Load estimation and source apportionment of nonpoint source nitrogen and phosphorus based on integrated application of SLURP model, ECM, and RUSLE: a case study in the Jinjiang River, China

The nonpoint source (NPS) pollution is difficult to manage and control due to its complicated generation and formation. Load estimation and source apportionment are an important and necessary process for efficient NPS control. Here, an integrated application of semi-distributed land use-based runoff process (SLURP) model, export coefficients model (ECM), and revise universal soil loss equation (RUSLE) for the load estimation and source apportionment of nitrogen and phosphorus was proposed. The Jinjiang River (China) was chosen for the evaluation of the method proposed here. The chosen watershed was divided into 27 subbasins. After which, the SLURP model was used to calculate land use runoff and to estimate loads of dissolved nitrogen and phosphorus, and ECM was applied to estimate dissolved loads from livestock and rural domestic sewage. Next, the RUSLE was employed for load estimation of adsorbed nitrogen and phosphorus. The results showed that the 12,029.06 t?a^?1 pollution loads of total NPS nitrogen (TN) mainly originated from dissolved nitrogen (96.24 %). The major sources of TN were land use runoff, which accounted for 45.97 % of the total, followed by livestock (32.43 %) and rural domestic sewage (17.83 %). For total NPS phosphorous (TP), its pollution loads were 570.82 t?a^?1 and made up of dissolved and adsorbed phosphorous with 66.29 and 33.71 % respectively. Soil erosion, land use runoff, rural domestic sewage, and livestock were the main sources of phosphorus with contribution ratios of 33.71, 45.73, 14.32, and 6.24 % respectively. Therefore, land use runoff, livestock, and soil erosion were identified as the main pollution sources to influence loads of NPS nitrogen and phosphorus in the Jinjiang River and should be controlled first. The method developed here provided a helpful guideline for conducting NPS pollution management in similar watershed.     

半导体行业挥发性有机物(VOCs)排放特征研究

采用工艺调查与现场监测相结合的方法,研究了半导体行业废气排放中VOCs的种类和排放水平.结果表明,共检测出26种有机物,其中以异丙醇排放量最大.采用排放系数法估算了该行业VOCs2004年的排放量和2010年的预期排放量,并提出了加强和完善排放标准控制以及清洁生产等控制措施的建议.     

Effects of environmental factors on the production and release of matrix-bound phosphine from lake sediments

Effects of pH, temperature, and oxygen on the production and release of phosphine in eutrophic lake sediments were investigated under laboratory tests. Results indicated that the elimination of matrix-bound phosphine was accelerated under initial pH 1 or 12. Phosphine levels could reach maximum under initial pH 10. The contents of phosphine increased with the addition of alkali under pH 4–12. The rates of phosphine production and release from lake sediments varied with temperature. 20°C was the most favorable temperature for the production of matrix-bound phosphine. Oxygen showed little effect on matrix-bound phosphine. Matrix-bound phosphine concentrations in lake sediments were concluded to be dependent on a balance of natural generation and depletion processes. Translated from Acta Scientise Circumstantiae, 2005, 25(5): 681–685 [译自: 环境科学学报]     

模拟医疗废物在管式电阻炉上的热解特性研究

在管式电阻炉上对由聚丙烯、面巾纸、纱布、医用脱脂棉、一次性口罩、医用乳胶手套等按一定比例组成的模拟医疗废物在氮气气氛进行了热解研究。重点探讨了10K／min，20K／min，30K／min和40K／min等不同升温速率对热解产物分布、产气特性和热解过程的影响。结果表明，随着温度升高，模拟废物的热解产生气体的主要成分逐渐由CO2和CO转变为C3H6、CH4、C2H6、C2H4和C3H8。同时，热解处理对模拟废物的减量化效果比较明显，固体残留率仅为5．61％～7．02％。而且，加热速率对模拟医疗废物热解过程的影响较大。     

铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

内电解组合工艺处理重度富营养化水体的初步中试试验

采用催化铁内电解-沸石床-生物活性炭组合工艺进行了处理重度富营养化水的中试试验.通过对进水与出水浊度、TP、CODMn、UV254、总铁、NH3-N、和NO2--N的监测,研究了本组合工艺对重度富营养化水体的处理性能.试验期间,水温约在10℃.初步结果表明,本组合工艺对浊度、TP、CODMn和UV254均有较好的去除作用,平均去除率达到50%以上,出水中铁含量均低于进水.由于水温过低,未观察到氨氮和亚硝酸盐氮的明显变化.     

兰州市城市生活垃圾处理研究

城市生活垃圾是指在城市日常生活中或者为城市日常生活提供服务的活动中产生的固体废物以及法律、行政规定视为城市生活垃圾的固体废弃物.随着中国城市化进程的加快和人民生活水平的提高,城市生活垃圾也在以每年8%～10%的速度增长,若垃圾问题得不到妥善解决,就会制约兰州市的发展.在对兰州市城市生活垃圾处理现状及存在问题分析的基础上,根据兰州市生活垃圾的特性,提出兰州市城市生活垃圾的处理办法:兰州市城市生活垃圾应当推行分类收集制度,由目前单一的卫生填埋处理走向资源化综合处理.     

电厂噪声的监测与防治

噪声是环境污染的一个重要方面,它危害人体健康.电厂噪声也不容忽视,本文将对电厂噪声的监测和防治作一简要说明.根据规定,火电厂环境监测的监测项目为厂区、生活区环境噪声,在接近发电负荷时每年监测一次.监测时,在电厂总平面图上,将厂区生活区划分为等距离的网格.监测噪声的基本仪器是声级计.电厂噪声的防治措施有:在设计中充分考虑噪声的控制问题;加装消声设备;集中控制关键设备及位置的噪声;选择优质吸音与隔音材料;合理布置并增大绿化面积等.     

过氧化氢催化氧化难降解废水的研究

文章以过氧化氢为氧化剂,以γ-Al2O3为载体采用浸渍法制得不同金属含量的九种催化剂进行催化氧化实验,并优选出以5.0%Co、2.5?(质量百分含量)催化剂CODcr去除率较好,并确定此催化剂在常温常压下,反应时间为30 min,pH=6,氧化剂用量为30g/L时,CODcr的去除率最高为83%,这样不仅提高了BOD5/CODcr值,而且有利于后续生化处理,减轻后续处理装置负荷.     

我校建立灾害经济学学科的重要性

本文回顾了灾害经济学的发展历程,分析了灾害经济学的理论框架及与其他学科的关系,从经济学的角度阐述了建立这一学科的必要性,并探讨了建立这一学科的基础条件.全文从经济学的角度阐述了建立这一学科的必要性.并探讨了建立这一学科所要研究的理论知识.