A Fast Gas Chromatographic Method for Measuring C2-C6 Alkanes and Alkenes in Air

The Environmental Protection Agency is responsible for establishing, reviewing, and revising standards of performance for new stationary sources of air pollution. Since this federal program was authorized in 1970, standards of performance (commonly referred to as new source performance standards or NSPS) have been developed for 34 categories of stationary sources. These regulations have focused primarily on large new sources of particulate matter, NO _x , and SO₂ emissions. Recently, work has begun on NSPS for a number of source categories that emit volatile organic compounds. Environmental professionals in these industries and in many regulatory agencies have little direct experience with the NSPS program and are unaware of the detailed engineering, cost, and economic information available with each proposed rulemaking. This article, therefore, reviews the purposes, procedures, and benefits of the NSPS program. A summary of the NSPS that have been promulgated through February 1983 are presented in tabular form.     

Treatment of Halogenated Organic Vent Streams for the Reduction of Air Emissions

Abstract

This work presents a three-stage treatment system to process halogenated organic vent streams for compliance with the Hazardous Organic NESHAP (HON) Rule. The three stages are incineration, energy recovery, and wet scrubbing. In particular, this work concentrates on the design of the scrubber, which the HON Rule states must remove at least 99% of any halogens or hydrogen halides generated during the combustion step. Computerized process simulation was found to be ineffective in designing a scrubber for this application, so laboratory data on the partial pressure of the hydrogen halide species over aqueous solutions was employed. The number of overall gas transfer units required for 99% removal was found to be slightly less than 5, and the overall gas transfer unit height was found to be approximately 0.5 m.     

Rural Ozone Across the Eastern United States: Analysis of CASTNet Data, 1988–1995

ABSTRACT

A predominantly rural ozone monitoring network was operated under the auspices of the Clean Air Status and Trends Network (CASTNet) from 1988 until 1995. Ozone data from sites in the eastern United States are presented and several indices are used to describe the spatial and temporal distribution of ozone concentration and exposure. These indices are SUM06, W126, the 8-hour rolling average (MAX_8hr>80), and the current National Ambient Air Quality Standards (NAAQS) for ozone. Ozone indices were selected to illustrate the spatial and temporal distribution of ozone, and the sensitivity of this distribution to different representations of concentration or exposure.

CASTNet is unique in that a uniform set of site selection criteria and uniform procedures, including traceability to a single primary standard, provide a high degree of comparability across sites. Sites were selected to avoid undue influence from point sources, area sources, or local activities. The sites reflect a wide range of land use and terrain types including agricultural and forested, in flat, rolling, and complex terrain from the eastern seaboard across the Appalachian Mountains to the Midwest.

Results indicate that ozone concentrations varied greatly in time and space across the eastern United States. Sites in the upper northeast, upper midwest, and southern periphery subregions experienced relatively low ozone during the years of record compared to sites in the northeast, midwest, and south central subregions. Ozone exposures at an individual rural site are dependent on many factors, including terrain, meteorology, and distance from sources of precursors. Relative to the current (as of 1996) NAAQS, only a handful of CASTNet sites near major urban areas report exceedances. In contrast, the majority of CASTNet sites might exceed the proposed new primary standard for ozone.

Sites at high elevation (>900m) in the east exhibit relatively high exposure statistics (e.g., SUM06 and W126), but no exceedance of the current ozone standard from 1988 through 1995. Terrain effects explain some of the variability within subregions and are an important consideration in the design of monitoring networks for ozone and possibly other pollutants.     

Preparing to Measure the Effects of the NOx SIP Call— Methods for Ambient Air Monitoring of NO,NO2, NOy,and Individual NOz Species

Abstract

The capping of stationary source emissions of NO_x in 22 states and the District of Columbia is federally mandated by the NO_x SIP Call legislation with the intended purpose of reducing downwind O₃ concentrations. Monitors for NO, NO₂, and the reactive oxides of nitrogen into which these two compounds are converted will record data to evaluate air quality model (AQM) predictions. Guidelines for testing these models indicate the need for semicontinuous measurements as close to real time as possible but no less frequently than once per hour. The measurement uncertainty required for AQM testing must be less than ±20% (±10% for NO₂) at mixing ratios of 1 ppbv and higher for NO, individual NO_z component compounds, and NO_y. This article is a review and discussion of different monitoring methods, some currently used in research and others used for routine monitoring. The performance of these methods is compared with the monitoring guidelines. Recommendations for advancing speciated and total NO_y monitoring technology and a listing of demonstrated monitoring approaches are also presented.     

