The effect of certain intrinsic and extrinsic variables on the acute toxicity of selected organophosphorus insecticides to the mummichog,Fundulus heteroclitus

Abstract

The acute toxicity of two organophosphorus (OP) insecticides, azinphosmethyl and acephate, was evaluated in the mummichog, Fundulus heteroclitus. In addition, the effects of certain intrinsic (sex) and extrinsic (salinity and multiple toxicant interraction) variables on the toxic response were also investigated. Azinphosmethyl was by far the most toxic of the two OP insecticides with a 96h LC50 ～ 100,000 x lower than that for acephate. Slight sex differences were observed in the sensitivity of mummichogs to each of the OP insecticides with male fish being marginally more sensitive. Significant effects of low salinity stress were observed only with acephate exposure and, in this case, low salinity appeared to be slightly protective. In general, all of the insecticide mixtures (azinphosmethyl/endosulfan, azinphosmethyl/fenvalerate and acephate/fenvalerate) tested exhibited simple additive toxicity.     

Minimizing drift and exposure from knapsack sprayers

Abstract

An improved drift shield for attaching to the lance of conventional knapsack sprayer to reduce wind induced drift and operator exposure was designed and tested. The drift shield consists of a conical wire frame covered with polythene and has an annular opening at the point of attachment to the lance which allows air to be drawn into the shield while spraying. Tests conducted with winds in the range of 1.25–5.75 m/s show that wind can increase the width of spray swath from an unshielded lance, up to 4.3 times the normal swath in no‐wind condition. Use of a conventional shield contained the swath width within 3.5 times and the improved shield restricted the swath width to 3.1 times the normal swath. Spray deposit from an unshielded lance, within the normal swath decreased to as low as 45%, due to wind effects. However, use of the conventional, and the improved shields enhanced the spray deposit to 54.2% and 68%, respectively. The improved drift shield improved the spray pattern displacement (SPD) significantly (P<0.05) compared with the conventional shield and the unshielded lance when the wind speed exceeded 1.25 m/s. The improved shield decreased the off target drift by as much as 63% compared with the unshielded spray. It also decreased the quantity of pesticide deposit on the operator's body by 41–84% and thereby reduced exposure and improved safety.     

Microwave extraction of incurred salinomycin from chicken tissues

Abstract

A rapid, accurate, environmentally friendly and cost‐effective microwave extraction technique was developed for the extraction of spiked and incurred salmomycin from chicken tissues (kidney, liver, muscle, ovarian yolk and fat). Extraction of salinomycin from various tissues was achieved by irradiating the sample in absolute ethanol and 2‐propanol (15+2) for 9 sec. in a common household microwave oven. The extract was analysed without further cleanup by HPLC on a C₁₈ column (5 μm) and detected at 592 nm via post‐column reaction with 4‐dimethylaminobenzaldehyde (DMABA) in a heated reactor coil at 86° C. Recoveries of salinomycin from spiked tissues at 30 ng/g level ranged between 87 and 100%. The limit of quantitation was found to be 10 ng/g. The developed method was applied for the analysis of incurred tissues and ovarian yolk of laying chickens given sodium salinomycin in feed at different levels for 14 consecutive days followed by withdrawal periods. Residues were detected in all tissues and ovarian yolk at 0 withdrawal time but declined during the withdrawal period. Highest residue were found in fat and ovarian yolk.     

Interactions Between Potassium and Sulfur Species in a Coal-Fired Magnetohydrodynamics System

The interactions between potassium and sulfur-containing species are unique, yet important, phenomena for a coal-fired magnetohydrodynamics (MHD) system. An in-depth understanding of such phenomena will help in the future design of MHD systems. This paper deals with the modeling of potassium and sulfur interactions in DOE's Coal-Fired Flow Facility (CFFF), located in Tullahoma, Tennessee.     

Hydrocarbon Measurements During the 1992 Southern Oxidants Study Atlanta Intensive: Protocol and Quality Assurance

Abstract

A major component of the Southern Oxidants Study (SOS) 1992 Atlanta Intensive was the measurement of atmospheric nonmethane hydrocarbons. Ambient air samples were collected and analyzed by a network of strategically located automated gas chromatography (GC) systems (field systems). In addition, an extensive canister sampling network was deployed. Combined, more than 3000 chromatograms were recorded. The SOS science team targeted for quantitative analysis 56 compounds which may be substantial contributors to ozone formation or used as air mass tracers. A quality assurance program was instituted to ensure that good measurements were being made throughout the network for each target compound. Common, high-quality standards were used throughout the network. The performance of individual field systems was evaluated during the intensive through the analysis of challenge mixtures. This methodology helped to identify and correct analytical problems as they arose.     

