A comparison of two techniques for studying sediment desorption kinetics of hydrophobic pollutants

A comparison of two techniques (gaseous purge and vial desorption) for studying the kinetics of desorption of hydrophobic pollutants from natural sediments was conducted using identical, pre-equilibrated pollutant-sediment suspensions. Desorption profiles for the two techniques [for Lindane, Aldrin, 2,2'-dichlorobiphenyl (2,2'-DCB), 4,4'-dichlorobiphenyl (4,4'-DCB), and 2,2',6,6'-tetrachlorobiphenyl (TCB)] were then compared, based on the distribution of pollutant mass between the labile (fast) and non-labile (slow) desorption phases and the release rate constants for each phase of release. The vial desorption technique shows many practical advantages over the gaseous purge technique, including its more realistic mixing conditions, the use of an independent sample for each data point (as opposed to a calculation of a cumulative mass purged at each time point), the fact that the vials constitute a closed system and are therefore less subject to ambient contamination, and the relatively low demands of time and money for the vial technique. No consistent trends in labile rate constants or in pollutant distribution between the labile and non-labile phase were observed between the two techniques. A comparison of kinetic parameters shows much faster non-labile rate constants for the gaseous purge technique, attributed to the violent, continuous agitation employed, which likely disrupted sediment aggregates and oxidized the natural organic matter associated with the sediment. Non-labile rate constants have implications for the long-term fate of compounds adsorbed to repetitively disturbed sediments. This study suggests that the traditionally less popular vial desorption technique may yield more realistic non-labile desorption rate constants.     

Integrated catalytic wet air oxidation and aerobic biological treatment in a municipal WWTP of a high-strength o-cresol wastewater

This study examines the feasibility of coupling a Catalytic Wet Air Oxidation (CWAO), with activated carbon (AC) as catalyst, and an aerobic biological treatment to treat a high-strength o-cresol wastewater. Two goals are pursued: (a) To determine the effect of the main AC/CWAO intermediates on the activated sludge of a municipal WasteWater Treatment Plant (WWTP) and (b) To demonstrate the feasibility of coupling the AC/CWAO effluent as a part of the influent of a municipal WWTP. In a previous study, a high-strength o-cresol wastewater was treated by AC/CWAO aiming to establish the distribution of intermediates and the biodegradability enhancement. In this work, the biodegradability, toxicity and inhibition of the most relevant intermediates detected in the AC/CWAO effluent were determined by respirometry. Also, the results of a pilot scale municipal WWTP study for an integrated AC/CWAO-aerobic biological treatment of this effluent are presented. The biodegradation parameters (i.e. maximum oxygen uptake rate and oxygen consumption) of main AC/CWAO intermediates allowed the classification of the intermediates into readily biodegradable, inert or toxic/inhibitory compounds. This detailed study, allowed to understand the biodegradability enhancement exhibited by an AC/CWAO effluent and to achieve a successful strategy for coupling the AC/CWAO step with an aerobic biological treatment for a high-strength o-cresol wastewater. Using 30%, as COD, of AC/CWAO effluent in the inlet to the pilot scale WWTP, the integrated AC/CWAO-biological treatment achieved a 98% of total COD removal and, particularly, a 91% of AC/CWAO effluent COD removal without any undesirable effect on the biomass.     

Age and seasonal variability of polybrominated diphenyl ethers in free-ranging East Greenland polar bears (Ursus maritimus)

Polybrominated diphenyl ethers (PBDEs) were analysed in adipose tissue from 92 East Greenland polar bears (Ursus maritimus) sampled during 1999-2001. Mean SigmaPBDE concentrations were 70 ng/g lipid weight (lw) (range: 22-192 ng/g lw) and showed no relationship with age or sex. Of the 32 analysed PBDE congeners; BDE47, BDE153, BDE99 and BDE100 dominated, and comprised 99.6% of the SigmaPBDE concentration. The SigmaPBDE concentration had a highly significant correlation with SigmaPCB, SigmaCHL, dieldrin, HCB and SigmaHCH concentrations. We found a seasonal pattern of median SigmaPBDE concentration with 1.2 to 1.8 times higher concentrations in March to July than the rest of the year. The seasonal variation also provides a clue to the seasonal exposure, bio-availability, toxic exposure and degradation. We suggest that future geographical PBDE data comparisons may not need corrections for sex or age, but such data sets should be corrected for seasonal variability, using the presented correctional trigonometric regression.     

Synthesis of polyhydroxyalkanoates in municipal wastewater treatment.