Diurnal and Weekday Variations in the Source Contributions of Ozone Precursors in California’s South Coast Air Basin

Abstract

For at least 30 years, ozone (O₃) levels on weekends in parts of California’s South Coast (Los Angeles) Air Basin (SoCAB) have been as high as or higher than on weekdays, even though ambient levels of O₃ precursors are lower on weekends than on weekdays. A field study was conducted in the Los Angeles area during fall 2000 to test whether proposed relationships between emission sources and ambient nonmethane hydrocarbon (NMHC) and oxides of nitrogen (NO_x) levels can account for observed diurnal and day-of-week variations in the concentration and proportions of precursor pollutants that may affect the efficiency and rate of O₃ formation. The contributions to ambient NMHC by motor vehicle exhaust and evaporative emissions, estimated using chemical mass balance (CMB) receptor modeling, ranged from 65 to 85% with minimal day-of-week variation. Ratios of ambient NO_x associated with black carbon (BC) to NO_x associated with carbon monoxide (CO) were approximately 1.25 ± 0.22 during weekdays and 0.76 ± 0.07 and 0.52 ± 0.07 on Saturday and Sunday, respectively. These results demonstrate that lower NO_x emissions from diesel exhaust can be a major factor causing lower NO_x mixing ratios and higher NMHC/NO_x ratios on weekends. Nonmobile sources showed no significant day-of-week variations in their contributions to NMHC. Greater amounts of gasoline emissions are carried over on Friday and Saturday evenings but are, at most, a minor factor contributing to higher NMHC/NO_x ratios on weekend mornings.     

Comparison of the MOVES2010a,MOBILE6.2, and EMFAC2007 mobile source emission models with on-road traffic tunnel and remote sensing measurements

The Desert Research Institute conducted an on-road mobile source emission study at a traffic tunnel in Van Nuys, California, in August 2010 to measure fleet-averaged, fuel-based emission factors. The study also included remote sensing device (RSD) measurements by the University of Denver of 13,000 vehicles near the tunnel. The tunnel and RSD fleet-averaged emission factors were compared in blind fashion with the corresponding modeled factors calculated by ENVIRON International Corporation using U.S. Environmental Protection Agency's (EPA's) MOVES2010a (Motor Vehicle Emissions Simulator) and MOBILE6.2 mobile source emission models, and California Air Resources Board's (CARB's) EMFAC2007 (EMission FACtors) emission model. With some exceptions, the fleet-averaged tunnel, RSD, and modeled carbon monoxide (CO) and oxide of nitrogen (NO_x) emission factors were in reasonable agreement (±25%). The nonmethane hydrocarbon (NMHC) emission factors (specifically the running evaporative emissions) predicted by MOVES were insensitive to ambient temperature as compared with the tunnel measurements and the MOBILE- and EMFAC-predicted emission factors, resulting in underestimation of the measured NMHC/NO_x ratios at higher ambient temperatures. Although predicted NMHC/NO_x ratios are in good agreement with the measured ratios during cooler sampling periods, the measured NMHC/NO_x ratios are 3.1, 1.7, and 1.4 times higher than those predicted by the MOVES, MOBILE, and EMFAC models, respectively, during high-temperature periods. Although the MOVES NO_x emission factors were generally higher than the measured factors, most differences were not significant considering the variations in the modeled factors using alternative vehicle operating cycles to represent the driving conditions in the tunnel. The three models predicted large differences in NO_x and particle emissions and in the relative contributions of diesel and gasoline vehicles to total NO_x and particulate carbon (TC) emissions in the tunnel.

Implications: Although advances have been made to mobile source emission models over the past two decades, the evidence that mobile source emissions of carbon monoxide and hydrocarbons in urban areas were underestimated by as much as a factor of 2–3 in past inventories underscores the need for on-going verification of emission inventories. Results suggest that there is an overall increase in motor vehicle NMHC emissions on hot days that is not fully accounted for by the emission models. Hot temperatures and concomitant higher ratios of NMHC emissions relative to NO_x both contribute to more rapid and efficient formation of ozone. Also, the ability of EPA's MOVES model to simulate varying vehicle operating modes places increased importance on the choice of operating modes to evaluate project-level emissions.     

