Formation of aerobic granules in the presence of a synthetic chelating agent

This paper examines the development of aerobic granular sludge in the presence of a synthetic chelating agent, nitrilotriacetic acid (NTA), in sequencing batch reactors (SBR). The growth of seed sludge at 0.26 mM, 0.52 mM and 1.05 mM of NTA was found to be significantly lower as compared to that in the absence of NTA. Aerobic granulation was significantly enhanced in the three SBRs (R2, R3 and R4), which were fed with 0.26 mM, 0.52 mM and 1.05 mM of NTA as a co-substrate, in comparison to the acetate-alone fed SBR (R1). After 2 months of operation, the mean diameter of the biomass stabilized at 0.35 mm in R1 (acetate alone), as compared to 2.18 mm in R4 (1.05 mM NTA+acetate). NTA degradation was established in SBRs, with almost complete removal during the SBR cycle. Batch experiments also showed efficient degradation of NTA by the aerobic granules.     

Aerobic and anaerobic membrane bioreactors for municipal wastewater treatment.

An aerobic bioreactor and an anaerobic bioreactor, each coupled with a microfiltration membrane filter (MBR), were operated at different hydraulic retention times (HRTs) with primary effluent from the City of Elmhurst, Illinois, municipal-wastewater-treatment plant. The soluble chemical oxygen demand (COD) removal performance of the anaerobic MBR system was similar to that of the aerobic MBR under the same operational conditions, without the added cost of aeration. The results indicated that the solids deposition rate on the membrane surface was lower in the case of anaerobic MBR compared to the aerobic MBR, indicating possible lower loss in water-flux rates. This research found that an anaerobic MBR is a feasible and economical option for municipal-wastewater-treatment plants seeking COD removal by a biological process followed by a separate nitrification and denitrification system.     

Determination of Cd,Cr, Cu,Pb and Zn from various water samples with use of FAAS techniques after the solid phase extraction on rice bran

A facile and novel method has been developed for the determination of cadmium, chromium, copper, lead, and zinc from various water samples using FAAS. In the present investigation, a syringe was loaded with sorbent (rice bran) for the separation and enrichment of cadmium, chromium, copper, lead, and zinc, prior to their analysis by flame atomic absorption spectrometry which was described to substitute the batch and column techniques. The syringe was loaded with 2.0 g of sorbent in order to retain the analyte elements. Six milliliter of sample solution (pH 8.0 ± 0.2) was drawn into the syringe in 15 s and discharged over a period of 15 s. Then, 2.0 M HCl eluent was drawn into the syringe and ejected back to desorb the analyte elements. At the optimum conditions, the percentage recoveries of Cd, Cr, Cu, Pb, and Zn was in the range of 95.5–99.4% with SD of 0.10%. The elements could be concentrated by drawing and discharging several portions of sample successively. The detailed study of various interferences made the confirmation of the method highly selective. The risk of contamination is less than that with the column technique. The method was successfully applied for the determination of Cd, Cr, Cu, Pb, and Zn in spiked and natural water samples. The results obtained are in good agreement with the reported methods at the 95% confidence level.     

Turbulent burst-sweep events around fully submerged vertical square cylinder over plane bed

Environmental Fluid Mechanics - The subtle variations of the turbulent shear stress affect the entrainment of bed sediments into the flow as well as sediment transport around submerged...     

Simultaneous removal of organic compounds and heavy metals from soils by electrokinetic remediation with a modified cyclodextrin

Thousands of sites are contaminated with both heavy metals and organic compounds and these sites pose a major threat to public health and the environment. Previous studies have shown that electrokinetic remediation has potential to remove heavy metals and organic compounds when they exist individually in low permeability soils. This paper presents the feasibility of using cyclodextrins in electrokinetic remediation for the simultaneous removal of heavy metals and polycyclic aromatic hydrocarbons (PAHs) from low permeability soils. Kaolin was selected as a model low permeability soil and it was spiked with phenanthrene as well as nickel at concentrations of 500 mg kg-1 each to simulate typical mixed field contamination. Bench-scale electrokinetic experiments were conducted using hydroxypropyl beta-cyclodextrin (HPCD) at low (1%) and high (10%) concentrations and using deionized water in control test. A periodic voltage gradient of 2VDC cm-1 (with 5 d on and 2 d off) was applied to all the tests, and 0.01 M NaOH was added during the experiments to maintain neutral pH conditions at anode. In all tests, nickel migrated as Ni2+ ions towards the cathode and most of it was precipitated as Ni(OH)2 within the soil close to the cathode due to high pH condition generated by electrolysis reaction. The solubility of phenanthrene in the flushing solution and the amount of electroosmotic flow controlled the migration and removal of phenanthrene in all the tests. Even though high flow was generated in tests using deionized water and 1% HPCD, migration and removal of phenanthrene was low due to low solubility of phenanthrene in these solutions. The test with 10% HPCD solution showed higher solubility of phenanthrene which caused it migrate towards the cathode, but further migration and removal was retarded due to reduced electric current and electroosmotic flow. Approximately one pore volume of flushing resulted in approximately 50% removal of phenanthrene from the soil near the anode. Sustained higher electroosmotic flow with higher concentration cyclodextrin and maintaining low soil pH near cathode should be investigated to increase removal efficiency of both phenanthrene and nickel.     

