基于自动监测网络的湘江流域衡阳段铊污染原因分析

运用自动监测网络与实验室验证相结合的手段,通过测定湘江流域衡阳段干流与支流铊浓度,分析铊浓度与溶解氧含量、氨氮浓度及叶绿素a浓度等水质指标的关系,进而对湘江流域衡阳段铊污染进行原因分析。结果表明,2021年8月上旬,湘江流域衡阳段干流铊污染的来源主要为多支流污染汇入。其中,松木下游断面铊污染极有可能来源于支流上游企业排放,江东水厂断面铊浓度异常的原因主要为溶解氧降低、死藻富集。该案例可为我国铊污染应急监测及污染原因分析提供借鉴。     

混凝法处理锰矿选矿废水的试验研究

选取聚合氯化铝（PAC）、聚合硫酸铁（PFS）、聚丙烯酰胺（PAM）和六水合氯化铁（FC）4种常用混凝剂,采用正交试验,以去浊率与去锰率作为综合评价指标,探讨了不同混凝剂处理锰矿选矿废水的效果及最佳混凝条件。结果表明：在以上混凝剂中,FC的混凝效果较差;PAM对锰矿选矿废水的处理效果最优,最佳的混凝条件为：处理500 ml的废水,投加1.5 ml的PAM,pH为7.0,搅拌后沉降20 min,废水经处理后去浊率与去锰率分别为96%、92%,其中废水的pH及投药量对混凝效果的影响较大。     

高效液相色谱-三重四级杆/复合线性离子阱质谱法测定饮用水中22种邻苯二甲酸酯

建立了一种同时测定饮用水中22种邻苯二甲酸酯(PAEs)的高效液相色谱-三重四级杆/复合线性离子阱质谱方法:饮用水样品经针头过滤器过滤,选用Biphenyl液相色谱柱进行分离,以含0.1%甲酸的水溶液和含0.1%甲酸的甲醇溶液为流动相,电离模式为电喷雾正离子,选用多反应监测触发增强子离子扫描模式进行检测。结果表明,22种PAEs的灵敏度良好,定量限为0.001～0.1 μg/L。配制浓度为0.1～100.0 μg/L的混标溶液进行进样分析,分析结果显示,22种PAEs在该范围内的线性关系良好,相关系数均大于0.995,方法的平均回收率为82.9%～108.9%,相对标准偏差为0.9%～11.2%。同时,使用增强子离子扫描谱图进行搜库匹配,定性准确性高。该方法适用于饮用水中PAEs的检测。     

低浓度硫化氢废气的液相催化氧化法净化实验研究

针对H2S浓度为750~1500mg/m3的气体的液相催化氧化技术进行了动力学实验研究。配制了以铁基离子作为主催化剂的复合吸收净化溶液,同时加入稳定剂和表面活性剂提高催化剂在碱性吸收溶液的活性。分别考察了原料气中H2S、O2含量以及吸收液中催化剂离子浓度、温度等因素对吸收速率的影响;确定了较为理想的吸收操作条件并获得了较好的吸收净化效果;饱和吸收液易于再生,净化性能恢复良好,可重复使用。     

一株好氧反硝化菌的筛选鉴定及固定化研究

从污水处理厂的活性污泥中筛选得到1株好氧反硝化细菌(YS),对其进行分子生物学鉴定和理化性能测试,并考察了该菌株固定化前后反硝化能力的变化.鉴定结果表明,菌株YS为反硝化产碱菌(Alcaligenes denitrificans).菌株经固定化后,其酶活力有所下降,但稳定性增强,在4 ℃下储存50 d后,固定态菌株对硝酸根的去除率仍可维持在80%以上,而游离态菌株仅为15%.在pH 7.0条件下,固定态菌株的反硝化率比游离态菌株低3%左右,但当pH降低至5.0时,固定态菌株对硝酸根的去除率为72.4%,比游离态菌株高2.6%,表明固定态菌株比游离态菌株更适应于弱酸的环境.在不同的工艺条件下,固定态菌株与游离态菌株反硝化能力的变化趋势相同.菌株YS的最适条件为:接种量1.5%左右,pH为6.0,C/N比为11,葡萄糖为碳源.     

