Effects of management and climate on elk brucellosis in the Greater Yellowstone Ecosystem.

Every winter, government agencies feed approximately 6000 metric tons (6 x 10(6) kg) of hay to elk in the southern Greater Yellowstone Ecosystem (GYE) to limit transmission of Brucella abortus, the causative agent of brucellosis, from elk to cattle. Supplemental feeding, however, is likely to increase the transmission of brucellosis in elk, and may be affected by climatic factors, such as snowpack. We assessed these possibilities using snowpack and feeding data from 1952 to 2006 and disease testing data from 1993 to 2006. Brucellosis seroprevalence was strongly correlated with the timing of the feeding season. Longer feeding seasons were associated with higher seroprevalence, but elk population size and density had only minor effects. In other words, the duration of host aggregation and whether it coincided with peak transmission periods was more important than just the host population size. Accurate modeling of disease transmission depends upon incorporating information on how host contact rates fluctuate over time relative to peak transmission periods. We also found that supplemental feeding seasons lasted longer during years with deeper snowpack. Therefore, milder winters and/or management strategies that reduce the length of the feeding season may reduce the seroprevalence of brucellosis in the elk populations of the southern GYE.     

Rapid and radical amniodrainage in the treatment of severe twin–twin transfusion syndrome†

We have evaluated the role of a rapid and radical method of amniodrainage in the treatment of severe twin–twin transfusion. The outcome of 15 patients with severe twin–twin transfusion for which a amniodrainage was performed by means of a vacuum bottle system was compared with the outcome of 15 patients with a similar condition, matched for gestational age at the time of the initial procedure and drained using a standard procedure. In the study group the amniodrainage ended when no amniotic fluid could be aspirated, whereas the women in the standard group were drained with a syringe system and the fluid was removed until the deepest amniotic fluid pool was <8 cm. At the initial procedure, the mean volume of amniotic fluid drained was significantly (p<0.05) higher (3252 vs 2153 ml) and the length of the procedure significantly (p<0.001) shorter (21 vs 41 min) in the study group than in the standard group. The mean post-procedure amniotic fluid index was significantly (p<0.001) smaller (2.9 vs 7.7 cm) after radical amniodrainage than after the standard amniodrainage. The mean number of procedures was significantly (p<0.001) lower (1.5 vs 5.6) in the study group compared to the standard group. In the study group the mean placental thickness increased significantly (p<0.001) from 9 mm before the procedure to 49 mm after, and the overall perinatal survival rate was 80% and the proportion of pregnancies with at least one survivor was 93%. The present data indicate that early, rapid and radical amniodrainage is an effective and low-cost therapy for severe twin–twin transfusion syndrome. Compared to the standard amniodrainage technique it also appears to reduce the need for multiple procedures. Copyright © 2001 John Wiley & Sons, Ltd.     

Optimization of the high-pressure, near-critical liquid-based microsortation of recyclable post-consumer plastics

High-pressure, near-critical liquids were used as float-sink separation media for the microsortation of polyolefin mixtures and PET/PVC mixtures. Near-critical carbon dioxide was used for the refinement of the polyolefins, and sulfur hexafluoride was used to separate post-consumer PVC from PET. Preliminary experiments indicated that there was no overlap in the density ranges of post-consumer HDPE, LDPE and PP containers. There was no overlap in the PET and PVC densities, with the exception of a single PVC packaging material with a density in the PET range. These initial results indicated that a float-sink separation was a viable means of microsortation. Separations of 91% LDPE (1/8′ beads)/9% PP (1/8′ chopped strands) resin mixtures and mixed post-consumer polyolefin flakes were then conducted in a laboratory-scale, 1-I batch apparatus. This apparatus not only permitted the observation of the separation, but also enabled the separated fractions to be removed from the high-pressure environment. The results indicated that LDPE purity of greater than 98.9% was obtained in 3 min or less if (a) the fluid density was 0.018 g/cm³ greater than the PP density and only 0.002 g/cm³ less than the LDPE density, thereby providing the greatest buoyancy force for the removal of the PP, (b) the fluid was recirculated upward through the bed of mixed plastics, facilitating the upward movement of the PP, and (c) the loading was kept at levels below 40% by volume. HDPE purity of 99% was also attained with clean, dry, post-consumer mixed plastic flakes. The loadings for these separations were very low, however, due to the difficulty in agitating the mixed bed of plastics using fluid recirculation. An economic analysis of these microsortation processes indicated that the value of the sorted plastics relative to the mixed feed must increase by approx. $0.08/lb for the CO₂-based separation and approx. $0.27/lb for the SF₆-based separation to justify the implementation of these high-pressure processes.     

