Mathematical Modeling of Photochemical Smog Using the PICK Method

A new method for solving the turbulent atmospheric diffusion equation has been developed based on Lagrangian mass points, or particles moving through an Eulerian grid. The method is one of a family of Particle-/n-Cell techniques but is a unique extension to incorporate the effects of turbulent diffusion based on K-theory; thus the acronym PICK.

In the three-dimensional computer-aided model, NEXUS (Numerical EXamination of Urban Smog), this method has been applied to simulation of carbon monoxide (CO) in Los Angeles. For CO the NEXUS simulation was within 20% of observed day-averaged concentrations at 12 stations and the hour-averages were also in good agreement. This model was extended to include the effects of photochemical smog in Los Angeles. The results of the photochemical simulation were also qualitatively correct due to rapid NO to NO₂ conversion in the simulation.     

Emissions from Slash Burning and the Influence of Flame Retardant Chemicals

Pollutants sampled during the burning of 30 lb ponderosa pine fuel beds yielded emission factors for CO, hydrocarbon gases, and par-ticulate matter of 146, 8.4, and 9.1 lb/ton of fuel, respectively. When similar beds were treated with diammonium phosphate flame retardant, these factors increased to 166, 11.7, and 19.3 lb/ton of fuel, respectively.

Gas chromatographic analysis of hydrocarbon gases showed that 15-40% of this material was composed of methane and eth-ylene. Ethane and acetylene were the next most abundant materials, with photochemically important materials constituting minor portions of this gaseous component. Fuel beds treated with flame retardant produced more oiefins, and this production lasted throughout the smoldering phase of burning.

These tests showed that the smoldering phase of combustion is of major importance to air pollutant production during slash burning. The initial 80% of the fuel burned accounted for only 20-30% of HC and CO emissions. This suggests that a rapid mop-up of slash burns could substantially reduce air pollutant production.     

Improvement of Ambient Sulfur Dioxide Concentrations by Conversion from Low to High Stacks

A study of the “before” and “after” ground-level S0₂ concentrations near the Muskingum River Plant of the American Electric Power System shows that the conversion from low to high stacks has accomplished marked reductions in ambient concentrations. These reductions are in reasonable agreement with theoretical calculations and are most apparent within 5 km of the source. EPA Standards are now being met in this area despite the presence of the 1440 MW power plant burning 5% sulfur fuel with no treatment of the stack gas.     

A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.     

Flow Patterns Upstream of Isokinetic Dust Sampling Probes

In isokinetic sampling from a gas stream it is usually assumed that the flow pattern upstream of the sampling probe is not affected by the presence of the probe. That some probes do seriously affect the gas streamlines is shown by velocity traverses taken with a hot wire anemometer under controlled flow conditions in a wind tunnel. The degree to v/hich the streamlines are affected depends on the wall thickness and taper of the nozzle, the stem diameter, as well as on the size and proximity of sampling accessories in the vicinity of the nozzle. For a probe to cause negligible disturbance under isokinetic conditions it should have a sharp-edged nozzle with little or no outside bevel, and the stem of the probe should be at least 11 stem diameters downstream from the nozzle inlet.     

R&D Activities,Operating Experience Discussed at Fabric Alternatives Forum

ABSTRACT

Previously reported volatile organic compounds (VOC) radiocarbon (¹⁴C) measurements for 1992 summertime Atlanta, GA, have been compared with chromatographic data and emissions inventory predictions. The chromatographic approach that was used provided a more comprehensive VOC characterization than typically achieved, and the emissions inventory was research-grade level (date-, site-, and time-specific). The comparisons are in general agreement that biogenic emissions contribute only modestly (<10%) to the VOC content of the particular ambient samples that were collected and measured. The choices of sampling site (near city-center) and times (early morning and late evening) are major influences on the results, which consequently should not be regarded as representing the average VOC biogenic impact for the Atlanta area.     

Technique for Measuring the Total Concentration of Gaseous Fixed Nitrogen Species

This paper reports the development of a rapid, continuous technique for analyzing fixed nitrogen species (NH₃, HCN, CH₃NH₂, etc.). The technique uses a platinum catalyst at low pressure in combination with a conventional chemiluminescent NO _x analyzer. Previous workers observed that conventional stainless steel catalysts, and platinum catalysts operated at atmospheric pressure, do not reliably convert NH₃ to NO. The most serious problem was the variation in the efficiency of these catalysts with operating conditions. Changes in temperature, gas composition, or X_NH3 could change the conversion efficiency from 99.9% to <30%. The new conversion technique, however, is quantitative up to several thousand ppm NH₃ in either O₂/He or O₂/CO₂/N₂.     

experience of the forest products industry in obtaining air quality permits for new and modified sources

A detailed study of the air quality permitting process for 65 different forest products industry projects requiring preconstruction permit approvals from EPA, state, and local air pollution control agencies was conducted. The projects included a wide array of sources including kraft recovery furnaces, lime kilns, fossil fuel and wood residue fired boilers, solid wood products manufacturing facilities, paper coaters, and printing presses. Information concerning the time involved in the permitting process, costs associated with obtaining the permits, use of air quality models and ambient monitoring data, emission control technology determinations, problem areas encountered during the permitting process, perceived benefits and drawbacks of the permitting process, and the effect of permitting requirements on project planning was obtained.

The results indicate that certain permitting requirements such as Best Available Control Technology (BACT) determinations, dispersion modeling results, and use of ambient air quality monitoring data seldom influence the emission limitations ultimately imposed in the final approved permit, with 87% of the final emission limits equivalent to the applicable New Source Performance Standard (NSPS). The 65 permitting case histories also show that obtaining permits for projects subject to Prevention of Significant Deterioration (PSD) requirements takes approximately twice as long and costs twice as much as obtaining permits for projects not subject to PSD requirements.