Ultrafine particle fluxes above four major European cities

Little information is known about the behaviour of ultrafine particles (UFP) on a citywide scale. Total particle number flux, dominated by UFP, and other meteorological parameters were collected from tower sites in Manchester, London, Edinburgh and Gothenburg between 1999 and 2006 using the eddy covariance technique. Averaged diurnal cycles were produced for particle number flux, concentration, sensible heat flux, emission velocity, friction velocity, wind speed and temperature. UFP flux cycles showed clear diurnal trends which were linked to traffic activity and local sources. Wind sector analysis showed contributions to flux from local heavily urbanised areas. A simple parameterised model linking UFP flux to traffic activity, sensible heat and friction velocity above the city was produced.     

Wood burning impact on PM10 in three Austrian regions

Anhydrosugars (levoglucosan, mannosan and galactosan) were investigated during one year in three Austrian regions at three types of sites (city-heavy traffic-impacted, city-residential and background) in order to assess the magnitude of the contribution of wood smoke to the particulate matter load and its organic fraction. The annually averaged concentrations of levoglucosan ranged from 0.12 to 0.48 μg m^?3. The levoglucosan concentration exhibited a strong annual cycle with higher concentrations in the cold season. The minor anhydrosugars had a similar annual trend, but their concentrations were lower by a factor of about 5 and about 25 in the cold season for mannosan and galactosan, respectively. Levoglucosan concentrations were higher at the inner-urban as compared to rural sites. The contribution of wood smoke to organic carbon and PM₁₀ levels was calculated using a constant ratio of levoglucosan and OC, respectively PM₁₀ as derived for fire wood typical for Alpine European regions [Schmidl, C., Marr, I.L., Caseiro, A.e, Kotianová, P., Berner, A., Bauer, H., Kasper-Giebl, A., Puxbaum, H., 2008a. Chemical characterisation of fine particle emissions from wood stove combustion of common woods growing in mid-European Alpine regions. Atmospheric Environment 42, 126–141]. The estimated contribution of wood smoke-OC to the OC of PM₁₀ ranged from one third to more than half in the cold season with higher contributions up to 70% in winter (December, January and February) in the smaller cities and the rural background. This indicates, that wood smoke is the predominant source of organic material at rural and small urban sites in central Europe. Consistently, wood smoke was an important contributor to PM₁₀ during the cold season, with contributions of around 10% in the Vienna larger region and around 20% at rural sites in the densely forested regions of Salzburg and Styria during the winter months. In those regions residential sites exhibited highest relative wood smoke contents in PM₁₀ during autumn (September till November), indicating the use of wood stoves for auxiliary heating in the transition of warm to cold season. Using the relationships between the different anhydrosugars the combustion of softwood was found to be dominant for the wood smoke occurrence in ambient air at the investigated sites. Potassium, a commonly used tracer for biomass burning, correlated well to levoglucosan, with a mass ratio of around 0.80 in the cold season.     

Investigating the chemical nature of humic-like substances (HULIS) in North American atmospheric aerosols by liquid chromatography tandem mass spectrometry

The high-molecular weight water-soluble organic compounds present in atmospheric aerosols underwent functional-group characterization using liquid chromatography tandem mass spectrometry (LC-MS/MS), with a focus on understanding the chemical structure and origins of humic-like substances (HULIS) in the atmosphere. Aerosol samples were obtained from several locations in North America at times when primary sources contributing to organic aerosol were well-characterized: Riverside, CA, Fresno, CA, urban and peripheral Mexico City, Atlanta, GA, and Bondville, IL. Chemical analysis targeted identification and quantification of functional groups, such as aliphatic, aromatic, and bulk carboxylic acids, organosulfates, and carbohydrate-like substances that comprise species with molecular weights (MW) 200–600 amu. Measured high-MW functional groups were compared to modeled primary sources with the purpose of identifying associations between aerosol sources, high-MW aerosol species, and HULIS. Mobile source emissions were linked to high-molecular weight carboxylic acids, especially aromatic acids, biomass burning was associated with carboxylic acids and carbohydrate-like substances, and secondary organic aerosol (SOA) correlated well with the total amount of HULIS measured, whereas organosulfates showed no correlation with aerosol sources and exhibited unique spatial trends. These results suggested the importance of motor vehicles, biomass burning, and SOA as important sources of precursors to HULIS. Structural characteristics of atmospheric HULIS were compared to terrestrial humic and fulvic acids and revealed striking similarities in chemical structure, with the exception of organosulfates which were unique to atmospheric HULIS.     

Human Dimensions of Forest Disturbance by Insects: An International Synthesis

Ecological disturbances of forests by insects have a complex array of associated human dimensions presenting complications for natural resource decision making and relationships between stakeholders and managers. This article discusses the human context of forest disturbances by insects by reviewing four cases of bark beetle forest disturbance from British Columbia in Canada, Bavarian Forest National Park in Germany, the Kenai Peninsula in Alaska, and the north central region of Colorado. Findings and lessons learned from these studies are outlined along with their implications for managing forest disturbances by insects in general. Conclusions focus on the need to assess the broad array of impacts and risks perceived by local residents and the capacity for local action and involvement in managing forest disturbances. Communication and interaction between resource managers and local stakeholders can facilitate the identification of management priorities and potentially reduce some of the risks associated with forest disturbances by insects.     

