Heavy metal accumulation and distribution in Phragmites australis seedlings tissues originating from natural and urban catchment

The retention of heavy metal (HM) was studied in root and rhizomes (BLG), stems (ST), and leaves (LF) of Phragmites australis (common reed) seedlings collected from different locations, differing in the scale of anthropogenic interference. The analysis includes the reference samples of sediments in uncontaminated lake Garczonki and contaminated roadside ditch in Cieplewo. The concentrations of Zn, Cu, Pb, Cd, Ni, and Cr were analyzed in plant tissues and sediments using the atomic absorption spectrometry and inductively coupled plasma mass spectrometry. The general assessment of sediments collected in the Garczonki lake showed a good environmental status; while in the roadside ditch in Cieplewo, the sediments were considerably polluted with HM. In the first stage of plant growth, all of the analyzed HMs are mainly inhibited by BLG system. The decreasing trend of elements was as follows: BLG > ST > LF. The organs followed different decreasing trends of HM concentration; the trend Zn > Cu > Ni > Cr > Pb > Cd was found in ST and LF for the Garczonki lake seedlings and for BLG and LF for the roadside ditch in Cieplewo seedlings. Zn showed the highest concentration, while Cd the lowest concentration in each of the examined organs. The bioaccumulation factor indicated the higher mobility of HM in seedlings in the Garczonki lake than in the roadside ditch in Cieplewo. The morphological studies suggest the good state and health of seedling from both sites; however, the reduction of root hair surface was observed for the roadside ditch seedlings. The anatomical studies present changes in the size of the nucleus and count of chloroplasts in LF. No reaction on HM contamination sediments in the seedlings from the roadside ditch in Cieplewo in the aerenchyma was noted. Potentially, both types of seedlings can be used to decontaminate environments rich in HM. However, the level of HM absorbed by seedlings (in the first stage of growth) should be considered due to the behavior in the target phytoremediation site.

     

Air toxics in Canada measured by the National Air Pollution Surveillance (NAPS) program and their relation to ambient air quality guidelines

This study reports ambient concentrations of 63 air toxics that were measured in Canada by the National Air Pollution Surveillance (NAPS) program over the period 2009–2013. Measured concentrations are compared with ambient air quality guidelines from Canadian jurisdictions, and compounds that exceeded guidelines are identified and discussed. Although this study does not assess risk or cumulative effects, air toxics that approached guidelines are also identified so that their potential contribution to ambient air toxics pollution can be considered. Eleven air toxics exceeded at least one guideline, and an additional 16 approached guidelines during the study period. Four compounds were measured using methods whose detection limits exceeded a guideline value, three of which could not be compared with guidelines, since they were not detected in any samples. The assessment of several metal(loid) concentrations is tentative, since they were measured only in fine particulate matter (PM) but compared with guidelines based on coarse or total PM. Improvements to sampling and analysis techniques for the latter compounds as well as for those whose methods are subject to known uncertainties would improve confidence in reported concentrations and their relation to applicable guidelines. Analysis of sampling strategies for all compounds found to exceed or approach guidelines would contribute to ensuring that their spatiotemporal coverage is adequate. Examination of the air toxics not measured by NAPS but having guidelines in Canadian jurisdictions or being included in other programs such as the U.S. National-Scale Air Toxics Assessment (NATA) would contribute to ensuring that the full suite of pollutants relevant to ambient air quality in Canada is subject to adequate study. The results of this study can be applied to evaluating the effectiveness of toxic substances management in Canada.

Implications: Recent measurements of 63 air toxics in Canada by the National Air Pollution Surveillance (NAPS) program showed that 11 compounds exceeded daily or annual ambient air quality guidelines and that an additional 16 compounds approached such guidelines within an order of magnitude. The results of this study can be applied to evaluating the effectiveness of toxic substances management in Canada and to identifying compounds that merit further investigation.     

Dust-particle migration around flotation tailings ponds: pine needles as passive samplers

The potential use of dust particles trapped on Scots pine needles for tracking dust migration around flotation tailings ponds in the Silesian-Krakowian ore district, Southern Poland was tested. 1-, 2- and 3-years old needles were studied using a scanning electron microscope and energy dispersive X-ray microanalysis. Particle sizes and morphologies, and the nature of the compounds hosting metals ions, were examined. A large majority of the particles examined are <10 microm in size. Almost 80% of particles represent respirable dust. All the components in the flotation wastes appear among the chemical compounds identified in particles on the pine needles. The quantity of the waste particles decreases with distance from the flotation tailings ponds. The analysis of dust particles on pine needles could be a useful method for estimating vectors and travel distances of suspended dust migrating around open flotation tailings ponds and around other point sources emitting dust particles with chemical compositions differing from the environmental background.     

