Concentrations,spatial distribution,and pollution assessment of heavy metals in surficial sediments from upstream of Yellow River,China

Surface sediments were collected from 122 sites in the upstream of the Yellow River, China. The concentration of Fe, Mn, Cu, Ni, Zn, Cr, Pb, and Cd in sediments was investigated to explore the spatial distribution based on statistics and interpolation method. The results suggested that the concentrations of heavy metals were lower than potential effect levels (PEL). The samples above threshold effect level (TEL) for Pb and Zn were less than 10%, while almost 50% of samples for Ni exceeded PEL. Pb and Zn in sediments performed little or no adverse effects on the aquatic ecosystems. Higher concentrations of all heavy metals occurred in Qinghai and Gansu sections; the concentrations of Cu, Ni, and Zn were significantly higher than the Inner Mongolia section. Lower concentration of Fe, Mn, Cu, Ni, and Zn appeared in Qinghai section; the concentrations of Fe, Mn, Cr, and Pb manifested relatively steady and similar distributions and approximately decreasing tendency along the upstream of Yellow River.

     

Light absorption enhancement of particulate matters and their source apportionment over the Asian continental outflow site and South Yellow Sea

Environmental Science and Pollution Research - Light absorption enhancement of black carbon due to the aerosol mixing states is an important parameterization for climate modeling, while emission...     

Metal distribution characteristic of MSWI bottom ash in view of metal recovery

Bottom ash is the major by-product of municipal solid waste incineration(MSWI), and is often reused as an engineering material, such as road-base aggregate. However, some metals(especially aluminum) in bottom ash can react with water and generate gas that could cause expansion and failure of products containing the ash; these metals must be removed before the ash is utilized. The size distribution and the chemical speciation of metals in the bottom ash from two Chinese MSWI plants were examined in this study, and the recovery potential of metals from the ash was evaluated. The metal concentrations in these bottom ashes were lower than that generated in other developed countries. Specifically, the contents of Al,Fe, Cu and Zn were 18.9–29.2, 25.5–32.3, 0.7–1.0 and 1.6–2.5 g/kg, respectively. Moreover,44.9–57.0 wt.% of Al and 55.6–75.4 wt.% of Fe were distributed in bottom ash particles smaller than 5 mm. Similarly, 46.6–79.7 wt.% of Cu and 42.9–74.2 wt.% of Zn were concentrated in particles smaller than 3 mm. The Fe in the bottom ash mainly existed as hematite, and its chemical speciation was considered to limit the recovery efficiency of magnetic separation.     

Quantum chemical investigation on photodegradation mechanisms of sulfamethoxypyridazine with dissolved inorganic matter and hydroxyl radical

Sulfamethoxypyridazine(SMP) is one of the commonly used sulfonamide antibiotics(SAs).SAs are mainly studied to undergo triplet-sensitized photodegradation in water under natural sunlight with other coexisting aquatic environmental organic pollutants.In this work,SMP was selected as a representative of SAs.We studied the mechanisms of triplet-sensitized photodegradation of SMP and the influence of selected dissolved inorganic matter,i.e.,anions(Br~-,Cl~-,and NO~-_3) and cations ions(Ca~(2+),Mg~(2+),and Zn~(2+)) on SMP photodegradation mechanism by quantum chemical methods.In addition,the degradation mechanisms of SMP by hydroxyl radical(OH·) were also investigated.The creation of SO_2 extrusion product was accessed with two different energy pathways(pathway-1 and pathway-2) by following two steps(step-I and step-II) in the tripletsensitized photodegradation of SMP.Due to low activation energy,the pathway-1 was considered as the main pathway to obtain SO_2 extrusion product.Step-II of pathway-1 was measured to be the rate-limiting step(RLS) of SMP photodegradation mechanism and the effect of the selected anions and cations was estimated for this step.All selected anions and cations promoted photodegradation of SMP by dropping the activation energy of pathway-1.The estimated low activation energies of different degradation pathways of SMP with OH·radical indicate that OH·radical is a very powerful oxidizing agent for SMP degradation via attack through benzene derivative and pyridazine derivative ring.     

