) DC. in Indian Himalayan Region under future climate scenarios

Environmental Science and Pollution Research - Himalaya, the highest mountain system in the world and house of important biodiversity hotspot, is sensitive to projected warming by climate change....     

On the emergence of a health-pollutant-climate nexus in the wake of a global pandemic

Environmental Science and Pollution Research - COVID-19 has wreaked havoc throughout the planet within a short time frame, inducing substantial morbidity and mortality in the global population. The...     

Environmental threat and change detection in saline lakes from 1960 to 2021: background,present, and future

Environmental Science and Pollution Research - Saline lakes are internationally known for unique chemical compositions, incorporate assorted foliage, and give a few biological system benefits and...     

Distribution of Metals in the Edible Plants Grown at Jajmau, Kanpur (India) Receiving Treated Tannery Wastewater: Relation with Physico-Chemical Properties of the Soil

The implications of metal contamination of agricultural soils due to long term irrigation with treated industrial wastewater and their subsequent accumulation in the vegetables/crops growing on such soils has been assessed in an area of industrial complex, Jajmau, Kanpur (India). Physico-chemical properties of the soil were also studied. The soil and vegetables/crops were sampled from an area of 2100 acre agricultural land and analyzed for physico-chemical properties and metal accumulation in different parts of the plants. The comparison of the data of physico-chemical properties of control and contaminated soil showed that salinity, electrical conductivity, available phosphorous, sodium and potassium content (both water soluble and exchangeable) were found high in contaminated soil. The analysis of plant available metal content in the soil showed the highest level of Fe, which ranged from 529.02 to 2615 μg g⁻¹ dw and lowest level of Ni (3.12 to 10.51 μg g⁻¹ dw). The analysis of the results revealed that accumulation of toxic metal Cr in leafy vegetables was found more than fruit bearing vegetables/crops. Thus, it is recommended that the leafy vegetables are unsuitable to grow in such contaminated sites. It is important to note that toxic metal, Ni was not detected in all the plants. The edible part of the vegetables (under ground) such as, garlic (19.27 μg g⁻¹ dw), potato (11.81 μg g⁻¹ dw) and turmeric (20.86 μg g⁻¹ dw) has accumulated lowest level of toxic metal, Cr than leafy and fruit bearing vegetables. In some fruit part of vegetables such as, bitter gourd, egg plant, jack tree, maize and okra, the accumulation of Cr was not detected and may be grown in this area.     

Pattern of Hexa-Valent Chromium in Air Borne Respirable Dust Generated at Various Workplaces in Opencast Chromite Mines

The paper presents a study into air borne respirable dust (ARD) concentration at various workplaces in two open cast chromite mines of Sukinda chromite belt, India. One of these mines is mechanised and the other one is semi-mechanised. The study has been conducted in three phases and ARD concentration has been measured at various workplaces in both the mines. Apart from the determination of ARD concentration, the dust samples collected on filter papers were analysed for hexa-valent chromium by colorimetric method and Cr(VI) direct absorption measurement. In addition, the particle size ranges in ARD have been determined by using cascade impactor fitted onto high volume samplers and laser guided particle size analyser. The paper finally presents a comparison between ARD concentration vis-à-vis the presence of hexa-valent chromium concentration in collected samples of both mechanised and semi-mechanised mines.