Occurrence of benzotriazoles in the rivers Main,Hengstbach, and Hegbach (Germany)

Background, aim, and scope  

Benzotriazoles (BT) as 1H-benzotriazole (1H-BT), 5-methyl-1H-benzotriazole (5Me-BT), and 4-methyl-1H-benzotriazole (4Me-BT) are frequently used as corrosion inhibitors in dish washer detergents, aircraft de-icing/anti-icing fluids (ADAF), automotive antifreeze formulations, brake fluids, fluids for industrial cooling systems, metal-cutting fluids, and in solid cooling lubricants. Discharge of treated municipal waste water and controlled over-runs of combined waste water sewers are potential point sources for BT in rivers. The aim of this monitoring study was to yield an overview on exposure concentrations and loads of BT in the German rivers Main, Hengstbach, and Hegbach.     

Investigation of partitioning mechanism for volatile organic compounds in a multiphase system

Laboratory experiments were performed to investigate the partitioning behavior of a set of diverse volatile organic compounds (VOCs). After equilibration at a temperature of 25 °C, the VOC concentrations were measured by headspace method in combination with gas chromatography/mass spectrometry (GC/MS). The obtained data were used to determine the partition coefficients (K_P) of VOCs in a gas-liguid-solid system. The results have shown that the presence and nature of solid materials in the working solution control the air-water partitioning of dissolved VOCs. The air/solution partitioning of BTEX and C₉-C₁₀ aldehydes was most affected in the presence of diesel soot. K_P values decreased by a factor ranging from 1.5 for toluene to 3.0 for ethylbenzene. The addition of mineral dust in the working solution exhibited greater influence on the partitioning of short aldehydes. K_P values decreased by a factor of 1.8. The experimental partition coefficients were used to develop a predictive model for partitioning of BTEX and n-aldehydes between air, water and solid phases.     

Hydraulic characterisation of the Stuttgart formation at the pilot test site for CO2 storage, Ketzin, Germany

The paper presents an approach for the interpretation of hydraulic tests of a CO₂ storage reservoir. The sandstone reservoir is characterised by a fluviatile channel structure embedded in a low-permeability matrix. Pumping tests were carried out in three wells, with simultaneous pressure monitoring in each well.The hydraulic parameters (permeability and storativity) and the boundary configurations were calibrated using three different approaches: (i) parameter calibration and type curve interpretation for single-hole tests, (ii) calibration of the entire build-up phase for cross-hole tests, and (iii) calibration of the initial pressure response for cross-hole pumping tests. In addition, the arrival time of the pressure response was determined and provides additional information about the pathways of hydraulic connection.The measured pumping test permeabilities of the formation were much lower than those measured on the cores, which is very unusual. The pumping test permeabilities are mainly between 50 mD and 100 mD (millidarcy), while core samples show a mean aquifer permeability of 500–1100 mD. Based on this it was concluded that some kind of continuous low-permeability structure exists, which was supported by core material. Three possible aquifer configurations were considered. The first and second were derived from traditional pumping test analysis and were conceptualised using flow boundaries. Each of the analyses provides a different result. A method was developed in which these differences were resolved by interpreting the pressure response with respect to its spatial and temporal sensitivity. This solution lead to a third configuration which was mainly based on spatially-variable permeabilities. Taking into account the pumping test results, the geological background and the behaviour of injected CO₂, we consider only the third configuration to be realistic. The results are in good agreement with modelled CO₂ arrival times and pressure history.     

Impact of humic substances on the aqueous solubility, uptake and bioaccumulation of platinum, palladium and rhodium in exposure studies with Dreissena polymorpha

Zebra mussels (Dreissena polymorpha) were exposed to different types of water containing PGE salts (PtCl4, PdSO4, RhCl3) to investigate the influence of humic substances on the aqueous solubility, uptake and bioaccumulation of noble metals. The results showed a time dependent decrease of the aqueous PGE concentrations in tank water for all groups. This could mainly be related to non-biological processes. The aqueous solubility of Pd and Rh was higher in humic water compared with non-chlorinated tap water, whereas Pt showed opposing results. Highest metal uptake rates and highest bioaccumulation plateaus were found for Pd, followed by Pt and Rh. Pd uptake and bioaccumulation was significantly hampered by humic substances, whose presence appear to increase Pt uptake and bioaccumulation. No clear trend emerged for Rh. Differences in effects of humic matter among the PGE may be explained by formation of metal complexes with different fractions of humic substances.     

