都江堰灵岩山3种人工林优势物种叶片的有机组分特征

叶片的有机组分特征不仅是植物光合产物分配策略和养分回收的重要参数,而且是衡量凋落叶分解难易程度的重要指标.为探究不同植物群落叶片间有机组分的差异,以华西雨屏区人工林的优势乔、灌、草植物作为对象,收集其成熟叶及凋落叶,研究其水溶性组分(water soluble component,WSC)、有机溶性组分(organic...     

Modeling porosity reductions caused by mineral fouling in continuous-wall permeable reactive barriers

A study was conducted to assess key factors to include when modeling porosity reductions caused by mineral fouling in permeable reactive barriers (PRBs) containing granular zero valent iron. The public domain codes MODFLOW and RT3D were used and a geochemical algorithm was developed for RT3D to simulate geochemical reactions occurring in PRBs. Results of simulations conducted with the model show that the largest porosity reductions occur between the entrance and mid-plane of the PRB as a result of precipitation of carbonate minerals and that smaller porosity reductions occur between the mid-plane and exit face due to precipitation of ferrous hydroxide. These findings are consistent with field and laboratory observations, as well as modeling predictions made by others. Parametric studies were conducted to identify the most important variables to include in a model evaluating porosity reduction. These studies showed that three minerals (CaCO3, FeCO3, and Fe(OH)2 (am)) account for more than 99% of the porosity reductions that were predicted. The porosity reduction is sensitive to influent concentrations of HCO3-, Ca2+, CO3(2-), and dissolved oxygen, the anaerobic iron corrosion rate, and the rates of CaCO3 and FeCO3 formation. The predictions also show that porosity reductions in PRBs can be spatially variable and mineral forming ions penetrate deeper into the PRB as a result of flow heterogeneities, which reflects the balance between the rate of mass transport and geochemical reaction rates. Level of aquifer heterogeneity and the contrast in hydraulic conductivity between the aquifer and PRB are the most important hydraulic variables affecting porosity reduction. Spatial continuity of aquifer hydraulic conductivity is less significant.     

3株反硝化聚磷菌的分离与鉴定

通过烛缸法培养富集、分离,结合除磷试验、硝酸盐还原产气试验及异染颗粒和PHB颗粒染色辅助检验相结合的方法筛选,得到3株具有较高脱氮除磷效率的反硝化聚磷菌DNPA8, DNPA9和DNPA10。在富氮富磷培养基中培养48 h,各菌株的脱氮率均大于75%,除磷率均大于78%。采用多相分类的方法确定了3株反硝化聚磷菌的分类地位,DNPA8为嗜麦芽寡养单胞菌,DNPA9为水生丛毛单胞菌属首次发现的反硝化聚磷菌;DNPA10为约翰逊氏不动杆菌。该研究结果为富营养化水体的治理提供了有效的菌种资源。     

负载型纳米TiO2光催化降解水中微量溶解性间二甲苯

以高压汞灯为光源 ,采用浸涂 -烧结法制备的负载型纳米TiO2 作为光催化剂 ,通过对水中微量溶解性间二甲苯的光催化氧化过程的研究表明 ,初始浓度在 6 .6 8— 17.36mg/L的范围内 ,间二甲苯的光催化反应遵循表观一级反应动力学规律 ,反应的表观速率常数随溶液初始浓度的增大而减小 ,半衰期则随初始浓度的增大而增加 ,经 1.5h反应后 ,溶液中间二甲苯的去除率从 17.36mg/L的 5 4 .4 4 %增加到 6 .6 8mg/L的 75 .90 %。     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

土壤渗滤对有机微污染物去除性能研究

采用土壤柱试验研究了土壤渗滤对再生水中有机微污染物的去除性能。结果表明,土壤柱对再生水中的DOC、UV₂₅₄、总氮和总磷有较好的去除效果,并具有较高的抗冲击负荷的能力;土壤表层10 cm厚度对DOC的去除起主要作用;UV₂₅₄和AOX在土壤表层10 cm厚度降解效果不明显,随着深度增加去除率逐渐升高;液相色谱有机碳探测(LC-OCD)检测结果表明,土壤柱对溶解性有机物质的去除主要体现在对多糖物质的降解上,其次是有机酸类,对腐殖质也有一定的去除作用。     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.     

Variations of metal distribution in sewage sludge composting

In the study, the variations of heavy metal distributions (of Cu, Mn, Pb, and Zn) during the sewage sludge composting process were investigated by sequential extraction procedures. The total content of Cu and Zn in the composted mixture increased after the composting process. Mn and Zn were mainly found in mobile fractions (exchangeable fraction (F1), carbonate fraction (F2), and Fe/Mn oxide fraction (F3)). Cu and Pb were strongly associated with the stable fractions (organic matter/sulfides fraction (F4) and residual fraction (F5)). These five metal fractions were used to calculate the metal mobility (bioavailability) in the sewage sludge and composted mixture. The mobility (bioavailability) of Mn, Pb, and Zn (but not Cu) increased during the composting process. The metal mobility in the composted mixture ranked in the following order: Mn>Zn>Pb>Cu.     

底泥中重金属毒性的室内孔隙水分析技术

根据孔隙水中重金属的浓度可以判定底泥中重金属的毒性但获得真正的底泥孔隙水十分困难。本文提供了一套简便易行的室内原状孔隙水取样技术,将碳化硅砂芯埋入底泥,添加表层水并静置９０ｄ,通过渗滤获得孔隙水,测定孔隙水中重的浓度,所得结果与微生态系统暴露试验中生物指示的重金属的毒性大小相吻合,与生物积累重金属的浓度显著正相关。     

应用D412螯合树脂治理含镍电镀废水的研究

本文研究了Ｄ４１２螯合树脂对Ｎｉ（Ⅱ）离子静态和动态的吸收性能,并且研究了使用Ｄ４１２树脂除去和回收电镀废水中镍的最佳条件。