基于环境因子和邻近信息的土壤属性空间分布预测

为探索乡镇尺度上土壤属性空间分布预测的最佳方法,以江西省万年县齐埠镇为例,借助四方位搜索法、地统计学和遥感影像分析技术提取环境因子（地形因子和植被覆盖指数）和邻近信息[w（有机质）与w（速效钾）],构建OK法（普通克里金法）、RK1法（仅基于环境因子的回归克里金法）以及RK2法（基于环境因子和邻近信息的回归克里金法）对齐埠镇耕地表层（0~20 cm）土壤w（有机质）、w（速效钾）空间分布进行预测.结果表明:齐埠镇土壤w（有机质）平均值为35.03 g/kg,w（速效钾）平均值为96.73 mg/kg,均为中等空间变异性.对62个样点进行建模,16个测试样点进行独立验证的误差分析表明,RK2法对土壤w（有机质）、w（速效钾）预测结果的均方根误差、平均绝对误差和平均相对误差较OK法分别降低了18.05%、18.01%、21.77%和7.25%、9.49%、9.84%;较RK1法分别降低了22.48%、20.91%、22.02%和9.27%、12.61%、13.52%.研究显示,RK2法明显提高了土壤w（有机质）、w（速效钾）空间分布模拟精度,并且存在改进和提高的空间.      

不同主体功能定位的县域空间功能区划研究

文章通过判别分析法,尝试构建一套针对不同主体功能定位县通用的指标体系,以反映社会经济发展状况、生态环境保护重要性、国土空间开发支撑条件。通过在广西10个不同主体功能定位县的实践应用,将县域空间划分为城镇空间、农业空间和生态空间,重点开发区、农产品主产区、重点生态功能区的城镇空间分别小于30%、20%和10%,农产品主产区的农业空间和重点生态功能区的生态空间均大于50%。研究成果为全省范围推广县域空间功能区划提供了科学依据。     

危险废物焚烧厂环境污染控制与风险管理水平评价指标体系研究与应用

采用德尔菲法、层次分析法和五分制综合评分法,构建了危险废物焚烧厂环境污染控制与风险管理水平评价指标体系。从选址、技术和管理的角度,制定了31个评价指标,并归纳为8个准则层指标群,通过计算权重和对评价指标的赋分,实现对危险废物焚烧厂环境污染控制与风险管理水平的量化评价。应用结果表明:华南某市两家危险废物焚烧厂的环境污染控制与风险管理水平分值分别为3.34和4.38,分别处于良好和先进的水平。     

煤制烯烃废水处理与回用技术解析

针对煤制烯烃项目废水的来源及水质特点,从生化处理技术与回用处理技术方面阐述了煤制烯烃废水处理现状及存在问题,展望了煤制烯烃废水处理与回用技术未来发展方向,指出了新型脱氮工艺、膜集成工艺及分质结晶技术在煤制烯烃废水处理中的可行性,为煤化工废水处理与资源化利用提供理论参考。     

利用餐厨垃圾湿热处理脱出液制备液态菌肥研究

以餐厨垃圾湿热处理脱出液为发酵培养基,选用圆褐固氮菌(Azotobacter chroococcum)作为实验菌种制作固氮液态菌肥。测定了圆褐固氮菌的主要生理特性,将其接种于餐厨湿热处理脱出液中进行培养,确定最佳发酵时间,并分别测定发酵的最佳初始p H值、接种量、培养温度、摇床转速、装液量、脱出液与水的混合比例。结果表明:圆褐固氮菌在餐厨湿热处理脱出液中最佳发酵时间为36 h,发酵最佳初始p H值、接种量、培养温度、摇床转速、装液量、脱出液与水的混合比例依次为7.5、1%、30℃、150 r/min、50 m L(250 m L锥形瓶)、1∶1。圆褐固氮菌在餐厨垃圾湿热处理脱出液中进行培养后,可达到液态菌肥的活菌数标准。     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.