水体富营养化综合水质模型及其应用研究

针对水体富营养化问题，探讨了一种多参数水体富营养化的水质生态模型（ＷＡＳＰ４）。在阐述其原理和计算方法的基础上结合汉江武汉段１９９２年性水华事件的实例进行水质模型，其特点是，不仅能够较好地模拟浮游植物的变化过程。而且能够提供发生水华问题的原因和生态机理的解释。     

SUFR系统活性污泥特性及稳定性研究

通过实验考察了SUFR系统中活性污泥的特性及进水COD浓度、SRT和停运对稳定性的影响。结果表明：SUFR系统的污泥颗粒直径多在0.7～0.9 mm之间,属于小颗粒污泥,污泥沉降性能良好;对氮、磷有较好的去除效果。SUFR系统氮的去除对SRT有一定的耐冲击负荷,但受进水COD的影响较大;磷的去除对进水COD和SRT有较好的冲击能力;系统在经过72 h停运后污泥沉降性、脱氮与除磷效果都有较大降低,但基本在1周内就可恢复。     

Bio-SR工艺去除硫化氢气体的研究

采用Bio-SR工艺,利用铁盐吸收与氧化亚铁硫杆菌的联合作用对H2S进行脱除实验。通过改进微生物的培养条件,减少了83.9%的沉淀量,一定程度上解决了挂膜后生物填料塔易堵塞的问题,保证了填料塔的连续运行。在实验选取工况下,硫化氢脱除率可达到98.4%以上,当吸收液中Fe3+浓度为5.5～6 g/L、H2S进气浓度为1 g/m3、通气量为0.08～0.12 m3/h时效果最佳,反应器可持续高效地运行。此外,对进气浓度、通气量与硫化氢去除率之间的相关性进行了进一步研究,其结果有利于反应器及运行参数的优化设计。     

粉煤灰合成分子筛及处理含氟废水的研究

实验利用工业废渣——循环流化床粉煤灰合成出较高结晶度的X型和P型分子筛,合成过程无须高温焙烧预处理.通过XRD分析表征,发现该法合成分子筛结晶度较高,X型和P型分子筛相对结晶度分别达68%～75%和55%.实验应用合成分子筛进行载铁改性,并对NaF模拟的工业含氟废水进行了除氟实验.结果表明,载铁X型分子筛处理工业含氟废水效果良好,除氟率可达74%～98%,除氟容量达25.0～30.0 mg/g.在处理含氟废水过程中,载铁合成分子筛与其他除氟剂相比较,具有除氟率高、除氟容量大、反应迅速的特点.     

Fluoride removal performance of a novel Fe-Al-Ce trimetal oxide adsorbent

A trimetal oxide was developed as a fluoride adsorbent by coprecipitation of Fe(II), Al(III) and Ce(IV) salt solutions with a molar ratio of 1:4:1 under alkaline condition. The material retained amorphous structure and maintained relatively stable fluoride adsorption performance at calcination temperatures lower than 600 degrees C. The optimum pH range for fluoride adsorption was 6.0-6.5 and the adsorbent also showed high defluoridation ability around pH 5.5-7.0, which is preferable for actual application. A high fluoride adsorption capacity of 178 mg g(-1) was acquired under an equilibrium fluoride concentration of 84.5 mg l(-1), adsorbent dose of 150 mg l(-1) and pH 7.0. The adsorption isotherm could be better described by the two-site Langmuir model than the one-site model, suggesting the existence of two types of active sites on the adsorbent surface. Coexistence of high concentrations of phosphate or arsenate only led to partial inhibition of fluoride adsorption, which further suggests the existence of heterogeneous adsorption sites. Sulfate and chloride did not affect fluoride adsorption, and nitrate influenced it only when the concentration of NO(3)(-)-N exceeded 50 mg l(-1). A high desorption efficiency of 97% was achieved by treating fluoride loaded Fe-Al-Ce oxide with NaOH solution at pH 12.2. A column experiment using the adsorbent fabricated into 1mm pellets was performed at an initial fluoride concentration of 5.5 mg l(-1), space velocity of 5h(-1) and pH of 5.8, and 2240 bed volumes were treated with the effluent fluoride under 1.0 mg l(-1).     

