The modelling of a hybrid combined cycle with pressurised fluidised bed combustion and CO2 capture

This study investigates the possibility of capturing CO₂ from flue gas under pressurised conditions, which could prove to be beneficial in comparison to working under atmospheric conditions. Simulations of two hybrid combined cycles with pressurised fluidised bed combustion and CO₂ capture are presented. CO₂ is captured from pressurised flue gas by means of chemical absorption after the boiler but before expansion. The results show a CO₂ capture penalty of approximately 8 percentage points (including 90% CO₂ capture rate and compression to 110 bar), which makes the efficiency for the best performing cycle 43.9%. It is 5.2 percentage points higher than the most probable alternative, i.e. using a natural gas fired combined cycle and a pulverised coal fired condensing plant separately with the same fuel split ratio. The largest part of the penalty is associated with the lower mass flow of flue gas after CO₂ capture, which leads to a decrease in work output in the expander and potential for feed water heating. The penalty caused by the regeneration of absorbent is quite low, since the high pressure permits the use of potassium carbonate, which requires less regeneration heat than for example the more commonly proposed monoethanolamine. Although the efficiencies of the cycles look promising it will be important to perform a cost estimate to be able to make a fair comparison with other systems. Such a cost estimate has not been done in this study. A significant drawback of these hybrid cycles in that respect is the complex nature of the systems that will have a negative effect on the economy.     

De-novo formation of dioxins and furans and the memory effect in waste incineration flue gases

The formation of dioxin (polychlorinated-rho-dibenzodioxins - PCDD) and furan (polychlorinated dibenzofurans - PCDF) in waste incineration flyash in relation to temperature has been investigated in a bench scale reactor. The PCDD/PCDF released into the exhaust gases of the reactor and trapped in a condensation and vapour phase adsorption system were also determined. The concentrations of PCDD/PCDF in the flyash were analysed in detail for all congeners and isomers including the mono-, di- and tri-PCDD/PCDF. De-novo synthesis of PCDD/PCDF was clearly seen in the flyash with large changes in concentrations of PCDD/PCDF with only small changes in temperature. Exhaust gas PCDD/PCDF were detected at all temperatures, with the maximum emission occurring at a flyash temperature of 350 degrees C, where the equivalent of over 42 times the total dioxin/furan concentration of the original flyash was lost to the vapour phase per unit mass of initial flyash. Although the desorbed species were mainly the lower mono- to tri-congener group of dioxins and furans, the desorbed dioxin/furans had a considerable toxic equivalent value.     

The effects of aeration rate on generated compost quality, using aerated static pile method

To determine the most appropriate composting process in an active municipal solid waste system, an experiment was carried out using a nested design method with three aeration rates. During each aeration rate, parameters such as temperature, pH, EC, carbon-to-nitrogen ratio, NO(3)-N, nitrogen, potassium and phosphorous were measured and the efficiency of different composting processes was evaluated. The result of this study showed that the lower and medium aeration rates had a significant impact on nitrogen, carbon-to-nitrogen ratio and temperature profile, while higher aeration rates led to higher EC values. Furthermore, the thermophilic phase lasted 13, 9 and 4 weeks for the aeration rates of 0.4, 0.6 and 0.9 L min(-1)kg(-1), respectively. Accordingly, it was concluded that starting at a rate of 0.6 L min(-1)kg(-1) during first 2 months (about 9 weeks) of the process and continuing at a rate of 0.4 L min(-1)kg(-1)until the end of composting process would result in lower energy consumption.     

Aging and compressibility of municipal solid wastes

The expansion of a municipal solid waste (MSW) landfill requires the ability to predict settlement behavior of the existing landfill. The practice of using a single compressibility value when performing a settlement analysis may lead to inaccurate predictions. This paper gives consideration to changes in the mechanical compressibility of MSW as a function of the fill age of MSW as well as the embedding depth of MSW. Borehole samples representative of various fill ages were obtained from five boreholes drilled to the bottom of the Qizhishan landfill in Suzhou, China. Thirty-one borehole samples were used to perform confined compression tests. Waste composition and volume-mass properties (i.e., unit weight, void ratio, and water content) were measured on all the samples. The test results showed that the compressible components of the MSW (i.e., organics, plastics, paper, wood and textiles) decreased with an increase in the fill age. The in situ void ratio of the MSW was shown to decrease with depth into the landfill. The compression index, Cc, was observed to decrease from 1.0 to 0.3 with depth into the landfill. Settlement analyses were performed on the existing landfill, demonstrating that the variation of MSW compressibility with fill age or depth should be taken into account in the settlement prediction.     

Natural Weathering Studies of Polypropylene

Polypropylene (PP) has achieved a dominating position and hence, their consumption increases thereby littering, which lead to environmental pollution. Photodegradation seems to be a better choice because of naturally available sunlight as energy source for degradation. The present work involves the study of the variation of degradation behavior of PP film during tropical summer and winter seasons. The photodegradation is followed by Fourier transform infrared (FTIR) spectroscopic technique. Various indices like hydroxyl, carbonyl, vinylidene, lactones, ester, carboxylic acid and crystallinity are calculated and these values increased after a brief induction period. The variation in the mechanical properties like tensile strength and elongation at break percentages are determined. The scanning electron microscopic (SEM) images of weathered PP showed surface cracks when carbonyl index value increases sharply and the mechanical properties show a sudden decrease. Attempted life time prediction using mathematical models showed that the carbonyl growth is more affected by ultraviolet (UV) and cumulative total solar radiation for PP weathered during summer. The loss in tensile strength of PP weathered during summer is more dependent on the average temperature and the UV portion of the total solar radiation whereas, intensity of UV radiation has profound effect on the tensile strength of PP weathered during winter.     

