Feasibility of incorporating waste grass clippings (Lolium perenne L.) in particleboard composites

This study investigated some of the important physical (thickness swelling) and mechanical (modulus of rupture, modulus of elasticity and internal bond) properties of single-layer particleboard panels made from eucalyptus (Eucalyptus camaldulensis Dehn.), waste of grass clippings (Lolium perenne L.) and combinations of the two. The chemical properties (pH, holocelluse and alpha cellulose contents, and water, alcohol-benzene and 1% sodium hydroxide solubilities) of the raw materials were also determined. Panels with a 6:94 ratio of grass-to-eucalyptus particles had the required mechanical properties for interior fitments including furniture and general uses. Boards manufactured with 100% grass clippings exhibited the lowest quality. The overall panel properties improved with a lower percentage of grass clippings added. Based on initial results, it also appears that grass should compose no more than 13% to achieve acceptable panel properties for interior fitments and general uses.     

Bench-scale composting of source-separated human faeces for sanitation

In urine-diverting toilets, urine and faeces are collected separately so that nutrient content can be recycled unmixed. Faeces should be sanitized before use in agriculture fields due to the presence of possible enteric pathogens. Composting of human faeces with food waste was evaluated as a possible method for this treatment. Temperatures were monitored in three 78-L wooden compost reactors fed with faeces-to-food waste substrates (F:FW) in wet weight ratios of 1:0, 3:1 and 1:1, which were observed for approximately 20 days. To achieve temperatures higher than 15 degrees C above ambient, insulation was required for the reactors. Use of 25-mm thick styrofoam insulation around the entire exterior of the compost reactors and turning of the compost twice a week resulted in sanitizing temperatures (>or=50 degrees C) to be maintained for 8 days in the F:FW=1:1 compost and for 4 days in the F:FW=3:1 compost. In these composts, a reduction of >3 log(10) for E. coli and >4 log(10) for Enterococcus spp. was achieved. The F:FW=1:0 compost, which did not maintain >or=50 degrees C for a sufficiently long period, was not sanitized, as the counts of E. coli and Enterococcus spp. increased between days 11 and 15. This research provides useful information on the design and operation of family-size compost units for the treatment of source-separated faeces and starchy food residues, most likely available amongst the less affluent rural/urban society in Uganda.     

Assessment of the status of municipal solid waste management in metro cities, state capitals, class I cities, and class II towns in India: an insight

Solid waste management is one of the most challenging issues in urban cities, which are facing a serious pollution problem due to the generation of huge quantities of solid waste. This paper presents an assessment of the existing situation of municipal solid waste management (MSWM) in major cities in India. The quantity and composition of MSW vary from place to place, and bear a rather consistent correlation with the average standard of living. Extensive field investigations were carried out for quantification, analysis of physical composition, and characterization of MSW in each of the identified cities. The MSW management status (per the MSW Rules, 2000) has also been assessed, and an action plan for better management has been formulated; both are presented in this paper. Studies carried out in 59 selected cities in India have revealed that there are many shortcomings in the existing practices used in managing the MSW. These shortcomings pertain mainly to inadequate manpower, financial resources, implements, and machinery required for effectively carrying out various activities for MSWM. To overcome the deficiencies in the existing MSWM systems, an indicative action plan has been presented incorporating strategies and guidelines. Based on this plan, municipal agencies can prepare specific action plans for their respective cities.     

Municipal solid waste management in Rasht City, Iran

Pollution and health risks generated by improper solid waste management are important issues concerning environmental management in developing countries. In most cities, the use of open dumps is common for the disposal of wastes, resulting in soil and water resource contamination by leachate in addition to odors and fires. Solid waste management infrastructure and services in developing countries are far from achieving basic standards in terms of hygiene and efficient collection and disposal. This paper presents an overview of current municipal solid waste management in Rasht city, Gilan Province, Iran, and provides recommendations for system improvement. The collected data of different MSW functional elements were based on data from questionnaires, visual observations of the authors, available reports and several interviews and meetings with responsible persons. Due to an increase in population and changes in lifestyle, the quantity and quality of MSW in Rasht city has changed. Lack of resources, infrastructure, suitable planning, leadership, and public awareness are the main challenges of MSW management of Rasht city. However, the present situation of solid waste management in this city, which generates more than 400tons/d, has been improved since the establishment of an organization responsible only for solid waste management. Source separation of wastes and construction of a composting plant are the two main activities of the Rasht Municipality in recent years.     

层次分析法在精细化工园区生态环境效益评价中的应用

介绍了杭州湾精细化工园区的概况;设计指标重要性专家打分表,依据指标得分构造了层次分析法的判断矩阵;运用层次分析法确定了精细化工园区生态环境效益评价指标体系中准则层和指标层的权重,进而依据指标权重分析r影响园区生态化改造的关键指标.结果表明,工业废水达标排放率、工业用水重复利用率、创新投入能力、染料行业单位产品新鲜水消耗量等指标是影响总目标的关键指标.     