Biologically derived polyesters known as polyhydroxyalkanoates (PHAs) represent a potentially "sustainable" replacement to fossil-fuel-based thermoplastics. However, current commercial practices that produce PHA with pure microbial cultures grown on renewable, but refined, feedstocks (i.e., glucose) under sterile conditions do not represent a sustainable commodity. Here, we report on PHA production with a mixed microbial consortium indigenous to an activated sludge process on carbon present in municipal wastewaters. Reactors operated under anaerobic/aerobic and aerobic-only mode and fed primary solids fermenter liquor maintained a mixed microbial consortium capable of synthesizing PHA at 10 to 25% (w/w), while reducing soluble COD by approximately 62 to 71%. More critically, an aerobic batch reactor seeded from the anaerobic/aerobic reactor and fed fermenter liquor achieved approximately 53% PHA (w/w). Results presented suggest that environmentally benign production of biodegradable polymers is feasible. We further used PHA-rich biomass to produce a natural fiber-reinforced thermoplastic composite that can be used to offset advanced wastewater treatment costs.     

Assessment of oxidative and UV-C treatments for inactivating bacterial biofilms from groundwater wells

Microorganisms are ubiquitous in natural environments and in water supply infrastructure including groundwater wells. Sessile-state microorganisms may build up on well surfaces as biofilms and, if excessive, cause biofouling that reduces well productivity and water quality. Conditions can be improved using biocides and other traditional well rehabilitation measures; however, biofilm regrowth is inevitable given the continuous introduction of microorganisms from the surrounding environment. Alternative and less invasive well maintenance approaches are desirable for reducing biofilm densities while also minimizing harmful disinfection-by-products. The primary objective of this research was to evaluate effectiveness of alternative treatments for inactivating microorganisms comprising biofilms. A novel approach was designed for in situ growth of biofilms on steel coupons suspended from ‘chandeliers’. After more than 100 days of in situ growth, biofilms were harvested, sampled, and baseline biofilm densities quantified through cultivation. Ultraviolet-C (UV-C) and oxidative treatments including hydrogen peroxide (H₂O₂), ozone (O₃) and mixed oxidants were then applied to the biofilms in laboratory-scale treatments. Microbial inactivation was assessed by comparing treated versus baseline biofilm densities. H₂O₂ was the most effective treatment, and decreased density below baseline by as much as 3.1 orders of magnitude. Mixed oxidants were effective for the well having a lower density biofilm, decreasing density below baseline by as much as 1.4 orders of magnitude. Disparity in the response to treatment was apparent in the wells despite their spatial proximity and common aquifer source, which suggests that microbiological communities are more heterogeneous than the natural media from which they originate.     

Generalists and specialists along a latitudinal transect: patterns of thermal adaptation in six species of damselflies

Tropical organisms colonizing temperate environments face reduced average temperatures and dramatic thermal fluctuations. Theoretical models postulate that thermal specialization should be favored either when little environmental variation is experienced within generations or when among-generation variation is small relative to within-generation variation. To test these predictions, we studied six temperate species of damselflies differing in latitudinal distribution. We developed a computer model simulating how organisms experience environmental variation (accounting for diapause and voltinism) and performed a laboratory experiment assaying thermal sensitivities of growth rates. The computer model showed opposing latitudinal trends in among- and within-generation thermal variability: within-generation thermal variability decreased toward higher latitudes, whereas relative levels of among-generation thermal variability peaked at midlatitudes (where a shift in voltinism occurred). The growth experiment showed that low-latitude species were more thermally generalized than mid- and high-latitude species, supporting the prediction that generalists are favored under high levels of within-generation variation. Northern species had steeper, near-exponential reaction norms suggestive of thermal specialization. However, they had strikingly high thermal optima and grew very slowly over most of the thermal range they are expected to experience in the field. This observation is at present difficult to explain. These results highlight the importance of considering interactions between life history and environmental variation when deriving expectations of thermal adaptation.     

