Tree bark as a passive air sampler to indicate atmospheric polybrominated diphenyl ethers (PBDEs) in southeastern China

The different barks were sampled to discuss the influence of the tree species, trunk circumference, and bark thickness on the accumulation processes of polybrominated diphenyl ethers (PBDEs) from air into the bark. The results of different PBDE concentrations indicated that barks with a thickness of 0–3 mm collected from weeping willow, Camphor tree, and Masson pine, the trunk circumferences of which were 100 to 150 cm, were better PBDEs passive samplers. Furthermore, tree bark and the corresponding air samples were collected at Anji (AJ), Hangzhou (HZ), Shanghai (SH), and Wenling (WL) to investigate the relationship between the PBDE concentrations in bark and those in air. In addition, the significant correlation (r ²?=?0.906; P?<?0.05) indicated that atmospheric PBDEs were the principle source for the accumulation of PBDEs in the barks. In this study, the log K _BA (bark–air partition coefficient) of individual PBDE congeners at the four sites were in the range from 5.69 to 6.79. Finally, the total PBDE concentration in WL was 5 to 20 times higher than in the other three cities. The result indicated that crude household workshops contributed a heavy amount of PBDEs pollution to the environment, which had been verified by the spatial distribution of PBDEs levels in barks collected at Wenling (range, 26.53–1317.68 ng/g dw). The good correlation between the PBDE concentrations in the barks and the air samples and the variations of the PBDE concentrations in tree barks collected from different sites reflected that the bark could be used as a passive sampler to indicate the atmospheric PBDEs.     

Hazardous substances in indoor dust emitted from waste TV recycling facility

Various hazardous substances contained in waste TV sets might be released into environment via dust during recycling activities. Two brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), and tetrabromobisphenol A (TBBPA), and five kinds of heavy metals (Cu, Pb, Cd, Cr, and Ni) were detected in indoor dust collected from two workshops (TV dismantling workshop and subsequent recycling workshop). PBDEs concentrations in dust from waste wires recycling line (722,000 ng/g) were the highest among the studied sites, followed by those in manual dismantling–sorting line (117,000 ng/g), whereas TBBPA concentrations were the highest in manual dismantling–sorting line (557 ng/g) and printed circuit board (PCB) recycling line (428 ng/g). For heavy metals, Cu and Pb were the most enriched metals in all dust samples. The highest concentration of Pb (22,900 mg/kg) was found in TV dismantling workshop-floor dust. Meanwhile, Cu was the predominant metal in dust from the PCB recycling line, especially in dust collected from electrostatic separation area (42,700 mg/kg). Occupational exposure assessment results showed that workers were the most exposed to BDE-209 among the four PBDE congeners (BDE-47, BDE-99, BDE-153, and BDE-209) in both workshops. The hazard quotient (HQ) indicated that noncancerous effects were unlikely for both BFRs and heavy metals (HQ?<?1), and carcinogenic risks for Cd, Cr, and Ni (risk?<?10^?6) on workers in two workshops were relatively low.     

CuO / 过硫酸氢钾体系催化氧化苯酚简

本论文通过直接沉淀法制备了CuO催化剂,结合过硫酸氢钾,在常温常压下催化氧化处理苯酚模拟废水。采用电子显微镜（SEM）、X射线粉末衍射（XRD）对催化剂进行了表征,并研究了反应过程中各影响因素对降解效率的影响。实验结果表明,在催化剂用量为0.2 g/L,氧化剂浓度为0.25 g/L,pH值为7,反应时间为60 min的条件下,浓度为50 mg/L的苯酚降解率可达100%,TOC去除率达84%。进一步实验表明,催化剂具有良好的重复使用能力。最后,通过自由基捕捉实验,考察了体系中的自由基种类,并根据实验结果,讨论了CuO/过硫酸氢钾体系的催化降解机理。     

Stability of 6:2 fluorotelomer sulfonate in advanced oxidation processes: degradation kinetics and pathway

Perfluorooctane sulfonate (PFOS), a widely used mist suppressant in hard chrome electroplating industry, has been listed in the Stockholm Convention for global ban. 6:2 Fluorotelomer sulfonate (6:2 FTS) acid and salts have been adopted as alternative products in the market, but no data about their abiotic degradation has been reported. In the present study, the degradability of 6:2 FTS potassium salt (6:2 FTS-K) was evaluated under various advanced oxidation processes, including ultraviolet (UV) irradiation, UV with hydrogen peroxide (H₂O₂), alkaline ozonation (O₃, pH = 11), peroxone (O₃/H₂O₂), and Fenton reagent oxidation (Fe²⁺/H₂O₂). UV/H₂O₂ was found to be the most effective approach, where the degradation of 6:2 FTS-K followed the pseudo-first-order kinetics. The intermediates were mainly shorter chain perfluoroalkyl carboxylic acid (C₇ to C₂), while sulfate (SO₄ ^2?) and fluoride (F^?) were found to be the final products. The high yields of SO₄ ^2? and F^? indicate that 6:2 FTS-K can be nearly completely desulfonated and defluorinated under UV/H₂O₂ condition. The degradation should firstly begin with the substitution of hydrogen atom by hydroxyl radicals, followed by desulfonation, carboxylation, and sequential “flake off” of CF₂ unit. Compared with PFOS which is inert in most advanced oxidation processes, 6:2 FTS-K is more degradable as the alternative.     