Genotoxicological effects of some phenoxyherbicides and their metabolites on Bacillus subtilis M45 Rec- and H17 Rec+ strains

Because they are used in a number of commercial preparations phenoxyacetic acids and their salts can occur in wastewater. During their degradation genotoxic substances may be created. The results of investigations of biodegradability and genotoxicity of some phenoxyherbicides are presented. Commercial formulations of 2,4-D (Aminopielik 720) and MCPA (Chwastox Extra) were the substrates studied. Biodegradation tests were conducted according to OECD guidelines for testing of chemicals--confirmatory test (OECD Method 303 A). Genotoxicity tests were conducted with Bacillus subtilis strains according to the method of [Chemical Mutagens, vol. 6, Plenum Press. New York, 1980, p. 149]. Genotoxicity of biodegradation products was also studied. Both commercial formulations were biodegradable. Aminopielik 720 was potentially genotoxic but only at great concentrations while Chwastox Extra was not genotoxic. Biodegradation products of neither compound were genotoxic.     

Occupational Exposure to Polycyclic Aromatic Hydrocarbons During Diesel Combustion

Identification and determination of polycyclic aromatic hydrocarbons (PAHs) in Diesel exhaust in the working environment and assessment of workers’ occupational exposure to these suspected human carcinogens were the aim of this experimental investigation.

The range of exposure factors calculated on the basis of 9 individual PAH concentrations determined in personal air samples shows that time-averaged concentration of these compounds did not exceed the Polish Maximum Admissible Concentration (MAC) value for PAHs, that is, 2 μg·m^–3. The highest concentrations of PAHs were determined in the breathing zone of forklift operators. The maximum exposure factor was 0.427 μg·m^–3 (about 1/4 of MAC).     

Adaptive alterations in the fatty acids composition under induced oxidative stress in heavy metal-tolerant filamentous fungus Paecilomyces marquandii cultured in ascorbic acid presence

The ability of the heavy metal-tolerant fungus Paecilomyces marquandii to modulate whole cells fatty acid composition and saturation in response to IC₅₀ of Cd, Pb, Zn, Ni, and Cu was studied. Cadmium and nickel caused the most significant growth reduction. In the mycelia cultured with all tested metals, with the exception of nickel, a rise in the fatty acid unsaturation was noted. The fungus exposure to Pb, Cu, and Ni led to significantly higher lipid peroxidation. P. marquandii incubated in the presence of the tested metals responded with an increase in the level of linoleic acid and escalation of electrolyte leakage. The highest efflux of electrolytes was caused by lead. In these conditions, the fungus was able to bind up to 100 mg?g^?1 of lead, whereas the content of the other metals in the mycelium was significantly lower and reached from 3.18 mg?g^?1 (Cu) to 15.21 mg?g^?1 (Zn). Additionally, it was shown that ascorbic acid at the concentration of 1 mM protected fungal growth and prevented the changes in the fatty acid composition and saturation but did not alleviate lipid peroxidation or affect the increased permeability of membranes after lead exposure. Pro-oxidant properties of ascorbic acid in the copper-stressed cells manifested strong growth inhibition and enhanced metal accumulation as a result of membrane damage. Toxic metals action caused cellular modulations, which might contributed to P. marquandii tolerance to the studied metals. Moreover, these changes can enhance metal removal from contaminated environment.     

Novel Tough Crystalline Blends of Polylactide with Ethylene Glycol Derivative of POSS

Blending of polylactide (PLA) with low stereoregularity and polyhedral oligomeric silsesquioxane grafted with arms of poly(ethylene glycol) methyl ether, acting as a plasticizer, allowed us previously to obtain a novel stable elastomeric-like material. The present contribution focuses on the properties of semi-crystalline PLA plasticized with this compound. Melt blends of PLA with 5–15 wt% of the plasticizer, were compression molded, quenched and annealed, which enabled cold-crystallization. The glass transition temperature of the blends and their drawability depended on their crystallinity and plasticizer content. The best ductility was reached at the plasticizer content of 15 wt%; the achieved strain at break was 6.5 (650%) and 1.3 (130%), for the quenched and annealed material, respectively. The latter value exceeded 20 times the strain at break of neat crystalline PLA. The tensile toughness of the annealed 15 wt% blend was 12 times larger than that of crystalline PLA. Moreover, annealing of 15 wt% blend improved its yield strength by 40%. Despite the two peaks of the loss modulus, indicating the two glass transitions in this blend, no heterogeneities were found by scanning electron microscopy, indicating that the plasticizer enriched phase formed instead of distinct inclusions of the plasticizer.     

