Formaldehyde Release from Simulated Wall Panels Insulated with Urea-Formaldehyde Foam Insulation

An important potential source of formaldehyde in the home is ureaformaldehyde foam insulation (UFFI). This study measures the long-term release of formaldehyde through the interior wall of test panels foamed with commercial urea-formaldehyde insulation. The measurements, made approximately 16 mo after initial foaming, were conducted under both static and dynamic air conditions with air flow selected to simulate a typical air exchange found in houses. Estimated room concentrations based on a simple model of uniform mixing within a room and measured emission rates are presented. Measurements of formaldehyde in the air from within the UFFI cavities are also reported.     

An Evaluation of the Semi-VOST Method for Determining Emissions from Hazardous Waste Incinerators

The Semi-Volatile Organic Sampling Train method was investigated to determine its reliability and to determine the bias and precision of the method when used to determine emissions from hazardous waste incinerators. Experiments showed that the matrix and sampling variables usually involved in sampling emissions from a hazardous waste incinerator had no significant effect on the recovery of 11 different organic compounds. Significant losses of the sampled compounds can occur during sample preparation. The degree of loss appears to be directly related to the compounds, vapor pressure. These losses can be corrected for by adding deuterated surrogates to the sample and analyzing the surrogates along with the native compounds.

The bias determination was based on dynamic spiking of the sampling train with five deuterated organic compounds selected from Appendix VIII of the Resource Conservation and Recovery Act regulations. The results show biases of from -1 ± 8 percent to -18 ± 27 percent for chlorinated and nonchlorinated compounds. Pyridine, a water-soluble compound, showed a larger bias of-29 ± 13 percent. Particular attention to the recovery of water soluble compounds is necessary to minimize bias in their determinations. Further work is needed to determine the reliability of laboratory-determined retention volumes that are used to determine sampling conditions.     

Use of Energy Scenarios in Addressing the CO2 Question

A reference scenario for CO₂ emissions was developed using a model of world energy supply and demand. In the reference scenario, world GNP and world energy demand increase at average rates of 2.1 percent per year and 1.5 percent per year, respectively during the period 1975-2100. The corresponding annual CO₂ emissions rise to a maximum of 16 gigatons of carbon around 2050 and then decline as a result of a transition to nonfossil fuel energy systems. A modified scenario for high CO₂ emissions was obtained by assuming an abundant supply of low cost coal, thus eliminating the transition. A low case was developed in which the low cost of alternative energy (i.e., solar, nuclear) induces an earlier shift away from fossil fuels.

Annual emissions of the three scenarios were used as input to a global carbon cycle model and the CO₂ buildup in the atmosphere during the period 1980-2100 was determined by the model. All three scenarios showed continuous rises in atmospheric CO₂ concentration. The reference scenario reached 775 ppm by 2100. The high CO₂ case resulted in concentrations of over 1040 ppm, and for the low case the 2100 concentration was just under 700 ppm. If the climate theory is correct, even 700 ppm is sufficient to give significant climate warming, but by experiencing the change gradually over a century, adaptation may not be painful. An early transition to nonfossil fuel supplies makes the problem less severe but does not eliminate it.     

A New Audit Technique for EPA Method 25

A simple, inexpensive, and accurate technique for evaluating or auditing the sampling, recovery, and analytical phases of EPA Source Reference Method 25 has been developed. The technique involves spiking a U-shaped stainless steel cartridge containing Tenax® with known quantities of selected organic compounds and thermally desorbing them at temperatures from 160°C to 180°C to generate organic vapors quantitatively. The major advantages of this technique are that no other measurement methods can be used to determine the generated organic concentrations in lieu of Method 25; and that the cartridge can easily be taken to the field for evaluation. The organic compounds generated in test runs are collected and analyzed using the Method 25 procedure. The generation of organics is quantitative and recoveries were found to be 100 ± 10%. The time required for desorption of the majority of organics is generally less than forty-five minutes at a flow rate of 100 mL/min; however, based on laboratory experience the recommended sampling time is sixty minutes. These spiked cartridges are stable at room temperature over a two-month period. Results of interlaboratory studies showed close agreement with the expected concentrations based on calculations from the mass loadings and sample volumes.     