The geographic distribution and economic value of climate change-related ozone health impacts in the United States in 2030

In this United States-focused analysis we use outputs from two general circulation models (GCMs) driven by different greenhouse gas forcing scenarios as inputs to regional climate and chemical transport models to investigate potential changes in near-term U.S. air quality due to climate change. We conduct multiyear simulations to account for interannual variability and characterize the near-term influence of a changing climate on tropospheric ozone-related health impacts near the year 2030, which is a policy-relevant time frame that is subject to fewer uncertainties than other approaches employed in the literature. We adopt a 2030 emissions inventory that accounts for fully implementing anthropogenic emissions controls required by federal, state, and/or local policies, which is projected to strongly influence future ozone levels. We quantify a comprehensive suite of ozone-related mortality and morbidity impacts including emergency department visits, hospital admissions, acute respiratory symptoms, and lost school days, and estimate the economic value of these impacts. Both GCMs project average daily maximum temperature to increase by 1–4°C and 1–5 ppb increases in daily 8-hr maximum ozone at 2030, though each climate scenario produces ozone levels that vary greatly over space and time. We estimate tens to thousands of additional ozone-related premature deaths and illnesses per year for these two scenarios and calculate an economic burden of these health outcomes of hundreds of millions to tens of billions of U.S. dollars (2010$).

Implications:?Near-term changes to the climate have the potential to greatly affect ground-level ozone. Using a 2030 emission inventory with regional climate fields downscaled from two general circulation models, we project mean temperature increases of 1 to 4°C and climate-driven mean daily 8-hr maximum ozone increases of 1–5 ppb, though each climate scenario produces ozone levels that vary significantly over space and time. These increased ozone levels are estimated to result in tens to thousands of ozone-related premature deaths and illnesses per year and an economic burden of hundreds of millions to tens of billions of U.S. dollars (2010$).     

Chlorinated Solvent Treatment Wetland

A first‐of‐its‐kind wetland restoration project was completed in October 2000 to treat trichloroethene‐(TCE‐)impacted groundwater from a former manufacturing facility prior to discharge into a highly valued recreational surface water body in the upper Midwest. This article summarizes the design, construction, operation, and effectiveness of the restored wetland. The groundwater‐surface water discharge zone at the site was restored as a wetland to improve the natural degradation of TCE and subsequent degradation by‐products. For the past 11 years, the treatment wetland performance was evaluated by monitoring the wetland vegetation, wetland hydraulics, and water chemistry. Water quality data have been used to assess the wetland geochemistry, TCE and TCE‐degradation by‐product concentrations within the wetland, and the surface water quality immediately downgradient of the wetland. The treatment wetland has been performing according to design, with TCE and TCE‐degradation by‐products not exceeding surface water criteria. The monitoring results show that TCE and TCE‐degradation by‐products are entering the treatment wetland via natural hydraulic gradients and that the geochemistry of the wetland supports both reductive dechlorination (anaerobic degradation) and cometabolic degradation (aerobic degradation) of TCE and TCE‐degradation by‐products: cis‐ and trans‐1,2‐dichloroethene and vinyl chloride. © 2013 Wiley Periodicals, Inc.     

Degradation of anti-inflammatory drug ketoprofen by electro-oxidation: comparison of electro-Fenton and anodic oxidation processes

The electrochemical degradation of the nonsteroidal anti-inflammatory drug ketoprofen in tap water has been studied using electro-Fenton (EF) and anodic oxidation (AO) processes with platinium (Pt) and boron-doped diamond (BDD) anodes and carbon felt cathode. Fast degradation of the parent drug molecule and its degradation intermediates leading to complete mineralization was achieved by BDD/carbon felt, Pt/carbon felt, and AO with BDD anode. The obtained results showed that oxidative degradation rate of ketoprofen and mineralization of its aqueous solution increased by increasing applied current. Degradation kinetics fitted well to a pseudo-first-order reaction. Absolute rate constant of the oxidation of ketoprofen by electrochemically generated hydroxyl radicals was determined to be (2.8?±?0.1)?×?10⁹ M^?1 s^?1 by using competition kinetic method. Several reaction intermediates such as 3-hydroxybenzoic acid, pyrogallol, catechol, benzophenone, benzoic acid, and hydroquinone were identified by high-performance liquid chromatography (HPLC) analyses. The formation, identification, and evolution of short-chain aliphatic carboxylic acids like formic, acetic, oxalic, glycolic, and glyoxylic acids were monitored with ion exclusion chromatography. Based on the identified aromatic/cyclic intermediates and carboxylic acids as end products before mineralization, a plausible mineralization pathway was proposed. The evolution of the toxicity during treatments was also monitored using Microtox method, showing a faster detoxification with higher applied current values.