FeS/K2S2O8去除水体系中的2,4-D

以2,4-二氯苯氧乙酸(2,4-D)为目标污染物,研究了自制FeS与K2S2O8混合体系去除水体中2,4-D的影响因素,实验结果表明,30℃时,初始pH=7,FeS和K2S2O8初始浓度分别为10 g/L和3.33 g/L,反应24 h,对初始浓度为10mg/L的2,4-D去除率可达77%;FeS/K2S2O8体系对2,4-D的去除速率受反应溶液pH影响显著,在pH为中性或弱碱性条件下速率较大,酸性和过碱性条件去除速率均会减小;对比FeS和K2S2O8单独处理目标污染物的去除率,相同时间和条件下FeS/K2S2O8体系对2,4-D的去除率要高于两者单独处理2,4-D时的去除率之和;利用乙醇和叔丁醇为分针探针,采用分针探针竞争实验鉴定证明该体系中产生了SO-4·和·OH。     

农药行业规划环境影响评价中的风险评价

针对专项工业规划环境影响评价中环境风险评价应用尚不成熟的现状,建立了一套专项工业规划环境风险评价方法,并将其应用到江苏省农药行业总体规划环境影响评价分析中。从环境风险角度分析行业发展方向、强度和布局的合理性,提出规划调整和行业风险管理的建议,以降低事故发生的概率和影响,保障行业的健康稳定发展。通过对江苏省农药行业规划明确的产品结构、产业组织结构、创新体系和技术发展目标等进行风险识别、分析和评价,得出生产和使用光气的定点企业、使用液氯的企业、产生硫化氢的企业的环境风险防护距离（以生产装置为起点）应至少设置为1 000,500,250 m。     

Process analysis of a regional air pollution episode over Pearl River Delta Region,China, using the MM5-CMAQ model

This study focuses on the influences of a warm high-pressure meteorological system on aerosol pollutants, employing the simulations by the Models-3/CMAQ system and the observations collected during October 10–12, 2004, over the Pearl River Delta (PRD) region. The results show that the spatial distributions of air pollutants are generally circular near Guangzhou and Foshan, which are cities with high emissions rates. The primary pollutant is particulate matter (PM) over the PRD. MM5 shows reasonable performance for major meteorological variables (i.e., temperature, relative humidity, wind direction) with normalized mean biases (NMB) of 4.5–38.8% and for their time series. CMAQ can capture one peak of all air pollutant concentrations on October 11, but misses other peaks. The CMAQ model systematically underpredicts the mass concentrations of all air pollutants. Compared with chemical observations, SO₂ and O₃ are predicted well with a correlation coefficient of 0.70 and 0.65. PM_2.5 and NO are significantly underpredicted with an NMB of 43% and 90%, respectively. The process analysis results show that the emission, dry deposition, horizontal transport, and vertical transport are four main processes affecting air pollutants. The contributions of each physical process are different for the various pollutants. The most important process for PM₁₀ is dry deposition, and for NO_x it is transport. The contributions of horizontal and vertical transport processes vary during the period, but these two processes mostly contribute to the removal of air pollutants at Guangzhou city, whose emissions are high. For this high-pressure case, the contributions of the various processes show high correlations in cities with the similar geographical attributes. According to the statistical results, cities in the PRD region are divided into four groups with different features. The contributions from local and nonlocal emission sources are discussed in different groups.

Implications: The characteristics of aerosol pollution episodes are intensively studied in this work using the high-resolution modeling system MM5/SMOKE/CMAQ, with special efforts on examining the contributions of different physical and chemical processes to air concentrations for each city over the PRD region by a process analysis method, so as to provide a scientific basis for understanding the formation mechanism of regional aerosol pollution under the high-pressure system over PRD.     

Effect of low-density polyethylene on smoke emissions from burning of simulated debris piles

Low-density polyethylene (LDPE) plastic is used to keep piled debris from silvicultural activities—activities associated with development and care of forests—dry to enable efficient disposal by burning. The effects of inclusion of LDPE in this manner on smoke emissions are not well known. In a combustion laboratory experiment, 2-kg mixtures of LDPE and manzanita (Arctostaphylos sp.) wood containing 0, 0.25, and 2.5% LDPE by mass were burned. Gaseous and particulate emissions were sampled in real time during the entire flaming, mixed combustion phase—when the flaming and smoldering phases are present at the same time—and during a portion of the smoldering phase. Analysis of variance was used to test significance of modified combustion efficiency (MCE)—the ratio of concentrations of fire-integrated excess CO₂ to CO₂ plus CO—and LDPE content on measured individual compounds. MCE ranged between 0.983 and 0.993, indicating that combustion was primarily flaming; MCE was seldom significant as a covariate. Of the 195 compounds identified in the smoke emissions, only the emission factor (EF) of 3M-octane showed an increase with increasing LDPE content. Inclusion of LDPE had an effect on EFs of pyrene and fluoranthene, but no statistical evidence of a linear trend was found. Particulate emission factors showed a marginally significant linear relationship with MCE (0.05 < P-value < 0.10). Based on the results of the current and previous studies and literature reviews, the inclusion of small mass proportions of LDPE in piled silvicultural debris does not appear to change the emissions produced when low-moisture-content wood is burned. In general, combustion of wet piles results in lower MCEs and consequently higher levels of emissions.

Implications:Current air quality regulations permit the use of burning to dispose of silvicultural piles; however, inclusion of low-density polyethyelene (LDPE) plastic in silvicultural piles can result in a designation of the pile as waste. Waste burning is not permitted in many areas, and there is also concern that inclusion of LDPE leads to toxic air emissions.     

