Idle Emissions from Heavy-Duty Diesel Vehicles: Review and Recent Data

Abstract

Heavy-duty diesel vehicle idling consumes fuel and reduces atmospheric quality, but its restriction cannot simply be proscribed, because cab heat or air-conditioning provides essential driver comfort. A comprehensive tailpipe emissions database to describe idling impacts is not yet available. This paper presents a substantial data set that incorporates results from the West Virginia University transient engine test cell, the E-55/59 Study and the Gasoline/Diesel PM Split Study. It covered 75 heavy-duty diesel engines and trucks, which were divided into two groups: vehicles with mechanical fuel injection (MFI) and vehicles with electronic fuel injection (EFI). Idle emissions of CO, hydrocarbon (HC), oxides of nitrogen (NO_x), particulate matter (PM), and carbon dioxide (CO₂) have been reported. Idle CO₂ emissions allowed the projection of fuel consumption during idling. Test-to-test variations were observed for repeat idle tests on the same vehicle because of measurement variation, accessory loads, and ambient conditions. Vehicles fitted with EFI, on average, emitted [~20 g/hr of CO, 6 g/hr of HC, 86 g/hr of NO_x, 1 g/hr of PM, and 4636 g/hr of CO₂ during idle. MFI equipped vehicles emitted ~35 g/hr of CO, 23 g/hr of HC, 48 g/hr of NO_x, 4 g/hr of PM, and 4484 g/hr of CO₂, on average, during idle. Vehicles with EFI emitted less idleCO, HC, and PM, which could be attributed to the efficient combustion and superior fuel atomization in EFI systems. Idle NO_x, however, increased with EFI, which corresponds with the advancing of timing to improve idle combustion. Fuel injection management did not have any effect on CO₂ and, hence, fuel consumption. Use of air conditioning without increasing engine speed increased idle CO₂, NO_x, PM, HC, and fuel consumption by 25% on average. When the engine speed was elevated from 600 to 1100 revolutions per minute, CO₂ and NO_x emissions and fuel consumption increased by >150%, whereas PM and HC emissions increased by ~100% and 70%, respectively. Six Detroit Diesel Corp. (DDC) Series 60 engines in engine test cell were found to emit less CO, NO_x, and PM emissions and consumed fuel at only 75%of the level found in the chassis dynamometer data. This is because fan and compressor loads were absent in the engine test cell.     

Ferrous iron oxidation rates in the pycnocline of a permanently stratified lake

Ferrous iron was found year round at 2-4 mM in the anoxic hypolimnion of the Halls Brook Holding Area (HBHA), a small lake in eastern Massachusetts. Oxygenated epilimnion waters always had total iron concentrations of <80 nanomolar, implying nearly complete oxidation of ferrous iron as it mixed upward across the lake's pycnocline. Assuming conductivity was a conservative parameter, and using data on the lake's water balance, upward advection rates (0.02-0.05 m d(-1)) and vertical eddy diffusion coefficients (0.007-0.05 m2 d(-1)) were determined for the lake's pycnocline on five dates. Using the same advection and diffusion parameters, corresponding pseudo first-order rate coefficients for ferrous iron oxidation, k(ox) (s(-1)), on those dates were calculated (0.0004-0.007 s(-1)). The values of k(ox) (s(-1)) were always too large to reflect only homogeneous solution reactions; and on at least four dates they appeared too fast to be due to heterogeneous catalysis on iron oxyhydroxides. This suggested that ferrous iron oxidation in this lake's pycnocline was primarily due to catalysis by microorganisms, and this was supported by comparison of azide-poisoned vs. untreated batch tests. As a result of their continuous production, iron oxyhydroxide precipitates and any associated sorbates/coprecipitates are most likely continuously settling back into the lake's deep water and bed sediments, except when episodic storm events flush these solids out of the pycnocline and downstream via the Aberjona River.     

Volatile organic compound emissions from dry mill fuel ethanol production

Ethanol fuel production is growing rapidly in the rural Midwest, and this growth presents potential environmental impacts. In 2002, the U.S. Environmental Protection Agency (EPA) and the Minnesota Pollution Control Agency (MPCA) entered into enforcement actions with 12 fuel ethanol plants in Minnesota. The enforcement actions uncovered underreported emissions and resulted in consent decrees that required pollution control equipment be installed. A key component of the consent decrees was a requirement to conduct emissions tests for volatile organic compounds (VOCs) with the goal of improving the characterization and control of emissions. The conventional VOC stack test method was thought to underquantify total VOC emissions from ethanol plants. A hybrid test method was also developed that involved quantification of individual VOC species. The resulting database of total and speciated VOC emissions from 10 fuel ethanol plants is relatively small, but it is the most extensive to date and has been used to develop and gauge compliance with permit limits and to estimate health risks in Minnesota. Emissions were highly variable among facilities and emissions units. In addition to the variability, the small number of samples and the presence of many values below detection limits complicate the analysis of the data. To account for these issues, a nested bootstrap procedure on the Kaplan-Meier method was used to calculate means and upper confidence limits. In general, the fermentation scrubbers and fluid bed coolers emitted the largest mass of VOC emissions. Across most facilities and emissions units ethanol was the pollutant emitted at the highest rate. Acetaldehyde, acetic acid, and ethyl acetate were also important emissions from some units. Emissions of total VOCs, ethanol, and some other species appeared to be a function of the beer feed rate, although the relationship was not reliable enough to develop a production rate-based emissions factor.     