Determination of benzene, toluene, ethylbenzene, xylenes in water at sub-ng l-1 levels by solid-phase microextraction coupled to cryo-trap gas chromatography-mass spectrometry

A trace analytical method of benzene, toluene, ethylbenzene and xylenes (BTEX) in water has been developed by using headspace solid-phase microextraction (HS-SPME) coupled to cryo-trap gas chromatography-mass spectrometry (GC-MS). The chromatographic peak shape for BTEX was improved by using cryo-trap equipment. The HS-SPME experimental procedures to extract BTEX from water were optimized with a 75 microm carboxen/polydimethylsiloxane (CAR/PDMS)-coated fiber at a sodium chloride concentration of 267 g l(-1), extraction for 15 min at 25 degrees C and desorption at 290 degrees C for 2 min. Good linearity was verified in a range of 0.0001-50 microg l(-1) for each analyte (r(2)=0.996-0.999). The limits of detection (LODs) of BTEX in water reached at sub-ng l(-1) levels. LODs of benzene, toluene, ethylbenzene, m/p-xylene and o-xylene were 0.04, 0.02, 0.05, 0.01 and 0.02 ng l(-1), respectively. The proposed analytical method was successfully used for the quantification of trace BTEX in ground water. The results indicate that HS-SPME coupled to cryo-trap GC-MS is an effective tool for analysis of BTEX in water samples at the sub-ng l(-1) level.     

2种改良土壤渗滤系统对降雨径流中氮的去除

为研究改良土壤渗滤系统对降雨径流中不同形态氮(NH4+-N,NO3--N,NO2--N,TN)的去除效果及径流中氮负荷对氮去除率的影响,实验分别以聚氨酯泡沫和人工草皮为改良材料,以降雨径流中的氮为处理对象进行室内模拟研究。结果表明,聚氨酯泡沫土壤渗滤系统及草皮土壤渗滤系统对TN,NH4+-N均具有较好的净化效果,并表现出良好的耐冲击负荷能力。TN平均去除率分别为72.65%和71.07%,NH4+-N平均去除率分别为98.10%和99.09%。2种渗滤系统对NO3--N去除效果均较差,表现为-420.07%和-171.66%的负去除率。聚氨酯泡沫土壤渗滤系统对NO2--N的平均去除率为87.29%,高于草皮土壤渗滤系统53.77%的平均去除率。总体上,聚氨酯泡沫土壤渗滤系统对径流中氮的去除效果优于草皮土壤渗滤系统,具有较好的应用前景。     

Rheology,Morphology, Crystallization Behaviors,Mechanical and Thermal Properties of Poly(lactic acid)/Polypropylene/Maleic Anhydride-Grafted Polypropylene Blends

The rheologies, morphologies, crystallization behaviors, mechanical and thermal properties of poly(lactic acid) (PLA)/polypropylene (PP) blends and PLA/PP/maleic anhydride-grafted PP (MAPP) blends were investigated. The results showed that the complex viscosities of PLA/PP blends were between those of neat PLA and neat PP, and MAPP had a thinning effect on those of the blends. PLA/PP blends exhibited the distinct phase separation morphologies due to the limited partial miscibility of the blend components. MAPP slightly improved the miscibility between PLA and PP. Both the cold crystallization of PLA component and melt crystallization of PP component were enhanced, probably because PLA and PP were reciprocal nucleating agents. The tensile strength and flexural modulus decreased, while the tensile strain at break and heat deflection temperature (HDT) increased with the increasing PP content. MAPP had the positive effects on the notched impact strength and HDT of PLA-rich blends and also increased the flexural modulus of the binary blends. The thermal stability of the blend was improved by PP, and the incorporation of MAPP further enhanced the thermal stability.     

农用地土壤重金属生态安全阈值确定方法的研究进展

农用地土壤重金属生态安全阈值作为农用地土壤环境质量基准制定的重要依据,近年来随着多学科的共同发展,农用地土壤重金属生态安全阈值的确定方法变得越来越完善,但目前对其的研究综述却鲜见报道。因此,文章综述了农用地土壤重金属生态安全阈值的确定方法,详细阐述了点模型、概率模型以及经验模型中的代表方法在确定农用地土壤重金属生态安全阈值方面的概念、原理、发展及应用,并深入探讨了各方法的适用情况和优缺点,系统分析了各方法在确定农用地土壤重金属生态安全阈值时的不确定性及影响因素,最后在前人的研究基础上提出了今后的主要发展方向,以期为我国农用地土壤环境质量标准的完善与细化及农用地土壤其他污染物生态安全阈值的确定提供参考依据。     

提高静电除尘器粉尘驱进速度方法研究

由Deutsch公式可知,尘粒驱进速度的大小直接决定着电除尘器除尘效率的高低。从提高驱进速度的角度入手,通过分析影响电除尘器除尘效率的主要因素与驱进速度的关系,得出提高电除尘器除尘效率的方法,为设计合理、高效、节能的静电除尘器提供指导。