Migration Pathways and Remediation of Urban Runoff for PAH Control

The migration pathways for polyaromatic hydrocarbons (PAH) and the associated active attenuating mechanisms within the urban environment are examined. The interest in developing an improved understanding of PAH migration/attenuation is focused toward quantification of the cost-effectiveness of urban runoff control strategies for mitigation of PAH inputs to receiving water bodies.A case study application to the City of Sault Ste Marie demonstrates that snow removal from sub-basins with the largest deposition rates, and relatively small wet and/or dry stormwater management ponds, are the most cost-effective remediation strategies.     

The effect of nitrogen deficiency,methionine and inhibitors of methionine metabolism on the DMSP contents of Tetraselmis subcordiformis (Stein)

The unicellular alga Tetraselmis (Platymonas) subcordiformis (Prasinophyceae) displayed a two-phase increase in DMSP (dimethylsulfoniopropionate) contents in response to nitrogen deficiency. In the first phase, DMSP pools increased by 75% within 24 h. The second increase in DMSP was observed after 14 d and was accompanied by cyst formation. Methionine metabolism was involved in DMSP accumulation. A 2.6-fold increase of the DMSP pool could be induced by supplementing a complete ASP (artifical seawater Provasoli) medium with 100 M L-methionine. Inhibition of methionine utilization by T. subcordiformis caused by the addition of S-adenosylhomocystein, a competitive inhibitor of S-adenosylmethionine-dependent transmethylases, resulted in a 24% increase of DMSP contents after 7 h. DMSP accumulation after hyperosmotic shock was significantly delayed when methionine liberation from proteins was inhibited by a set of protease inhibitors. A model for the mechanism of DMSP accumulation is presented on the basis of these data and additional information from the literature. It is proposed that methionine availability in T. subcordiformis determines the rate of DMSP synthesis.     

Sources, distribution, and risk assessment of organochlorine pesticides in Nairobi City, Kenya

The distribution and sources of organochlorine pesticides (OCPs) in air and surface waters were monitored in Nairobi City using triolein-filled semipermeable membrane devices (SPMDs). The SPMDs were extracted by dialysis using n-hexane, followed by cleanup by adsorption chromatography on silica gel cartridges. Sample analysis was done by GC-ECD and confirmed by GC–MS. Separation of means was achieved by analysis of variance, followed by pair-wise comparison using the t-test (p≤ 0.05). The total OCPs ranged between 0.018 – 1.277 ng/m³ in the air and <LOD – 1391.000 ng/m³ in surface waters. Based on the results, the means of Industrial Area, Dandora and Kibera were not significantly different (p≤ 0.05), but were higher (p≤ 0.05) than those of City square and Ngong’ Forest. The results revealed non-significant (p≤ 0.05) contribution of long-range transport to OCP pollution in Nairobi City. This indicated possible presence of point sources of environmental OCPs in the city. The water-air fugacity ratios indicated that volatilization and deposition played an important role in the spatial distribution of OCPs in Nairobi City. This indicated that contaminated surface waters could be major sources of human exposure to OCPs, through volatilization. The incremental lifetime cancer risks (ILCR) determined from inhalation of atmospheric OCPs were 2.3745  ×  10^?13 – 1.6845  ×  10^?11 (adult) and 5.5404  ×  10^?13 – 3.9306  ×  10^?11 (child) in the order: Dandora > Kibera > Industrial Area > City Square > Ngong’ Forest. However, these were lower than the USEPA acceptable risks, 10^?6 – 10^?4. This study concluded that atmospheric OCPs did not pose significant cancer risks to the residents.     

Application of cryofocusing hydride generation and atomic fluorescence detection for dissolved mercury species determination in natural water samples

The concentration levels of mercury (Hg) species in natural water samples are usually low. Consequently, accurate analysis with low detection limits is still a major problem. In this work, a method was applied for the simultaneous direct determination of dissolved mercury species in water samples by on-line hydride generation (HG), cryogenic trapping (CT), gas chromatography (GC) and detection by atomic fluorescence spectrometry (AFS). The suitability of the method for real samples with different organic matter and chloride contents was evaluated by recovery experiments in synthetic and natural spiked water samples. The HG method was compared with other current available methods for mercury analysis with respect to the different fraction of mercury analysed, i.e. 'reactive', 'reducible' or total. HG derivatization and SnCl2 reduction (with and without previous oxidation with BrCl) were applied to synthetic and natural (spiked and non-spiked) water samples. The influence of chloride and dissolved organic matter concentrations was studied. The results suggest that the HG procedure is suitable for the simultaneous determination of Hg2+ and MeHg+ in surface water samples. Inorganic mercury analysed by HG (i.e. reducible) is close to the total inorganic mercury.     

High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

Bioindicator organisms: Heavy metal pollution evaluation in the Ionian Sea (Mediterranean Sea—Italy)

Trace metal concentrations of mercury, cadmium, lead and chromium in Patella caerulea, and Mullus barbatus were investigated to provide information on pollution of Ionian Sea, since these metals have the highest toxic potential. High chromium levels (0.47–0.97 g g^–1 ww) were registered in limpet samples collected from two station near the Gulf of Taranto, while elevated concentration of mercury (0.31–1.50 g g^–1 ww) were found in mullet specimens from Sicily. The metal concentrations recorded at the clean stations may be considered as useful background levels to which to refer for comparison within the Mediterranean area. On the contrary, the high levels of chromium and mercury found respectively in the areas near the Gulf of Taranto and at Capo Passero being of concern in terms of environmental health need frequent monitoring.     

Flow-injection analysis with fluorescence detection for the determination of trace levels of ammonium in seawater

A method using flow-injection, gas-diffusion, derivatisation and then fluorescent detection has been established for ammonium ion determination in seawater. The fluorescent derivative formed by reacting ortho-phthaldialdehyde (OPA) and sulfite with ammonia gives high sensitivity while removing potential interferences. This is required to measure the low concentrations of ammonium often seen in the open ocean. The experimental conditions (flow-rate, reagent concentrations, membrane configurations, etc.) were manipulated to improve performance. For a sample throughput of 30 samples h(-1), the limit of detection was 7 nM, the coefficient of variation was 5.7% at 800 nM, and the calibration curve was linear to at least 4 micromol L(-1). Interferences were minimised by a gaseous diffusion step. Volatile small molecular-weight amines as interferents were discriminated against by this method. They neither passed through the membrane as efficiently as ammonia, nor reacted as readily with OPA when sulfite was the reductant. Contamination by ammonia from laboratory and shipboard sources complicates application of the method to natural waters, especially measurement of low concentrations (<100 nM) in open-ocean waters. Steps to overcome contamination are described in detail. Some results are presented for ammonium determination in Southern Ocean and Huon Estuary (Tasmania) waters.     

Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.