Preservative leaching from weathered CCA-treated wood

Disposal of discarded chromated copper arsenate (CCA)-treated wood in landfills raises concerns with respect to leaching of preservative compounds. When unweathered CCA-treated wood is leached using the toxicity characteristic leaching procedure (TCLP), arsenic concentrations exceed the toxicity characteristic (TC) limit of 5mg/L in most cases. The majority of discarded CCA-treated wood, however, results from demolition activities, where the wood has typically been subjected to weathering. Since preservatives do migrate from the wood during its normal use, leaching characteristics of weathered and aged CCA-treated wood may differ from unweathered wood. To evaluate this, CCA-treated wood removed from service after various degrees of weathering was collected from multiple sources and leached with the TCLP, the synthetic precipitation leaching procedure (SPLP) and California's waste extraction test (WET). Five to seven individual pieces of wood were analyzed from each source. The average TCLP arsenic concentration for the 14 sources ranged from 3.2 to 13 mg/L. The average TCLP concentrations of the 100 wood pieces tested were 6.4, 5.9 and 3.2 mg/L for arsenic, copper and chromium, respectively. Overall, in 60 out of 100 samples tested by the TCLP, arsenic concentrations exceeded 5 mg/L (the TC regulatory value). SPLP leachate concentrations were similar to TCLP concentrations, although copper leached somewhat more with the TCLP. WET leachate concentrations were approximately a factor of 10 higher than TCLP concentrations. Discarded CCA-treated wood, even after exposure to years of weathering, often exceeds the TC limit for arsenic and without the current regulatory exemption would possibly require management as a TC hazardous waste in the US.     

Contribution of arbuscular mycorrhiza to soil quality in contrasting cropping systems

The aim of this study was to determine how the potential to rely on arbuscular mycorrhiza (AM) for plant nutrition differs between a conventional and a low-input cropping system in the long term. The roles of fertilisation rate, composting of recycled plant residues and stage of the rotations in the overall impact of the cropping systems on soil quality and AM were also identified. The conventional cropping system with a non-leguminous crop rotation (barley–barley–rye–oat–potato–oat) was fertilised at either full or half the recommended rate. In the low-input cropping system, one year with barley was replaced by clover, and oat was cultivated mixed with pea. Straw and clover were returned to the soil either with or without composting. In the low-input system, biotite and rock phosphate were used to compensate for K and P in the harvested yield, while animal manure was applied at the start only. After 15 years, crop growth and nutrition, AMF colonisation and soil quality were assessed in the field, while the AM contribution to growth and nutrient uptake were determined in a bioassay in a growth chamber. AM functioning made a higher contribution to soil quality in terms of crop performance and environmental benefits in the low-input cropping system than at either fertilisation rate in the conventional system. Halving fertilisation in the conventional system prevented some costs and enhanced some of the benefits of AM in comparison with full fertilisation. However, only the low-input system with composting conclusively favoured AM in comparison with the conventional system. It resulted in the highest percentage colonisation and, in a bioassay with flax and clover, gave a relative average contribution to growth of 27% and to P uptake of 68% in comparison with 4 and 36%, respectively, for the conventional cropping system with full fertilisation. Rye yield was in the low-input system without composting similar to that in the conventional system with full fertilisation, and with composting 87% of the latter one. Incorporation of clover green manure without composting inhibited AM functioning, leading to a temporary loss of AM contribution to crop performance. This effect draws attention to the impact of the form of recycled organic matter on supporting ecosystem services such as nutrient cycling.     

Embryogenesis of decapod crustaceans with different life history traits,feeding ecologies and habitats: a fatty acid approach

Variations in embryo size and fatty acid (FA) dynamics during embryogenesis were evaluated in deep-sea pandalids and portunid swimming crabs from the Portuguese continental margin and Madeira Island slope and compared with previous data on neritic and deep-sea lobsters and shrimps (collected between February 2001 and March 2004). Inter-specific variations in embryo size seem to be dictated primarily by phylogeny rather than by differences in reproductive or early life history traits. FA reserves were significantly correlated with embryo size (P < 0.001). Principal component analysis revealed differences among three groups (1—neritic caridean shrimps, 2—deep-sea pandalids of the genus Plesionika, and lobsters, 3—portunid crabs and the deep-sea pandalid Chlorotocus crassicornis, Costa 1871). Group 1 was clearly separated by PC1 mainly due to the higher percentage of essential C₁₈ (linoleic and linolenic acids) and C₂₀ (namely eicosapentaenoic) polyunsaturated FA (specific markers of primary producers). PC2 separated Group 2 from Group 3 due to differences in the percentage of several saturated FA (including odd-numbered FA—bacterial markers) and C₁₈ monounsaturated FA (namely 18:1n − 9, a general marker of carnivory). Therefore, these differences among groups seem to result from distinctions in diet and ecological niche. Intra-specific differences in FA composition between western and southern Plesionika martia martia (A. Milne-Edwards, 1883) populations may reflect higher water temperatures on the south sub-tropical coast. Lobster embryonic development was more demanding of lipid energy than that of the other decapod species, which may reflect an evolutionary trend in decapod taxa related to an increasing degree of lecithotrophy. However, a lower FA catabolism can be interpreted as an enhanced independence of the newly hatched larvae from external energy sources. Higher FA content at hatching and, as a consequence, a greater independence from the external environment should increase the chances of larval survival. Electronic supplementary material Supplementary material is available in the online version of this article at and is accessible for authorized users.     

