可吸入颗粒物污染与气象因子的关系

对闸北区空气自动监测站2009年SO2、NO2、PM10的浓度和气象参数变化特征进行研究,可吸入颗粒物的时间变化特征表明,总体上呈现冬春季高、夏秋季低;PM10与降水量、相对湿度、温度呈现一定的负相关性,但与风速的相关性随季节不同而不同,与气压略呈正相关性。对典型日和灰霾日PM10、SO2、NO2以及相应气象因子的特征进行了分析比较。     

青岛市港口区域PM2.5污染特征及来源解析研究

港口区域因大气污染物排放量大且污染源复杂,已成为沿海城市大气污染防治的关键区域.为明确青岛港口区域PM_2.5污染特征及主要贡献源类,于2019年在青岛市3个港口区域和1个背景点位采集了不同季节的环境PM_2.5样品,并分析了其化学组分特征;同时,采用正定矩阵因子分析模型（PMF）和潜在源贡献函数（PSCF）分别分析了港口区域PM_2.5的主要贡献源类及各源类潜在的影响区域.结果表明,2019年青岛港口区域ρ（PM_2.5）年均值为64 μg·m^-3,是我国空气质量二级标准的1.8倍,其中,董家口点位最高（74 μg·m^-3）,崂山点位最低（55 μg·m^-3）. NO₃^-、OC和SO₄^2-是PM_2.5的主导组分,其中,NO₃^-含量（13.1%）明显高于其它组分.董家口点位ρ（NO₃^-）、ρ（SO₄^2-）、ρ（OC）和ρ（EC）（分别为13.0、7.09、8.98和2.91 μg·m^-3）明显高于其它点位,燃煤、工业特别是钢铁企业及货车等影响可能较为明显.同时,冬季这些组分浓度也显著高于其它 季节,而夏季Na的浓度（0.96 μg·m^-3）和占比（2.13%）明显较高;春季Si和Al的浓度（1.27和0.45 μg·m^-3）和占比（2.79%和1.00%）明显高于其它季节.PMF源解析结果表明,二次硫酸盐和二次有机碳气溶胶（SOA）混合源（22.4%）及二次硝酸盐（20.1%）是港口区域PM_2.5的主要贡献源类,其次为机动车源（16.7%）和扬尘源（14.6%）,燃煤源的贡献率为13.8%,而海盐和船舶源的贡献为7.2%.从季节变化来看,春季扬尘贡献（32.1%）较高,夏季二次硫酸盐和二次有机碳气溶胶（SOA）混合源（31.6%）、海盐和船舶源（19.2%）贡献较高,而冬季燃煤（16.6%）、机动车（22.8%）、二次硝酸盐（23.9%）、钢铁及相关冶金源（3.2%）和建筑水泥尘（3.6%）贡献较高.河北省中南部及山东省中西部地区是青岛港口各 源类的主要潜在源区,黄海是船舶排放的主要潜在源区.     

Efficient removal of naphthalene-2-ol from aqueous solutions by solvent extraction

Naphthalene-2-ol is a typical biologically recalcitrant pollutant in dye wastewater.Solvent extraction of naphthalene-2-ol from aqueous solutions using mixed solvents was investigated.Various extractants and diluents were evaluated,and the effects of volume ratio of extractant to diluent,initial p H,initial concentration of naphthalene-2-ol in aqueous solution,extraction time,temperature,volume ratio of organic phase to aqueous phase(O/A),stirring rate and extraction stages,on extraction efficiency were examined separately.Regeneration and reuse of the spent extractant were also investigated.Results showed that tributyl phosphate(TBP) achieved 98% extraction efficiency for naphthalene-2-ol in a single stage extraction,the highest among the 12 extractants evaluated.Extraction efficiency was optimized when cyclohexane and n-octane were used as diluents.The solvent combination of 20% TBP,20% n-octanol and 60% cyclohexane(V/V) obtained the maximum extraction efficiency for naphthalene-2-ol,99.3%,within 20 min using three cross-current extraction stages under the following extraction conditions:O/A ratio of 1:1,initial p H of 3,25°C and stirring rate of 150 r/min.Recovery of mixed solvents was achieved by using 15%(W/W) Na OH solution at an O:A ratio of 1:1 and a contact time of 15 min.The mixed solvents achieved an extraction capacity for naphthalene-2-ol stably higher than90% during five cycles after regeneration.     

Layered sphere-shaped TiO2 capped with gold nanoparticles on structural defects and their catalysis of formaldehyde oxidation

We describe here a one-step method for the synthesis of Au/TiO₂ nanosphere materials, which were formed by layered deposition of multiple anatase TiO₂ nanosheets. The Au nanoparticles were stabilized by structural defects in each TiO₂ nanosheet, including crystal steps and edges, thereby fixing the Au–TiO₂ perimeter interface. Reactant transfer occurred along the gaps between these TiO₂ nanosheet layers and in contact with catalytically active sites at the Au–TiO₂ interface. The doped Au induced the formation of oxygen vacancies in the Au–TiO₂ interface. Such vacancies are essential for generating active oxygen species (*O⁻) on the TiO₂ surface and Ti^3 + ions in bulk TiO₂. These ions can then form Ti^3 +–O⁻–Ti^4 + species, which are known to enhance the catalytic activity of formaldehyde (HCHO) oxidation. These studies on structural and oxygen vacancy defects in Au/TiO₂ samples provide a theoretical foundation for the catalytic mechanism of HCHO oxidation on oxide-supported Au materials.     

