三峡库区滑坡地带岩石特性的研究

针对三峡库区组成滑坡岩层的主要岩石——泥质岩、灰岩、砂岩,通过显微镜观察、X射线分析显微镜的定量分析及室内岩石力学强度试验,对各岩石的特性进行了分析。显微镜及X射线定量分析结果表明风化较弱的泥质岩基本上含有石英与钙质矿物,后者由于易溶于水而导致岩石的孔隙率增加。孔隙的一部分连接形成了裂缝, 从而使岩石的强度下降。各岩石的单轴压缩试验结果表明砂岩的强度最高,发生了风化的泥质砂岩的强度最低。在饱和状态下紫红色泥岩及风化了的泥质砂岩的单轴压缩强度降低最显著,比自然干燥状态下降低了大约50%, 推测是受粘土矿物含量的影响。所有岩石都表现出在峰值强度之前应力与应变几乎呈线性关系,而峰值强度之后应力急剧下降的脆性特征。这种在饱和状态下岩石强度大幅度下降与脆性特征表明在治理滑坡时需要采取十分周密及复杂的预防措施。     

Synthesis of Short-chain-length/Medium-chain-length Polyhydroxyalkanoate (PHA) Copolymers in Peroxisome of the Transgenic Arabidopsis Thaliana Harboring the PHA Synthase Gene from Pseudomonas sp. 61-3

In this paper, the photosynthetic production of short-chain-length/medium-chain-length polyhydroxyalkanoate (PHA) copolymers is reported. The wild-type and highly active doubly mutated PHA synthase 1 (S325T/Q481K, abbreviated ST/QK) genes from Pseudomonas sp. 61-3 were introduced into Arabidopsis thaliana. Peroxisome targeting signal 1 (PTS1) was used to target PHA synthases into the peroxisome to synthesize PHA from the intermediates of the β-oxidation pathway. The transgenic Arabidopsis produced PHA copolymers consisting of 40–57 mol% 3-hydroxybutyrate, 21–49 mol% 3-hydroxyvalerate, 8–18 mol% 3-hydroxyhexanoate, and 2–8 mol% 3-hydroxyoctanoate. The maximum PHA contents were 220μ g/g cell dry weight (cdw) in leaves, and 36μ g/g cdw in stems, respectively. The expression of the ST/QK mutated PHA synthase in leaves gene did not lead to significant difference in PHA content and monomer composition of PHAs, compared to the wild-type PHA synthase gene, suggesting that the supply of monomers may be a rate-determining step of PHA biosynthesis in the peroxisome. However, in stems, there were significant differences dependent on whether the wild-type or ST/QK mutated PHA synthase was expressed. These results suggest that tissue-specific monomer availability is important in determining the final mol% composition of PHA copolymers produced by the peroxisome in plants.     

无过氧化氢添加Fenton氧化法降解有机物的可行性研究

Fenton反应可以氧化分解有机物,在反应中的关键氧化剂羟基自由基(HO·)是通过亚铁离子与过氧化氢作用生成的,因此,传统的Fenton氧化必须由外部添加过氧化氢.研究了一种新的方法,即采用Nafion膜固定化亚铁离子,并通过光催化反应提供Fenton氧化所需的过氧化氢,使得Fenton反应在不添加过氧化氢的条件下也能够连续进行.结果表明,以甲酸为代表有机物,该方法可以在不添加过氧化氢的条件下起到分解甲酸的作用.而且,通过对负载亚铁离子Nafion膜的再生,可以使该方法的降解能力保持在稳定的范围.     

PCDD/PCDF formation in the chlor-alkali process—laboratory study and comparison with patterns from contaminated sites

Studies on the formation of polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) during the electrolysis of sodium chloride solution (brine) using graphite or titanium electrodes were carried out at a laboratory scale. High concentrations of PCDFs but no PCDDs were formed in tests using graphite electrodes. With titanium electrodes, PCDFs were only formed when tar pitch was added and mainly originated from the dibenzofuran present in the tar. For the first time, a detailed assessment of the formation of mono- to octachlorinated PCDD/PCDF from tar pitch was investigated. The assessment included of the chlorination steps proved that PCDFs were formed by successive lateral chlorinated from dibenzofuran to MonoCDFs, DiCDFs, and TriCDFs to form the typical known “chlorine pattern” of TetraCDF to OctaCDF with a dominance of 1,2,7,8- and 2,3,7,8-TetraCDFs, 1,2,3,7,8-PentaCDF, and 1,2,3,4,7,8-HexaCDF as marker congeners. The final homologue distributions depended on reaction time and reaction temperature. In addition, electrolysis with non-chlorinated dibenzo-p-dioxins, dibenzofuran, and biphenyl was carried out. As a result, PCDDs, PCDFs, and PCB were formed at comparable yields. Congener patterns in soil samples from a PCDD/F-contaminated site where chlor-alkali electrolysis had been operated for decades in Japan had identical isomer distribution demonstrating the source and contamination potential and risk of these processes. Therefore, sites where in the past 120 years chlor-alkali electrolysis has been operated or where residues from chlor-alkali production or other chlorine using industries have been disposed should be assessed for their pollution level and exposure relevance. The assessment of total organohalogen content revealed that PCDF is only a small fraction of organohalogens in the contaminated soils. For an appropriate risk assessment, also other chlorinated aromatic compounds such as PCBs or PCNs need to be considered.     

