Is there an inverted U-shaped curve? Empirical analysis of the Environmental Kuznets Curve in agrochemicals

As the largest contributor to water impairment, agriculture-related pollution has attracted the attention of scientists as well as policy makers, and quantitative information is being sought to focus and advance the policy debate. This study applies the panel unit root, heterogeneous panel cointegration, and panel-based dynamic ordinary least squares to investigate the Environmental Kuznets Curve on environmental issues resulting from use of agricultural synthetic fertilizer, pesticide, and film for 31 provincial economies in mainland China from 1989 to 2009. The empirical results indicate a positive long-run co-integrated relationship between the environmental index and real GDP per capita. This relationship takes on the inverted U-shaped Environmental Kuznets Curve, and the value of the turning point is approximately 10,000–13,000, 85,000–89,000 and over 160,000 CNY, for synthetic fertilizer nitrogen indicator, fertilizer phosphorus indicator and pesticide indicator, respectively. At present, China is subject to tremendous environmental pressure and should assign more importance to special agriculture-related environmental issues.     

Simple model of sludge thickening process in secondary settlers

In wastewater treatment plants (WWTPs), a secondary settler acts as a clarifier, sludge thickener, and sludge storage tank during peak flows and therefore plays an important role in the performance of the activated sludge process. Sludge thickening occurs in the lower portions of secondary clarifiers during their operation. In this study, by detecting the hindered zone from the complete thickening process of activated sludge, a simple model for the sludge thickening velocity, u _s = aX ^b (a = 0.9925SSVI _3.5, b = 3.541ln(SSVI _3.5)+12.973), describing the potential and performance of activated sludge thickening in the hindered zone was developed. However, sludge thickening in the compression zone was not studied because sludge in the compression zone showed limited thickening. This empirical model was developed using batch settling data obtained from four WWTPs and validated using measured data from a fifth WWTP to better study sludge thickening. To explore different sludge settling and thickening mechanisms, the curves of sludge thickening and sludge settling were compared. Finally, it was found that several factors including temperature, stirring, initial depth, and polymer conditioning can lead to highly concentrated return sludge and biomass in a biologic reactor.     

Removal of elemental mercury by KI-impregnated clay

This study described the use of clay impregnated by KI in gas phase elemental mercury (Hg^o) removal in flue gas. The effects of KI loading, temperature, O₂, SO₂ and H₂O on Hg^o removal were investigated using a fixed bed reactor. The Hg^o removal efficiency of KI-clay with 3% KI loading could maintain at a high level (approximately 80 %) after 3 h. The KI-clay demonstrated to be a potential adsorbent for Hg^o removal when compared with activated carbon based adsorbent. O₂ was found to be an important factor in improving the Hg^o removal. O₂ was demonstrated to assist the transfer of KI to I₂ on the surface of KI-clay, which could react with Hg^o directly. NO and SO₂ could slightly improve Hg^o removal, while H₂O inhibited it greatly. The results indicated that after adsorption, most of the mercury escaped from the surface again. Some of the mercury may have been oxidized as it left the surface. The results demonstrated that the chemical reaction primarily occurred between KI and mercury on the surface of the KI-clay.     

Vacuum promotes metabolic shifts and increases biogenic hydrogen production in dark fermentation systems

The successful operation of any type of hydrogen-producing bioreactor depends on the performance of the microorganisms present in the system. Both substrate and partial gas pressures are crucial factors affecting dark fermentation metabolic pathways. The main objective of this study was to evaluate the impact of both factors on hydrogen production using anaerobic granular sludge as inoculum and, secondly, to study the metabolic shifts of an anaerobic community subjected to low partial gas pressures. With this goal in mind, seven different wastewater (four synthetic media, two industrial wastewater, and one domestic effluent) and the effect of applying vacuum on the systems were analyzed. The application of vacuum promoted an increase in the diversity of hydrogenproducing bacteria, such as Clostridium, and promoted the dominance of acetoclastic- over hydrogenotrophic methanogens. The application of different media promoted a wide variety of metabolic pathways. Nevertheless, reduction of the hydrogen partial pressure by application of vacuum lead to further oxidation of reaction intermediates irrespective of the medium used, which resulted in higher hydrogen and methane production, and improved the COD removal. Interestingly, vacuum greatly promoted biogenic hydrogen production from a real wastewater, which opens possibilities for future application of dark fermentation systems to enhance biohydrogen yields.     

A photolysis coefficient for characterizing the response of aqueous constituents to photolysis

UV photolysis and UV based advanced oxidation processes (AOPs) are gaining more and more attention for drinking water treatment. Quantum yield (ø) and molar absorption coefficient (ε) are the two critical parameters measuring the effectiveness of photolysis of a compound. The product of the two was proposed as a fundamental measure of a constituent’s amenability to transformation by photolysis. It was shown that this product, named the photolysis coefficient, k _p , can be determined using standard bench tests and captures the properties that govern a constituent’s transformation when exposed to light. The development showed the photolysis coefficient to be equally useful for microbiological, inorganic and organic constituents. Values of k _p calculated by the authors based on quantum yield and molar absorption coefficient data from the literature were summarized. Photolysis coefficients among microorganisms ranged from 8500 to more than 600000 and are far higher than for inorganic and organic compounds, which varied over a range of approximately 10 to 1000 and are much less sensitive to UV photolysis than the microorganisms.     