厌氧系统中碱处理对污泥减量的影响

碱解预处理污泥和原污泥按一定比例进行混合后,投入厌氧反应器中进行消化,研究其对污泥减量化的影响。结果表明,该处理既可以提高污泥减量率,又能改善污泥厌氧消化性能,提高污泥产气量。当碱处理污泥和原污泥混合比为1∶3时,在混合初期由于稀释作用和水解中和作用,溶液的pH能迅速恢复到中性。SS减少48%,较对照组提高了10%;SCOD减少约80%,较对照组提高20%,而空白对照组因未发生溶胞作用,各参数值均处于较低水平,降解率也维持在较低水平。     

Spatio-temporal variations of nitrogen in an agricultural watershed in eastern China: catchment export, stream attenuation and discharge

Using the monthly hydrogeochemical data of ChangLe River system from 2004 to 2008, total nitrogen (TN) export load (S(n)) from nonpoint sources (NPS) to stream and in-stream attenuation load (A(L)) was estimated by the inverse and forward format of an existing in-stream nutrient transport equation, respectively. Estimated S(n) contributed 96 ± 2% of TN entering the river system, while A(L) reduced the input TN by 23 ± 14% in average. In-stream TN attenuation efficiency in high flow periods (10 ± 5% in average for the entire river system) was much lower than that in low flow periods (39 ± 17%). TN attenuation efficiency in tributaries (28 ± 16% in average) was much higher than that in mainstream (11 ± 8%). Hydrological conditions are important in determining the spatio-temporal distributions of NPS TN export, stream attenuation and discharge. Increasing the water residence time might be a practical method for mitigating stream TN.     

Composition analysis and application of degradation products of whole feathers through a large scale of fermentation

Purpose

Feathers are one of the most abundant bioresources. They are discarded as waste in most cases and could cause environmental pollution. On the other hand, keratin constituted by amino acids is the main component of feathers. In this article, we reported on biorefined feathers and integrants and application of degraded products.

Materials and methods

The fermentation of whole chicken feathers with Stenotrophomonas maltophilia DHHJ in a scale-up of a 5-L bioreactor was investigated in this article. The fermentation process was controlled at 0.08 MPa pressure, 2.5 L/min airflow, and 300 rpm as 100% oxygen saturation level, 40°C, and pH 7.8.

Results

Feathers were almost completely degraded in the tested fermentation reaction with the following conditions: 80 g of whole feathers in 3 L fermentation broth for 72 h, seed age of 16 h, 100 mL inoculation amount, and 50% oxygen saturation level. The degraded products contain 397.1 mg/L soluble protein that has mass weight ranging from 10 to 160 kD, 336.9 mg/L amino acids, and many kinds of metal ions. The fermentation broth was evaluated as leaf fertilizer and found to increase plant growth to 82% or 66% for two- or fourfold dilutions, respectively. In addition, in a hair care assay, the broth showed a hair protective function by increasing weight, flexibility, and strength of the treated hair.

Conclusions

The whole feathers were degraded completely by S. maltophilia DHHJ. The degraded product includes many factors to life, such as peptides, amino acids, and mineral elements. It could be applied as leaf fertilizer and hair care product.     

钛基IrO2-SnO2电极在烟气海水脱硫恢复系统中的应用

采用浸渍-热分解法制备了含IrOx-TiO2中间层的IrO2-SnO2电极,得到的电极具有较高的析氯电催化活性和较强的稳定性,并通过电化学氧化法对Na2SO3海水脱硫模拟液进行处理,考察了电流密度、温度、pH值和电解时间等电解工艺参数对Na2SO3去除率和化学需氧量COD的影响。结果表明,在电流密度为200 mA/cm^2,pH值为3.5,电解440 mg/L的Na2SO3海水脱硫模拟液,15 min时Na2SO3去除率可达96.5%,COD去除率可达82.6%。     

钛基IrO2-SnO2电极在烟气海水脱硫恢复系统中的应用

采用浸渍-热分解法制备了含IrOx-TiO2中间层的IrO2-SnO2电极,得到的电极具有较高的析氯电催化活性和较强的稳定性,并通过电化学氧化法对Na2SO3海水脱硫模拟液进行处理,考察了电流密度、温度、pH值和电解时间等电解工艺参数对Na2SO3去除率和化学需氧量COD的影响.结果表明,在电流密度为200 mA/cm...