Carbon dioxide and methane fluxes in the littoral zones of two lakes,east Antarctica

During the summertime of 2007/2008, carbon dioxide (CO₂) and methane (CH₄) fluxes across air–water interface were investigated in the littoral zones of Lake Mochou and Lake Tuanjie, east Antarctica, using a static chamber technique. The mean fluxes of CO₂ and CH₄ were ?70.8 mgCO₂ m^?2 h^?1 and 144.6 μgCH₄ m^?2 h^?1, respectively, in the littoral zone of Lake Mochou; The mean fluxes were ?36.9 mgCO₂ m^?2 h^?1 and 109.8 μgCH₄ m^?2 h^?1, respectively, in the littoral zone of Lake Tuanjie. Their fluxes showed large temporal and spatial dynamics. The CO₂ fluxes showed a significantly negative correlation with daily total radiation (DTR) and a weakly negative correlation with air temperature and water temperature, indicating that sunlight intensity controlled the magnitude of CO₂ fluxes from the open lakes. The CH₄ fluxes significantly correlated with local air temperature, water table and total dissolved solids (TDS), indicating that they were the predominant factors influencing CH₄ fluxes. Summertime CO₂ budgets in the littoral zones of Lake Mochou and Lake Tuanjie were estimated to be ?152.9 gCO₂ m^?2 and ?79.7 gCO₂ m^?2, respectively, and net CH₄ emissions were estimated to be 312.3 mgCH₄ m^?2 and 237.2 mgCH₄ m^?2, respectively. Our results show that shallow, open, alga-rich lakes might be strong summertime CO₂ absorbers and small CH₄ emitters during the open water in coastal Antarctica.     

Measurement of the surface charge of ultrafine particles from laser printers and analysis of their electrostatic force

Ultrafine particles (UFPs) released from laser printers are electrostatically charged during the working processes of the devices, and the electrostatic force can obviously influence the dynamics of the particles. Due to the measurement difficulty and scarcity of relevant research, this issue was not reported. This study tried to address this issue through experimental measurement of the surface charge of UFPs and numerical investigation on the influence of electrostatic force on the dynamics of UFPs. A test chamber was set up to collect the UFPs, and the Scanning Electron Microscope was used to observe the morphologies of the UFPs. Based on the particle diameter and surface zeta potential, the surface charge of UFPs was calculated. The measurement results gave that particle emitted from laser printers are negatively charged and the average surface charge of particle emissions for four laser printers is in a range of about ?4.16 × 10^?17 to ?6.07 × 10^?17 C (～?260 to ?379 e). This paper also discussed the influence of electrostatic force on the dynamics of UFPs. According to the numerical investigation, it was found that, in the absence of electric field, the electrostatic force has to be considered when the surface charge is larger than 1 × 10^?16 C and when the UFP is very close to the wall with a distance of less than 0.01 m. These findings will guide constructively in predicting the dispersion and deposition of particles emitted from laser printers.     

TiO_2光催化对微滤去除腐殖酸的膜污染控制研究

着重研究了不同紫外灯光源和照射时间条件下,TiO_2光催化(PCO)对微滤去除腐殖酸过程中的膜污染控制,并探讨了膜污染的控制机理。研究结果表明,TiO_2光催化能有效提高微滤对腐殖酸的去除,同时降低膜通量的下降,起到有效控制膜污染的作用。进一步的实验分析表明,TiO_2光催化控制膜污染的主要机理在于将腐殖酸降解为易于被TiO_2吸附的小分子量物质,吸附腐殖酸降解产物后的TiO_2聚合颗粒粒径增大,易于在膜表面形成更为松散的沉积层,并使膜污染从以膜孔堵塞和沉积层污染为主转化为以沉积层污染为主的可逆性污染。     

O3/BAF工艺系统中有机物生物降解数学模型

研究臭氧预氧化/曝气生物滤池（O₃/BAF）联合工艺深度处理实际城市污水二级出水过程中,后续BAF系统中有机物的生物降解数学模型。以有机底物浓度、填料层高度两个基本变量为控制条件,研究BAF的总体运行常数和填料特性常数,得出BAF有机物生物降解动力学方程为S_e/S₀=exp(－Kh/qSⁿ₀)。出水与进水COD浓度比值（S_e/S₀）的对数与反应器填料高度（h）之间可表达成一次函数关系。在不同的进水浓度（S₀）下,根据ln（S_e/S₀）~h和关系式m=K/qSⁿ₀,得到方程ln(q_m)=－nln(S₀)+lnK。BAF总体运行常数K和填料特性常数n分别为1.708和0.5063。该模型对BAF工艺有如下指导意义：可以根据设计流量、进水有机物浓度和出水浓度,初步确定BAF的尺寸（如横截面积、高度等）。     

