管式法高压聚乙烯装置的道化学火灾爆炸危险指数评价

运用道化学火灾爆炸危险指数评价方法,对Quantum管式法高压聚乙烯装置中多次出现泄漏火灾的聚合单元进行评价。对照装置实际分析了防火防爆缺陷因子,提出完善聚合单元的防火防爆措施。     

PAC-chitosan复合絮凝剂中铝形态

以不同碱化度(B)的聚合氯化铝(PAC)和不同粘度的壳聚糖为原料制备出一系列PAC-chitosan复合絮凝剂。采用Al-Ferron逐时络合比色法研究了PAC-chitosan复合絮凝剂中铝的形态分布,探讨了PAC的B值、壳聚糖的含量（C）和粘度（η）对复合絮凝剂中铝的形态分布的影响。结果表明：壳聚糖与PAC之间发生了一定的相互作用,通过试验结果推断出当B=1.5,壳聚糖粘度η=800 Pa·s,C=0.6 mg/mL絮凝效果最佳。并用某造纸废水进行了烧杯絮凝试验。絮凝试验结果与推断结果相一致。     

Biohydrogen production through fermentation using liquid swine manure as substrate

In this paper, continuous production of hydrogen through fermentation with liquid swine manure as substrate was researched using a semi-continuously fed fermenter (8 L in total volume and 4 L in working volume). The pH and temperature for the fermenter were controlled at 5.3 +/- 0.1 and 35 +/- 1 degrees C, respectively, throughout the experiment. Three hydraulic retention times (16, 20, and 24 h) were investigated for their impact on the efficiency and performance of the fermenter in terms of hydrogen yields. The results indicate that hydraulic retention time (HRT) has a strong influence on the fermenter performance. An increasing HRT would increase the variation in hydrogen concentration in the offgas. To produce hydrogen with a fairly consistent concentration, the HRT of the fermenter should not exceed 16 h, which, however, did not appear to be short enough to control methanogenesis because the offgas still contained about 5% methane. When methane content in the offgas exceeded 2%, an inverse linear relationship between hydrogen and methane was observed with a correlation coefficient of 0.9699. To increase hydrogen content in the offgas, methane production has to be limited to below 2%. Also, keeping oxygen content in the fermenter below 1.5% would increase the hydrogen concentration to over 15%. The product to substrate ratio was found to be around 50% for the fermenter system studied, evidenced by the observation that for every 6 liters of manure fermented, 3 liters of pure hydrogen were produced, which was significant and encouraging.     

Photoelectrocatalytic degradation of pentachlorophenol in aqueous solution using a TiO2 nanotube film electrode

Titanium dioxide (TiO2) nanotube film electrodes are fabricated by the anodic oxidation method. Scanning electron microscopy (SEM) showed that these tubes were well aligned and organized into high-density uniform arrays. XRD analysis showed the TiO2 nanotubes to be in the anatase crystal form. The TiO2 nanotube film electrode exhibited increased photoelectrocatalytic (PEC) capability compared to a traditional TiO2 film electrode fabricated using the anodizing method for pentachlorophenol (PCP) degradation in aqueous solution. The bias potential, pH value, and electrolyte concentration were shown to be important factors influencing the degradation of PCP by the PEC method using the TiO2 nanotube film electrode as the working electrode.     

以聚己内酯作为生物反硝化固体碳源的研究

为解决水体因低碳氮比而导致脱氮效率差的问题,将颗粒聚己内酯(PCL)重新塑形为阶梯环状,研究其作为反硝化过程的生物膜载体与固相碳源的反硝化性能。结果表明,在静态实验中,平均反硝化速率为8.57 mg NO3-N/(L·h);反硝化过程为零级反应。连续填充床实验中,超过90%的硝酸盐可被去除,出水NO2-N质量浓度低于0.20 mg/L;出水NH3-N质量浓度略有上升;出水溶解性有机碳(DOC)先上升后降低至1 mg/L左右。电子扫描显微镜扫描显示,PCL阶梯环反应表面空隙率较高,表面生物膜以杆菌为主,反应后被明显腐蚀;液相色谱检测显示PCL阶梯环分子量反应前后略有下降,其结构未受到破坏;表明该材料适合作为反硝化反应的碳源的同时,又可以作为载体供微生物附着生长。     

高强度好氧生物反应器处理制药废水的启动和稳定性试验研究

高强度好氧反应器(jet-loop compact reactor,JLCR)采用射流曝气强制溶氧.对JLCR处理制药废水进行了试验研究,考察了JLCR的运行效果、反应器的启动与污泥驯化、抗冲击负荷性能以及污泥沉降性能等.初步结果表明,该系统启动时间较短,运行稳定,COD去除效果较好.进水COD为8000 mg/L左右时,去除率达到80%.     

分子印迹技术在环境科学领域中的应用

分子印迹技术（MIT）是一门新兴的边缘科学技术,它的产生与发展为环境科学打开了又一视角。介绍了MIT的产生与发展及基本原理,综述了MIT在环境科学领域中的应用,主要包括MIT在固相萃取、膜分离、色谱分析、传感器及分子印迹聚合物作为催化剂在环境修复中的应用。     

多功能粉煤灰治理垃圾场渗滤液

以具絮凝、吸附、降解多功能粉煤灰污水处理材料,填充成絮凝沉降降解过滤箱,组合有鼓气、臭氧的连续式5级垃圾场渗滤液集成处理系统。垃圾渗滤液流量、鼓气量、臭氧量分别为40Lh、40L(m3·h)、15mgL的工艺条件下,渗滤液的悬浮物、色度、CODCr、BOD5、氨氮、硫化物等主要污染物指标分别降低93%、90%、96%、92%、86%和92%,达到垃圾场渗滤液二级控制标准。     

电动单梁起重机吊具冲顶引发起升电机坠落事故分析

针对一起电动单梁起重机吊具冲顶并引发起升电机坠落的起重作业事故,分析了事故起重机电气控制系统和现场紧急处置中存在的问题,指出了导致事故发生的直接原因和主要原因;并从完善起重机电气控制系统本质安全性和加强起重机械使用安全管理的角度提出了相应建议和意见,对预防类似事故的发生具有借鉴作用.