Application of a Three-Layer Photochemical Box Model in an Athens Street Canyon

ABSTRACT

The aim of this paper is to show that a photochemical box model could describe the air pollution diurnal profiles within a typical street canyon in the city of Athens. As sophisticated three-dimensional dispersion models are computationally expensive and they cannot serve to simulate pollution levels in the scale of an urban street canyon, a suitably modified three-layer photochemical box model was applied. A street canyon of Athens with heavy traffic was chosen to apply the aforementioned model. The model was used to calculate pollutant concentrations during two days with meteorological conditions favoring pollutant accumulation. Road traffic emissions were calculated based on existing traffic load measurements. Meteorological data, as well as various pollutant concentrations, in order to compare with the model results, were provided by available measurements. The calculated concentrations were found to be in good agreement with measured concentration levels and show that, when traffic load and traffic composition data are available, this model can be used to predict pollution episodes. It is noteworthy that high concentrations persisted, even after additional traffic restriction measures were taken on the second day because of the high pollution levels.     

Feasibility of Applying a Stable Isotopic Tracer for Direct Determination of Dry Particulate Deposition to Soybean Plants

ABSTRACT

A stable rare-earth isotopic tracer was used to measure the deposition of KNO₃ particles on soybean leaves by direct measurement of the tracer on the plant surfaces by thermal-ionization mass spectrometry. Submicrometer particles, made from a solution containing 3 |mg mL^-1 neodymium isotope (¹⁴⁸Nd, 87.9%) and 1,000 mg mL^-1 KNO₃, were dispersed with a two-fluid nozzle and released upwind of a soybean field. Total suspended- and size-fractionated-aerosol particles were collected on an open-face filter and in a micro-orifice impactor, respectively, at a distance of 40 m from the release point. Soybean leaves exposed to the plume were collected at distances ranging from 25 to 100 m. As little as 5.5 pg of the tracer (i.e., excess ¹⁴⁸Nd) was detected in soybean leaves at signal-to-noise ratios ranging from 7,500 to 240,000, in the presence of 200 to 2,700 pg of naturally occurring Nd. The dry-particle deposition velocity, determined from the ratio of the aerial concentration and directly deposited aerosol (geometric mass mean diameter, 0.20 mm) flux, and its corresponding analytical uncertainty were 0.30 cm sec^-1 and 2.5%, respectively.     

Variation of the Relative Humidity of Air Released from Canisters after Ambient Sampling

ABSTRACT

Dalton's law of partial pressures and the hypothesis that water vapor equilibrium in a canister is identical to that established above liquid water are used to predict the variation of the percent relative humidity (%RH) of air released from canisters used in ambient air sampling, typically 6-L canisters pressurized with 18 L of air. When (and if) the water vapor partial pressure in a canister exceeds its saturation vapor pressure, water vapor condensation begins and the condensation rate equals the sampling rate of water vapor into the canister. Under constant temperature conditions, the air subsequently released from the canister is less humid than the original sample, following the relationship %RH = 100% (6 L/V_s) for V_s> V_r, where V_s is the residual air volume (referenced to atmospheric pressure), and V_r is shown to depend on the %RH of the ambient air sample. V_r is the residual air volume at which water is completely removed (except for adsorbed water vapor) from the canister wall. For V_s < V_r, the predicted %RH is constant and equal to its value at V_r. Experimental values agree reasonably well with predictions at both high (90%) and low (34%) RH. However, experimental values are often slightly displaced (usually towards lower values of %RH) for mid-range %RH (61%) and variations in %RH near V_r change from canister to canister.     

Estimating Maximum Concentrations for Open Path Monitoring Along a Fixed Beam Path

ABSTRACT

Researchers have applied open path optical sensing techniques to a variety of workplace and environmental monitoring problems. Usually these data are reported in terms of a path-average (or path-integrated) concentration. When assessing potential human exposures along a beam path, this path-average value is not always informative, since concentrations along the path can vary substantially from the beam average. The focus of this research is to arrive at a method for estimating the upper-bound in contaminant concentrations over a fixed open beam path. The approach taken here uses a statistical model to estimate an upper-bound concentration based on a combination of the path-average and a measure of the spatial variability computed from point samples along the beam path. Results of computer simulations and experimental testing in a controlled ventilation chamber indicate that the model produced conservative estimates for the maximum concentration along the beam path. This approach may have many applications for open path monitoring in workplaces or wherever maximum concentrations are a concern.