Impact of injection system design on ISCO performance with permanganate--mathematical modeling results

In situ chemical oxidation (ISCO) using permanganate (MnO(4)(-)) can be a very effective technique for remediation of soil and groundwater contaminated with chlorinated solvents. However, many ISCO projects are less effective than desired because of poor delivery of the chemical reagents to the treatment zone. In this work, the numerical model RT3D was modified and applied to evaluate the effect of aquifer characteristics and injection system design on contact and treatment efficiency. MnO(4)(-) consumption was simulated assuming the natural oxidant demand (NOD) is composed of a fraction that reacts instantaneously and a fraction that slowly reacts following a 2nd order relationship where NOD consumption rate increases with increasing MnO(4)(-) concentration. MnO(4)(-) consumption by the contaminant was simulated as an instantaneous reaction. Simulation results indicate that the mass of permanganate and volume of water injected has the greatest impact on aquifer contact efficiency and contaminant treatment efficiency. Several small injection events are not expected to increase contact efficiency compared to a single large injection event, and can increase the amount of un-reacted MnO(4)(-) released down-gradient. High groundwater flow velocities can increase the fraction of aquifer contacted. Initial contaminant concentration and contaminant retardation factor have only a minor impact on volume contact efficiency. Aquifer heterogeneity can have both positive and negative impacts on remediation system performance, depending on the injection system design.     

Changes in the pore network structure of Hanford sediment after reaction with caustic tank wastes

At the former nuclear weapon production site in Hanford, WA, caustic radioactive tank waste leaks into subsurface sediments and causes dissolution of quartz and aluminosilicate minerals, and precipitation of sodalite and cancrinite. This work examines changes in pore structure due to these reactions in a previously-conducted column experiment. The column was sectioned and 2D images of the pore space were generated using backscattered electron microscopy and energy dispersive X-ray spectroscopy. A pre-precipitation scenario was created by digitally removing mineral matter identified as secondary precipitates. Porosity, determined by segmenting the images to distinguish pore space from mineral matter, was up to 0.11 less after reaction. Erosion-dilation analysis was used to compute pore and throat size distributions. Images with precipitation had more small and fewer large pores. Precipitation decreased throat sizes and the abundance of large throats. These findings agree with previous findings based on 3D X-ray CMT imaging, observing decreased porosity, clogging of small throats, and little change in large throats. However, 2D imaging found an increase in small pores, mainly in intragranular regions or below the resolution of the 3D images. Also, an increase in large pores observed via 3D imaging was not observed in the 2D analysis. Changes in flow conducting throats that are the key permeability-controlling features were observed in both methods.     

Adapting a geographical information system-based water resource management to the needs of the Romanian water authorities

Background, aim, and scope

The need for global and integrated approaches to water resources management, both from the quantitative and the qualitative point of view, has long been recognized. Water quality management is a major issue for sustainable development and a mandatory task with respect to the implementation of the European Water Framework Directive as well as the Swiss legislation. However, data modelling to develop relational databases and subsequent geographic information system (GIS)-based water management instruments are a rather recent and not that widespread trend. The publication of overall guidelines for data modelling along with the EU Water Framework Directive is an important milestone in this area. Improving overall water quality requires better and more easily accessible data, but also the possibility to link data to simulation models. Models are to be used to derive indicators that will in turn support decision-making processes. For this whole chain to become effective at a river basin scale, all its components have to become part of the current daily practice of the local water administration. Any system, tool, or instrument that is not designed to meet, first of all, the fundamental needs of its primary end-users has almost no chance to be successful in the longer term.

Materials and methods

Although based on a pre-existing water resources management system developed in Switzerland, the methodological approach applied to develop a GIS-based water quality management system adapted to the Romanian context followed a set of well-defined steps: the first and very important step is the assessment of needs (on the basis of a careful analysis of the various activities and missions of the water administration and other relevant stakeholders in water management related issues). On that basis, a conceptual data model (CDM) can be developed, to be later on turned into a physical database. Finally, the specifically requested additional functionalities (i.e. functionalities not provided by classical commercial GIS software), also identified during the assessment of needs, are developed. This methodology was applied, on an experimental basin, in the Ialomita River basin.

Results

The results obtained from this action-research project consist of a set of tangible elements, among which (1) a conceptual data model adapted to the Romanian specificities regarding water resources management (needs, data availability, etc.), (2) a related spatial relational database (objects and attributes in tables, links, etc.), that can be used to store the data collected, among others, by the water administration, and later on exploited with geographical information systems, (3) a toolbar (in the ESRI environment) offering the requested data processing and visualizing functionalities. Lessons learned from this whole process can be considered as additional, although less tangible, results.

