异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

多孔富铁填料曝气过滤除磷机理研究

采用多孔富铁填料的曝气过滤装置具有优良的除磷性能,理论分析研究了多孔富铁填料的除磷机理,通过铁细菌测定、电镜扫描、红外光谱分析等实验对其除磷机理进行了验证。结果表明,多孔富铁填料除磷为化学除磷过程,铁的形态转化中存在铁细菌的氧化作用,沉淀物以碱式磷酸铁为主。     

PEM式臭氧消毒在地上游泳池水处理中的应用

采用臭氧法水处理系统对地上游泳池的循环水进行灭菌消毒,研究了臭氧用量、循环水流量和运行时间等因素对臭氧法灭菌效果的影响。结果表明,3组PEM臭氧发生器应用于21.2 m3的地上游泳池,在4 m3/h的循环水流量下运行12 h后,水中的细菌总数与大肠杆菌群数达到国家标准,去除率均在99%以上。与盐电解法水处理系统相比较,臭氧法水处理系统的优势在于:杀菌快速高效、出水水质的理化指标较好和运行费用低廉。     

超声协同TiO_2光催化降解4,4′-二溴联苯

以纳米TiO2膜为光催化剂,对4,4′-二溴联苯水溶液进行了超声光催化(US+UV)、光催化(UV)和超声(US)降解,探讨了初始浓度、超声的声强和频率等对降解4,4′-二溴联苯的影响。结果表明,4,4′-二溴联苯的超声光催化降解存在协同效应,降解率随4,4′-二溴联苯初始浓度的增大而下降,随声强和频率的增大而增大。超声光催化过程符合一级动力学方程,反应数率常数为0.011 min-1。超声光催化与光催化的降解产物不同。     

微观福利视角下的库区移民搬迁意愿调查

三峡地区社会经济的发展受到资源、环境的限制,又面临再次移民的规划.为有效的缓解由于搬迁中搬迁主体与搬迁规划向左而产生的社会矛盾,优化搬迁政策制度,实现社会的和谐,就应分析库区移民自身的福利状态与搬迁意愿之间的关系.本文在福利理论分析框架下建立理论模型并设计问卷,在多层随机抽样调查的基础上,对理论模型进行验证,运用Logit模型建立三个逐次包含的模型,进行回归分析,试图找到对移民搬迁意愿产生较大影响的福利影响因素,并分析其原因.研究表明,对于库区人口搬迁的自身福利的变化而言,最重要的影响因素为:居住环境、居住方式、教育程度、饮水方式、政策了解程度、环境满意度等;收入、承包地面积、工作等因素也起着一定的影响作用;年龄及基础设施建设中的电话和教育建设对于搬迁意愿的影响则不明显.     

Photocatalytic degradation of contaminants of concern with composite NF-TiO2 films under visible and solar light

This study reports the synthesis and characterization of composite nitrogen and fluorine co-doped titanium dioxide (NF-TiO₂) for the removal of contaminants of concern in wastewater under visible and solar light. Monodisperse anatase TiO₂ nanoparticles of different sizes and Evonik P25 were assembled to immobilized NF-TiO₂ by direct incorporation into the sol–gel or by the layer-by-layer technique. The composite films were characterized with X-ray diffraction, high-resolution transmission electron microscopy, environmental scanning electron microscopy, and porosimetry analysis. The photocatalytic degradation of atrazine, carbamazepine, and caffeine was evaluated in a synthetic water solution and in an effluent from a hybrid biological concentrator reactor (BCR). Minor aggregation and improved distribution of monodisperse titania particles was obtained with NF-TiO₂-monodisperse (10 and 50 nm) from the layer-by-layer technique than with NF-TiO₂?+?monodisperse TiO₂ (300 nm) directly incorporated into the sol. The photocatalysts synthesized with the layer-by-layer method achieved significantly higher degradation rates in contrast with NF-TiO₂-monodisperse titania (300 nm) and slightly faster values when compared with NF-TiO₂-P25. Using NF-TiO₂ layer-by-layer with monodisperse TiO₂ (50 nm) under solar light irradiation, the respective degradation rates in synthetic water and BCR effluent were 14.6 and 9.5?×?10^?3?min^?1 for caffeine, 12.5 and 9.0?×?10^?3?min^?1 for carbamazepine, and 10.9 and 5.8?×?10^?3?min^?1 for atrazine. These results suggest that the layer-by-layer technique is a promising method for the synthesis of composite TiO₂-based films compared to the direct addition of nanoparticles into the sol.     

