TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

Preparation of biochar catalyst with saccharide and lignocellulose residues of corncob degradation for corncob hydrolysis into furfural

This paper presented a novel process for production of furfural by hydrothermal degradation of corncob over biochar catalyst, in which it was prepared with the recycling degradation solution and lignocellulosic solid residues. The biochar catalyst was papered by lignocellulose residues and concentrated saccharide solution, and then impregnated in 0.5 mol/L sulphuric acid at room temperature for 24 h assisted by the ultrasonic vibration. In the system of recycling, 8.8 % lignocellulose residues and 100 % concentrated saccharide solution from corncob hydrolysis have been recycled. Hydrolysis of corncob was carried out at 180 °C for duration of 170 min over the biochar catalyst. The experimental results have shown that the furfural yield of up to 37.75 % and overall corncob conversion rate of 62.00 % could be achieved under optimum operating conditions for the catalysts preparation and the corncob hydrolysis. It is believed that the acid density of 4.27 mmol/g of biochar catalyst makes the SO₃H groups cleave β-1,4 glycosidic linkages effectively and hydrolyze the cellulose and hemicellulose to water-soluble sugars, as well as to facilitate dehydration of xylose to give the product of furfural.     

PbO_2复合电极预处理甲苯二胺废水

通过涂覆—热分解法与电沉积法制备了β-PbO_2/α-PbO_2/SnO_2-Sb2O3/Ti复合电极(PbO_2复合电极),采用X射线衍射(XRD)、扫描电子显微镜(SEM)、循环伏安法(CV)、线性极化法(LSV)和加速寿命试验对电极进行表征。将PbO_2复合电极用于处理甲苯二胺(TDA)废水,考察了电解质浓度、电流密度对TDA降解效果的影响。实验结果表明:α-PbO_2呈梭状,β-PbO_2呈花菜状,多层结构的PbO_2电极利于提高电极的稳定性和活性;PbO_2复合电极的析氧电位(1.9 V)明显高于TDA的氧化电位(1.28 V),其使用寿命长达486 d;在电流密度为60 m A/cm2、Na2SO4质量浓度为10 g/L、电解时间为240 min的条件下,对COD为4 791.74 mg/L、TDA质量浓度为486.4mg/L的废水进行处理,TDA去除率高达97.3%,COD去除率可达88.1%。     

Simulation of dam/levee-break hydrodynamics with a three-dimensional implicit unstructured-mesh finite element model

Dam failures usually cause huge economic and life losses , especially in urban areas where there is a high concentration of inhabitants and economic actors. In order to understand the physical mechanisms of the formation and development of dam-break flooding, lots of efforts have been put into different types of modelling techniques. However, most of existing models are 1D (one-dimensional) or 2D models based on the shallow water equations. In this paper, we present a 3D numerical modelling investigation of dam-break flow hydrodynamics in an open L-shape channel. A newly developed 3D unstructured mesh finite element model is used here. An absorption-like term is introduced to the Navier–Stokes equations in order to control the conditioning of the matrix equation in the numerical solution process and thus improve the stability. A wetting and drying algorithm is used here to allow the free surface height to be treated with a high level of implicitness and stability. The 3D model has been validated by comparing the results with the published experimental data. Good agreement has been achieved at six selected locations. This study shows that the 3D unstructured mesh model is capable of capturing the 3D hydraulic aspects and complicated local flows around structures in simulation of dam-break flows.     

Role of illumination intensity in microcystin development using Microcystis aeruginosa as the model algae

Environmental Science and Pollution Research - Microcystis aeruginosa (M. aeruginosa) is one of the most common genera of cyanobacteria in algal blooms. In the present work, the impact of the...     

强化循环厌氧反应器处理印染废水的中试启动研究

应用自主研制的强化循环厌氧反应器(SCAR)中试规模处理实际印染废水,研究反应器的启动特性。反应器接种厌氧颗粒污泥后启动运行83 d,形成连续内循环并实现了对印染废水处理的高效稳定运行。在进水COD浓度1 000~3 650 mg/L、系统容积负荷0.7~6.4 kg/(m3·d)条件下,废水COD和色度平均去除率分别达到55%和73%。反应器内较高浓度的NH+4-N保证了系统pH的稳定性,350~600 mg/L的NH+4-N浓度没有对强化循环厌氧反应器产生抑制作用,系统内也没有出现VFA(以乙酸计)积累。启动过程中,厌氧颗粒污泥的粒径增大、沉降性能变好。启动实验完成时,反应器内微生物的脱氢酶活性(以TF计)和辅酶F420浓度分别为3.4973 mg/(g·h)和0.1872μmol/g。     