Degassing of H/He, CFCs and SF6 by denitrification: Measurements and two-phase transport simulations

The production of N₂ gas by denitrification may lead to the appearance of a gas phase below the water table prohibiting the conservative transport of tracer gases required for groundwater dating. We used a two-phase flow and transport model (STOMP) to study the reliability of ³H/³He, CFCs and SF₆ as groundwater age tracers under agricultural land where denitrification causes degassing. We were able to reproduce the amount of degassing (R² = 69%), as well as the ³H (R² = 79%) and ³He (R² = 76%) concentrations observed in a ³H/³He data set using simple 2D models. We found that the TDG correction of the ³H/³He age overestimated the control ³He/³He age by 2.1 years, due to the accumulation of ³He in the gas phase. The total uncertainty of degassed ³H/³He ages of 6 years (± 2 σ) is due to the correction of degassed ³He using the TDG method, but also due to the travel time in the unsaturated zone and the diffusion of bomb peak ³He. CFCs appear to be subject to significant degradation in anoxic groundwater and SF₆ is highly susceptible to degassing. We conclude that ³H/³He is the most reliable method to date degassed groundwater and that two-phase flow models such as STOMP are useful tools to assist in the interpretation of degassed groundwater age tracer data.     

Limitations of an optimum sustainable population or potential biological removal approach for conserving marine mammals: Pacific walrus case study

Decision rules are the agreed-upon points at which specific management interventions are initiated. For marine mammal management under the U.S. Marine Mammal Protection Act (MMPA), decision rules are usually based on either a numeric population or biological-removal approach. However, for walrus and other ice-associated pinnipeds, the inability to reliably assess population numbers or biological removals highlights a significant gap in the MMPA, particularly when the Arctic environment is rapidly changing. We describe the MMPA's ecosystem-based management goals, and why managers have bypassed these goals in favor of an approach that depends upon numerical population assessment. We then revisit the statute's primary goals in light of current knowledge about the Pacific walrus ecosystem and new developments in environmental governance. We argue that to monitor and respond to changes in the walrus ecosystem, decision rules should be based on scientific criteria that depend less on the currently-impractical goal of accurately enumerating population size and trends, or removals from that population. Rather, managers should base decisions on ecological needs and observed ecological changes. To implement this approach would require an amendment to the MMPA that supports filling the gap in management with achievable decision rules. Alternatively, walrus and other ice-associated pinnipeds will remain largely unmanaged during a period of profound environmental change.     

One laptop per child,local refurbishment or overseas donations? Sustainability assessment of computer supply scenarios for schools in Colombia

With the intention of bridging the ‘digital divide’ many programmes have been launched to provide computers for educational institutions, ranging from refurbishing second hand computers to delivering low cost new computers. The fast and economical provision of large quantities of equipment is one of the many challenges faced by such programmes. If an increase is to be achieved in the sustainability of computer supplies for schools, not only must equipment be provided, but also suitable training and maintenance delivered. Furthermore, appropriate recycling has to be ensured, so that end-of-life equipment can be dealt with properly. This study has evaluated the suitability of three computer supply scenarios to schools in Colombia: (i) ‘Colombian refurbishment’, -refurbishment of computers donated in Colombia, (ii) ‘Overseas refurbishment’, -import of computers which were donated and refurbished abroad, and (iii) ‘XO Laptop’, -purchase of low cost computers manufactured in Korea. The methods applied were: Material Flow Assessment, -to assess the quantities-, Life Cycle Assessment, -to assess the environmental impacts, and the application of the Multiple Attribute Utility Theory, -to analyse, evaluate and compare different scenarios. The most sustainable solution proved to be the local refurbishment of second hand computers of Colombian origin to an appropriate technical standard. The environmental impacts of such practices need to be evaluated carefully, as second hand appliances have to be maintained, require spare parts and sometimes use more energy than newer equipment. Providing schools with second hand computers from overseas and through programmes such as ‘One Laptop Per Child’ has the disadvantage that the potential for social improvements – such as creation of jobs and local industry involvement – is very low.     

Measurement of charge transfer during filling and emptying FIBC

Filling and emptying normal FIBC (flexible intermediate bulk containers) in hazardous areas represents a high electrostatic ignition hazard. Manufacturers of FIBC have therefore designed different measures to reduce the ignition risks from static electricity. Depending on the measures applied FIBC are categorized into types A, B, C and D. End of 2005 a new international standard for testing type D FIBC has been published. Type D FIBC have now to be certified according to this standard. Since this standard requires comprehensive ignition testing on a test rig especially designed for this purpose, industry is looking for a simpler test method, which can be used for the development of new FIBC fabric and in production quality control. In the present paper it is attempted to apply the method of charge transfer measurement to assess the ignition probability of static discharged from FIBC during filling and emptying and to correlate the results with the ignition tests performed on the standard test rig.