A GPS-based system for recording the flight paths of birds

 The GPS recorder consists of a GPS receiver board, a logging facility, an antenna, a power supply, a DC-DC converter and a casing. Currently, it has a weight of 33 g. The recorder works reliably with a sampling rate of 1/s and with an operation time of about 3 h, providing time-indexed data on geographic positions and ground speed. The data are downloaded when the animal is recaptured. Prototypes were tested on homing pigeons. The records of complete flight paths with surprising details illustrate the potential of this new method that can be used on a variety of medium-sized and large vertebrates. Received: 2 February 2000 / Accepted in revised form: 17 April 2000     

Investigation on organic pollutants from a domestic heating system using various solid biofuels

Various herbaceous biofuels (straw, whole plant cereals and set aside hay) and spruce wood were tested for their potential to form PCDD/F, PCPh, PCBz and PAH during combustion. The trials were conducted in an automatically charged multi-fuel furnace for domestic applications (50 kWth). Both, flue gas and the different ash fractions were analysed. CO-emission results show, that combustion conditions were relatively uniform (mean CO-level: 200 mg/m3 at 13% O2 in flue gas). Likewise, the TOC- and PAH-emissions in the fuel gas remained constantly on a relatively low level. However, for the PCDD/F, PCPh and PCBz increased emissions were detected when herbacious fuels were applied. This may be attributed to their higher chlorine concentration and the high ash content, which is responsible for increased dust emissions during combustion. Similar observations were also found for the PCDD/F-concentrations in the ashes. Combustion chamber ashes usually showed a drastically reduced contamination with highly toxical compounds, compared to the ash fraction from the heat exchanger ash or to chimney soot.     

Application of a purge and trap TDS-GC/MS procedure for the determination of emissions from flame retarded polymers

Emissions of volatile organic compounds (VOCs) from different thermoplastic polymers used in electrotechnical applications were investigated using a purge and trap procedure that involved adsorption on Tenax GR. Results were compared to those for an operating TV set monitored in a test chamber. The analyses were in both cases carried out using thermodesorption gas chromatography with mass spectrometric detection (TDS-GC/MS). Substances identified were monomers, volatile additives, or related compounds. Special attention was given to the detection of halogenated compounds. Their origin was studied using reference samples and synthetic standards.     

Application of a stochastic, Weibull probability generator for replacing missing data on ambient concentrations of gaseous pollutants

A stochastic, three-parameter, Weibull frequency distribution, probability generator was tested by using theoretical data. Subsequently, it was applied to replace missing values of hourly atmospheric concentrations of trace gases that were continuously monitored at three study sites, for 2 years. The results were highly accurate and realistic. The cumulative means and the medians calculated by the Weibull method were intermediate between corresponding values calculated by uniform substitution of missing values with 'zero' or with half of the minimum detection limit of the appropriate measurement instrument used. Furthermore, the Weibull method allowed the replacement of as many as 100 missing values on either side of a measured data sub-set, without altering the overall characteristics of the true frequency distribution of the entire data set.     

What is the potential measurement error in occupational exposure studies?

This paper demonstrates statistical methods that estimate measurement error from available industrial hygiene data. Errors in measuring a continuous exposure variable may arise when all individuals in a work area are assigned the same exposure. An example is when the mean of exposure measurements obtained on a sample of individuals is assigned to all workers with similar jobs. This may lead to inaccurate point and interval estimates in exposure-response modeling. A method of simulating the distribution of true (i.e., unobserved) individual exposures is described in order to estimate the mean and variance of measurement error. The minimum variance unbiased estimator approximates the mean of lognormally distributed exposure measurements. The distribution of true individual exposures is approximated by the distribution of simulated estimates of mean exposure. The methodology is illustrated by exposure data from work areas manufacturing refractory ceramic fiber (RCF) and RCF products. Results show that exposure is slightly underestimated in work areas with between 25 and 113 exposure measurements; measurement error variance averages about 1.3% of the total variance.     

Study of Fatigue Life and Filler Interaction of Paper Sludge Filled Epoxidized Natural Rubber (ENR) and Maleated Natural Rubber (MNR) Composites

An investigation on the effect of epoxidation and maleated natural rubber (MNR) on fatigue and rubber-filler interaction properties of paper sludge filled natural rubber composites was elucidated. Paper sludge loading was varied from 0 to 40 phr and conventional vulcanisation system was used while compounding was carried out on a laboratory sized two roll mill. Two different types of natural rubber, SMR L and ENR 50 having 0 and 50 mole% of epoxidation were used in order to investigate the effect of epoxidation on the composites. Results indicate that, at a fixed filler loading, ENR 50 vulcanizates exhibit higher fatigue life than SMR L vulcanizates especially at filler loading below 20 phr which might be associated with better rubber-filler interaction. In the case of composites with the addition of maleated natural rubber (MNR), a higher fatigue life was observed due to presence of physical and/or chemical linkages, which increases the interfacial adhesion. Scanning electron microscopy (SEM) micrographs of fatigue fracture surfaces and rubber-filler interaction study supported the observed result on fatigue life.     

