Solid waste management planning for sub-district scale: a case study in Buleleng sub-district,Buleleng district,Bali province,Indonesia

Journal of Material Cycles and Waste Management - This study aims to identify the amount of solid waste generation, composition, and characteristics of the Buleleng sub-district waste. The results...     

Photocatalytic degradation of chlorophenols using Ru(bpy) 3 2+ /S2O 8 2−

Advanced oxidation processes, such as photocatalysed oxidation, provide an important route for degradation of wastes. In this study, the lowest excited state (³MLCT) of Ru(bpy)₃²⁺ is used to break down chlorophenol pollutant molecules to harmless products. This has the advantage of using visible light and a short-lived catalytically active species. Photolysis of deaerated aqueous solutions of a variety of mono- and poly-substituted chlorophenols has been followed in the presence of Ru(bpy)₃²⁺/S₂O₈²⁻ with near visible light (λ > 350 nm) by UV/visible absorption spectroscopy, luminescence, potentiometry, NMR and HPLC techniques. Upon irradiation, a decrease is observed in the chlorophenol concentration, accompanied by the formation of Cl⁻, H⁺ and SO₄²⁻ ions as the main inorganic products. Benzoquinone, phenol, dihydroxybenzenes and chlorinated compounds were the dominant organic products. As the ruthenium(II) complex is regenerated in the reaction, the scheme corresponds to an overall catalytic process. The kinetics of the rapid chlorophenol photodechlorination has been studied, and are described quite well by pseudo-first order behaviour. Further studies on this were made by following Cl⁻ release with respect to the initial Ru(bpy)₃²⁺ and S₂O₈²⁻ concentrations. A comparison is presented of the photodechlorination reactivity of the mono and polychlorophenols studied at acidic and alkaline pH.     

Three party symbiosis: acoelomorph worms,corals and unicellular algal symbionts in Eilat (Red Sea)

Epizoic worms were found to occur on certain coral colonies from reefs off the coast of Eilat (Red Sea). We identified 14 coral species infested by acoelomorph worms at a depth range of 2–50 m. The host corals were all zooxanthellate and included both massive and branching stony corals and a soft coral. Worms from all hosts were identified as belonging to the genus Waminoa and contained two distinct algal symbionts differing in size. The smaller one was identified as Symbiodinium sp. and the larger one is presumed to belong to the genus Amphidinium. Worm-infested colonies of the soft coral, Stereonephthya cundabiluensis, lacked a mucus layer and exhibited distinct cell microvilli, a phenotype not present in colonies lacking Waminoa sp. In most cases, both cnidarian and Acoelomorph hosts displayed high specificity for genetically distinctive Symbiodinium spp. These observations show that the epizoic worms do not acquire their symbionts from the “host” coral.     

Sampling design trade-offs in occupancy studies with imperfect detection: examples and software.

Researchers have used occupancy, or probability of occupancy, as a response or state variable in a variety of studies (e.g., habitat modeling), and occupancy is increasingly favored by numerous state, federal, and international agencies engaged in monitoring programs. Recent advances in estimation methods have emphasized that reliable inferences can be made from these types of studies if detection and occupancy probabilities are simultaneously estimated. The need for temporal replication at sampled sites to estimate detection probability creates a trade-off between spatial replication (number of sample sites distributed within the area of interest/inference) and temporal replication (number of repeated surveys at each site). Here, we discuss a suite of questions commonly encountered during the design phase of occupancy studies, and we describe software (program GENPRES) developed to allow investigators to easily explore design trade-offs focused on particularities of their study system and sampling limitations. We illustrate the utility of program GENPRES using an amphibian example from Greater Yellowstone National Park, U.S.A.     

Patterns of houses and habitat loss from 1937 to 1999 in northern Wisconsin, USA.

Rural America is witnessing widespread housing development, which is to the detriment of the environment. It has been suggested to cluster houses so that their disturbance zones overlap and thus cause less habitat loss than is the case for dispersed development. Clustering houses makes intuitive sense, but few empirical studies have quantified the spatial pattern of houses in real landscapes, assessed changes in their patterns over time, and quantified the resulting habitat loss. We addressed three basic questions: (1) What are the spatial patterns of houses and how do they change over time; (2) How much habitat is lost due to houses, and how is this affected by spatial pattern of houses; and (3) What type of habitat is most affected by housing development. We mapped 27 419 houses from aerial photos for five time periods in 17 townships in northern Wisconsin and calculated the terrestrial land area remaining after buffering each house using 100- and 500-m disturbance zones. The number of houses increased by 353% between 1937 and 1999. Ripley's K test showed that houses were significantly clustered at all time periods and at all scales. Due to the clustering, the rate at which habitat was lost (176% and 55% for 100- and 500-m buffers, respectively) was substantially lower than housing growth rates, and most land area was undisturbed (95% and 61% for 100-m and 500-m buffers, respectively). Houses were strongly clustered within 100 m of lakes. Habitat loss was lowest in wetlands but reached up to 60% in deciduous forests. Our results are encouraging in that clustered development is common in northern Wisconsin, and habitat loss is thus limited. However, the concentration of development along lakeshores causes concern, because these may be critical habitats for many species. Conservation goals can only be met if policies promote clustered development and simultaneously steer development away from sensitive ecosystems.     