Dynamics of the head of gravity currents

The present work experimentally investigates the dynamics of unsteady gravity currents produced by lock-release of a saline mixture into a fresh water tank. Seven different experimental runs were performed by varying the density of the saline mixture in the lock and the bed roughness. Experiments were conducted in a Perspex flume, of horizontal bed and rectangular cross section, and recorded with a CCD camera. An image analysis technique was applied to visualize and characterize the current allowing thus the understanding of its general dynamics and, more specifically, of the current head dynamics. The temporal evolution of both head length and mass shows repeated stretching and breaking cycles: during the stretching phase, the head length and mass grow until reaching a limit, then the head becomes unstable and breaks. In the instants of break, the head aspect ratio shows a limit of 0.2 and the mass of the head is of the order of the initial mass in the lock. The average period of the herein called breaking events is seen to increase with bed roughness and the spatial periodicity of these events is seen to be approximately constant between runs. The rate of growth of the mass at the head is taken as a measure to assess entrainment and it is observed to occur at all stages of the current development. Entrainment rate at the head decreases in time suggesting this as a phenomenon ruled by local buoyancy and the similarity between runs shows independence from the initial reduced gravity and bed roughness.     

Evaluating surrogates of genetic diversity for conservation planning

Protected-area systems should conserve intraspecific genetic diversity. Because genetic data require resources to obtain, several approaches have been proposed for generating plans for protected-area systems (prioritizations) when genetic data are not available. Yet such surrogate-based approaches remain poorly tested. We evaluated the effectiveness of potential surrogate-based approaches based on microsatellite genetic data collected across the Iberian Peninsula for 7 amphibian and 3 reptilian species. Long-term environmental suitability did not effectively represent sites containing high genetic diversity (allelic richness). Prioritizations based on long-term environmental suitability had similar performance to random prioritizations. Geographic distances and resistance distances based on contemporary environmental suitability were not always effective surrogates for identification of combinations of sites that contain individuals with different genetic compositions. Our results demonstrate that population genetic data based on commonly used neutral markers can inform prioritizations, and we could not find an adequate substitute. Conservation planners need to weigh the potential benefits of genetic data against their acquisition costs.     

Watershed integrated management: A decision-support model on Sete Cidades Lake (Azores)

The Sete Cidades Lake (437 ha) is located in a volcanic crater of São Miguel Island (Azores). The watershed is 1923 ha, and 25% of it is covered with water. Extreme logging and the use of fertilizers in the cattle grazing areas have caused sedimentation and eutrophication of the main water body (Carlson Trophic State Index TSI = 40–50 mesoeutrophy). To deal with the issue, a linear programming model was created to generate efficient land-use scenarios for different amounts of phosphorus release. The model was calibrated for the present situation and then simulated to obtain 29 scenarios. It allowed us to derive parameters for each scenario. Then a multiobjective program was used to derive an acceptable weight for each indicator. The dominant solutions were discovered and discussed with different stakeholders.     

Seals at sea: modelling seal distribution in the German bight based on aerial survey data

The Wadden Sea is an important habitat for harbour seals and grey seals. They regularly haul-out on sandbanks and islands along the coast. Comparably little is known about the time seals spend at sea and how they use the remainder of the North Sea. Yet, human activity in offshore waters is increasing and information on seal distribution in the North Sea is crucial for conservation and management. Aerial line transect surveys were conducted in the German bight from 2002 to 2007 to investigate the distribution and abundance of marine mammals. Distance sampling methodology was combined with density surface modelling for a spatially explicit analysis of seal distribution in the German North Sea. Depth and distance to coast were found to be relevant predictor variables for seal density. Density surface modelling allowed for a depiction of seal distribution in the study area as well as an abundance estimate. This is the first study to use aerial survey data to develop a density surface model (DSM) for a spatially explicit distribution estimate of seals at sea.

---

Geospatial analysis of vulnerable beach-foredune systems from decadal time series of lidar data

Time series of lidar data, acquired over the past decade along the North American East Coast, provide opportunities to gain new insights into 3D evolution of barrier islands and their beach and dune systems. GIS-based per grid cell statistics and map algebra was applied to time series of Digital Surface Models representing two sections of North Carolina barrier islands to quantify elevation change trends, map dynamic and stable locations, identify new and lost buildings, measure relative volume evolution in the beach and foredune systems and analyze shoreline dynamics. Results show a relatively small stable core in both study areas, with beaches and the ocean side of the dunes exhibiting systematic high rates of elevation loss while areas landward from the dunes increase slightly in elevation. Significant number of new homes have been built at locations with very small core surface elevation, and homes built within the shoreline dynamics band have already been lost. The raster-based methodology used in this study can be applied to perform similar analyses in other coastal areas where time series of lidar data are available.     

Suicides and other fatalities from train-person collisions on Swedish railroads: a descriptive epidemiologic analysis as a basis for systems-oriented prevention

PROBLEM: Suicide is a dominating, although hidden, safety problem on Swedish railroads. The aim of this paper is to describe the epidemiology of fatal train-person collisions as a basis for systems-oriented prevention. METHOD: Data on collision circumstances were collected from narrative reports at the Swedish National Rail Administration. RESULTS: The events were evenly distributed by months and weekdays, however, most suicides occur during the day while unintentional events usually occur at night. Most train-person collisions happened in densely populated areas, and 75% of the suicide victims were waiting on the track before the collision. Significance test between types of injury event (suicide, accident, or unknown intent) showed small or no differences. CONCLUSION: Traditional approaches to accident prevention by systems modification seem largely applicable to combat railroad suicide as well. IMPACT ON INDUSTRY: Our findings show promising preventive potentials.