Air Pollution Control Measures for Hot Dip Galvanizing Kettles

ABSTRACT

Three commercially available conversion varnish coating “systems” (stain, sealer, and topcoat) were selected for an initial scoping study. The total volatile content of the catalyzed varnishes, as determined by U.S. Environmental Protection Agency (EPA) Method 24, ranged from 64 to 73 weight%. Uncombined (free) formaldehyde concentrations, determined by a sodium sulfite titration method, ranged from 0.15 to 0.58 weight% of the uncatalyzed varnishes. Each sealer and topcoat was also analyzed by gas chromatography (EPA Method 311). The primary volatile organic constituents included methyl ethyl ketone (MEK), isobutanol, n-butanol, methyl isobutyl ketone (MIBK), toluene, ethylbenzene, the xylenes, and 1,2,4-trimethylbenzene.     

Polynuclear Aromatic Hydrocarbons In Urban Atmospheres in Ontario

A comprehensive program comprising the collection of particulate samples at some 20 sampling sites throughout the Province of Ontario afforded seasonal or monthly composites of airborne particulates which were extracted for determinations of polynuclear hydrocarbons. Results indicated that concentrations of airborne carcinogens or potential carcinogens in urban air throughout Ontario are much lower than values reported in the literature for urban atmospheres in England. The project served as a test of the practicability of methods recommended for extractive, chromatographic, and spectroscopic aspects of a complex routine, and the experience gained should be useful as a guide in the ultimate establishment of standardized methods. The work has identified areas in the province where more detailed sampling would be useful, and has indicated analytical problems requiring investigation.     

Impact of Alternative Fuels on Vehicle Emissions of Greenhouse Gases

Abstract

The conversion of methane to liquid products, hydrogen (H₂), and ammonia (NH₃) was investigated experimentally using microgap discharge plasma at an environmentally friendly condition. The experimental results indicated that H₂ and NH₃ were detected as the main gas products. The highest yield and production rate of H₂ was 14.4% (v/v) and 2974.6 μmol/min, respectively, whereas the highest yield and production rate of NH₃ was 8000 ppm (v/v) and 165.1 μmol/min, respectively. Particularly, the liquid products were collected on the plate and consisted of pyrrole, 2-methyl-1,4-pentadiene, α-amidopyri-dine, 2,5-dimethylpyrrole, methylpyrazine, 1-hexyne, 1,4-heptadiene, and polycyclic organic compounds. Some liquid products were the intermediates of drug, ?avor, dye, and organic synthesis, as well as edible ?avor. The collection efficiency in mass and energy efficiency were 26.3% at once and 22.9 g/kWh, respectively. The whole reaction process was considered to be in line with green chemistry principles.     

Klinefelter Syndrome: What should we tell prospective parents?

Klinefelter syndrome (KS) or 47,XXY is the most common sex chromosome aneuploidy (SCA), occurring at a prevalence of 1 in 600 male pregnancies. Historically, only 25% of individuals with KS came to medical attention, for a range of issues across the life course including under-virilisation at birth, developmental and social concerns in childhood, absence, delay or arrest of puberty in adolescence or infertility in adulthood. Our understanding of the phenotypic spectrum of KS has been largely influenced by this ascertainment bias. With increasing uptake of antenatal noninvasive prenatal testing (NIPT), a corresponding increase in identification of KS has been documented. Population-based longitudinal data from infancy to adulthood on these individuals is lacking, which impedes balanced antenatal genetic counselling and raises issues for prospective parents and clinicians alike.     

A comparison of hourly with annual air pollutant emissions: Implications for estimating acute exposure and public health risk

Health risks from air pollutants are evaluated by comparing chronic (i.e., an average over 1 yr or greater) or acute (typically 1-hr) exposure estimates with chemical- and duration-specific reference values or standards. When estimating long-term pollutant concentrations via exposure modeling, facility-level annual average emission rates are readily available as model inputs for most air pollutants. In contrast, there are far fewer facility-level hour-by-hour emission rates available for many of these same pollutants. In this report, we first analyze hour-by-hour emission rates for total reduced sulfur (TRS) compounds from eight kraft pulp mill operations. This data set is used to demonstrate discrepancies between estimating exposure based on a single TRS emission rate that has been calculated as the mean of all operating hours of the year, as opposed to reported hourly emission rates. A similar analysis is then performed using reported hourly emission rates for sulfur dioxide (SO₂) and oxides of nitrogen (NO_x) from three power generating units from a U.S. power plant. Results demonstrate greater variability at kraft pulp mill operations, with ratios of reported hourly to average hourly TRS emissions ranging from less than 1 to greater than 160 during routine facility operations. Thus, if fluctuations in hourly emission rates are not accounted for, over- or underestimates of hourly exposure, and thus acute health risk, may occur. In addition to this analysis, we also demonstrate an additional challenge when assessing health risk based on hourly exposures: the lack of human health reference values based on 1-hr exposures.

Implications: Largely due to the lack of reported hourly emission rate data for many air pollutants, an hourly average emission rate (calculated from an annual emission rate) is often used when modeling the potential for acute health risk. We calculated ratios between reported hourly and hourly average emission rates from pulp and paper mills and a U.S. power plant to demonstrate that if not considered, hourly fluctuations in emissions could result in an over- or underestimation of exposure and risk. We also demonstrate the lack of 1-hr human health reference values meant to be protective of the general population, including children.     

Biological response to physical processes in the Indian Ocean sector of the Southern Ocean: a case study in the coastal and oceanic waters

The spatial variation of chlorophyll a (Chl a) and factors influencing the high Chl a were studied during austral summer based on the physical and biogeochemical parameters collected near the coastal waters of Antarctica in 2010 and a zonal section along 60°S in 2011. In the coastal waters, high Chl a (>3 mg m^?3) was observed near the upper layers (～15 m) between 53°30′E and 54°30′E. A comparatively higher mesozooplankton biomass (53.33 ml 100 m^?3) was also observed concordant with the elevated Chl a. Low saline water formed by melting of glacial ice and snow, as well as deep mixed-layer depth (60 m) due to strong wind (>11 ms^?1) could be the dominant factors for this biological response. In the open ocean, moderately high surface Chl a was observed (>0.6 mg m^?3) between 47°E and 50°E along with a Deep Chlorophyll Maximum of ～1 mg m^?3 present at 30–40 m depth. Melt water advected from the Antarctic continent could be the prime reason for this high Chl a. The mesozooplankton biomass (22.76 ml 100 m^?3) observed in the open ocean was comparatively lower than that in the coastal waters. Physical factors such as melting, advection of melt water from Antarctic continent, water masses and wind-induced vertical mixing may be the possible reasons that led to the increase in phytoplankton biomass (Chl a).