Experimental and statistical determination of indicator parameters for the evaluation of fly ash and boiler ash PCDD/PCDF concentration from municipal solid waste incinerators

On-line detectable indicator parameters in the flue gas of municipal solid waste incinerators (MSWI) such as chlorinated benzenes (PCBz) are well known surrogate compounds for gas-phase PCDD/PCDF concentration. In the here presented work derivation of indicators is broadened to the detection of fly and boiler ash fractions with increased PCDD/PCDF content. Subsequently these fractions could be subject to further treatment such as recirculation in the combustion chamber to destroy their PCDD/PCDF and other organic pollutants' content. Aim of this work was to detect suitable on-line detectable indicator parameters in the gas phase, which are well correlated to PCDD/PCDF concentration in the solid residues. For this, solid residues and gas-phase samples were taken at three MSWI plants in Bavaria. Analysis of the ash content from different plants yielded a broad variation range of PCDD/PCDF concentrations especially after disturbed combustion conditions. Even during normal operation conditions significantly increased PCDD/PCDF concentrations may occur after unanticipated disturbances. Statistical evaluation of gas phase and ash measurements was carried out by means of principal component analysis, uni- and multivariate correlation analysis. Surprisingly, well known indicators for gas-phase PCDD/PCDF concentration such as polychlorinated benzenes and phenols proved to be insufficiently correlated to PCDD/PCDF content of the solid residues. Moreover, no single parameter alone was found appropriate to describe the PCDD/PCDF content of fly and boiler ashes. On the other hand, multivariate fitting of three or four parameters yielded convenient correlation coefficients of at least r=0.8 for every investigated case. Thereby, comprehension of plant operation parameters such as temperatures and air flow alongside concentrations of inorganic compounds in the gas phase (HCl, CO, SO2, NOx) gave the best results. However, the suitable set of parameters suited best for estimation of PCDD/PCDF concentration in solid residues has to be derived anew for each individual plant and type of ash.     

Statistical downscaling for climate change projections in the Mediterranean region: methods and results

Besides dynamical downscaling by regional climate models, statistical downscaling (SD) is a major tool to derive climate change projections on regional or even local scales. For the Mediterranean area, an increasing number of downscaling studies based on different statistical techniques have been published in the last two decades with a broad range of sometimes differing results relating to different variables and regional domains. This paper gives a short review of these Mediterranean downscaling studies mainly considering the following two aspects: (1) what kind of progress has been realized in this field since the early 1990s? The review addresses the inclusion of extremes in downscaling assessments, the development of probabilistic approaches, the extension of predictor sets, the use of ensembles for both dynamical model simulations and statistical model assessments, the consideration of non-stationarities in the predictor–predictand relationships, and some advances related to synoptic downscaling. (2) What are the main regional climate change signals in the Mediterranean area, considering agreed and controversial points also with respect to dynamical models? Best accordance among future projections can be found in seasonal temperatures with lower rates of warming in winter and spring, and, in most cases, higher ones in summer and autumn. Different results are obtained for the intra-annual range of extreme temperatures, but high-temperature conditions are generally expected to increase. Regarding seasonal precipitation, predominant reductions are indicated for spring, summer, and autumn. For winter, however, projections are distinctly different (GCMs: rainfall decrease; RCMs: increase only in the northernmost parts of the Mediterranean region; SD: widespread increases in the northern and western parts in several studies). Different results are obtained for rainfall extremes, but the entire precipitation distribution tends to shift towards higher and lower values. Apart from some sub-regional deviations, there is a predominant increase in future dry period durations. For near-surface winds, only a few studies are available, and they project some decline mainly for the winter season.     

Inheritance of dominance in honeybees (Apis mellifera capensis Esch.)

Summary Hierarchies in worker dominance are well developed in reproductive workers of the Cape honeybee (Apis mellifera capensis Esch.). Elements that influence worker dominance (trophallactic behaviour, fecundity, queen substance content) are mainly genetically determined. The estimated values for the heritabilities in the broader sense range from 0.27 to 0.89. This genetically based hierarchy leads to new insight into the theory of natural selection in honeybees. Besides selection at the colony level, or selection at the level of reproductives, natural selection also operates at the level of the individual worker bee within a colony.