Effects of phytoextraction on heavy metal concentrations and pH of pore-water of biosolids determined using an in situ sampling technique

Heavy metal concentrations and pH of pore-water in contaminated substrates are important factors in controlling metal uptake by plants. We investigated the effects of phytoextraction on these properties in the solution phase of biosolids and diluted biosolids in a 12-month phytoextraction column experiment. Phytoextraction using Salix and Populus spp. temporarily decreased pore-water pH of the substrates over the experimental period followed by a return to initial pH conditions. Salix × reichardtii and Populus balsamifera effectively extracted Ni, Zn and Cd and actively mobilized these metals from the solid to the solution phase. S. × reichardtii had the stronger effect on mobilization of metals due to its larger root system. Phytoextraction did not affect Cu in the solution phase of the biosolids. Heavy metals were leached down to lower depths of the columns during the phytoextraction process.     

Environmental occurrences, behavior, fate, and ecological effects of nanomaterials: an introduction to the special series

The release of engineered nanomaterials (ENMs) into the biosphere will increase as industries find new and useful ways to utilize these materials. Scientists and engineers are beginning to assess the material properties that determine the fate, transport, and effects of ENMs; however, the potential impacts of released ENMs on organisms, ecosystems, and human health remain largely unknown. This special collection of four review papers and four technical papers identifies many key and emerging knowledge gaps regarding the interactions between nanomaterials and ecosystems. These critical knowledge gaps include the form, route, and mass of nanomaterials entering the environment; the transformations and ultimate fate of nanomaterials in the environment; the transport, distribution, and bioavailability of nanomaterials in environmental media; and the organismal responses to nanomaterial exposure and effects of nanomaterial inputs, on ecological communities and biogeochemical processes at relevant environmental concentrations and forms. This introductory section summarizes the state of knowledge and emerging areas of research needs identified within the special collection. Despite recent progress in understanding the transport, transformations, and fate of ENMs in model environments and organisms, there remains a large need for fundamental information regarding releases, distribution, transformations and persistence, and bioavailability of nanomaterials. Moreover, fate, transport, bioaccumulation, and ecological impacts research is needed using environmentally relevant concentrations and forms of ENMs in real field materials and with a broader range of organisms.     

Global Genetic Relationships Among Isolates of Golden Alga (Prymnesium parvum)1

Lutz-Carrillo, Dijar J., Gregory M. Southard, and Loraine T. Fries, 2010. Global Genetic Relationships Among Isolates of Golden Alga (Prymnesium parvum). Journal of the American Water Resources Association (JAWRA) 46(1):24-32. DOI: 10.1111/j.1752-1688.2009.00388.x Abstract: Prymnesium parvum is considered among the most harmful algal species in the world for finfish and other gill breathing organisms. Although it is globally distributed, with the exception of Antarctica, P. parvum is usually associated with coastal and brackish waters. Historically, P. parvum incidents were recorded in the eastern hemisphere; however, in 1985 it was detected in inland Texas waters. We used DNA sequence variation of the first internal transcribed spacer in the nuclear ribosomal operon (ITS1) among multiple samples of P. parvum from Texas and other locales to address the possible origins of P. parvum in Texas and the United States (U.S.). With the exception of a sample from Diversion Lake, other samples from Texas, South Carolina, and Wyoming exhibited limited genetic variation and were similar in sequence to a sample from Scotland. The Diversion Lake sample was similar in sequence to samples from Denmark and Norway, and the Maine sample was highly similar to samples from England. These results suggest multiple independent introductions of P. parvum to the U.S.     

Evaluation of the potential for the natural attenuation of hexavalent chromium within a sub-wetland ground water

In this work, the potential for natural attenuation (NA) of Cr(VI) is evaluated for sub-wetland ground water at a chromium-contaminated site in Connecticut, incorporating the experimental findings of previous work at the site. Experimental data is assessed through long-term attenuation capacity calculations and modeling, which incorporates statistical uncertainty of parametric values. The NA evaluation yielded the following results: (1) Significant increases in Cr(VI) concentration and extremely long chromium source dissolution timeframes are required to exceed the attenuation capacity of the sub-wetland region soils studied in this work; and (2) Based on the 1-D transport modeling and incorporating input parameter uncertainty, there is an approximately 92% and 98% probability that the applicable regulatory criteria will not be exceeded at Point C, near a river which serves as the receptor, for the cases of (1) sorption of Cr(VI) only and (2) pseudo first order disappearance of Cr(VI) from the aqueous phase only, respectively.