High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

A Comparative Study on the Archives of Xanthine Oxidase and Aldehyde Oxidase in Different Fish Species from Two Rivers in the Western Niger-Delta

Glycaemia, a classical indicator of stress, xanthine oxidase and aldehyde oxidase which are involved in phase I detoxication were investigated in two different fish species from two rivers with different pollution levels in the Western Niger-Delta. Four sampling zones covering the entire lengths of Warri and Ethiope Rivers respectively were used in this study. For each species of fish five were obtained from a sampling zone in a river. Blood glucose was significantly higher (P < 0.001) in M. electricus from Warri River (82.13 +/- 5.50 mg cm(-3)) compared to the same species from Ethiope River (36.47 +/- 1.49 mg cm(-3)). With the same parameter a similar profile was observed for C. gariepinus; Warri River (56.92 +/- 10.31 mg cm(-3)); Ethiope River (37.65 +/- 0.90 mg cm(-3)) which was also significant (P < 0.01). The activity of xanthine oxidase in M. electricus from Warri River (255.80 +/- 41 it mol cm(-3)) was significantly higher (P < 0.001) compared to the value obtained for the same species (108 +/- 22.36 micro mol cm(-3)) from Ethiope River. Also the activity of xanthine oxidase in C. gariepinus from Warri River (197 +/- 34.65 micro mol cm(-3)) was significantly higher (P < 0.001) when matched with the value obtained for the same species (78.40 +/- 26.84 micro mol cm(-3)) from Ethiope River. That blood glucose level was related to xanthine oxidase activity in the two fish species from Warri River was supported by the high positive correlation between these two parameters (M. electricus. r = 1: C. gariepinus, r = 0.71). The activity of aldehyde oxidase in C. gariepinus from Warri River (143.80 +/- 28.45 micro mol cm(-3)) was significantly higher (P < 0.001) compared to the value obtained for the same species (61.20 +/- 15.21 micro mol cm(-3)) from Ethiope River. A similar profile in aldehyde oxidase activity observed for M. electricus; Warri River (130 +/- 28.39 micro mol cm(-3)); Ethiope River (89 +/- 19.70 micro mol cm(-3)) but an inferior statistical variation (P < 0.05) was obtained. The results obtained in this study indicate that the level of xanthine oxidase in M. electricus is a more specific marker and to a lesser extent its activity in C. gariepinus in monitoring environmental stress due to pollution.     

Antibiotic resistance and plasmid profiling of <Emphasis Type="Italic">Vibrio</Emphasis> spp. in tropical waters of Peninsular Malaysia

Vibrio species isolated from four different sampling stations in the west coast of Peninsular Malaysia were screened for their antimicrobial resistance and plasmid profiles. A total of 138 isolates belonging to 15 different species were identified. Vibrio campbellii, V. parahaemolyticus, V. harveyi, and V. tubiashii were found to predominance species at all stations. High incidence of erythromycin, ampicillin, and mecillinam resistance was observed among the Vibrio isolates. In contrast, resistance against aztreonam, cefepime, streptomycin, sulfamethoxazole, and sulfonamides was low. All the Vibrio isolates in this study were found to be susceptible to imipenem, norfloxacin, ofloxacin, chloramphenicol, trimethoprim/sulfamethoxazole, and oxytetracycline. Ninety-five percent of the Vibrio isolates were resistant to one or more different classes of antibiotic, and 20 different resistance antibiograms were identified. Thirty-two distinct plasmid profiles with molecular weight ranging from 2.2 to 24.8 kb were detected among the resistance isolates. This study showed that multidrug-resistant Vibrio spp. were common in the aquatic environments of west coast of Peninsular Malaysia.     