Studies of mercury pollution in a lake due to a thermometer factory situated in a tourist resort: Kodaikkanal, India

Kodaikkanal, India, suffered mercury contamination due to emissions and waste from a thermometer factory. Kodai Lake is situated to the north of the factory. The present study determined mercury in waters, sediment and fish samples and compared the values with those from two other lakes, Berijam and Kukkal. Total mercury (Hg(T)) of 356-465 ng l(-1), and 50 ng l(-1) of mercury in methyl mercury form were seen in Kodai waters while Berijam and Kukkal waters showed significantly lower values. Kodai sediment showed 276-350 mg/kg Hg(T) with about 6% methyl mercury. Berijam and Kukkal sediments showed Hg(T) of 189-226 mg/kg and 85-91 mg/kg and lower methylation at 3-4% and 2%, respectively. Hg(T) in fish from Kodai lake ranged from 120 to 290 mg/kg. The results show that pollution of the lake has taken place due to mercury emissions by the factory.     

Microbial degradation of pyridine using Pseudomonas sp. and isolation of plasmid responsible for degradation

Pseudomonas (PI2) capable of degrading pyridine was isolated from the mixed population of the activated sludge unit which was being used for treating complex effluents, the strain was characterized. Aerobic degradation of pyridine was studied with the isolated strain and the growth parameters were evaluated. Pyridine degradation was further conformed by chromatography (HPLC) analysis. The process parameters like biomass growth and dissolved oxygen consumption were monitored during pyridine degradation. In order to conform with the plasmid capability to degrade pyridine, the requisite plasmid was isolated and transferred to DH 5alpha Escherichia coli. The subsequent biodegradation studies revealed the ability of the transformed plasmid capability to degrade the pyridine.     

MODELING THE EFFECT OF BRUSH CONTROL ON RANGELAND WATER YIELD1

ABSTRACT: With the increase in water demand in Texas, attention has turned to improving water yield by brush control on rangeland watersheds. Several hydrologic models have been developed for either farmland or rangeland. However, none of the models were specifically developed to assess the impact of brush control on rangeland water yield. Yet, modeling the impact of brush control on water yield needs to be considered if alternative techniques are to be compared. Two models, Ekalaka Rangeland Hydrology and Yield Model (ERHYM-II) and Simulator for Water Resources on Rural Basins (SWRRB) were selected. The Soil Conservation Service curve number (SCS-CN) method is used in both models to predict surface runoff from each rainfall event. The major differences between the ERHYM-II and SWRRB models are the evapotranspiration, soil water routing, and plant growth components. The models were evaluated on brush-dominated and chemically and mechanically brush-controlled range watersheds in Texas. Results indicated that both models were capable of simulating soil water and water yield from brush dominated and chemically brush-controlled range watersheds. The models were not able to predict water yield from the mechanically brush-controlled (root plowed) watershed with acceptable accuracy. The depressions that were caused by root plowing stored surface runoff and reduced water yield from the watershed. Information about the size of depressions was not available for further model evaluation.     

A simple method for the extraction of mutagens from airborne particles

Organic materials were extracted with acetone from filters of airborne particles by soaking, shaking, soxhletion, and sonication. These extracts were tested with and without S9 for mutagenicity using Ames assay and arabinose-resistant assay of Salmonella typhimurium. Among the extraction methods, soaking extract had the highest mutagenic activity followed by sonication, shaking, and soxhletion in both the assays. With the samples studied, it was concluded that soaking with acetone for 1/2 hr is the simplest and an efficient procedure for the extraction of mutagens from airborne particles.Results of cooperative investigation of NIOSH and West Virginia Agricultural and Forstry Experimental Station. Published with the approval of the Director of the West Virginia Agricultural and Forestry Experiment Station as Scientific Paper No. 1822.