Effect of Recycling on Material Properties of Glass-filled Polyethylene Terephthalate

Recycled plastics are considered low performance materials because their properties are expected to decrease drastically with recycling. The objective of this study was to characterize a 15 wt.% glass filled polyethylene terephthalate (rPET-15GF) using six recycle generations and four recycle ratios. Mechanical properties such as tensile strength, elastic modulus, and percent elongation to failure of the PET composite were determined for various recycle generations and recycle ratios. Results show that the mechanical properties of rPET-15GF decrease slightly per recycle generation. In contrast, thermal properties of rPET-15GF were not at all affected by the recycling process. This data demonstrates that recycled glass filled PET can be used effectively to fabricate components without significantly affecting their mechanical performance.     

Setting priorities for waste management strategies in developing countries.

This study aimed to determine whether the waste management systems, that are presently applied in affluent countries are appropriate solutions for waste management in less developed regions. For this purpose, three cities (Vienna, Damascus and Dhaka) which differ greatly in their gross domestic product and waste management were compared. The criteria for evaluation were economic parameters, and indicators as to whether the goals of waste management (protection of human health and the environment, the conservation of resources) were reached. Based on case studies, it was found that for regions spending 1-10 Euro capita(-1) year(-1) for waste management, the 'waste hierarchy' of prevention, recycling and disposal is not an appropriate strategy. In such regions, the improvement of disposal systems (complete collection, upgrading to sanitary landfilling) is the most cost-effective method to reach the objectives of solid waste management. Concepts that are widely applied in developed countries such as incineration and mechanical waste treatment are not suitable methods to reach waste management goals in countries where people cannot spend more than 10 Euro per person for the collection, treatment and disposal of their waste. It is recommended that each region first determines its economic capacity for waste management and then designs its waste management system according to this capacity and the goals of waste management.     

Chloroethene dechlorination in acidic groundwater: Implications for combining fenton's treatment with natural attenuation

A sulfuric acid leak in 1988 at a chloroethene‐contaminated groundwater site at the Naval Air Station Pensacola has resulted in a long‐term record of the behavior of chloroethene contaminants at low pH and a unique opportunity to assess the potential impact of source area treatment technologies, which involve acidification of the groundwater environment (e.g., Fenton's‐based in situ chemical oxidation), on downgradient natural attenuation processes. The greater than 75 percent decrease in trichloroethene (TCE) concentrations and the shift in contaminant composition toward predominantly reduced daughter products (dichloroethene [DCE] and vinyl chloride [VC]) that were observed along a 30‐m groundwater flow path characterized by highly acidic conditions (pH = 3.5 ± 0.4) demonstrated that chloroethene reductive dechlorination can continue to be efficient under persistent acidic conditions. The detection of Dehalococcoides‐type bacteria within the sulfuric acid/chloroethene co‐contaminant plume was consistent with biotic chloroethene reductive dechlorination. Microcosm studies conducted with ¹⁴C‐TCE and ¹⁴C‐VC confirmed biotic reductive dechlorination in sediment collected from within the sulfuric acid/chloroethene co‐contaminant plume. Microcosms prepared with sediment from two other locations within the acid plume, however, demonstrated only a limited mineralization to ¹⁴CO₂ and ¹⁴CO, which was attributed to abiotic degradation because no significant differences were observed between experimental and autoclaved control treatments. These results indicated that biotic and abiotic mechanisms contributed to chloroethene attenuation in the acid plume at NAS Pensacola and that remediation techniques involving acidification of the groundwater environment (e.g., Fenton's‐based source area treatment) do not necessarily preclude efficient chloroethene degradation. © 2007 Wiley Periodicals, Inc.     

Emotional intelligence and individual performance: evidence of direct and moderated effects

We examined the direct and moderated effects of an ability‐based measure of emotional intelligence (MSCEIT© V2.0) on individual performance in a sample of business undergraduates. Controlling for general mental ability and personality, emotional intelligence explained unique incremental variance in performance ratings on only one of two measures of interpersonal effectiveness (public speaking effectiveness). However, the interaction of emotional intelligence with conscientiousness explained unique incremental variance both in public speaking and group behavior effectiveness, as well as academic performance (cumulative GPA). We conclude that the effects of emotional intelligence on performance are more indirect than direct in nature. Individuals must not only have emotional intelligence, but also must be motivated to use it. Copyright © 2006 John Wiley & Sons, Ltd.