Development of Federal Air Standards to Reduce Sulfur Dioxide Emissions from New Industrial Boilers

Federal new source performance standards to control air emissions of sulfur dioxide from new industrial boilers were proposed by EPA on June 19, 1986. These standards would require boiler owners to reduce SO₂ emissions by 90 percent and meet an emission limit of 1.2 lb/MM Btu of heat input for coal-fired boilers and 0.8 lb/MM Btu for oil-fired boilers. In developing these standards, several regulatory options were considered, from standards that could be met by firing low sulfur fuels to standards that would necessitate flue gas treatment. The environmental, economic, and cost impacts of each option were analyzed. National impacts were estimated by a computer model that projects the population of new boilers over the 5-year period following proposal, predicts the compliance strategy that will be used to comply with the particular option (always assuming that the lowest cost method of compliance will be selected), and estimates the resulting emission reductions and costs. Impacts on specific industries and on model boilers were also analyzed. This paper focuses on these analyses and their results. The Agency's conclusions from these analyses, which led to the decision to establish percent reduction standards, are provided, and the proposed SO₂ standards are summarized. The proposed standards also include an emission limit for particulate matter from oil-fired boilers (0.1 lb/MM Btu). However, this article focuses only on the SO₂ standards.     

An Assessment of the Economic Effects of Ozone on U.S. Agriculture

Past attempts to measure the economic consequences of ozone on agriculture have been based on limited plant science information. This paper reports on an economic assessment of ozone on U.S. agriculture using recent crop response data from the National Crop Loss Assessment Network (NCLAN). The results are derived from a U.S. agricultural sector model that includes major crop and livestock production as well as domestic consumption, livestock feeding and export uses. The economic effects of four hypothetical ambient ozone levels are investigated. The analysis Indicates that the benefits to society of moderate (25%) ozone reductions are approximately $1.7 billion. A 25% Increase in ozone pollution results in costs (negative benefits) of $2.1 billion. These estimates do not reflect compliance costs of achieving the ozone changes and hence are not net benefits.     

化学沉淀法强化常规工艺应急去除水中的镉

在常规工艺基础上,通过投加氢氧化钠,实验进行了应急去除重金属镉的研究。实验结果表明,该方法能有效去除饮用水水源的镉,效果稳定,可进行应急处理。对pH、镉初始浓度和混凝剂投加量3个影响因素的灰色关联分析表明,3个因素对镉去除效果影响的大小排序为:滤后水pH>混凝剂投加量>镉初始浓度。在水源镉突发污染时,在原有常规水处理工艺基础上,通过控制滤后水pH可实现对重金属镉的去除,pH的控制值与水源水质有关。     

ASBBR处理超高盐榨菜腌制废水

研究以超高盐榨菜腌制废水为对象,考察填料种类、负荷和温度对ASBBR启动及处理效能的影响。研究结果表明,在温度为30℃,盐度为7%（NaCl计）,负荷为1 kg COD/（m³·d）的条件下,采用聚氨酯泡沫填料的反应器经67 d可成功构建超高盐榨菜腌制废水厌氧生物处理系统,较未设置填料、投加半软性组合填料、球形组合填料和聚苯乙烯泡沫填料的反应器分别缩短了26、6、24和18 d,且运行至第79天,可使出水COD降至375 mg/L,COD去除率为92.86%;通过对负荷的阶段逐步提高,可提升反应器有机负荷至15 kg COD/（m³·d）,使进水COD为（27 000±2 000）mg/L的超高盐废水,出水COD均值降至2 200 mg/L ,平均去除率达到92.03%;温度对反应器处理效能影响显著,温度分别为30、25、20、15和10℃时,反应器COD去除率分别为92.63%、84.07%、67.13%、54.61%和44.19%。     

Increased Bioavailability of Mercury in the Lagoons of Lomé, Togo: The Possible Role of Dredging

Surface sediments of the lagoons of Lomé, Togo, were analyzed for mercury, methylmercury, and trace elements. Concentrations were greater than typical for natural lagoon sediments, and with greater variability within the Eastern lagoon compared to the Western one. The Eastern lagoon is larger and has been dredged in the past, while the Western lagoon, which also receives major waste inputs, has not been dredged and shows less tidal flushing. Accordingly, one naturally believes that the Eastern lagoon is cleaner and probably safe to use due to its natural resources, including fishes to eat. Unexpectedly, we describe here that mercury methylation was greater in the Eastern lagoon, indicating increased bioavailability of mercury, as probably facilitated by past dredging that decreased solid-phase retention of inorganic mercury. Urbanization has historically been more developed in the southern part of the lagoons, which is still reflected in contamination levels of sediment despite dredging, probably because sources of contamination are still more important there today. Such urban contamination emphasizes the need to regulate waste discharges and possible airborne contamination in growing cities of developing countries, and implements environmental and public health monitoring, especially in relation to misbelieves systematically associated with the cleansing effect of dredging activity.