不同碳源和泥龄对反硝化聚磷的影响

在4个SBR装置(1#~4#)中,对4种不同比例的丙酸/乙酸合成废水采用厌氧/缺氧方式驯化富集反硝化聚磷菌(DPB),研究了碳源浓度和污泥龄对除磷的影响。实验结果表明:(1)厌氧段碳源COD浓度越高,释磷越充分,溶解性正磷酸盐(SOP)去除率越高;但当碳源COD浓度超过某个浓度值时,未反应完全的有机物残留于后续缺氧段对缺氧吸磷产生抑制作用。(2)污泥龄SRT=15 d时,活性污泥的性能较好,达到了较好的除磷效果。(3)在相同碳源浓度和相同的污泥龄下,随着丙酸/乙酸比例的提高,SOP的去除率逐渐的降低。说明在厌氧/缺氧环境下,碳源中丙酸比例的提高不利于系统中磷的去除。高乙酸含量的碳源更适合反硝化除磷系统。     

改性粉煤灰协同PSFA处理高度乳化油废水

通过正交实验对改性粉煤灰协同粉煤灰基混凝剂PSFA处理高度乳化油废水的工艺条件进行了优化。实验结果表明:当处理500 mL废水,投加改性粉煤灰25 g,粉煤灰基混凝剂6～8 g,PAM6～9 mL,pH为7.0,搅拌10～15 min的优化条件下,高度乳化油废水中COD、石油类物质的去除率可分别可达85.4%及50.3%。该方法与传统CaCl2+PFS+PAM组合相比,具有处理效果好,沉降速度快,运行费用低等优点。     

新型活性炭固定化产品的制备及其处理焦化废水的特性

为解决优势菌种工程应用,研究不同固定化方法、载体和结构的固定化产品对焦化废水的降解特性。用活性炭粉末吸附菌种后,与聚乙烯醇和海藻酸钠混合制备了新型固定化球;用聚乙烯醇和海藻酸钠包埋吸附菌种的活性炭纤维毡,与立体弹性塑料填料连用,制备出3种不同形状的活性炭纤维膜片固定化产品复合填料。将游离菌和制备的4种活性炭固定化产品投入A/A/O工艺系统平行实验,考察处理焦化废水的效果。结果表明,活性炭纤维膜片固定化产品复合填料对焦化废水的降解能力优于其他固定化产品:缺氧池出水硝酸盐氮和亚硝酸盐氮浓度分别稳定在1.96 mg/L和0.49 mg/L,未产生氮的累积现象,COD去除率可达到60.92%。好氧池COD和氨氮降解效率分别为78.83%和85.52%,苯酚、氰化物降解效率均为97%以上。     

新型SBBR处理畜禽废水脱氮实验研究

以畜禽废水为处理对象,将序批式运行模式应用到好氧三相内循环生物流化床中,考察在不同模式下的处理效果及氮的转化情况。实验结果表明,在室温条件下,进水COD浓度为2 000 mg/L左右,总氮为140 mg/L左右时,保持溶解氧在2~2.5 mg/L,交替好氧/缺氧运行方式处理效果优于单一的好氧/缺氧方式;模式为3 h(曝气)-1.5 h(停曝)-1.5 h(曝气)-1 h(停曝)时系统对总氮和氨氮处理效果最好,总氮去除率达到90%,系统主要脱氮方式为同步硝化反硝化和短程硝化反硝化。     

SBR处理生活污水好氧颗粒污泥的培养研究

采用SBR,以生活污水为进水,在常温条件下,接种苏州某污水厂活性污泥,对好氧颗粒污泥进行培养,并对反应器的运行效能进行了研究。研究表明,经100多天的运行,培养出粒径在4~8 mm间,结构松散,外观灰白色的好氧颗粒污泥;用城市生活污水培养的颗粒污泥对污染物的去除效果不好,无明显的脱氮除磷能力。     

非水相硝基苯在含水层中的迁移释放规律

通过室内模拟实验,探讨了在非水相硝基苯污染含水层的条件下,其在含水层中的迁移及释放规律。迁移规律表明,非水相硝基苯并非在含水层中直接进行垂向迁移,而是一方面在自身重力作用下向含水层下部迁移,另一方面在地下水流的作用下随地下水同向运移,整体表现为随地下水流的侧向运移,并最终迁移至含水层底部。释放规律表明,非水相硝基苯在含水层迁移的过程中会向地下水大量释放,释放出的硝基苯在水流的作用下随地下水同向运移,污染源及迁移至含水层底部的非水相硝基苯均存在再次释放。