Graphitic carbon nitride/biochar composite synthesized by a facile ball-milling method for the adsorption and photocatalytic degradation of enrofloxacin

In order to enhance the removal performance of graphitic carbon nitride (g-C₃N₄) on organic pollutant, a simultaneous process of adsorption and photocatalysis was achieved via the compounding of biochar and g-C₃N₄. In this study, g-C₃N₄ was obtained by a condensation reaction of melamine at 550°C. Then the g-C₃N₄/biochar composites were synthesized by ball milling biochar and g-C₃N₄ together, which was considered as a simple, economical, and green strategy. The characterization of resulting g-C₃N₄/biochar suggested that biochar and g-C₃N₄ achieved effective linkage. The adsorption and photocatalytic performance of the composites were evaluated with enrofloxacin (EFA) as a model pollutant. The result showed that all the g-C₃N₄/biochar composites displayed higher adsorption and photocatalytic performance to EFA than that of pure g-C₃N₄. The 50% g-C₃N₄/biochar performed best and removed 45.2% and 81.1% of EFA (10 mg/L) under darkness and light with a dosage of 1 mg/mL, while g-C₃N₄ were 19.0% and 27.3%, respectively. Besides, 50% g-C₃N₄/biochar showed the highest total organic carbon (TOC) removal efficiency (65.9%). Radical trapping experiments suggested that superoxide radical (?O₂^?) and hole (h⁺) were the main active species in the photocatalytic process. After 4 cycles, the composite still exhibited activity for catalytic removal of EFA.     

低温等离子体处理工业废气中甲苯的研究进展

甲苯作为挥发性有机化合物的代表,其治理技术已成为研究的热点。介绍了低温等离子体的概况及其处理甲苯的机理,重点概述了单独低温等离子体技术处理甲苯的放电形式、放电参数以及低温等离子体协同催化技术处理甲苯的工艺、催化剂种类和放电模式,并对低温等离子体技术处理工业废气中甲苯的发展方向进行了展望。低温等离子体技术处理工业废气中甲苯的处理效率高,但选择性较差,通过协同催化技术,可以进一步提高选择性,具有很好的应用前景。     

稀土对低浓度硫化氢液相催化氧化净化效率的影响

采用液相催化氧化法净化低浓度H2S,系统研究了反应温度、pH值及助催化剂--稀土(La、Ce)的加入量对吸收液净化效率和硫容量的影响.结果显示,在优化的实验条件下(原料气H2S浓度720～920mg·m-3、反应温度60℃、pH=9.0、Fe3+浓度0.05mol·L-1、吸收液体积50mL)添加表面恬性剂磺基水杨酸和稀土助催化剂后.吸收液具有较高的净化效率(98%以上)和较大的硫容量(4g·L-1以上).     

Preparation and characterization of surface modified powder of calcium hydroxide used as chlorine scavenger

In order to avoid existing shortcomings of chlorine leakage treatment, we developed a new chlorine scavenger. The main composition of the chlorine scavenger was calcium hydroxide. The chlorine scavenger was prepared by wet process with water as solvent through adding surface active agent and silicone oil, etc. The influence of surfactant on modified powder was investigated, which included the sodium dodecyl benzene sulfonate, the sodium stearate, the water-soluble silicone oil, the emulsifying silicon oil and the amino silicone oil, and the effect of modification of judgment were illustrated, which mainly involved the sifting rate, the bulk density, the contact angle, on this basis, also the author analyzed the powder of modification by using SEM analysis and size distribution, The modified powder had the following characteristics: high absorptivity, anti-caking, good air permeability and so on. The results showed that overall performance of modified powder was better than the performance of unmodified powder. The adding amount of sodium stearate was preferably 2% while the optimum amount of emulsifying silicon oil and amino silicone oil was 3%. The comprehensive performance of powder modified with compound modifiers was better than the performance of the powder modified with a single modifier. The property of powder modified with sodium stearate and amino silicone oil had a good performance analyzed from the uniformity of particle size distribution of the powder and anti-caking. The powder modified with sodium stearate and emulsifying silicon oil had a good absorption rate of chlorine.     

Co- or Ni-modified Sn-MnOx low-dimensional multi-oxides for high-efficient NH3-SCR De-NOx: Performance optimization and reaction mechanism

NH₃-SCR performances were explored to the relationship between structure morphology and physio-chemical properties over low-dimensional ternary Mn-based catalysts prepared by one-step synthesis method.Due to its strong oxidation performance,Sn-MnOx was prone to side reactions between NO,NH₃ and O₂,resulting in the generation of more NO₂ and N₂ O,here most of N₂ O was driven from the non-selective oxidation of NH₃,while ...