A Novel Method to Capture and Analyze Flow in a Gross Pollutant Trap Using Image-Based Vector Visualization

A novel method is developed to capture and analyze several experimental flow regimes through a gross pollutant trap (GPT) with fully and partially blocked screens. Typical flow conditions and screen blockages are based on findings from field investigations that show a high content of organic matter in urban areas. Fluid motion of neutral buoyant particles is tracked using a high-speed camera and particle image velocimetry (PIV) software. The recorded fluid motion is visualized through an image-based, line integral convolution (LIC) algorithm, generally suitable for large computational fluid dynamics (CFD) datasets. The LIC method, a dense representation of streamlines, is found to be superior to the point-based flow visualization (e.g., hedgehog or arrow plots) in highlighting main flow features that are important for understanding litter capture and retention in the GPT. Detailed comparisons are made between the flow regimes, and the results are compared with CFD data previously obtained for fully blocked screens. The LIC technique is a useful tool for identifying flow structures in the GPT and areas that are subjected to abnormalities difficult to detect by conventional methods. The novel method is found to be useful both in the laboratory and in the field, with little preparation and cost. The enhancements and pitfalls of the LIC technique along with the experimentally captured flow field are presented and discussed.     

Valuing lives equally in a benefit-coast analysis of safety projects: A method to reconcile theory and practice

A value of statistical life (VSL) is used in cost-benefit analysis (CBA) as a monetary measure of the benefits to people from small risk reductions that arise from safety projects. Despite its widespread use in a number of countries, the concept of a VSL remains controversial, not least because it implies acceptance of the underlying ethical assumptions of CBA together with the idea that ‘social welfare’ can be measured and aggregated in some manner. In addition, to comply with theory, variable VSLs for different groups within society would be advocated. However, without fail, empirically, it is the case that those countries that employ a willingness to pay based approach to cost-benefit analysis of a safety project appraisal tend to use a single value for that accident context that is independent of the per capita income level, or indeed other personal characteristics, of the sub-group in society to which the safety improvement will actually apply. This article presents a straightforward, but theoretically justified adaptation to the calculation of a VSL which allows empirical practice by policymakers i.e. the application of a “common” VSL for any particular hazard within a given society, to be compatible with a CBA decision making approach.     

Adaptation Scenarios of Agriculture in Poland to Future Climate Changes

This paper demonstrates the ability of Polish agriculture to adapt to predicted climate change according to GISS and GFDL scenarios. Both climate-change scenarios will significantly affect farming conditions in Poland through water deficit, shifts in planting and harvesting seasons, changes in crop yields and crop structure. Neither scenario seems to endanger the self-sufficiency of Poland as long as preventative measures are taken. Moreover, the realization of GISS creates the possibility of a surplus in production. It must be emphasized that regardless of the scenario, the adaptation of agriculture to an expected climate change cannot be handled by the farming community itself.     

A Framework for Comprehensive,Integrated, Watershed Monitoring in New York City

The International Life SciencesInstitute (ILSI) Risk Science Institute (RSI) convenedan expert panel of scientists to developrecommendations for a comprehensive monitoring programfor the Croton and Catskill/Delaware watersheds, whichprovide drinking water to New York City's residents. This effort was conducted as part of efforts topreserve and enhance the quality of New York City'sreservoir system through a watershed protectionprogram. The panel developed recommendations for astrategic framework on which to construct a monitoringprogram. As part of this activity, the paneldetermined whether existing monitoring activities weredeficient and, where activities were deficient, thepanel developed recommendations for additionalinformation that should be collected.The panel recommended the development and use of anintegrated approach to watershed monitoring, whichdraws on modeling, risk-based planning and analysis,statistical sampling and design, and basic compliancemonitoring. The approach should be designed toprovide an assessment of natural and anthropogenicsources of stress to the system as well as anassessment of water quality trends in response tostresses acting in concert, both over the long termand over the five-year New York City Memorandum ofAgreement (MOA) assessment time frame. It should alsoprovide an assessment of the human health andenvironmental risks posed by a variety of stressors,and the impact of management actions implemented toameliorate stressors.     

Using the polychaete Arenicola marina to determine toxicity and bioaccumulation of PAHS bound to sediments

Transportation system has contributed significantly to the development of human civilization; on the other hand it has an enormous impact on the ambient air quality in several ways. In this paper the air and noise pollution at selected sites along three sections of National Highway was monitored. Pakistan National Highway Authority has started a Highway Improvement program for rehabilitations and maintenance of National highways to improve the traffic flows, and would ultimately improve the air quality along highways. The ambient air quality and noise level was monitored at nine different locations along these sections of highways to quantify the air pollution. The duration of monitoring at individual location was 72 h. The most of the sampling points were near the urban or village population, schools or hospitals, in order to quantify the air pollution at most affected locations along these roads. A database consisting of information regarding the source of emission, local metrology and air quality may be created to assess the profile of air quality in the area.