Selecting optimal hyperspectral bands to discriminate nitrogen status in durum wheat: a comparison of statistical approaches

Hyperspectral data can provide prediction of physical and chemical vegetation properties, but data handling, analysis, and interpretation still limit their use. In this study, different methods for selecting variables were compared for the analysis of on-the-ground hyperspectral signatures of wheat grown under a wide range of nitrogen supplies. Spectral signatures were recorded at the end of stem elongation, booting, and heading stages in 100 georeferenced locations, using a 512-channel portable spectroradiometer operating in the 325–1075-nm range. The following procedures were compared: (i) a heuristic combined approach including lambda-lambda R² (LL R²) model, principal component analysis (PCA), and stepwise discriminant analysis (SDA); (ii) variable importance for projection (VIP) statistics derived from partial least square (PLS) regression (PLS-VIP); and (iii) multiple linear regression (MLR) analysis through maximum R-square improvement (MAXR) and stepwise algorithms. The discriminating capability of selected wavelengths was evaluated by canonical discriminant analysis. Leaf-nitrogen concentration was quantified on samples collected at the same locations and dates and used as response variable in regressive methods. The different methods resulted in differences in the number and position of the selected wavebands. Bands extracted through regressive methods were mostly related to response variable, as shown by the importance of the visible region for PLS and stepwise. Band selection techniques can be extremely useful not only to improve the power of predictive models but also for data interpretation or sensor design.     

Assessment of physicochemical parameters and prevalence of virulent and multiple-antibiotic-resistant <Emphasis Type="Italic">Escherichia coli</Emphasis> in treated effluent of two wastewater treatment plants and receiving aquatic <Emphasis Type="Italic">milieu</Emphasis> in Durban,South Africa

The poor operational status of some wastewater treatment plants often result in the discharge of inadequately treated effluent into receiving surface waters. This is of significant public health concern as there are many informal settlement dwellers (ISDs) that rely on these surface waters for their domestic use. This study investigated the treatment efficiency of two independent wastewater treatment plants (WWTPs) in Durban, South Africa and determined the impact of treated effluent discharge on the physicochemical and microbial quality of the receiving water bodies over a 6-month period. Presumptive Escherichia coli isolates were identified using biochemical tests and detection of the mdh gene via PCR. Six major virulence genes namely eae, hly, fliC, stx1, stx2, and rfbE were also detected via PCR while antibiotic resistance profiles of the isolates were determined using Kirby-Bauer disc diffusion assay. The physicochemical parameters of the wastewater samples ranged variously between 9 and 313.33 mg/L, 1.52 and 76.43 NTUs, and 6.30 and 7.87 for COD, turbidity, and pH respectively, while the E. coli counts ranged between 0 and 31.2?×?10³ CFU/ml. Of the 200 selected E. coli isolates, the hly gene was found in 28 %, fliC in 20 %, stx2 in 17 %, eae in 14 %, with stx1 and rfbE in only 4 % of the isolates. Notable resistance was observed toward trimethoprim (97 %), tetracycline (56 %), and ampicillin (52.5 %). These results further highlight the poor operational status of these WWTPs and outline the need for improved water quality monitoring and enforcement of stringent guidelines.     

Assessing regulatory violations of disinfection by-products in water distribution networks using a non-compliance potential index

Inactivating pathogens is essential to eradicate waterborne diseases. However, disinfection forms undesirable disinfection by-products (DBPs) in the presence of natural organic matter. Many regulations and guidelines exist to limit DBP exposure for eliminating possible health impacts such as bladder cancer, reproductive effects, and child development effects. In this paper, an index named non-compliance potential (NCP) index is proposed to evaluate regulatory violations by DBPs. The index can serve to evaluate water quality in distribution networks using the Bayesian Belief Network (BBN). BBN is a graphical model to represent contributing variables and their probabilistic relationships. Total trihalomethanes (TTHM), haloacetic acids (HAA5), and free residual chlorine (FRC) are selected as the variables to predict the NCP index. A methodology has been proposed to implement the index using either monitored data, empirical model results (e.g., multiple linear regression), and disinfectant kinetics through EPANET simulations. The index’s usefulness is demonstrated through two case studies on municipal distribution systems using both full-scale monitoring and modeled data. The proposed approach can be implemented for data-sparse conditions, making it especially useful for smaller municipal drinking water systems.