A note on the effectiveness of the house-arrest alternative for motivating DWI offenders to install ignition interlocks

Introduction

The effectiveness of ignition interlocks at reducing drunk driving has been limited by the ability of driving-while-intoxicated (DWI) offenders to avoid court orders to install the devices.

Methods

In a pilot program in New Mexico, four Santa Fe County judges imposed home confinement (via electronic monitoring bracelets) on offenders who claimed to have no car or no intention to drive. Interlock installation rates for Santa Fe County were compared with all other counties in New Mexico over a 2-year program and 2-year post-program period.

Results

During the two program years, 70% of the drivers convicted of DWI in Santa Fe County installed interlocks, compared to only 17% in the other counties, but when the program was terminated, the Santa Fe installation rate fell by 18.8 percentage points.

Summary

Mandating the alternative sanction of house arrest led to the highest reported interlock installation rate for DWI offenders.

Impact on Industry

Impaired driving is a substantial expense to employers, particularly when it bars driving that interferes with employment. Interlocks provide a method of protecting the public while permitting the offender to drive sober. This study was directed at increasing interlock use by DWI offenders.     

Preferred modes of travel among older adults: What factors affect the choice to walk instead of drive?

Introduction

There are many factors that influence older adults' travel choices. This paper explores the associations between mode of travel choice for a short trip and older adults' personal characteristics.

Methods

This study included 406 drivers over the age of 64 who were enrolled in a large integrated health plan in the United States between 1991 and 2001. Bivariate analyses and generalized linear modeling were used to examine associations between choosing to walk or drive and respondents' self-reported general health, physical and functional abilities, and confidence in walking and driving.

Results

Having more confidence in their ability to walk versus drive increased an older adult's likelihood of walking to make a short trip by about 20% (PR = 1.22; 95% CI: 1.06-1.40), and walking for exercise increased the likelihood by about 50% (PR = 1.53; 95% CI = 1.22-1.91). Reporting fair or poor health decreased the likelihood of walking, as did cutting down on the amount of driving due to a physical problem.

Discussion

Factors affecting a person's decision to walk for exercise may not be the same as those that influence their decision to walk as a mode of travel. It is important to understand the barriers to walking for exercise and walking for travel to develop strategies to help older adults meet both their exercise and mobility needs. Impact on Industry: Increasing walking over driving among older adults may require programs that increase confidence in walking and encourage walking for exercise.     

Implications of turnover and trust for safety attitudes and behaviour in work teams

Turnover potentially leads to a new individual being selected into a work team. This study investigated the safety-specific trust which team members place in their organisation’s selection and induction processes, and related this to the perceived risk from new employees. The research was conducted with teams working in forest harvesting, an occupation which has high-turnover, high risk and a high accident rate. Results indicate that trust in induction processes was negatively correlated with perceived risk from a new employee. Team members also engaged in a number of safety ensuring behaviours when a new individual joined the team, and these were related to the level of perceived risk, and how much they cared about their team members’ safety. It is argued that trust in the safety-specific characteristics of an organisation’s selection and induction process may have negative consequences for safety.     

Injury and loss concentration by sinkings in fishing fleets

Sinkings of fishing vessels, when accompanied by human loss, are accidents which lead to a great social upheaval, especially in the local area where they occur. In order to avoid or reduce these accidents, national governments must include in their legislation for this sector the appropriate safety measures. These resources and their distribution must be assigned in accordance with the needs of the accidentality, this requiring a detailed knowledge of the concentration of accidentality of a country’s fishing sector. In this context, the aim of the present work is twofold: first, to formulate a methodology for the fishing sector of a country, allowing the inequalities in the concentration of sinking accidents to be analysed; and second, to apply this methodology to the Spanish fishing fleet. Thus, two indices are constructed per region and type of fishing, for two variables: fishermen and vessels. Results are obtained both for the concentration of accidents and the associated Lorenz curves. An increase in the inequality in the spatial and functional distribution of these accidents is verified.     

Measurement of charge transfer during filling and emptying FIBC

Filling and emptying normal FIBC (flexible intermediate bulk containers) in hazardous areas represents a high electrostatic ignition hazard. Manufacturers of FIBC have therefore designed different measures to reduce the ignition risks from static electricity. Depending on the measures applied FIBC are categorized into types A, B, C and D. End of 2005 a new international standard for testing type D FIBC has been published. Type D FIBC have now to be certified according to this standard. Since this standard requires comprehensive ignition testing on a test rig especially designed for this purpose, industry is looking for a simpler test method, which can be used for the development of new FIBC fabric and in production quality control. In the present paper it is attempted to apply the method of charge transfer measurement to assess the ignition probability of static discharged from FIBC during filling and emptying and to correlate the results with the ignition tests performed on the standard test rig.