Isolation and characterization of a Rhodococcus strain with phenol-degrading ability and its potential use for tannery effluent biotreatment

Introduction

Wastewater derived from leather production may contain phenols, which are highly toxic, and their degradation could be possible through bioremediation technologies.

Materials, methods and results

In the present work, microbial degradation of phenol was studied using a tolerant bacterial strain, named CS1, isolated from tannery sediments. This strain was able to survive in the presence of phenol at concentrations of up to 1,000?mg/L. On the basis of morphological and biochemical properties, 16S rRNA gene sequencing, and phylogenetic analysis, the isolated strain was identified as Rhodococcus sp. Phenol removal was evaluated at a lab-scale in Erlenmeyer flasks and at a bioreactor scale in a stirred tank reactor. Rhodococcus sp. CS1 was able to completely remove phenol in a range of 200 to 1,000?mg/L in mineral medium at 30 ± 2?°C and pH 7 as optimal conditions. In the stirred tank bioreactor, we studied the effect of some parameters, such as agitation (200?C600 rpm) and aeration (1?C3?vvm), on growth and phenol removal efficiency. Faster phenol biodegradation was obtained in the bioreactor than in Erlenmeyer flasks, and maximum phenol removal was achieved at 400?rpm and 1 vvm in only 12?h. Furthermore, Rhodococcus sp. CS1 strain was able to grow and completely degrade phenols from tannery effluents after 9?h of incubation.

Conclusion

Based on these results, Rhodococcus sp. CS1 could be an appropriate microorganism for bioremediation of tannery effluents or other phenol-containing wastewaters.     

Phytoremediation of a Petroleum‐Hydrocarbon Contaminated Shallow Aquifer in Elizabeth City,North Carolina,USA

A former bulk fuel terminal in North Carolina is a groundwater phytoremediation demonstration site where 3,250 hybrid poplars, willows, and pine trees were planted from 2006 to 2008 over approximately 579,000 L of residual gasoline, diesel, and jet fuel. Since 2011, the groundwater altitude is lower in the area with trees than outside the planted area. Soil‐gas analyses showed a 95 percent mass loss for total petroleum hydrocarbons (TPH) and a 99 percent mass loss for benzene, toluene, ethylbenzene, and xylenes (BTEX). BTEX and methyl tert‐butyl ether concentrations have decreased in groundwater. Interpolations of free‐phase, fuel product gauging data show reduced thicknesses across the site and pooling of fuel product where poplar biomass is greatest. Isolated clusters of tree mortalities have persisted in areas with high TPH and BTEX mass. Toxicity assays showed impaired water use for willows and poplars exposed to the site's fuel product, but Populus survival was higher than the willows or pines on‐site, even in a noncontaminated control area. All four Populus clones survived well at the site. © 2014 Wiley Periodicals, Inc.*     

Strontium isotope study of coal utilization by-products interacting with environmental waters

Sequential leaching experiments on coal utilization by-products (CUB) were coupled with chemical and strontium (Sr) isotopic analyses to better understand the influence of coal type and combustion processes on CUB properties and the release of elements during interaction with environmental waters during disposal. Class C fly ash tended to release the highest quantity of minor and trace elements-including alkaline earth elements, sodium, chromium, copper, manganese, lead, titanium, and zinc-during sequential extraction, with bottom ash yielding the lowest. Strontium isotope ratios ((87)Sr/(86)Sr) in bulk-CUB samples (total dissolution of CUB) are generally higher in class F ash than in class C ash. Bulk-CUB ratios appear to be controlled by the geologic source of the mineral matter in the feed coal, and by Sr added during desulfurization treatments. Leachates of the CUB generally have Sr isotope ratios that are different than the bulk value, demonstrating that Sr was not isotopically homogenized during combustion. Variations in the Sr isotopic composition of CUB leachates were correlated with mobility of several major and trace elements; the data suggest that arsenic and lead are held in phases that contain the more radiogenic (high-(87)Sr/(86)Sr) component. A changing Sr isotope ratio of CUB-interacting waters in a disposal environment could forecast the release of certain strongly bound elements of environmental concern. This study lays the groundwork for the application of Sr isotopes as an environmental tracer for CUB-water interaction.     

Interactions between chromium and sulfur metabolism in Brassica juncea

The effects of chromate on sulfate uptake and assimilation were investigated in the accumulator Brassica juncea (L.) Czern. Seven-day-old plants were grown for 2 d under the following combination of sulfate and chromate concentration: (i) no sulfate and no chromate (-S), (ii) no sulfate and 0.2 mmol L(-1) chromate (-S +Cr), (iii) 1 mmol L(-1) sulfate and no chromate (+S), or (iv) 1 mmol L(-1) sulfate and 0.2 mmol L(-1) chromate (+S +Cr). Despite the toxic effects exerted by chromate as indicated by altered level of reducing sugars and proteins in leaves, the growth of B. juncea was only weakly reduced by chromate, and no variation in chlorophyll a and b was measured, regardless of S availability. Chromium (Cr) was stored more in roots than in leaves, and the maximum Cr accumulation was measured in -S +Cr plants. The significant decrease of the sulfate uptake rates observed in Cr-treated plants was accompanied by a repression of the root low-affinity sulfate transporter (BjST1), suggesting that the transport of chromate in B. juncea may involve sulfate carriers. Once absorbed, chromate induced genes involved in sulfate assimilation (ATP-sulfurylase: atps6; APS-reductase: apsr2; Glutathione synthethase: gsh2) and accumulation of cysteine and glutathione, which may suggest that these reduced S compounds play a role in Cr tolerance. Together, our findings indicate that when phytoremediation technologies are used to recover Cr-contaminated areas, the concentration of sulfate in the plant growth medium must be considered because it may influence the ability of plants to accumulate and tolerate Cr.     