超高效液相色谱法测定土壤中微量阿特拉津

采用超高效液相色谱仪,建立了土壤中微量阿特拉津的快速检测方法.研究结果表明:采用反相C18色谱柱,以甲醇/水(70:30,v/v)为流动相,流速为0.2 ml/min,柱温为30℃,检测波长为220 nm条件下,在12.5～1000μg/L质量浓度范围内线性关系良好(r=0.9999),检出限0.18×10-3 mg/...     

Fiscal spending and the environment: Theory and empirics

During economic crises, governments often increase fiscal spending to stimulate the economy. While the fiscal spending surge may be temporary, spending composition is often altered in favor of expenditures on social programs and other public goods which may persist over time. We model and measure the impact of fiscal spending patterns on the environment. The model predicts that a reallocation of government spending composition towards social and public goods reduces pollution. However, increasing total government spending without altering its composition does not reduce pollution. We empirically test these predictions for air and water pollutants showing that they are fully supported.     

Foraging behaviour of larval cod (<Emphasis Type="Italic">Gadus morhua</Emphasis>) at low light intensities

The ability to forage at low light intensities can be of great importance for the survival of fish larvae in a pelagic environment. Three-dimensional silhouette imaging was used to observe larval cod foraging and swimming behaviour at three light intensities (dusk ~1.36 × 10⁻³ W/m², night ~1.38 × 10⁻⁴ W/m² and darkness ~3.67 × 10⁻⁶ W/m²) at 4 different ages from 6 to 53 days post-hatch (dph). At 6 dph, active pursuit of prey was only observed under dusk conditions. Attacks, and frequent orientations, were observed from 26 dph under night conditions. This was consistent with swimming behaviour which suggested that turn angles were the same under dusk and night conditions, but lower in darkness. Cod at 53 dph attacked prey in darkness and turn angles were not different from those under other light conditions. This suggests that larvae are still able to feed at light intensities of 3.67 × 10⁻⁶ W/m². We conclude that larval cod can maintain foraging behaviour under light intensities that correspond to night-time at depths at which they are observed in the field, at least if they encounter high-density patches of prey such as those that they would encounter at thin layers or fronts.     

Cement industry: sustainability, challenges and perspectives

Cement-based materials, such as concrete and mortars, are used in extremely large amounts. For instance, in 2009 concrete production was superior to 10 billion tons. Cement plays an important role in terms of economic and social relevance since it is fundamental to build and improve infrastructure. On the other hand, this industry is also a heavy polluter. Cement production releases 5–6% of all carbon dioxide generated by human activities, accounting for about 4% of global warming. It can release huge amounts of persistent organic pollutants, such as dioxins and heavy metals and particles. Energy consumption is also considerable. Cement production use approximately 0.6% of all energy produced in the United States. On the other hand, the chemistry underlying cement production and its applications can be very helpful to overcome these environmental issues. In terms of manufacture, there are many alternative materials that can be used to minimize carbon dioxide production and reduce energy consumption, such as calcium sulfoaluminates and β-Ca₂SiO₄—rich cements. Using residues from other industrial sectors can also improve the sustainability of cement industry. Under adequate conditions, waste materials such as tyres, oils, municipal solid waste and solvents can be used as supplementary fuel in cement plants. Concrete can be used for encapsulation of waste materials such as tyres, plastics and glasses. In this review, we discuss some aspects of the cement industry associated with environmental science. Other issues such as economic aspects, the chemistry of cement manufacture and its properties are also presented. Special attention is given to the role that cement chemistry can play in terms of sustainability. The most relevant aspects are outlined, such as the use of alternative materials, new possibilities and also the recycling of materials. It is also argued that an important aspect is the role of research and development necessary to improve cement sustainability.     

Deterministic approach to the study of the interaction predator-prey in a chemostat with predator mutual interference. Implications for the paradox of enrichment

Our understanding of predator-prey systems has progressed in recent decades mainly due to the ability to test models in chemostats. This study aimed to develop a deterministic model using differential equations to reproduce the dynamics of the interaction of a predator and a prey in a two stage chemostat focusing in the proposed previous prey dependent model of Fussmann et al. (2000) [Fussmann, G.F., Ellner, S.P., Shertzer, K.W., Hairston Jr., N.G., 2000. Crossing the Hopf bifurcation in a live predator-prey system. Science 290, 1358-1360]. The main problem with that model, but parameterized with the values obtained in this study (particularly the concentration of nutrient), was that the temporal trajectory of both the prey and the predator showed very high peaks that eventually led to the extinction of predator in all cases. In the same way the experimental time series obtained in this study does not exhibit the behavior predicted by the model of Fussman et al. On the contrary, as prey density increases, the system actually becomes more stable. Finally, the model that best explained the behavior of the predator and prey in the chemostat, at medium to high dilution rates, was the ratio dependent (algae-nitrogen) model with mutual interference measured in the chemostat (rotifer-alga) and that incorporated the age structure of the predator. Qualitative analysis of the dynamic behavior enabled evaluation of coexistence at equilibrium, coexistence on limit cycles, extinction of the predator or extinction of both populations.