Multiphase redistribution differences of polycyclic aromatic hydrocarbons (PAHs) between two successive sediment suspensions

Successive sediment suspensions often happen in estuary, yet little research has probed into the difference in the release behaviors of organic compounds among different suspensions. This study took polycyclic aromatic hydrocarbons (PAHs) as typical organic contaminants and investigated the release behaviors between two successive suspensions with a particle entrainment simulator (PES). Results showed that successive sediment suspensions lowered the concentration of dissolved PAHs in the overlying water via facilitating the re-adsorption of dissolved PAHs onto the suspended particles. Fast-release and slow-release periods of PAHs were successively observed in the both suspensions. The concentration changes of dissolved PAHs in the second suspension were generally similar with but hysteretic to those in the first suspension. More vigorous desorption and re-absorption of PAHs were induced in the second suspension. Successive sediment suspensions obviously decreased the concentrations of mineral composition and organic matters in the overlying water, which significantly affects multiphase distribution of PAHs.     

The prediction of adsorption isotherms of ester vapors on hypercrosslinked polymeric adsorbent

Adsorption isotherms of methyl acetate, ethyl acetate, propyl acetate, isopropyl acetate and ethyl propionate on hypercrosslinked polymeric resin (ND- 100) were measured at 303K, 318K and 333K,respectively, and well fitted by Dubinin–Astakhov (DA) equation. The plots of the adsorbed volume (q _v ) versus the adsorption potential (ε) at three different temperatures all fell basically onto one single curve for every ester. A predicted model based on DA equation was obtained on the basis of adsorption equilibrium data of methyl acetate, ethyl acetate and ethyl propionate at 318K. The model equation successfully predicted the adsorption isotherms of methyl acetate, ethyl acetate and ethyl propionate on ND-100 at 303K, and 333K, and also gave accurate predictive results for adsorption isotherms of the other two ester compounds (propyl acetate and isopropyl acetate) on ND-100 at 303K, 318K and 333K. The results proved the effectiveness of DA model for predicting the adsorption isotherms of ester compounds onto ND-100. In addition, the relationship between physico-chemical properties of adsorbates and their adsorption properties was also investigated. The results showed that molecular weight, molar volume and molar polarizability had good linear correlations with the parameter E (which represents adsorption characteristic energy) of DA equation.     

Chemical characteristics of fine particulate matter emitted from commercial cooking

The chemical characteristics of fine particulate matter (PM_2.5) emitted from commercial cooking were explored in this study. Three typical commercial restaurants in Shanghai, i.e., a Shanghai-style one (SHS), a Sichuan-style one (SCS) and an Italian-style one (ITS), were selected to conduct PM_2.5 sampling. Particulate organic matter (POM) was found to be the predominant contributor to cooking-related PM_2.5 mass in all the tested restaurants, with a proportion of 69.1% to 77.1%. Specifically, 80 trace organic compounds were identified and quantified by gas chromatography/mass spectrometry (GC/MS), which accounted for 3.8%–6.5% of the total PM_2.5 mass. Among the quantified organic compounds, unsaturated fatty acids had the highest concentration, followed by saturated fatty acids. Comparatively, the impacts of other kinds of organic compounds were much smaller. Oleic acid was the most abundant single species in both SCS and ITS. However, in the case of SHS, linoleic acid was the richest one. ITS produced a much larger mass fraction of most organic species in POM than the two Chinese cooking styles except for monosaccharide anhydrides and sterols. The results of this study could be utilized to explore the contribution of cooking emissions to PM_2.5 pollution and to develop the emission inventory of PM_2.5 from cooking, which could then help the policymakers design efficient treatment measures and control strategies on cooking emissions in the future.     

Changes of microbial composition during wastewater reclamation and distribution systems revealed by high-throughput sequencing analyses

This study employed 454-pyrosequencing to investigate microbial and pathogenic communities in two wastewater reclamation and distribution systems. A total of 11972 effective 16S rRNA sequences were acquired from these two reclamation systems, and then designated to relevant taxonomic ranks by using RDP classifier. The Chao index and Shannon diversity index showed that the diversities of microbial communities decreased along wastewater reclamation processes. Proteobacteria was the most dominant phylum in reclaimed water after disinfection, which accounted for 83% and 88% in two systems, respectively. Human opportunistic pathogens, including Clostridium, Escherichia, Shigella, Pseudomonas and Mycobacterium, were selected and enriched by disinfection processes. The total chlorine and nutrients (TOC, NH₃-N and NO₃-N) significantly affected the microbial and pathogenic communities during reclaimed water storage and distribution processes. Our results indicated that the disinfectant-resistant pathogens should be controlled in reclaimed water, since the increases in relative abundances of pathogenic bacteria after disinfection implicate the potential public health associated with reclaimed water.