Methods for evaluating investment strategies for environmental technologies

Environmental technology development, like other ventures, requires decisions regarding where to invest scarce capital. The investment option that offers the greatest benefit relative to the cost should be chosen. The problem is to determine a way to analyze the project and apply a useful measure for comparison to other investment opportunities. In this article, three methods of analysis are presented: return on investment, benefit-to-cost ratio, and payback period. Formulas are developed for each of the methods, and a case study illustrates their application.     

The Southeastern Aerosol Research and Characterization Study: Part II. Filter-based measurements of fine and coarse particulate matter mass and composition

The Southeastern Aerosol Research and Characterization Study (SEARCH) was implemented in 1998-1999 to provide data and analyses for the investigation of the sources, chemical speciation, and long-term trends of fine particulate matter (PM2.5) and coarse particulate matter (PM10-2.5) in the Southeastern United States. This work is an initial analysis of 5 years (1999-2003) of filter-based PM2.5 and PM10-2.5 data from SEARCH. We find that annual PM2.5 design values were consistently above the National Ambient Air Quality Standards (NAAQS) 15 microg/m3 annual standard only at monitoring sites in the two largest urban areas (Atlanta, GA, and North Birmingham, AL). Other sites in the network had annual design values below the standard, and no site had daily design values above the NAAQS 65 microg/m3 daily standard. Using a particle composition monitor designed specifically for SEARCH, we found that volatilization losses of nitrate, ammonium, and organic carbon must be accounted for to accurately characterize atmospheric particulate matter. In particular, the federal reference method for PM2.5 underestimates mass by 3-7% as a result of these volatilization losses. Organic matter (OM) and sulfate account for approximately 60% of PM2.5 mass at SEARCH sites, whereas major metal oxides (MMO) and unidentified components ("other") account for > or = 80% of PM10-2.5 mass. Limited data suggest that much of the unidentified mass in PM10-2.5 may be OM. For paired comparisons of urban-rural sites, differences in PM2.5 mass are explained, in large part, by higher OM and black carbon at the urban site. For PM10, higher urban concentrations are explained by higher MMO and "other." Annual means for PM2.5 and PM10-2.5 mass and major components demonstrate substantial declines at all of the SEARCH sites over the 1999-2003 period (10-20% in the case of PM2.5, dominated by 14-20% declines in sulfate and 11-26% declines in OM, and 14-25% in the case of PM10-2.5, dominated by 17-30% declines in MMO and 14-31% declines in "other"). Although declining national emissions of sulfur dioxide and anthropogenic carbon may account for a portion of the observed declines, additional investigation will be necessary to establish a quantitative assessment, especially regarding trends in local and regional emissions, primary carbon emissions, and meteorology.     

Optimal design for sustainable development of a material recovery facility in a fast-growing urban setting

Installing material recovery facilities (MRFs) in a solid waste management system could be a feasible alternative to achieve sustainable development goals in urban areas if current household and curbside recycling cannot prove successful in the long run. This paper addresses the optimal site selection and capacity planning for a MRF in conjunction with an optimal shipping strategy of solid waste streams in a multi-district urban region. Screening of material recovery and disposal capacity alternatives can be achieved in terms of economic feasibility, technology limitation, recycling potential, and site availability. The optimization objectives include economic impacts characterized by recycling income and cost components for waste management, while the constraint set consists of mass balance, capacity limitation, recycling limitation, scale economy, conditionality, and relevant screening constraints. A case study for the City of San Antonio, Texas (USA) presents a vivid example where scenario planning demonstrates the robustness and flexibility of this modeling analysis. It proves especially useful when determining MRF ownership structure. Each scenario experiences two case settings: (1) two MRF sites are proposed for selection and (2) a single MRF site is sought. Cost analysis confirms processing fees are not the driving force in the City's operation, but rather shipping cost. Sensitivity analysis solidifies the notion that significant public participation plays the most important role in minimizing solid waste management expenses.     

Ecological factors limiting the distribution of Gilia tricolor in a California grassland mosaic

Recent evolutionary models of range limits emphasize the importance of ecological and demographic factors operating at species' margins. This study aims to establish the ecological context driving population boundaries in Gilia tricolor, a native California annual restricted to distinct habitat patches in the coastal range of California. A transplant experiment in one hillside G. tricolor population examined the roles of competition and soil chemistry as well as litter and biomass accumulation in setting local population boundaries. Results indicate that boundaries are maintained primarily by inhibition of seedling emergence by vegetation and litter, and that upslope and downslope population boundaries are heterogeneous in litter biomass and transplant performance. Consistent emergence inhibition in undisturbed, peripheral sites maintains limits to the distribution of G. tricolor in this population. Fine-scaled ecological heterogeneity and heterogeneous boundary conditions likely play important roles in limiting adaptation and subsequent range expansion at population boundaries in G. tricolor.