Adsorption behavior of light green anionic dye using cationic surfactant-modified wheat straw in batch and column mode

An agricultural by-product, natural wheat straw (NWS), was soaked in 1 % cationic surfactant (hexadecylpyridinium bromide, CPB) solution for 24 h (at 293 K), and modified wheat straw (MWS) was obtained. Analysis of FTIR, XFR, and nitrogen element showed that CPB was adsorbed onto surface of NWS. Then, MWS was used as adsorbent for the removal of light green dye (LG, anionic dye) from aqueous solution. The experiment was performed in batch and column mode at room temperature (293 K). Sodium chloride (up to 0.1 mol/L) existed in solution was not favor of LG dye adsorption. The equilibrium data were better described by Langmuir isotherm, and adsorption capacity of q _m from Langmuir model was 70.01?±?3.39 mg/g. In fixed-bed column adsorption mode, the effects of initial LG concentration (30, 50, 70 mg/L) and flow rate (6.5, 9.0, 14.5 mL/min) on adsorption were presented. Thomas and modified dose–response models were used to predict the breakthrough curves using nonlinear analysis method, and both models can fit the breakthrough curves. Theoretical and experimental breakthrough curves were drawn and compared. The results implied that MWS can be used as adsorbent material to remove LG from aqueous solution.     

Copper ultrastructural localization, subcellular distribution, and phytotoxicity in Hydrilla verticillata (L.f.) Royle

Laboratory experiments were conducted to investigate copper (Cu) subcellular distribution and toxicity in Hydrilla verticillata. Fronds were subjected to different concentrations (15, 75, and 150 μM) of Cu for 7 days. Cu grains were found in cell walls, plasmodesmata, and within the nuclei and chloroplasts using the autometallographic technique. Subcellular fractionation of Cu-containing tissues indicated that in leaves subjected to high Cu concentrations, 59–65 % of the element was located in the cell wall fraction, followed by cell organelles (21–30 %) and the soluble fraction (10–14 %). The levels of K, P, Zn, and Mg declined under all Cu concentrations, but Ca, Mn, and Fe contents reached their peak at 15 μM Cu and decreased thereafter. F _v/F _m, F ₀, and F _m fell significantly in line with the decrease in pigment content. Cu exposure also caused significant damage to the chloroplasts, mitochondria, and nuclei, including disintegration of the chloroplasts and vacuolization of the mitochondria and nuclei, all of which suggested that Cu hastened plant senescence. The Cu maximum permissible concentration for H. verticillata was 10 μM, which was less than the existing general water quality standard. This suggested that H. verticillata could be used to assess Cu phytotoxicity.     

Parental phenols exposure and spontaneous abortion in Chinese population residing in the middle and lower reaches of the Yangtze River

Widespread use of phenols has led to ubiquitous exposure to phenols. In experimental animals, phenols increased resorptions, reduced live litter size and fetal body weights. However, there are limited epidemiological evidences of the relationships between exposure to phenols and pregnancy outcomes. We evaluated the associations between parental urinary levels of various phenols and spontaneous abortion in a Chinese population residing in the middle and lower reaches of the Yangtze River. A case-control study was conducted that included 70 case couples with medically unexplained spontaneous abortion and 180 control couples who did not have a history of spontaneous abortion and had at least one living child. Both parental urinary phenols were measured by ultra-high performance liquid chromatography-tandem mass spectrometry including bisphenol A (BPA), benzophenone-3 (BP-3), 2,3,4-trichlorophenol (2,3,4-TCP), pentachlorophenol (PCP), 4-n-octylphenol (4-n-OP) and 4-n-nonylphenol (4-n-NP). Compared with the low exposure group, there was an increased risk of spontaneous abortion with high paternal urinary PCP concentration [odds ratio (OR) = 2.09, 95% Confidence Interval (CI), 1.05–4.14], and maternal exposure to 4-n-OP and alkylphenol(s) also significantly increased the risk of spontaneous abortion (OR = 2.21, 95% CI, 1.02–4.80; OR = 2.81, 95% CI, 1.39–5.65, respectively). Our study firstly provides the evidence that paternal PCP exposure, maternal 4-n-OP and alkylphenol(s) exposure are associated with spontaneous abortion in humans.     

Photo-dissociation of dimethylamine by KrBr excilamp

A study of dimethylamine photo-dissociation in the gas phase has been conducted using UV radiation delivered from a KrBr^* excilamp, driven by a sinusoidal electronic control gear with maximum emission at wavelength of 207 nm. The electrical input power and radiant power of the lamp were measured to determine their effects on the degradation. The influence of flow velocity and initial concentration of dimethylamine were also examined. In order to evaluate the photo-dissociation process comprehensively, several parameters were investigated, including removal efficiency, energy yield, carbon balance and CO₂ selectivity. It is shown that the removal efficiency increases with enhanced input power and decreased gas flow rate. A high removal efficiency of 68% is achieved for lamp power 102 W and flow velocity 15 m³ h⁻¹. The optimum dimethylamine initial concentration is around 3520 mg m⁻³, for which the energy yield reaches up to 442 g kW h⁻¹ when the input power is 65 W. In addition, two chain compounds (1,3-bis-dimethylamino-2-propanol; 3-penten-2-one, 4-amino) and three ring organic matters (1-azetidinecarboxaldehyde, 2,2,4,4-tetramethyl; N-m-tolyl-succinamic acid; p-acetoacetanisidide), were identified by GC–MS as secondary products, in order to demonstrate the pathways of the dimethylamine degradation.