DO浓度对间歇曝气单级自养脱氮系统N2O排放的影响

以单级自养脱氮系统为研究对象,采用有效容积为15 L的SBBR反应器,系统进水NH+4-N浓度约为360 mg/L,控制温度为(30±2)℃,采用间歇曝气方式运行,曝气段DO浓度从2.4~2.6 mg/L逐渐下降到0.9~1.1 mg/L,研究了单级自养脱氮系统的脱氮性能与N2O排放情况。结果表明,反应器曝气段DO浓度从2.4~2.6 mg/L下降到0.9~1.1mg/L,系统TN去除率均达到80%,但在相同运行时间内的TN去除率依次降低,NH+4-N平均反应速率从0.19 mg/(L·min)降低至0.05 mg/(L·min),NO-3-N累计产生量稳定于14.9~16.5 mg/L,NO-2-N浓度在反应器内未产生明显的积累。随着曝气段DO浓度的下降,最大N2O释放速率逐渐降低,N2O累计释放量从73.8 mg下降到61.0 mg,N2O转化率介于2.4%~2.9%。     

非离子型聚丙烯酰胺絮凝剂的制备及其絮凝性能

以丙烯酰胺（AM）和烷基酚聚醚（APAP）为单体,采用反相乳液聚合法制备了流动性好的非离子型聚丙烯酰胺絮凝剂（PAM-APAP）。考察了乳化剂和引发剂的种类、单体总质量分数、单体配比和反应温度等因素对聚合反应的影响。实验结果表明,制备PAM-APAP的最佳工艺条件为：单体总质量分数35%、m（AM）∶m（APAP）=9.0∶1.0、Span80+Tween80复配乳化剂加入量为油水总质量的7%、m（Span80）∶m（Tween80）=7.0∶1.5、V50加入量为单体总质量的1.5‰、反应温度50℃。PAM-APAP具有较好的絮凝效果,与其他絮凝剂相比用量较少,在加入量为100mg/L时,对聚合物驱油中产生的含聚合物污水的浊度去除率为87.9%,去油率为89.5%,且絮体不黏壁。     

Generation of solid wastes in typhoon disasters and their emergent cleaning and treatment means

In Taiwan, typhoons usually result in a large amount of waste that needs to be removed in a short time from July to October. This study reviewed the relevant regulations on the clean-up of typhoon waste, including emergency response regulations, organizations and information systems; and we also discuss different typhoon waste clean-up and disposal methods. The results indicate that the parameters other than the maximum wind speed, such as the maximum accumulated rainfall, flooded area, waste output, sludge output, disinfected area and government dispatched attendance reached statistical significance (p < 0.05). Waste, tree branches and bird carcasses were primarily incinerated, while silt and building materials were buried, and pig and cattle carcasses were placed in a landfill with the tertiary treatment of wastewater. This study also reports on the relevant regulations for prevention of epidemics among personnel working in disaster areas. The results can provide important references for the disposal of typhoon waste in developing countries. As Asian countries have similar life styles and are often attacked by typhoons, the results of this study provide Asian countries with the operating experience of Taiwan in emergency treatment of solid waste resulting from typhoons as a reference for them to plan response systems and operation.     

Concentration and health risk evaluation of heavy metals in market-sold vegetables and fishes based on questionnaires in Beijing,China

Concentrations of heavy metals (As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn) in market vegetables and fishes in Beijing, China, are investigated, and their health risk to local consumers is evaluated by calculating the target hazard quotient (THQ). The heavy metal concentrations in vegetables and fishes ranged from not detectable (ND) to 0.21 mg/kg fresh weight (f.w.) (As), ND to 0.10 mg/kg f.w. (Cd), and n.d to 0.57 mg/kg f.w. (Pb), with average concentrations of 0.17, 0.04, and 0.24 mg/kg f.w., respectively. The measured concentrations of As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn are generally lower than the safety limits given by the Chinese regulation safety and quality standards of agriculture products (GB2762-2012). As, Cd, and Pb contaminations are found in vegetables and fishes. The exceeding standard rates are 19 % for As, 3 % for Cd, and 25 % for Pb. Pb contaminations are found quite focused on the fish samples from traditional agri-product markets. The paper further analyzed the health risk of heavy metals in vegetables and fishes respectively from supermarkets and traditional agri-product markets; the results showed that the fishes of traditional agri-product markets have higher health risk, while the supermarkets have vegetables of higher heavy metal risk, and the supervision should be strengthened in the fish supply channels in traditional agri-product markets.