Destruction of polychlorinated naphthalenes by a high-temperature melting treatment (GeoMelt process)

A series of treatment experiments were carried out to evaluate the applicability of a high-temperature melting treatment (GeoMelt process) to the destruction of polychlorinated naphthalene (PCN) formulation. We started with 10-kg-scale experiments in which a small melting furnace was used and then scaled up to a 1-t-scale experiment in which a melting furnace that resembled an actual treatment system was used. These runs were evaluated whether destruction efficiency (DE) of total PCNs was more than 99.999 % and whether concentrations of PCNs and polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDDs/DFs) in vitrified materials, emission gas, and scrubber water were below the target levels. Because DE values and the target levels of PCNs and PCDDs/DFs in these runs were satisfactory, then we carried out a demonstrative experiment using the actual treatment system and confirmed destruction of PCNs. Based on good results of the demonstrative experiment, stock of PCN formulation was successfully treated continuously.     

Sustainability of silicon feedstock for a low-carbon society

We need to ensure the sustainable management of advanced materials, such as purified silicon, that contribute to a low-carbon society. Because a drastic increase in the demand for photovoltaic (PV) systems is tightening the supply of silicon for PV cells, the sustainability of silicon feedstock needs to be explored. For this purpose, a material flow analysis of silicon in Japan from 1996 to 2006 is presented in this paper. Our analysis finds that rapid growth in demand for polycrystalline silicon (pc-silicon) and single crystalline silicon (sc-silicon) has changed the structure of the purified silicon supply. The strong demand for purified silicon for solar cells is responsible for this change. While off-grade silicon obtained as a by-product of electronic-grade silicon (EG-Si) covered the demand for solar sells before 2000, pc-silicon is currently produced independently for solar cells via an energy-intensive process. Analysis of the resource effective-use index (REI), which indicates how effectively purified silicon is used, shows progress in the effective use of pc- and sc-silicon. REI analysis indicates that the effective use of pc-silicon is reaching a maximum, while the effective use of sc-silicon is advancing, with a corresponding increase in price. To ensure a sustainable supply of silicon feedstock, this paper proposes four solutions: (1) production of solar-grade pc-silicon by a less costly and less energy-consuming method; (2) reduction in the amount of crystalline silicon per watt in solar cells; (3) acceleration of the development and deployment of other solar cell types; and (4) reuse and recycling of solar cells in the future.     

Spectroscopic analysis of NIR-dye sensitization in bulk heterojunction polymer solar cells

The photovoltaic conversion efficiency for near-infrared (NIR) sunlight is improved successfully by dye sensitization of bulk heterojunction polymer solar cells, in which the active layer was prepared by a ternary blend of poly(3-hexylthiophene), a fullerene derivative (1-(3-methoxycarbonyl)propyl-1-phenyl-[6,6]-methanofullerene), and an NIR dye, silicon phthalocyanine bis(trihexylsilyl oxide). The mechanism of the NIR-dye sensitization is studied by femtosecond transient absorption spectroscopy.     

Spectroscopic Analysis of NIR-Dye Sensitization in Bulk Heterojunction Polymer Solar Cells

The photovoltaic conversion efficiency for near-infrared (NIR) sunlight is improved successfully by dye sensitization of bulk heterojunction polymer solar cells, in which the active layer was prepared by a ternary blend of poly(3-hexylthiophene), a fullerene derivative (1-(3-methoxycarbonyl)propyl-1-phenyl-[6,6]-methanofullerene), and an NIR dye, silicon phthalocyanine bis(trihexylsilyl oxide). The mechanism of the NIR-dye sensitization is studied by femtosecond transient absorption spectroscopy.     

Screening for potential effects of endocrine-disrupting chemicals in peri-urban creeks and rivers in Melbourne, Australia using mosquitofish and recombinant receptor–reporter gene assays

Sexually mature male mosquitofish (Gambusia holbrooki) were collected from various sites around Melbourne in 2009 to evaluate the performance of gonopodial indices as a biomarker for endocrine disruption in Melbourne's waterways. The mosquitofish indices assessed were body length (BL), gonopodial length (GL)/BL ratio, ray 4:6 ratio and the absence or presence of hooks and serrae, and these varied between sites. The study was complemented by measurements of estrogenic, retinoid, thyroid and aryl hydrocarbon (AhR) receptor activities of the water. Male mosquitofish were 16.3–21.5 mm in length, and although there was a statistically significant positive relationship showing that bigger fish had longer gonopodia than small fish (r2 = 0.52, p < 0.001), there were few significant differences in GL/BL ratio of fish between sites. Measured estrogenic activity was mostly in the range 0.1–1.7 ng/L EEQ, with one site having much higher levels (~12 ng/L EEQ). Aryl hydrocarbon (AhR) receptor activity was observed in all water samples (7–180 ng/L βNF EQ), although there was no consistent pattern in the level of AhR activity observed, i.e., ‘clean’ sites were as likely to return a high AhR activity response as urban or wastewater treatment plant (WWTP)-impacted sites. There was no correlation between measurements of receptor actvity and gonopodial length (GL):BL ratio and BL. We conclude that the mosquitofish gonopodia only fulfills part of the criteria for biomarker selection for screening. The mosquitofish indices assessed were cheap and easy-to-perform procedures; however, there is no baseline data from the selected sites to evaluate whether differences in the morpholical indices observed at a site were a result of natural selection in the population or due to estrogenic exposure.