Spatiotemporal trends of PM2.5 and its major chemical components at urban sites in Canada

To evaluate the effectiveness of emission control regulations designed for reducing air pollution, chemically resolved PM_2.5 data have been collected across Canada through the National Air Pollution Surveillance network in the past decade. 24-hr time integrated PM_2.5 collected at seven urban and two rural sites during 2010-2016 were analyzed to characterize geographical and seasonal patterns and associated potential causes. Site-specific seven-year mean gravimetric PM_2.5 mass concentrations ranged from 5.7 to 9.6 µg/m³. Seven-year mean concentrations of SO₄^2?, NO₃^?, NH₄⁺, organic carbon (OC), and elemental carbon (EC) were in the range of 0.68 to 1.6, 0.21 to 1.5, 0.27 to 0.71, 1.1 to 1.9, and 0.37 to 0.71 µg /m³, accounting for 10.8%-18.1%, 3.7%-16.7%, 4.7%-7.4%, 18.4%-21.0%, and 6.4%-10.6%, respectively, of gravimetric PM_2.5 mass. PM_2.5 and its five major chemical components showed higher concentrations in southeastern Canada and lower values in Atlantic Canada, with the seven-year mean ratios between the two regions being on the order of 1.7 for PM_2.5 and 1.8-7.1 for its chemical components. When comparing the concentrations between urban and rural sites within the same region, those of SO₄^2? and NH₄⁺ were comparable, while those of NO₃^?, OC, and EC were around 20%, 40%-50%, and 70%-80%, respectively, higher at urban than rural sites, indicating the regional scale impacts of SO₄^2? and NH₄⁺ and effects of local sources on OC and EC. Monthly variations generally showed summertime peaks for SO₄^2? and wintertime peaks for NO₃^?, but those of NH₄⁺, OC, and EC exhibited different seasonality at different locations.     

Small effects of a large sediment contamination with heavy metals on aquatic organisms in the vicinity of an abandoned lead and zinc mine

The effects of the long-term contamination of water reservoirs with mine effluents were investigated at an abandoned mine site in Upper Silesia, southern Poland. The studies covered metal content and mobility in bottom sediments as well as water chemistry in relation to the content of metals in selected macrophytes and their physiology and the composition of phyto- and zooplankton communities. Although it is 40 years since mining ceased, reservoir sediments are still heavily contaminated with cadmium, zinc and lead with concentrations (mg/kg), which vary roughly between 130–340, 10,000–50,000 and 4,000–12,000, respectively. About 50–80 % of these elements are associated with the reducible phase, and only a small percentage, <10 %, is present in the most mobile exchangeable phase. Despite the high total metal concentration in sediments, their content in the submerged plants Myriophyllum spicatum and the emerged plants Phragmites australis was low. The observed effects of heavy metal contamination on photosynthetic activity in the leaves of P. australis were negligible, whereas those in M. spicatum show up only as a difference in the distribution of photosynthetic activity in leaves of different ages, which seems to be related to the very good water quality and to the generally small concentrations of metals in pond water. The physicochemical properties of water also seem to control the presence of planktonic species more than does sediment contamination. However, a shift toward groups of species known to be more resistant to heavy metals (diatoms, green algae and Rotifera) indicates some adaptative changes related to the long-lasting contamination of ponds.     

Arizona Hazardous Air Pollutants Monitoring Program

ABSTRACT

In order to evaluate the existing risk to public health in Arizona related to hazardous air pollution, ambient air monitoring for selected hazardous air pollutants (HAPs) was carried out in 1994-1996 in several representative urban and rural areas of Arizona. A wide range of organic HAPs was monitored, requiring a variety of sampling and analysis methods. Stainless steel SUMMA canisters were used for collection of volatile hydrocarbons and halocarbons, which were analyzed by capillary gas chromatography with flame ionization and electron capture detection (GC-FID/ECD). Carbonyl compounds were collected using 2,4-dinitrophenylhydrazine-impregnated cartridges and analyzed by high performance liquid chromatog-raphy with ultraviolet detection. Semi-volatile and non-volatile polycyclic aromatic compounds were collected using a sampling train consisting of a filter followed by a PUF/XAD-4/PUF sandwich cartridge. Following extraction, samples were analyzed by capillary GC with mass spectrometric detection (GC-MS). Database software was developed for data processing and reporting functions. This paper describes the sampling strategy and the sampling and analysis methods employed in the monitoring program and presents a summary of all the results obtained during the duration of the sampling program.