Study of Pollution of the Plitvice Lakes by Water and Sediment Analyses

The process of eutrophication in form of intense plant growth has been observed in some lakes and water streams at the Plitvice Lakes National Park in central Croatia. Here we investigate whether this phenomenon is a consequence of anthropogenic pollution or due to naturally produced organic matter in the lakes. We applied chemical analysis of water at two springs and four lakes (nutrients, dissolved organic carbon (DOC), trace elements) and measurements of surface lake sediments (mineral and organic fraction analyses, trace elements) in four different lakes/five sites. The chemical composition of water does not indicate recent anthropogenic pollution of water because the concentrations of most trace elements are below detection limits. The concentrations of DOC and nutrients are slightly higher in the area of increased eutrophication-plant growth. Also the content of organic matter in the sediment is at the highest level in areas with highest C/N ratio indicating that the organic fraction of this sediment is mainly of terrestrial origin. There is no significant difference among the trace element concentration in the upper segment of all cores, deposited approximately during last 50 years when higher anthropogenic influence is expected due to development and touristic activity, and the lower part of the cores, corresponding to the period approximately 100–200 years before present. The content of trace elements and organic matter in sediments decreases from the uppermost lake downstream. According to our results there is no indication of recent anthropogenic pollution in water and sediment. Higher concentrations of DOC in water as well as phosphorus and some other elements in the lake sediment can be a consequence of input of natural organic matter to the lake water.     

Printed wiring boards for mobile phones: characterization and recycling of copper

The popularization of mobile phones, combined with a technological evolution, means a large number of scrap and obsolete equipment are discarded every year, thereby causing economic losses and environmental pollution. In the present study, the printed wiring boards scrap of mobile phones were characterized in order to recycle some of the device components, using techniques of mechanical processing, hydrometallurgy and electrometallurgy. The use of the techniques of mechanical processing (milling, particle size classification, magnetic and electrostatic separation) was an efficient alternative to obtain a concentrated fraction (mainly iron in the magnetic fraction and copper in the conductive fraction) and another fraction containing polymers and ceramics. At the end of mechanical processing, a concentrated fraction of metals could be obtained with an average concentration of 60% copper. This concentrated fraction in metals was dissolved in aqua regia and sent to electrowinning to recover 92% of the dissolved copper. The obtained cathodes have a copper content above 95%, which demonstrates the technical feasibility of recovery of copper using the techniques of mechanical processing, hydrometallurgy and electrometallurgy.     

Methodology for quantification of waste generated in Spanish railway construction works

In the last years, the European Union (EU) has been focused on the reduction of construction and demolition (C&D) waste. Specifically, in 2006, Spain generated roughly 47million tons of C&D waste, of which only 13.6% was recycled. This situation has lead to the drawing up of many regulations on C&D waste during the past years forcing EU countries to include new measures for waste prevention and recycling. Among these measures, the mandatory obligation to quantify the C&D waste expected to be originated during a construction project is mandated. However, limited data is available on civil engineering projects. Therefore, the aim of this research study is to improve C&D waste management in railway projects, by developing a model for C&D waste quantification. For this purpose, we develop two equations which estimate in advance the amount, both in weight and volume, of the C&D waste likely to be generated in railway construction projects, including the category of C&D waste generated for the entire project.     

Correlation analysis between sulphate content and leaching of sulphates in recycled aggregates from construction and demolition wastes

In some recycled aggregates applications, such as component of new concrete or roads, the total content of soluble sulphates should be measured and controlled. Restrictions are usually motivated by the resistance or stability of the new structure, and in most cases, structural concerns can be remedied by the use of techniques such as sulphur-resistant cements. However, environmental risk assessment from recycling and reuse construction products is often forgotten. The purpose of this study is to analyse the content of soluble sulphate on eleven recycled aggregates and six samples prepared in laboratory by the addition of different gypsum percentages. As points of reference, two natural aggregates were tested. An analysis of the content of the leachable amount of heavy metals regulated by European regulation was included. As a result, the correlation between solubility and leachability data allow suggest a limiting gypsum amount of 4.4% on recycled aggregates. This limit satisfies EU Landfill Directive criteria, which is currently used as reference by public Spanish Government for recycled aggregates in construction works.     

Effect of aeration rate and moisture content on the emissions of selected VOCs during municipal solid waste composting

The influence of the industrial control composting conditions (aeration 0.005–0.300?L_air?kg^?1 and moisture 40–70?%) of municipal solid waste on the composition of the selected compound emitted (limonene, β-pinene, 2-butanone, undecane, phenol, toluene, dimethyl sulfide, dimethyl disulfide) was studied. The highest emissions of volatile organic compounds (VOCs) were observed in the early stages of the processes. At the end of the process, low concentrations of the emitted compounds were found. Aeration rate had a strong effect on emissions. High aeration rate (0.300?L_air?kg^?1?min^?1) caused normally high emissions of all selected compounds whereas low aeration rates (0.05?L_air?kg^?1?min^?1) could cause anaerobiosis problems and generation of organic sulphur compounds. We observed that the effect of the moisture upon the emitted concentrations varied depending on the studied compound.     