温度对SBR单级好氧生物除磷性能的影响

以合成废水为研究对象,以丙酸钠作为单一碳源,分别设置温度为5、15、25、35℃的4组序批式反应器(R1、R2、R3、R4),考察了温度对单级好氧工艺除磷的影响。结果表明,稳定运行阶段,R1、R2、R3、R4出水磷浓度分别为4.05、2.17、1.34和0.11 mg/L,去除效率分别为61.5%、79.3%、87.2%和99.0%,吸磷速率分别为0.501、1.432、2.538和3.700mg P/(g VSS·h),即提高温度有利于磷的去除。此外,各反应器中多聚磷酸盐激酶(PPK)和外切磷酸盐酶(PPX)活性分别为0.093、0.213、0.376、0.549 U和0.010、0.019、0.029、0.025 U,导致吸磷速率和释磷速率随之增大,可知温度影响聚磷菌PPK和PPX的活性,从而影响除磷效果。静置阶段,聚磷菌体内储能物质糖原质和聚羟基脂肪酸酯基本保持不变,但各反应器均出现了释磷现象,聚磷作为主要供能物质,单位释磷量分别为1.95、6.42、9.90和9.56 mg P/(g TSS),提高温度可促进静置段聚磷分解提供能量,从而驱动好氧吸磷达到更好的除磷效果。     

制药废水的厌氧生化性评价及UASB处理

为了处理山东某一药厂的高浓度有机废水,首先采用间歇式实验对山东某一制药厂各主要车间生产废水及综合废水进行厌氧可生化性评价。然后以此为基础,采用两级中温UASB,以某一时期排放的厂区综合废水为处理对象,通过缩短HRT,考察在COD容积负荷的逐步升高下,反应器处理效果的变化。进水COD稀释至10 000 mg/L左右,p H维持在6.8到7.1。在单级UASB最大工程设计容积负荷6 g COD/(L·d)的条件下,经过两级UASB的串联处理,总COD的去除率能达73.5%,出水COD能基本稳定在2 600 mg/L。在这个系统运行时期,产气稳定,出水p H值稳定在7.4到8.0之间,VFA在500 mg/L以下。实验结果表明,两级UASB处理该制药厂废水是可行的。     

淡水养殖水体溶解氧含量诊断分析及浮头泛塘气象预报

通过实时监测荆州农试站养殖塘各种水质要素,结合2011~2012年养殖塘发生的25个鱼泛塘实例,探讨了养殖水体溶解氧含量与气象要素之间的联系。分析表明:养殖水体溶解氧含量与6 h变温、总辐射量、气压值正相关,与水温、空气相对湿度值负相关。从平时的调查记录来看,鱼泛塘事件主要发生在5~10月间,湿度大、气温低、气压下降、日照强度弱等都会引起溶解氧含量低,严重的会诱发鱼泛塘。根据25个鱼泛塘实例,结合气象要素的特点,提出了急剧降温降压型、寡照型、高温高热型3种鱼泛塘发生条件的概念模型,分别以实例进行了验证,并初步总结出根据气象要素观测资料进行浮头泛塘预报的方法和流程     

县域农村居民点景观格局指数的空间粒度效应

利用ArcGIS 93软件从2009年全国第二次土地调查成果数据库中提取丰县农村居民点数据作为数据源,采用中心属性值原则得到20种空间粒度下的农村居民点景观格局,借助Fragstats 33软件对选取的8个景观指数进行计算,分析农村居民点景观格局的粒度效应并据此确定适宜粒度范围。研究表明：除景观面积指数及景观分离度指数外,其他景观指数的粒度效应较明显,即景观格局对空间粒度的依赖性较强,若避开粒度谈论景观格局意义不大;空间粒度由10 m增大到200 m,斑块个数、斑块密度、景观形状指数、景观结合度指数、景观聚集度指数均下降,最大斑块指数上升,说明最大斑块的优势度上升,斑块破碎化程度降低,斑块形状趋于规则,景观斑块间连接程度降低且分布趋向分散;综合各个景观指数的第一尺度域,研究确定丰县1〖DK〗∶10 000比例尺精度下农村居民点景观格局分析的适宜粒度范围为50～60 m,最佳粒度为60 m     

光环境污染监测分类与控制值探索

在研究分析国内外现有光污染相关技术规定的基础上,结合我国城市光污染现状,为解决我国城市光污染中危害最严重的典型问题,将我国城市光环境污染划分为玻璃幕墙眩光污染、交通道路眩光污染、居住区光污染、室外光污染源4个重点监测项目,并针对具体项目初步提出了玻璃幕墙反射眩光监测控制值、交通道路眩光监测控制值、居住区光污染监测控制值和室外光污染源监测控制值。     

毛细管柱气相色谱法测定工业废气和废水中N,N-二甲基甲酰胺

采用HP-INNOWAX毛细管柱、气相色谱氢火焰离子化检测器测定工业废气和废水中的N,N-二甲基甲酰胺,可能共存的丙酮、乙醇和乙酰丙酮均对测试无干扰.方法在0.939 mg/L～75.1 mg/L范围内线性良好,对工业废水、无组织排放工业废气和有组织排放工业废气中N,N-二甲基甲酰胺的检出限分别为0.47 mg/L、0.16 mg/m3和0.31 mg/m3,标准溶液平行测定的RSD为1.9％ ～2.2％,废水样品加标回收率为94％～ 97％.