Suggested protocol for collecting, handling and preparing peat cores and peat samples for physical, chemical, mineralogical and isotopic analyses

For detailed reconstructions of atmospheric metal deposition using peat cores from bogs, a comprehensive protocol for working with peat cores is proposed. The first step is to locate and determine suitable sampling sites in accordance with the principal goal of the study, the period of time of interest and the precision required. Using the state of the art procedures and field equipment, peat cores are collected in such a way as to provide high quality records for paleoenvironmental study. Pertinent field observations gathered during the fieldwork are recorded in a field report. Cores are kept frozen at -18 degree C until they can be prepared in the laboratory. Frozen peat cores are precisely cut into 1 cm slices using a stainless steel band saw with stainless steel blades. The outside edges of each slice are removed using a titanium knife to avoid any possible contamination which might have occurred during the sampling and handling stage. Each slice is split, with one-half kept frozen for future studies (archived), and the other half further subdivided for physical, chemical, and mineralogical analyses. Physical parameters such as ash and water contents, the bulk density and the degree of decomposition of the peat are determined using established methods. A subsample is dried overnight at 105 degree C in a drying oven and milled in a centrifugal mill with titanium sieve. Prior to any expensive and time consuming chemical procedures and analyses, the resulting powdered samples, after manual homogenisation, are measured for more than twenty-two major and trace elements using non-destructive X-Ray fluorescence (XRF) methods. This approach provides lots of valuable geochemical data which documents the natural geochemical processes which occur in the peat profiles and their possible effect on the trace metal profiles. The development, evaluation and use of peat cores from bogs as archives of high-resolution records of atmospheric deposition of mineral dust and trace elements have led to the development of many analytical procedures which now permit the measurement of a wide range of elements in peat samples such as lead and lead isotope ratios, mercury, arsenic, antimony, silver, molybdenum, thorium, uranium, rare earth elements. Radiometric methods (the carbon bomb pulse of (14)C, (210)Pb and conventional (14)C dating) are combined to allow reliable age-depth models to be reconstructed for each peat profile.     

Soil sensitivity to acidification in Asia: status and prospects

Exceedance of steady-state critical loads for soil acidification is consistently found in southern China and parts of SE Asia, but there is no evidence of impacts outside of China. This study describes a methodology for calculating the time to effects for soils sensitive to acidic deposition in Asia under potential future sulfur (S), nitrogen (N), and calcium (Ca) emission scenarios. The calculations are matched to data availability in Asia to produce regional-scale maps that provide estimates of the time (y) it will take for soil base saturation to reach a critical limit of 20% in response to acidic inputs. The results show that sensitive soil types in areas of South, Southeast, and East Asia, including parts of southern China, Burma, Hainan, Laos, Thailand, Vietnam, and the Western Ghats of India, may acidify to a significant degree on a 0-50 y timescale, depending on individual site management and abiotic and biotic characteristics. To make a clearer assessment of risk, site-specific data are required for soil chemistry and deposition (especially base cation deposition); S and N retention in soils and ecosystems; and biomass harvesting and weathering rates from sites across Asia representative of different soil and vegetation types and management regimes. National and regional assessments of soils using the simple methods described in this paper can provide an appreciation of the time dimension of soil acidification-related impacts and should be useful in planning further studies and, possibly, implementing measures to reduce risks of acidification.     

Heavy metal mobility in runoff water and absorption by eggplant fruits from sludge treated soil

Sewage sludge addition to agricultural lands requires judicious management to avoid environmental risks arising from heavy metal and nitrate contamination of surface water and accumulation in edible plants. A field study was conducted on a silty-loam soil of 10% slope at Kentucky State University Research Farm. Eighteen plots of 22 x 3.7 m each were separated using metal borders and the soil in six plots was mixed with sewage sludge and yard waste compost mix (SS-YW) at 15 t acre(-1), six plots were mixed with sewage sludge (SS) at 15 t acre(-1), and six unamended plots that never received sludge were used for comparison purposes. Plots were planted with eggplant, Solanum melongena L. as the test plant. The objectives of this investigation were to: 1) assess the effect of soil amendments on the transport of NO3, NH4, and heavy metals (Cd, Cr, Ni, Pb, Zn, Cu, and Mo) into surface water; 2) investigate the effect of soil amendments on heavy metal bioavailability in eggplant fruits at harvest; and 3) assess chemical and physical properties of soil following addition of soil amendments and their impact on the yield and quality of eggplant fruit. SS-YW treatments reduced runoff water by 63% while plots incorporated with sewage sludge alone reduced runoff water by 37% compared to control treatment. The SS-YW treatments transported more mineral nitrogen (NO3-N and NH4-N) in runoff water than SS treatments. Total marketable yield (lbs acre(-1)) and number of eggplant fruits were greatest in SS-YW treatments. This response may be due to improved soil porosity, water, and nutrient retention of the soil amended with SS-YW mixture. Concentrations of heavy metals in soil amended with sludge were below the U.S. Environmental Protection Agency (USEPA) limits. Chromium, Ni, Zn, and Cu were taken up by eggplant fruits but their concentrations were below the Codex Commission allowable levels.