Volunteer Macroinvertebrate Monitoring: Tensions Among Group Goals,Data Quality,and Outcomes

Volunteer monitoring of natural resources is promoted for its ability to increase public awareness, to provide valuable knowledge, and to encourage policy change that promotes ecosystem health. We used the case of volunteer macroinvertebrate monitoring (VMM) in streams to investigate whether the quality of data collected is correlated with data use and organizers' perception of whether they have achieved these outcomes. We examined the relation between site and group characteristics, data quality, data use, and perceived outcomes (education, social capital, and policy change). We found that group size and the degree to which citizen groups perform tasks on their own (rather than aided by professionals) positively correlated with the quality of data collected. Group size and number of years monitoring positively influenced whether a group used their data. While one might expect that groups committed to collecting good-quality data would be more likely to use it, there was no relation between data quality and data use, and no relation between data quality and perceived outcomes. More data use was, however, correlated with a group's feeling of connection to a network of engaged citizens and professionals. While VMM may hold promise for bringing citizens and scientists together to work on joint conservation agendas, our data illustrate that data quality does not correlate with a volunteer group's desire to use their data to promote regulatory change. Therefore, we encourage scientists and citizens alike to recognize this potential disconnect and strive to be explicit about the role of data in conservation efforts.     

Oil spill cleanup cost estimation—Developing a mathematical model for marine environment

The field of oil spill cost modelling is not as well explored as desirable. Generally speaking, the existing models have either low accuracy, in that their predictions are far from the real cost, or low applicability, in that they are only valid under very specific conditions; such as in one particular country. This work strives to construct a model that is functional in a global scope and still possess a high level of accuracy. The resulting attempt is in many ways superior to the publicly available competitors, not only because of its predictive capacity but also because the model is quick to use, and its input variables should be readily available to any informed user. The model is more accurate comparing with similar available models. However, further study is needed to modify it to obtain more realistic results.     

Solid waste characterization and recycling potential for a university campus

Integrated waste management systems are one of the greatest challenges for sustainable development. For these systems to be successful, the first step is to carry out waste characterization studies. In this paper are reported the results of a waste characterization study performed in the Campus Mexicali I of the Autonomous University of Baja California (UABC). The aim of this study was to set the basis for implementation of a recovery, reduction and recycling waste management program at the campus. It was found that the campus Mexicali I produces 1ton of solid wastes per day; more than 65% of these wastes are recyclable or potentially recyclable. These results showed that a program for segregation and recycling is feasible on a University Campus. The study also showed that the local market for recyclable waste, under present conditions - number of recycling companies and amounts of recyclables accepted - can absorb all of these wastes. Some alternatives for the potentially recyclables wastes are discussed. Finally some strategies that could be used to reduce waste at the source are discussed as well.     

Preferential sorption of some natural organic matter fractions to titanium dioxide nanoparticles: influence of pH and ionic strength

Natural organic matter (NOM) sorption to nanoparticles (NPs) can influence their transport and bioavailability in the aquatic environment. The sorption affinity of NOM to surfaces including NPs is size dependent, and depending on environmental conditions, NOM may enhance or mitigate NPs toxicity. The aim of this study was to investigate the preferential sorption of different-sized fractions of NOM to titanium dioxide (TiO₂) NPs. We specifically investigated the influence of pH, ionic strength, and NOM concentration on the extent of this preferential sorption using a constant sorbent concentration (400 mg/L TiO₂ NPs). Additionally, sorption of NOM to TiO₂ NPs at varying pH was investigated. The nonsorbed NOM was separated from the sorbed, by 50 nm polycarbonate membrane filters and ultracentrifugation. High-performance size exclusion chromatography (HPSEC) was used to determine the average molecular weights of NOM (MWw). Corroborative evidence of preferential sorption of different-sized molecular weight fractions of NOM was obtained from optical techniques such as absorbance and fluorescence spectrophotometry. The total organic carbon was measured by the Total Organic Carbon Analyzer—Shimadzu (TOC-VCPH). The results indicated that there is preferential sorption of larger sized fractions of NOM to TiO₂ NPs irrespective of NOM concentration. It was observed that the sorption of larger sized fractions of NOM was much enhanced at lower pH and at higher ionic strength. Both absorbance and fluorescence spectrophotometric techniques gave credible corroborative evidence on the extent of preferential sorption of lager sized fractions of NOM with respect to pH and ionic strength. The sorption results demonstrated higher sorption at lower pH than at higher pH. Overall, the results of this study suggest that the environmental conditions are key factors that can contribute to NOM’s fractional preferential sorption to NPs in the aquatic environment.