Valorisation of used cooking oil sludge by codigestion with swine manure

The addition of lipid wastes to the digestion of swine manure was studied as a means of increasing biogas production. Lipid waste was obtained from a biodiesel plant where used cooking oil is the feedstock. Digestion of this co-substrate was proposed as a way of valorising residual streams from the process of biodiesel production and to integrate the digestion process into the biorefinery concept.Batch digestion tests were performed at different co-digesting proportions obtaining as a result an increase in biogas production with the increase in the amount of co-substrate added to the mixture. Semi-continuous digestion was studied at a 7% (w/w) mass fraction of total solids. Co-digestion was successful at a hydraulic retention time (HRT) of 50 d but a decrease to 30 d resulted in a decrease in specific gas production and accumulation of volatile and long chain fatty acids. The CH₄ yield obtained was 326 ± 46 l/kg VS_feed at an HRT of 50 d, while this value was reduced to 274 ± 43 l/kg VS_feed when evaluated at an HRT of 30 d. However these values were higher than the one obtained under batch conditions (266 ± 40 l/kg VS_feed), thus indicating the need of acclimation to the co-substrate. Despite of operating at low organic loading rate (OLR), measurements from respirometry assays of digestate samples (at an HRT of 50 d) suggested that the effluent could not be directly applied to the soil as fertiliser and might have a negative effect over soil or crops.     

Urbanisation and flood vulnerability in the peri-urban interface of Mexico City

Chronic flooding in the Chalco valley, state of Mexico, Mexico, is the outcome of past and present socio‐environmental changes which have taken place in Mexico City's south‐eastern peri‐urban interface. This flooding is the result of a complex interaction between urbanisation in an ex‐lacustrine area, permanent ecological deterioration and ground subsidence, poor sanitation and inadequate policy responses. Far from solving the flooding problem, short‐term policy responses have created increasingly unsafe conditions for current residents. A socio‐historical analysis of disasters reveals the importance of taking into consideration particular social actors and institutions in hazard generation and flood vulnerability over time. This paper analyses three aspects of this flooding: first, the importance of approaching floods from a socio‐historical perspective; second, the relation between urbanisation, former policies and flood risk generation; and third, current policy responses to and the failure in the risk management of La Compañía Canal.     

The 2004 Madrid train bombings: an analysis of pre-hospital management

The terrorist train bombings in Madrid, Spain, on 11 March 2004 triggered a swift and massive medical response. This paper analyses the pre-hospital response to the attacks to gain insight into current trends in disaster management among Madrid's Emergency Medical Services (EMSs). To this end, the existing emergency planning framework is described, the basic structures of the different EMSs are presented, and the attacks are briefly depicted before consideration is given to pre-hospital management. Finally, an explanation of the main underlying misconceptions in emergency planning and management in Madrid is provided to aid understanding of the origins of some of the problems detected during the response. These are attributable mainly to inappropriate planning rather than to mistakes in field-level decision-making. By contrast, many of the successes are attributable to individual initiatives by frontline medics who compensated for the lack of clear command by senior managers by making adaptive and flexible decisions.     

Fiscal spending and the environment: Theory and empirics

During economic crises, governments often increase fiscal spending to stimulate the economy. While the fiscal spending surge may be temporary, spending composition is often altered in favor of expenditures on social programs and other public goods which may persist over time. We model and measure the impact of fiscal spending patterns on the environment. The model predicts that a reallocation of government spending composition towards social and public goods reduces pollution. However, increasing total government spending without altering its composition does not reduce pollution. We empirically test these predictions for air and water pollutants showing that they are fully supported.     

Information-theoretic approaches to statistical analysis in behavioural ecology: an introduction

Scientific thinking may require the consideration of multiple hypotheses, which often call for complex statistical models at the level of data analysis. The aim of this introduction is to provide a brief overview on how competing hypotheses are evaluated statistically in behavioural ecological studies and to offer potentially fruitful avenues for future methodological developments. Complex models have traditionally been treated by model selection approaches using threshold-based removal of terms, i.e. stepwise selection. A recently introduced method for model selection applies an information-theoretic (IT) approach, which simultaneously evaluates hypotheses by balancing between model complexity and goodness of fit. The IT method has been increasingly propagated in the field of ecology, while a literature survey shows that its spread in behavioural ecology has been much slower, and model simplification using stepwise selection is still more widespread than IT-based model selection. Why has the use of IT methods in behavioural ecology lagged behind other disciplines? This special issue examines the suitability of the IT method for analysing data with multiple predictors, which researchers encounter in our field. The volume brings together different viewpoints to aid behavioural ecologists in understanding the method, with the hope of enhancing the statistical integration of our discipline.