Discussion

The applied methodology is fairly classical and did not come up with revolutionary results. Actually, the interesting aspects of this work are, on the one hand, and obviously, the fact that it produced tools matching the needs of the local (if not national) water administration (i.e. with a good chance of being effectively used in the day-to-day practice), and, on the other hand, the adaptations and adjustments that were needed both at the staff level and in technical terms.

Conclusions

This research showed that a GIS-based water management system needs to be backed by some basic data management tools that form the necessary support upon which a GIS can be deployed. The main lesson gained is that technology transfer has to pay much attention to the differences in existing situations and backgrounds in general, and therefore must be able to show much flexibility. The fact that the original objectives could be adapted to meet the real needs of the local end-users is considered as a major aspect in achieving a successful adaptation and development of water resources management tools. Time needed to setup things in real life was probably the most underestimated aspect in this technology transfer process.

Recommendations and perspectives

The whole material produced (conceptual data model, database and GIS tools) was disseminated among all river basin authorities in Romania on the behalf of the national water administration (ANAR). The fact that further developments, for example, to address water quantity issues more precisely, as envisaged by ANAR, can be seen as an indication that this project succeeded in providing an appropriate input to improve water quality in Romania on the long term.

     

Bait-lamina assay as a tool to assess the effects of metal contamination in the feeding activity of soil invertebrates within a uranium mine area

As part of the tier 2 of a site-specific risk assessment, this study was the first reporting an intensive in situ application of the bait-lamina assay; two exposure periods (7 and 14 days) were tested during four seasons in ten different sites, within a uranium mine area and at two different depths. The most contaminated sites (by deposition of sludge from the effluent treatment pond) were discriminated after 14 days of exposure because extremely low percentages of feeding activity were recorded. Previous sub-lethal ecotoxicological assays, already had demonstrated that the habitat function of these soils is compromised. Nevertheless, seasonality has proved to have a significant influence on responses. Thus to strength conclusions about the impact of contaminants, the in situ bait-lamina assay should be performed on different annual seasons, at least for temperate regions. It was also found that some environmental parameters (e.g. soil moisture and litter) can act as confounding factors in the bait-lamina assay.     

Continuous measurement of peroxyacetyl nitrate (PAN) in suburban and remote areas of western China

Knowledge on atmospheric abundance of peroxyacetyl nitrate (PAN) is important in assessing the severity of photochemical pollution, and for understanding chemical transformation of reactive odd nitrogen and its impact on the budget of tropospheric ozone (O₃). In summer 2006, continuous measurements of PAN were made using an automatic GC–ECD analyzer with an on-line calibrator at a suburban site of Lanzhou (LZ) and a remote site of Mt. Waliguan (WLG) in western China, with concurrent measurements of O₃, total reactive nitrogen (NO_y) and carbon monoxide (CO). At LZ, several photochemical episodes were observed during the study, and the average mixing ratio of PAN (plus or minus standard deviation) was 0.76 (±0.89) ppbv with the maximum value of 9.13 ppbv, compared to an average value of 0.44 (±0.16) ppbv at remote WLG. The PAN mixing ratios in LZ exhibited strong diurnal variations with a maximum at noon, while enhanced concentrations of PAN were observed in the evening and a minimum in the afternoon at WLG. The daily O₃ and PAN concentration maxima showed a strong correlation (r² = 0.91) in LZ, with a regression slope (PAN/O₃) of 0.091 ppbv ppbv^?1. At WLG, six well-identified pollution plumes (lasting 2–8 h) were observed with elevated concentrations of PAN (and other trace gases), and analysis of backward particle release simulation shows that the high-PAN events at WLG were mostly associated with the transport of air masses that had passed over LZ.     

Microbial transformation products of benzoxazolinone and benzoxazinone allelochemicals--a review

Cyclic hydroxamic acids and lactams are allelochemicals present in the common agricultural crops wheat, rye, and maize. The hydroxamic acids are mainly present in the plants as glucosides. Upon injury or insect attack or when exuded to the soil environment, the hydroxamic acids occur in their unstable agluconic form. In the first step in the transformation of hydroxamic acids, benzoxazolinones are formed spontaneously. It is necessary to elucidate the further microbial transformation of these compounds in the soil environment for a purposeful exploitation of the allelopathic properties of wheat, rye, and maize. In the present paper, the existing knowledge on microbial transformation products of benzoxazolin-2-one (BOA), 6-methoxy-benzoxazolin-2-one (MBOA), and 2-hydroxy-1,4-benzoxazin-3-one (HBOA) was reviewed. Three main groups of transformation products were identified: aminophenoxazinones, malonamic acids, and acetamides. Future research needs concerning the transformation of these chemicals in soil are discussed, when their properties for suppressing weeds and soil-borne diseases are going to be exploited.     