Glucose production from hydrolysis of cellulose over a novel silica catalyst under hydrothermal conditions

A novel silica catalyst was synthesized by evaporation-induced self-assembly (EISA) method and tested for the catalytic selective hydrolysis of cellulose to glucose. This silica catalyst exhibited a higher catalytic activity than other oxides prepared by the same method, such as ZrO₂, TiO₂, and Al₂O₃. Using silica as a catalyst, cellulose was selectively hydrolyzed into glucose with a glucose yield as high as 50% under hydrothermal conditions without hydrogen gas. The silica catalyst was characterized by Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD) and transmission electron microscopy (TEM). The results of temperature-programmed desorption of ammonia (NH₃-TPD) and textural properties indicated that the synergistic effect between strong acidity and a suitable pore diameter of the silica catalyst may be responsible for its high activity. In addition, the catalyst was recyclable and showed excellent stability during the recycle catalytic runs.     

Operating condition influences on PCDD/Fs emissions from sinter pot tests with hot flue gas recycling

This study was designed to clarify the influence of operating conditions on the formation and emissions of polychlorinated-pdibenzodioxins and dibenzofurans (PCDD/Fs) from a sintering process with hot flue gas recycling. A pilot scale sinter pot with simulated flue gas recycling was developed, and four key operational parameters, including temperature, oxygen content of the simulated waste flue gas, the coke rate of the sintering mixture, and the quicklime quality, were selected for exploring PCDD/Fs formation. The results showed that the temperature of the recycled flue gas had a major affect on PCDD/Fs formation, and a high temperature could significantly increase their formation during sintering. A clear linear correlation between the temperature of recycling flue gas and PCDD/Fs emission (r = 0.93) was found. PCDD/Fs could be reduced to a certain extent by decreasing the level of oxygen in the recycled flue gas, while sintering quality was unchanged. The coke rate had no significant influence on the formation of PCDD/Fs, but the quality of quicklime used in the sintering mixture could affect not only the amount of PCDD/Fs emissions but also the sintering productivity. Compared with a benchmark sinter pot test, PCDD/Fs emissions markedly decreased with improvements to quicklime quality. However, the reduction in PCDD/Fs emissions realized by using high-quality quicklime was limited by the temperature of the inlet gas. The highest reduction achieved was 51% compared with conventional quicklime when the temperature of the inlet gas was 150°C.     

Anaerobic treatment of fresh leachate from a municipal solid waste incinerator by upflow blanket filter reactor

This paper describes the feasibility of fresh leachate treatment by an upflow blanket filter (UBF). Through dilution and partial effluent recycling, the organic loading rates increased from 0.51 to 14.56 kg COD/(m³·d), meanwhile the corresponding hydraulic retention time decreased from 9.0 to 3.6 d. The reactor was able to achieve steady-state within 80 d. Based on the distribution of COD fluxes in the process, it was concluded that anabolism was the main pathway of COD removal in the initial phase (1–33 d), accounting for 57%–85% of total COD removed. As the anaerobic consortium of bacteria reached steady-state (after 70–86 d), the majority of COD removed was transformed into methane, because the specific methane yield was close to the theoretical value (0.36 L CH₄/(g COD_deg)).     

滦河锡林郭勒盟段水质状况评价

利用水质指数法对滦河锡林郭勒盟段水质状况进行了分析评价,结果显示：（1）滦河锡林郭勒段2005-2007年主要污染因子为：高锰酸盐指数、化学需氧量、铁、生物需氧量、锰、总磷等;（2）2005-2007年间,上都河监测断面水质状况整体呈变好趋势,但地方经济增长带来的化学需氧量异常升高不容忽视,大河口断面不同水期水质状况变化不同;（3）2005-2007年,滦河锡林郭勒段化学需氧量与溶解氧超标污染加重明显、高锰酸盐指数超标污染逐渐减轻;三年内,上游水质均优于下游水质,两个监测断面水质均为丰水期水质〈平水期水质〈枯水期水质。     

汶川地震期间天津地震前兆台网运行与管理

汶川地震发生后,天津市地震局迅速进入应急体制,高效应对突发事件.监测中心、预报中心全体人员坚守岗位,履行职责,较好地完成了汶川地震期间天津地震前兆台网运行监控、数据管理、台站综合评比、数据服务、总结评估等项工作,以无私奉献的团队精神为地震监测预报工作做出了应有的贡献.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.