Ozone Injury to Pinus Strobus

In a study of the ozone-induced needle blight of eastern white pine in central New York, acute injuries naturally induced on field trees during a year of relatively low ozone concentrations (1 966) were compared with injuries induced during a year of higher concentrations (1967). Injuries were more frequent and severe and were associated with higher mean ozone concentrations in 1967 than in 1966. Characteristic symptoms were induced on foliage of pine branches exposed to controlled doses of ozone as low as 7 ± 1 pphm for four hours or 3 ± 1 pphm for 48 hours. Such doses were equalled or exceeded two and four times, respectively, in the field during the 1 967 season. Ozone sensitivity of pine needle tissue was increased by fumigation in atmospheres containing water mist. High concentrations of ozone (40-60 pphm) caused general injury of foliage of both ozone-susceptible and resistant trees; the symptoms were unlike those found in the field or caused by fumigation with low concentrations of ozone.     

Sulfur Dioxide Removal and Recovery from Pulp Mill Power Plants

The use of soda ash liquor to scrub SO₂ rich power plant flue gases was studied using an Airetron pilot scrubber with a maximum capacity of 3000 cfm. The relative effects of the major operating variables— temperature, soda ash concentration, and the gas/liquid flow ratio—on the absorption phenomenon were determined. Orthogonal factorial experiments were used to derive a response function relating mass transfer values to operating variables. The economics of a full scale NSSC installation are discussed.     

Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.     

Stack Dust Sampling: in-Stack Filter or E.P.A. Train

The Environmental Protection Agency has recommended or specified methods for the measurement of participate concentrations in flue gases. The EPA Train for this measurement originally comprised two segments: the front half and the impinger train downstream from the filter proper. This review examines the controversial areas implicit in the use of this EPA Train or the revised EPA train which eliminates the impinger train.     

Honorary Memberships

Honorary Memberships are conferred by the Air Pollution Control Association on persons of widely recognized eminence in some part of the field of air pollution control or who have rendered especially meritorious service to the Association. Honorary Memberships were awarded this year to Dr. Leonard Greenburg and Mr. Milton Reizenstein, both past presidents of APCA.     

Mathematical Modeling of Photochemical Smog Using the PICK Method

A new method for solving the turbulent atmospheric diffusion equation has been developed based on Lagrangian mass points, or particles moving through an Eulerian grid. The method is one of a family of Particle-/n-Cell techniques but is a unique extension to incorporate the effects of turbulent diffusion based on K-theory; thus the acronym PICK.

In the three-dimensional computer-aided model, NEXUS (Numerical EXamination of Urban Smog), this method has been applied to simulation of carbon monoxide (CO) in Los Angeles. For CO the NEXUS simulation was within 20% of observed day-averaged concentrations at 12 stations and the hour-averages were also in good agreement. This model was extended to include the effects of photochemical smog in Los Angeles. The results of the photochemical simulation were also qualitatively correct due to rapid NO to NO₂ conversion in the simulation.     

Stack Sampling of Hygroscopic Particulates In an Entrained Water Environment

Reference methods for the determination of mercury emissions from stationary sources typically include collection of mercury by solutions which are acidic and oxidizing. In the presence of high levels of SO₂ the oxidizing capacity of these absorbing solutions will be degraded and the collection efficiency for mercury compromised. This seriously limits the usefulness of the reference methods as they apply to the mining and smelting industries. In the present work peroxide is used to remove SO₂ and acidic permanganate is used to collect mercury. At a mean sampling rate of 10 L/min concentrations of at least 12 mg/m³ mercury can be satisfactorily collected in the presence of up to 20,000 ppm SO₂.     

Rotating Concentric “Homogeneous Turbulence” Gas Scrubber

A device which utilizes the Couette (secondary) flow patterns, which are developed in a fluid between rotating concentric cylinders, is proposed for use in particle collection. The gas being cleaned is dispersed in the scrubbing liquid within the annular space between cylinders. The device was untested at the time of presentation of the paper.     

Prevention Of Significant Deterioration A Critical Review

Prevention of significant deterioration has been a subject of study and discussion for about ten years. An extensive survey of the legislative and legal aspects of this concept is presented in this review. The growth of the concept and its implementation are subjected to critical scrutiny.