Current issues and uncertainties in the measurement and modelling of air-vegetation exchange and within-plant processing of POPs

Air-vegetation exchange of POPs is an important process controlling the entry of POPs into terrestrial food chains, and may also have a significant effect on the global movement of these compounds. Many factors affect the air-vegetation transfer including: the physicochemical properties of the compounds of interest; environmental factors such as temperature, wind speed, humidity and light conditions; and plant characteristics such as functional type, leaf surface area, cuticular structure, and leaf longevity. The purpose of this review is to quantify the effects these differences might have on air/plant exchange of POPs, and to point out the major gaps in the knowledge of this subject that require further research. Uptake mechanisms are complicated, with the role of each factor in controlling partitioning, fate and behaviour process still not fully understood. Consequently, current models of air-vegetation exchange do not incorporate variability in these factors, with the exception of temperature. These models instead rely on using average values for a number of environmental factors (e.g. plant lipid content, surface area), ignoring the large variations in these values. The available models suggest that boundary layer conductance is of key importance in the uptake of POPs, although large uncertainties in the cuticular pathway prevents confirmation of this with any degree of certainty, and experimental data seems to show plant-side resistance to be important. Models are usually based on the assumption that POP uptake occurs through the lipophilic cuticle which covers aerial surfaces of plants. However, some authors have recently attached greater importance to the stomatal route of entry into the leaf for gas phase compounds. There is a need for greater mechanistic understanding of air-plant exchange and the 'scaling' of factors affecting it. The review also suggests a number of key variables that researchers should measure in their experiments to allow comparisons to be made between studies in order to improve our understanding of what causes any differences in measured data between sites.     

Treatment and detoxification of a sanitary landfill leachate

The leachate from an old sanitary landfill (Gramacho Metropolitan Landfill, Rio de Janeiro) was characterized and submitted to coagulation and flocculation treatment followed by ozonation and ammonia stripping. The performance of the treatment was assessed by monitoring the removal of organic matter (COD and TOC), ammonium nitrogen and metals. Detoxification was assessed by determining acute toxicity, using the following organisms: Vibrio fisheri, Daphnia similis, Artemia salina and Brachydanio rerio. Membrane fractionation was employed to infer the range of molecular masses of the pollutants found in the effluent, as well as the toxicity associated to these fractions. Of the techniques under investigation, coagulation and flocculation followed by ammonia stripping were the most effective for toxicity and ammonium nitrogen removal. Membrane fractionation was effective for COD removal; however, acute toxicity was almost the same in all the fractionated samples. Ozonation was moderately effective for COD removal, but significant toxicity removal was only attained when high ozone doses were used.     

Use of X-ray absorption imaging to examine heterogeneous diffusion in fractured crystalline rocks

Heterogeneous diffusion in different regions of a fractured granodiorite from Japan has been observed and measured through the use of X-ray absorption imaging. These regions include gouge-filled fractures, recrystallized fracture-filling material and hydrothermally altered matrix. With the X-ray absorption imaging technique, porosity, relative concentration, and relative mass of an iodine tracer were imaged in two dimensions with a sub-millimeter pixel size. Because portions of the samples analyzed have relatively low porosity values, imaging errors can potentially impact the results. For this reason, efforts were made to better understand and quantify this error. Based on the X-ray data, pore diffusion coefficients (Dp) for the different regions were estimated assuming a single diffusion rate and a lognormal multirate distribution of Dp. Results show Dp for the gouge-filled fractures are over an order of magnitude greater than those of the recrystallized fracture-filling material, which in turn is approximately two times greater than those for the altered matrix. The recrystallized fracture-filling material was found to exhibit the greatest degree of variability. The results of these experiments also provide evidence that diffusion from advective zones in fractures through the gouge-filled fractures and recrystallized fracture-filling material could increase the pore space available for matrix diffusion. This evidence is important for understanding the performance of potential nuclear waste repositories in crystalline rocks as diffusion is thought to be an important retardation mechanism for radionuclides.     

Droplet charging for wet scrubbers

Water droplet charge/mass of wet scrubbers was measured over the direct charging applied potential range of 0-20 kV, 30-70 pounds per square inch gauge (206.8-482.6 kPa) water pressure, and with spiral, impingement, and whirl nozzles. The measured charge/mass ranged from -0.0005 to 0.2 microcoulomb/gm and was directly related to the applied voltage. The water charge/mass was a function of the spray nozzle, with the smaller orifice lower-flow nozzles having the higher charge/mass.